Camry 2012+ :: 2016 - Wiring The Turn Signals To Be DRL?
Apr 25, 2016
How would I go about wiring the turn signals to be DRL instead of the high beams?
View 8 Replies
Apr 25, 2016
Advertisement
Camry 2012+ :: SE V6 - How To Make Turn Signals To Do 3 Blink For Changing Lanes
How to make the 2012 Camry SEV6 turn signals do the little 3 blink for changing lanes, llike the newer ones, or the corollas do... Is it impossible???
View 14 RepliesGolf IV R32 :: Wiring Turn Signals As City Lights
I have a set of retros with dual turns. I was wondering how to go about wiring up the turns as my city lights (i have a euro switch). Is there a diagram of the wiring anywhere?
View 3 RepliesFord Wiring/Electrical :: Turn Signals Will Not Work With Engine Running
My turn signals will not work with the engine running. With the engine off they will. With the engine running if I move the ignition like I am going to turn it off they work.. Is it the ignition switch or ign cylinder....
View 5 RepliesFord Wiring/Electrical :: 2006 E350 - Flasher For Turn Signals
I must be missing something here. Where is the flasher for the turn signals? It isn't the two relays behind the radio is it?
View 2 RepliesFord Wiring/Electrical :: 2006 F150 - Turn Signals Won't Work
I have a 2006 f150. Both front turn signals do not work. I replaced bulbs still nothing. There back signals do work. They blink really fast.
View 4 RepliesElectrical-wiring - Chevrolet - Equinox :: Turn Signals And Hazard Lights Stopped Working
I have checked the fuses for the Hazard and the Turn Signals. Both look fine. I tried replacing the turn signal flasher (which was a task in itself). After all of this it is still not working. What else could it be? Simple short?
View 2 RepliesFord Wiring/Electrical :: 2001 - Turn Signals Stop Working When Vehicle Heats Up
I have a 2001 Econoline and the turn signals work in the morning but when the vehicle warms up they stop working. I have replaced the bulbs and the fuses. What I could try next.
View 4 RepliesFord Wiring/Electrical :: Passenger Side Does Not Light For Brakes Or Turn Signals Suddenly
I installed LED tail lights a few months ago, now all of a sudden the passenger side does not light for brakes or turn signals. The lights came with resistors that I put in when installing and the adhesive wore out and they were dangling in the truck frame. The wires connecting the resistors to the light were damaged. I taped the exposed wires and secured them a with a heavier tape, but taping did not work. I also tried switching the resistor packs with the driver side to see if it was them that have an open winding, but they are still operable.
I narrowed it down to wiring between the trailer hook up and passenger light assembly in the electrical circuit. I plugged an LED light bar into the trailer connection and the same problem occurred (running lights come on, but no turn signal or brake light). Where could there be a short? Or is this circuit fused somewhere that the running lights come on but a separate fused circuit triggers the higher voltage for LEDs.
Ford Wiring/Electrical :: 2004 F250 - Turn Signals And Hazards Stopped Working
So I have an 04 F250 Super Duty 6.0L and suddenly the turn signals and hazards stopped working. First I replaced the switch on the steering column...no luck. Today I replaced the flasher relay under the dash panel (the blue one)...still no luck. I remember checking fuses in the fuse box but don't remember which ones I checked but I didn't see anything obvious. I also took a quick look under the dash at all the wires for any anomalies...nothing. I'm lost... What to do next!?
View 1 RepliesFord Wiring/Electrical :: 2004 F150 - Brake Lights / Turn Signals And Flashers Not Working
My brake lights, turn signals, and flasher are not working in my truck. Is it a fuse and what fuse? Could it be a relay?
View 2 RepliesFord Wiring/Electrical :: 1973 F250 - No Turn Signals / Brake Lights Or Rear Hazards
Dad borrowed truck and wired 7 pin trailer harness. Lights worked on truck/trailer for use but upon return the turn signals didnt work. Hazards and running and brake lights did work. Replaced TS flasher and Haz flasher. Still no signals. Pulled steering wheel and replaced turn signal cam only, not whole switch. Now no brake lights, no rear hazards or turn signals. Losing my marbles trying to follow schematic and using test light and mulit meter. All bulbs and fuses are good. Running lights and head lights working as well.
