I would like to make one or both of the 12v charging ports in the center console supplied by constant power, instead of accessory fed.
I haven't torn too deep into this car yet, so is there an easier way to do this besides running a lead from the battery? An empty spot in the fuse block perhaps?
Can't upload the pic but I just opened the cc box. Don't see any extra plug?
View 2 RepliesTo those who owns a 2013 Camry SE, when you're looking at the center console and below the A/C unit, there's a compartment with leather trimming around it, do you have a "gap" between the leather and the compartment?
View 10 RepliesI just noticed yesterday that the center console is moving a bit when I apply pressure to it. Seems like a screw or something is loose. Luckily there is no vibrating while driving yet, so it's livable for now but I would like to fix it.
Here's a video showing the movement when I lightly push on the piece:
It's even worse when I put my entire weight on it, like when reaching for something on the passenger side floor. I don't want to rip the entire thing out one day
As some of you may be aware, I swapped out my OEM HU recently for an aftermarket one -- I show it in post 486 here -- and for various reasons, I decided to go back to stock. I got a pair of 70-1761 & 71-1761 wiring harnesses (because I have a 4-channel aftermarket amplifier) and in a lapse of judgement I tapped the dimming wire into the illumination wire.
Later that night, I noticed when driving with my headlights or parking lights on, the center console buttons don't light up. Specifically, the radio, home & other buttons don't light up and all & the climate control dial knobs are very dim. The ventilation buttons buttons of the HVAC all light up fine & my hazard & passenger seat belt light up fine.
I already check the instrument cluster dash light control & I notice the dial knobs react to it but are still very dim. The brightness of the instrument cluster doesn't match their brightness at all.
I went ahead an looked at my fuse box under the steering wheel column and checked the 10 amp PANEL fuse & it's not blown. For good measure, I swapped it out but the buttons still don't light up. I then checked EVERY fuse under the steering wheel column & non are blown.
In addition to that, I checked every 10 amp fuse in the engine bay fuse box & non of them are blown.
I have a 2009 Prius with the Aux port in the center console. It has stopped working unless you jiggle the cable. Need to get a replacement?
View 4 RepliesI have a camry se and I am currently adding accent lighting to my car. I am trying to take the area around the shifter and the cupholders out so I can hide some wires and mount the led lights controller. How to get this out?
View 4 RepliesI just learned that the charging port is in the right rear, compared to the Prototype with the port in the left front. Seems to me that about 50% of the time, the driver will get in the car and drive off with the car still plugged in because they won't see the cable when getting in. Or at best, you will get in the car, and then have to get out again to unplug it. What am I missing?
View 19 RepliesI bought a 2015 Camry LE, with manual AC.
I just noticed that every time I turn the temperature knob, there is a small buzz/hiss noise come from the center console. the more you turn the knob, the noise last longer, however, the sound disappear soon once you stop turning the knob.I tested this when the car is parked with power on but engine is not running, this noise is also noticeable in City drive if you audio is off.
I did some research and know that it is from the Heat blend door actuator/Air mix door motor. When you change the temperature, the motor is going to change the direction of the heat blend door.
My questions is : Is this noise noticeable on every Camry?
I want to change my B5 center console for a B5.5 one. I've heard that I have to change the handbrake handle too, is this a direct swap?
Anything else I have to be aware of? (besides that the fuel door button have to be relocated).
i just picked up a Black 2010 camry le yesterday, 20K Miles for 15$.Tints are getting done today, spoiler ordered, window rain guards ordered, next is fog lights.. are our cars pre-wired for fog lights or no? can i just get a fog lights from ebay and install them?URL....also does the inserts in the bumper just pop-out? no screws right?
View 1 RepliesIt rattles when i drive, idk if its the clip or lid itself.. i remember another user saying they used felt or something to pad the lid or clip to stop the rattle, where its rattling?
View 13 RepliesTonight I was moving some stuff in my car around and placed my work badge in the console area behind the shifter of my 2011 Camry LE. It's the area with the aux plug in. I will attach picture. Anyways the badge somehow became stuck between the door and the back side. How to remove the lid?
View 6 RepliesI am trying to remove the center console on my 2004 Camry. Removed the obvious bolts and screws but there seems to be more to it than pulling a few screws.
View 8 RepliesSo I have the center console apart trying to get access to remove the 12v power outlet, and I have it all apart but I can't for the life of me figure out how the power outlet comes out of its mount. Does it slide out of the top, or come down through the bottom?
View 2 Replies2005 Camry... I have tried and failed to find how to remove the center console. No bolts in sight.
View 2 RepliesI am having this same problem shown in the video is there any easy maybe cheap fixes that i can do? [URL] ......
View 3 RepliesI'm trying to get to the shifter light for a 12v power source. I know how to take the left panel off, but how do I get the cup holders out to drill a hole for some led's?
Also, without a multimeter, how would one know which lead is positive and which is ground?
How to remove the console center right under the radio head unit. I could not find any screws. But it did not pop out if I pull it.
View 2 RepliesHow do you remove the armrest storage part of the center console? Ive undone the two screws by the shifter and the whole thing shakes but it doesn't come out...
2011 se by the way.
Have an E150 van with 302 engine. Where is the low pressure charging port on this beast.? The high press. is immediately visible but can not find low....
The van still has the old r-12 and I have 2 cans left...want to charge the system one more time before we get our new 6.0L VAN late this winter!