Camry 2012+ :: 2016 - Clicking Noise While Turning Steering Wheel Left Or Right
Mar 3, 2016
I have 2016 camry 4 cyl have roughly 2300 miles and I'm noticing a click click while turning the steering wheel left or right while stationary and vehicle running sounds like it's coming from under the dash.
I've seen there is a tsb for other year camry intermediate shaft issue, my vehicle is lowered on eibach Springs and would hate to take back to dealer and have them blame it on the springs in a vehicle that has only 2,500 miles.
View 10 Replies
Advertisement
I've recently replaced the power steering pulleys and belts. Now when i turn car, it makes a clunking /clicking noise and sometimes the power steering tugs back a bit. 2010 camry.
View 3 Replies
2013 Camry SE; I am experiencing a plastic buzzing noise coming from the left side of the steering wheel, the noise seems to be coming from the small compartment area (below the AC vent). If I press my hand against it, then the noise stops.
View 3 Replies
09 Camry steering wheel clicks when going over speed bumps or if turning the wheel left and right somewhat rapidly at a stop. Seems to not be as bad when the tilt is all the way down.
View 1 Replies
My 2007 Camry makes clunking noises when I turn the steering wheel to the left mostly. This happens most often when the weather is warm and hot but not during the winter time.
The noise seems to come only from around the steering wheel area inside my vehicle. Hence, I don't think it has to do with the CV Joints or anything like that but the steering wheel unit.
View 2 Replies
I posted in this thread originally: [URL] .....
But today I had my wife drive the car and take some slow left turns while I listened so I could get a better idea about what the sound was and where it was coming from. From inside the garage and in the car, it sounded like it was coming from the rear but I now know it's coming from the front passenger wheel and it is not a "grinding" sound at all, it's more of a tick-tick-tick/click-click-click sound.
Applying brakes doesn't change the frequency or quality of the sound, but speed does. The faster the wheel turns, the frequencly of the ticking increases. It doesn't appear to tick/click only once per revolution, it clicks a number of times throughout the rotation and at some points during the rotation it clicks more often than others. Like, tick.... tick... tickticktick...tick...
When going straight there is no noise, turning right, it sometimes might click once or something but it doesn't really happen turning the other way. I've looked at the dust shield around and even tried bending it back a little bit in case it was making contact when I thought it was more of a grind but nothing looks out of place and nothing has been done to the wheel recently other than putting new rims on a couple of months ago.
Wheel bearing? I thought a bad wheel bearing would make noise no matter what direction you're going and pretty much constantly. CV? I thought CV ticking usually only happens at full lock but it ticks even on not so severe turning. Fender liner doesn't appear to be touching the tire, and the car isn't dropped and is AWD so there's plenty of clearance.
So, is this a trip to the dealer? I'm only under powertrain... not sure if something is up if it would be covered. I think wheel bearings are, but not sure about other suspension parts that might cause this.
View 14 Replies
Noticed a clicking noise when only turning left out of a parking lot today? What this could be? Sounds like it was coming from the driver side front wheel?
View 2 Replies
Front sway bar bushings causing "clicking" noise while turning the steering wheel? Usually happens when I'm moving into or out of a parking spot and while I'm turning my steering wheel. I got the driver side, I believe, lower control arm replaced and after that i started getting a faint clicking noise when I'm turning the steering wheel.
The dealer, after multiple visits, discovered it's the front sway bar bushing causing the noise. They said it's really not worth the cost, since it's isn't a safety issue and the whole sway bar needs to be replace since you can't buy bushings alone. I want to get rid of the noise regardless of safety or not.
View 5 Replies
I bought an '08 Elantra about a month ago. A few weeks after buying it i noticed a creaking noise while turning the steering wheel to the left. It happens at low speeds or when stopped, but I haven't heard anything at high speeds. I can't tell for sure but it sounds closer to the inside of the car than the outside and will happen the entire time the steering wheel is turning to the left. No sound turning it to the right.
My brother liked my car so we test drove 3 other Elantras, 2 '08s and an '09. Two of them made the exact same noise. He ended up liking the one that didn't but after a while his started making the EXACT same noise too. I'm thinking this must be a common problem with the '07-'10 Elantras as all 4 cars had the same noise, but I can't find anything about it.
My right strut is bad and I'm having both front struts replaced Monday, so if it's something that can be done while he's doing the struts I'd like to find out before he takes everything apart so he doesn't have to do it twice.
View 1 Replies
When I am sitting at a dead standstill and I turn the wheel lock to lock, left or right, I hear a clicking sound. The clicking is louder inside the car, but I can't tell if it's coming from the steering column or the various linkages in the suspension or drive systems.
If I drive in circles, with the wheel at a constant (or changing) angle, there are no clicks, so I don't think this is a CV joint issue.
