I just replaced my turn signals with LED's, so obviously the car is reacting to the LED's by flashing quickly.
My question, is there any way of slowing down the speed of the turn signal WITHOUT replacing the LED back to stock bulbs?
My front left turn signal was hyper flashing. I replaced all four bulbs to no avail. Just to satisfy my curiosity I switched the bulb holder from left to right sides. The hyper flash followed to the right side. Turns out that the bulb holder shorted out. I had it replaced under warranty yesterday.
View 2 RepliesIt all began on my 1997 Camry when the driver's front turn signal began the rapid flashing thing, indicating to me that the bulb in the front was out. I replaced the bulb. The running light part works, but the flasher still does not. On the front passenger side of the car, the turn signal works, but the running light does not. I replaced the passenger side bulb at the same time I replaced the driver's side bulb. The flashing turn signal works as it did before, but the running light still does not go on.
The problem shouldn't be the bulbs - they are new. The flasher unit behind the fuse box should affect both lights flashing, so it probably is not that.
What thing or things can cause one light to flash for the turn signal but not be on constantly for the running light (passenger front side) and to work as a running light being constantly on, but not flashing as a turn signal (driver's front side)?
My wife's 2007 Buick Lucerne's directional signal is acting odd... When you turn it to the left-hand blinker, the pace is not the normal factory pace. After two or three cycle it then starts blinking on and off VERY quickly, like those blinkers you see on junkers periodically. The right blinker is normal pace as are the hazards lights. I am looking for potential causes before I bring it in for repair. I can't say anything trigger it, other than I noticed it after a car wash. Electrical problems are not my thing.
View 5 RepliesI recently replaced a burnt out left turn signal bulb in my 2002 camry v6 xle. The signal light was blinking quickly. Once replaced problem fixed. Now bulb is not working again and fast flashing is back.
View 2 RepliesThinking about getting a used Camry. Is there any issues with any of the years in the seventh generation Camry? What are some of your likes and dislikes of your car? For example I have been told that on the sixth generation Camry you have to remove the bumper to change the turn signal bulb. I have never had to deal with this, just what I have been told.
View 14 RepliesMy issue is i recently have put two different sets of front LED turn signals in my car and only after a day or so they blow out. When i pull out the bulbs they smell burnt. i do have LED turn signals in the rear as well they are plug and play with decoders no resistor required. For the front ones i did add 50W 6Ohm resistors on each side.
View 7 RepliesI bought my 2015 XLE May 20. I remember seeing in the vehicle setup a place to set the number of flashes of the turn signal when changing lanes, but now I cannot seem to find it. Where it is, or is it gone with the latest update?
View 13 RepliesI've read that the driver gets a warning if the lane marker is crossed without the turn signal operating. If you pull out to pass a car and don't use the turn signal does it give a warning the entire time you're in the "wrong lane" ? Does the warning stop when you're back in the lane you left?
View 4 RepliesDisclaimer: When I refer to lights, I mean the back-lit radio controls.
Noticed they're lights flicker when they turn off the car? It doesn't happen all the time and just kinda weird.
I have a 2014.5 SE Sport and the only thing I can think of is I always have my parking lights on (cuz I turned off DRL) but they always turn off when I open my car. Each time I try to record it, it stops doing it. It usually only last for a few seconds but just thought it to be odd.
I finally got my hands on tech stream cable and software and turned off DRL today. I also adjusted light sensitivity setting from normal to light 2. What i was trying to accomplish is to have faster respond of headlights coming on Auto and turning off quickly once it become light again if for example I am going through a tunnel.
I was in the mall today and headlights came on when i enter the garage. When i was leaving it was still light outside and yet even after 1 minute being outside of the cover garage the headlight would not turn off. I finally put it on DRL off and then back on auto and headlight stayed off.
Did i change the wrong setting? Is the result of me putting on light 2 means that while it will come on quicker in dark situation it will take longer to turn off?
2003 SCrew, 5.4, auto, 4x4.... Yesterday my left turn signal started flashing fast; checked and the front was not flashing. Picked up a new bulb, changed it, didn't fix anything.
