I put lowering springs on a few months ago and a pop/clunk has developed. There is a tiny lip of pavement just past my garage door and it clunks as I back out at an angle over it. Worse case I can check the torque on all of the bolts.
View 2 RepliesWe have a 1999 Passat GLX 2.8 auto. I recently put on a new inner and outer tie rod as well as a lower forward control arm. The issue that we are experiencing is that when accelerating or braking hard there is a popping/clunking noise coming from the driver front area. When accelerating or braking normally/ smoothly it is fine. But, as I said accelerate or brake hard it will make a single pop or clunk and that is it, just once when braking hard or accelerating quickly.
View 2 RepliesI purchased a 2012 Camry SE V6 end of December 2011. I really like the car's performance but have an annoying issue.
Above the driver's position, I hear short popping or cracking sounds when the car is moving and going over bumps or when the road twists. This sounds like a body structural issue and comes from the roof area to the left of the sunroof. This happens less often when it is sunny and more often when it is not sunny so the cooler metal may be the issue. The noise sometimes stops altogether when it is sunny or after the car has been driven for an hour. Once it sits for a couple of hours on an overcast day, the annoying pop/crack will start up again.
The door panel was replaced but the problem continued.
I am a new Camry owner. I am very pleased with the vehicle so far, but I've noticed a strange buzzing/static sound coming from my driver's side front door.
I checked to see if anything was in the storage compartment on the doors (all of them in fact) but I saw nothing in there. I turned off the stereo system and I double checked that all the windows were closed, yet the sound persisted for about 5 minutes. This has happened intermittently for several days now, and seems to happen whenever I go over some rough surfaces.
I just bought a used 2015 Camry LE 3 days ago. I just went to open the driver's door & heard popping as it opened. It's coming from the hinge area. I see posts about older Sienna vans having problems with broken welds causing the sound. Is it possible that a 2015 Camry could have the same problem? It's still under warranty. Are there any TSB's about it? Anything official from Toyota that I can take back to the dealer so they don't try to lube it instead of repair it & try to wait out my warranty?
View 1 RepliesHere's one I haven't heard of before on a Prius:
As I was closing my front driver's side window this afternoon I heard a pop or bang, and I noticed the window was closed, mostly, but it didn't fit right and the top rear of the window was out of the frame, up above where it should be, and the front, sloping portion of the window was below where it should be.
I put it up and down a few times, and eventually managed to coax it back into position, but it didn't stay there when I opened and closed the window again. It feels to me like whatever connects the glass to the motor and gizmoss that lift it up and down has broken or come undone.
I fear that it is a dangerous condition, because the window might pop out completely at high speed. Unlike the last time I remember having a car with a window disconnected from its mechanism (the 60's or so), we no longer have window frames to make sure they stay in place when the machinery breaks. Also, it has always seemed to me that the car's aerodynamic shape puts pressure on the doors and glass at highway speeds.
Anyway, I'm going to get this in to the dealer as soon as possible, but I wanted to ask:
Am I paranoid not to want to drive it at speed until I get it fixed?
I have a 05 camry that is making popping noises by the drivers side when the wheel is turned once around (left or right) in PARK. Everything looked good to me, I just recently got the car back from a shop.
*The car doesn't pop when it is in motion, because of this, I raised the front of the car to test and see if it would make the popping noise but there no popping noise either.
What would cause the front wheel on drivers side to lock up if it isn't the brakes. have been hearing a loud popping noise for a while on drivers side especially when turning left. Today got really loud just driving and then a real loud grinding noise. Then a loud pop and front wheel locked up and skidded across highway til i came to a stop. What it could be or how can i at least get wheel to turn to get it on trailer...
View 6 RepliesI have a stick shift Camry 2004 with 160K miles on it and I hear a popping noise (not clicking cv joint noise) coming from the front left side . I hear the noise when I drive off from a stop regardless of whether I am turning or not but mostly when I release the clutch after changing gears on second and sometimes third gear. I was told by a mechanic and a ntb tires and a former toyota mechanic it had to be the struts.
I figured what the heck ordered new mounts and struts had and I installed them and had the car aligned. That did not solve the problem. My next guess was the engine mount by the transmission so i changed that and still no success. The former toyota mechanic told me he now thinks it's the transmission but I am skeptical. How to diagnose this? BTW 95 % sure the problem started when my wife hit the sidewalk really hard (so hard I had to change the rim).
My LS460 recently developed a rattle from the front drivers side. It's triggered more by rumbles/vibrations from an uneven surface rather than speed bumps or large pot holes.
It sounds a bit like a washer vibrating on a metal tray (for what that's worth)!
Interestingly though it gets a LOT worse when the car is in 'Comfort' suspension mode, and is nowhere near as bad in 'Sports' mode. So it seems that having the suspension higher gives this thing more room to rattle.
I noticed in the service history that the front passenger air strut was replaced 30k ago, so I'm worrying that there is a large bill on the horizon.