What could be causing this noise? I really don't want to take off my lowering springs and restore this thing to the original configuration for a warranty repair visit to the dealership.
If I do, you may see a fire sale of H&R 20mm wheel adapters and B&G lowering springs in the near future.
View 3 Replies
Experienced a weird clicking sound when the steering wheel is fully locked either left or right, when turning at low speeds? Its more of a pop than click. No issues driving straight, or in regular turns, just when fully extended.
View 7 Replies
What do I need to do about the high pitched noise I hear when turning the steering wheel right or left?
View 2 Replies
I had some steering issues with my truck so took it for an evaluation at pep boys. They recommended a new steering gear box and tie rod that hooks to the pitman arm so I had them replace them. Steering was improved but now the wheel is canted to the left or right depending on when I make a turn. When I make a left turn, the wheel is canted about 10 o'clock. When I make a right turn, it's canted about 1 o'clock.
I looked under and had my brother turn the wheel and didn't really notice any thing loose. I lifted the front and noticed the left wheel bearings need to be replaced. I also noticed the shocks were shot and replaced them but it didn't make a difference in the crooked wheel.
Do you think it's the wheel bearing that can cause this? How about the ball joints? The truck has 407k miles and I bought it a month ago. Previous owner said he never replaced any steering components. Should I just replace all steering components with the Moog kit? I'd like to hold off on the $600+ kit for now as I just bought a a boat and the boat needs some stuff. I hope to find that one thing (hopefully not more) that's loose.
View 7 Replies
Noticed a squeaking like noise coming from their from front drivers side wheel when turning left? Seems to only do it right after driving my car after it has been sitting for a bit. Can't make it in to Hyundai until next week, and I'm a little worried.
View 10 Replies
When I was reversing back and turning the steering wheel. I heard a metal clunk sound and it had happened twice in the past two days. Today happened after I released the parking brake and set it to reverse. What is the problem? Miles on the car is ~30700 miles.
View 2 Replies
Ford Focus 2012 - 25,000 miles
There's a loud grinding noise from the front end of car when I turn the steering wheel... even when the car is off and in park.I can post videos of the noise if needed.
View 2 Replies
'08 F350 6.4l 4wd, I had the truck come in with a exploded transfer case. (See pics). Ive read all about this happening to many others. The truck still drove, hubs not locked, plenty of fluid in the TC, pretty sure it was the double Cardan that did it. Anyways I replaced thwith TC, replaced the front driveshaft, filled the TC with recommended fluid. Test drove and drives great, shifts fine. Only until I turned left.
At slow speeds turning hard or 15-20 taking a turn, it sounds like a ratchet clicking from somewhere on the left side, right around the drivers door, from what I can hear from the cab. Does it in 2wd, 4wd hi/low, hubs locked or not. I changed the vacuum pump, no leaks, changed the IWE solenoid, pulled out both locking mechanisms, tightened crossmember, checked everything from the hours of research I did on the internet. I cannot find the problem. I don't know what else to check. Front axles free spin and lock when they are supposed to. I'm at the end...
View 6 Replies
Recently on my gen 6 with about 68k miles I have noticed a very pronounce noise when turning the steering wheel whether the car is stationary or in motion. It makes a loud creaking/popping noise and it cant be heard from outside the car. The noise happens no matter which way I turn the steering wheel. I know Toyota has had problems with their intermediate steering shafts.
View 5 Replies
Lately my 2007 Camry (2.4 L, Auto) has developed a bit strange problem. When I'm driving on highway, even slight left turn results in a grinding noise and sort of resistant steering wheel. It happens only when I turn left. As soon as steering wheel gets back to straight, the noise and steering wheel resistance/hardness goes away. I don't really feel much when I'm driving slow on the city streets. Although some time when I am little bit fast, I feel slight grinding noise and steering hardness. No problem in turning right at all.
View 5 Replies
I've owned my 14.5 camry se 4 cyl since may and a few weeks into owning it i noticed a pop/clunk coming from the front passenger side while reversing and turning the wheel. So, finally got some free time to take it into the dealer today and dropped it off. Also, when letting off the brakes you can hear like a creaking noise, almost like the brakes are metal to metal but it only happens LETTING OFF the brakes?
My service advisor says supposedly the "creaking" noise when letting off the brakes is normal. I told him i really don't believe that lol and asked to test drive another new camry on the lot which is being arranged for tomorrow. In the meantime he says they're gonna look at it either way.
View 4 Replies
I just recently replaced the inner and outer tie rods an got a 4 wheel alignment on my 2005 camry le and now whenever you turn the steering wheel all the way lleft or right, it makes a loud groaning noise, and it sounds like something is scraping kinda? What this could be an how to solve this problem? It is not low on power steering fluid...!
View 3 Replies