View 6 RepliesFord Wiring/Electrical :: 2001 F350 - No Turn Signals When Start The Truck - Fuse 1 Keeps Blowing
2001 F-350 diesel. Out of nowhere, I start the truck and there's no turn signals. Fuse is blown so I replace it. It immediately blows. Tail lights work. No turn signal, brake lights, or hazards. I haven't hooked up a trailer or done anything abnormal recently. Only the #1 fuse (20Amp) is blown. Pulled bulbs and they work fine. Inspected wiring under and near lights. NOTHING! Any way to localize a short?
View 2 RepliesFord Wiring/Electrical :: 2005 F250 - Rear Turn Signal Signals And Brake Lights Don't Work
I just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights don't work.
The front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
My second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
Accent RB (2012+) :: Hyper Flashing Turn Signals
My drivers side turn signals are hyper blinking. I tried replacing all four bulbs with new ones, but it keeps doing this. I am using stock turn signal (1157a and 1156a bulbs)...
View 9 RepliesJeep - Wrangler :: 2012 - Wipers Go On When Using The Turn Signals
My Jeep Wrangler periodically has the wiper go on when using the turn signals.
View 1 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Turn Signals Do Not Work - Green Arrow Indicator Won't Even Turn On
I just got a 2000 F350 cc drw 7.3l.
I did search but have had no luck. My turn signals do not work, unless my foot is on the brake pedal my green arrow indicator wont even turn on. When they do my bulbs work but don't cycle so I know all the bulbs are good as I had my wife check all four corners when I got them to come on for a split second. I have tried replacing the MFS and the turn signal relay under the radio in the dash.... When I do turn on my blinkers I can hear the relay click once but that is it, no more.
I tried checking the wiring in the column and tilting the column to its extremes while trying to engage the turn signals. Also, if I unplug the brake light switch then I do not get an arrow on the IC to light up so I am guessing the power flows through that switch. I don't have a chilton manual yet and the owners manual was not in the truck. I did check fuse 23 ?
Ford Wiring/Electrical :: 2010 - No Brake / High Mount Brake Light / Rear Turn Signals?
2010 F-250 14,000 miles, gas engine with Knapheide utility bed. Tilt wheel has been kept in the up position from day 1.
The problem:
No rear brake lights.
No high mount brake light.
No rear turn signals.
No rear hazard flashing lights.
All trailer lights work.
All other truck lights work.
Things checked: Fuses all OK. Visual inspection of multi-function switch. Looks clean. Brake switch at brake pedal has power on one wire. Jumpered the other wire-no brake lights.
I need to haul my trailer and am nervous when I see a Savannah, GA metro police car.
Ford F-150 (2009-2014) :: 2012 - LED Turn Signals And Flasher Relay?
I am getting ready to switch out the turn signal bulbs in my 2012 F150 to LED bulbs. I know on my previous truck (2006) I had to switch out the turn signal relay so the turn signal lights would not fast flash. On my 2012 it sounds like the flasher unit is up high in the dash board behind the instrument panel and I can't see it.
How to access it easily? I have seen on other forums the talk of there not being a flasher relay and being computer controlled, but there is one listed on Ford parts for the 2011 and 2012 F150s.
Camry :: LED Turn Signals Flash Too Fast
I did my research and it turns out I need a relay switch for my blinkers. these bulbs are bright but flash too fast..
How do the relay switches work, what do i plug them into and do I need one relay switch per blinker?
Ford Super Duty (1999-2016) :: EBrake Light Show Up On Dash / Turn Signals Stopped Working / Heated Seats No Longer Turn On
Coming back from a trip I got a e-brake light show up on the dash then noticed the signals stopped working and the heated seats no longer turn on. I scanned it with my AE and got a brake fluid sensor error come up but nothing about the signals .... is this a common problem or is there a connection between all this? 2003 F350 6.0L .....
View 2 Replies