I'm a new Mk4 R32 owner in the Portland area and my driver's front suspension developed a nasty squeak on the long drive home after buying the car. When you hit a pothole or any sort of bump it makes a nasty "clink" sound under compression/rebound. It's only on the driver's side front, and it seems to be a bushing/bearing or upper mount in the car when I got it up on Matrix Integrated's lift.
Also - the driver's front spring is squeaking since the powder coating flaked off after all the miles.
Thinking of buying a cheap set of coil overs to remedy this and refresh some of the more worn suspension items. Car drives just fine too.
2003 Jetta TDI 245K miles- owner's records show front bushings were replaced some time ago.
Suddenly started a groaning sound whenever the front driver's side suspension compresses. Started suddenly right after I hit a speed bump but not "hard". I parked and bounced on each corner of the car, no noise on anything but the front driver's side. The suspension's "give" felt similar across all 4x corners.
Of course whenever I'm braking or turning I get that sound. But it's definitely the suspension. And like I say, it's sudden.
I didn't see anything wrong, but the wheel's mostly in the way. The wheel cowling isn't rubbing the wheel. Handling feels fine, still goes straight with the hands off the wheel.
Front driver side area making a flat tire noise. Replaced the tires and axle and wheel bearings. Kinda lost on what could btw making the noise. Alignment done 15k miles ago when lowering springs and new shocks were put on.
View 5 RepliesI have a '99 E350 passenger van I have been trying to figure out a vibration problem. All the way up to 67 mph it is as smooth as a Lincoln, but from there up a vibration emerges from where I think is the front driver side area. I have done new rotors/calipers, because it needed them, balanced tires numerous times, have put the fronts in the rear and those have not fixed the vibration. The van has 100k on it and I love owning it especially with the big V10. The vibration is just enough to be annoying and when driving it is almost like it cycles for 4 seconds for the vibration then smooth for 6 seconds.
View 3 RepliesI just purchased my first VW, a 2012 Tiguan SE in Night Blue Metallic. The level of fit and finish, handling, and general feel are miles ahead of my old '04 Jeep Liberty.
Anyway, I've had the car for about 250 miles and have noticed a clunking/rattling noise coming from what sounds like the front passenger side suspension arm. The noise is fairly quiet but seems to consistently happen when turning left over uneven pavement.
I plan on taking it to the dealer this weekend and it is only a minor annoyance, but a shame since the rest of the vehicle is so quiet and refined.
What the defective part could be? GS300 has run 90.000km, sound can be recognized by passing for example gullys or small bumps with speed of ~20km/h. Increasing speed let the sound disappear. I have already replaced stabilizer bar bushes, link assy and lower ball joint assy.
Attached a linked sound file [URL] .....
I just recently noticed that 3 of my 4 windows will not go up or down. Drivers side OK. Recently had the recall done for the passenger seat sensor, but I can't recall if I exercised the windows after. I am thinking maybe the master switch in the driver's door could have died. 2012 Camry XLE ...
View 9 RepliesWash the car today, unfortunately found the driver side doorsill start to have some rust, and luckily the rust only found at he driver side doorsill rest doorsill looks fine.
Don't know what to do now, get it painted? or just grease it will keep rust from spreading?
So I'm coming from the MK5, MK6, & CC/B6 Passat world. On those cars, they were notorious for having the front subframe "clunk" noise. The suframe would shift back & forth, creating a "clunk." This was VW's fix: [URL] ....
Anyways....I've noticed this about 5 times now I'm on my '13 Passat V6.....when I go to back up into a parking spot. And that's the ONLY time it's done it too.
Going from Drive, I put it into Reverse and then turn the wheel a little (NOT even all the way) and hear a "pop" or creak/clunk....definitely from the front. So my guess is that it's the subframe shifting. Only 400 miles on the car too, btw.
So I've had my R now for almost 6 months now and my PSS10's have been in it since day 1. I bought the car approx 4 months used with 8200kms on it. It's now at 16600km's.
Ever since I've had it, there's been a front end suspension noise that reminds me very much of the typical upper strut mount bearing and bushing noises. It's like a popping sound.
It only happens at low speed(parking lot) but with most moves like fwd, rev, turns and straight lines. The upper strut mount bearings and bushings were just replaced < 2 weeks ago, but it still does it and just as bad.
My 2014 Camry XLE has the drivers side door rattle. What is it inside the door that rattles?
In comparison, my 2012 Corolla LE was built in Japan and was just as quiet as a mouse inside.
This is the only rattle. So small and so persistent. It comes and goes, sometimes lasting an hour, but when it is gone it is definitely gone.
I can tap on the panels, open and shut the door, run the window up and down and yet it continues to rattle. Then, all on its own, it disappears. Sometimes for days without making a peep or a squeak.
It is not the Seat belt, nor is it anything attached to the seat belt. (If anything should be rattling it should be at the seat belt pillar adjustment).