I've tried:
-tilt wheel up/down in all settings-no change
-checked the wiring at the top of the column; still good and solid.
-swapped the bulbs left to right and vice versa-no change.
-swapped the sockets left to right and vice versa-no change.
Other info:
-the left front is the only one not flashing with hazards on.
-all original equipment, except I removed the stock side mirrors (w/signal) and installed manual trailer towing mirrors, but that was 2 or 3 years ago.
-the dash indicator light for left turn (arrow) does not come on at all.
-last trailer tow was over a month ago and all was good.
I ran out of daylight last night and at work now so I would like know which Fuse, Flasher, Relay, etc., I should check/replace and where to find them on the truck; under the hood (1st or 2nd stack of the fuse blocks); under the dash above the pedals; steering column???
I have been reading threads all day. Noone seems to have exactly the same issue so I'm just looking for some clarification. Turn signals dont work but lights work as "parking lamps" and internal climate lights are not illuminating either. Also, my blinkers making the clicking noise but much faster when the turn signal bulbs are not flashing. I had a radio issue but that is resolved. Where do I start? Do I go right for the hazard relay? I read somewhere there was an ignition relay that could potentially be causing all of this?
View 7 RepliesMy HD radio signal keeps going in and out. I had my windows tinted right when i bought the car so not sure if this was issue before or not??? i did ask the tint company, Zeibart, if the tint would affect the antenna and they said not at all cuz it was not mettalic tint. I have never had an issue on any other cars with tint. could this be caused from a different issue?
View 7 RepliesAny link I can go on to see how to remove turn signal switch on 2012 chevy traverse????
View 5 RepliesJust purchased my 1st SUV - 2012 Nissan Murano. Rides good, handles great. Seats a little firm. Problem: when the radio is on (not really very loud), can't hear the click of the turn signal -- it's set at a very low volume. As it doesn't stop clicking after changing lanes, how can I increase the sound of the click so I'm not one of those goofballs driving down the freeway making a perpetual left turn?
View 6 RepliesI have searched the Owners Manual, forum and internet about this, but I can't come up with a solution. Perhaps I am not using the correct terminology. I also have an ALLDATA DIY subscription on this vehicle, but I could not find any instance of this occurring to be able to troubleshoot. I though that there might have been a light out somewhere.
View 2 RepliesI need to know the Location of the turn signal relay, my left front bilnker is super dim, and the rear left blinker is normal brightness as well as they blink rapidly. I've replaced both front and back bulbs as well as the flasher and turn signal fuses, so I am assuming the last and final one is the turn signal relay.
View 2 RepliesI have an issue that popped up on my 2012 F-150 today. I was driving a bit today and when I returned home and shut the truck off I noticed that the right turn signal indicator stayed faintly illuminated. None of the lights outside are affected, and they all work normally, just that the indicator on the dash is staying lit.
The only thing I can see is that last week I smashed up the drivers side mirror and it busted the lens off of the LED lights in the mirror and 1 LED bulb is exposed. It did rain a bit today but I figured it would short out and blow a fuse if anything.
I will undo the negative battery cable tomorrow and see if it will reset, if not I will have te dealer check it out when I drop it off to have the roof reprinted next week.
My drivers side turn signals are hyper blinking. I tried replacing all four bulbs with new ones, but it keeps doing this. I am using stock turn signal (1157a and 1156a bulbs)...
View 9 RepliesI bought, new, a 2012 Camry back in 2012. I got the satellite radio option. The reception with satellite is horrible. On the clearest of days, I lose signal all the time making it useless trying to listen to it.
Yes, I understand vegetation can hinder reception. But, it shouldn't to this extent. Not long after I bought the Camry, I purchased a 2010 Ford Fusion. It, too, had satellite radio.
I think, in the 2 years I had the Fusion, I lost signal 2 times. On the cloudiest, foggiest, snowiest, and raniest of days, the Fusion never lost sat signal.
I had the dealer check out the system and they found nothing wrong. I've let my subscription to Sirius expire since I can't even get a decent signal. Is this typical of the satellite radio with Camry's???