Camry 2012+ :: 2013 - Shifting From 1st To 3rd Gear Is Not Smooth
Oct 18, 2014
I have been reading some topics with people having issues with their Camry transmissions and torque converters. I have 15000 miles now and I'm noticing not as smooth shifts anymore from 1st to 3rd gear. It also jerks a little when you suddenly step back on the gas.
View 10 Replies
Advertisement
My wife and I recently purchased a 2013 Jetta and have noticed some abnormal lag when accelerating. It's an automatic transmission and the gear shifts aren't as smooth as they should be. I have read that it is possibly related to the drive by wire system and may just be an inherent result of that system.
View 4 Replies
Recently, a problem has developed with shifting gears in my 1984 Mercedes 300D. The shift feels too smooth as I move the gear shift knob from Park to Neutral and back. It doesn't catch when in Park. The car will still roll when in Park and the engine will not turn over. If I move the gear shift knob from Park to Neutral and back a few times and push the car a little, the engine will eventually turn over and crank. Sometimes it cranks in Park and sometimes in Neutral. Can you tell me what's causing this?
View 2 Replies
I have a 2012 Sierra 1500 SLE with a 5.3 liter engine, 6 speed transmission and about 7700 miles. I have noticed that at times the truck does not seem to be performing efficiently and will not seem as smooth and transmission shifting is sometimes not so smooth in the lower gears. I have noticed that when I let the truck warm up for about a minute before putting it in gear, that all seems to go much more smoothly, but if I crank up cold and take off right away, then it tends to run not as smooth. I have even heard a slight "slap" type noise that I think is the transmission shifting when slowing down to make a turn at about 15-20 MPH. When I go to accelerate after the turn, it will sometimes slap as if it is hunting for the right gear. Obviously, I now let it warm up for a minute before I drive it. I have not talked to the dealer, but I probably will when I take it in for its 10K checkup.
View 1 Replies
I recently bought a 2012 Camry LE with 34,000 miles that used to be a rental. At the time of the test drive the car ride seemed perfect. Later, I noticed it doesn't ride nicely on large bumps at low speed. So I bought four new tires which improved the ride. But it's still not as smooth as a new one on the bumps. There is a lot of shock going into a car which gives it a cheap feel.
What would make my car ride the bumps better?
Put in new shocks?
Would I have to place front and rear?
And can I leave the springs?
View 14 Replies
This car runs rough after forward gear shifts unless I give the accelerator a push. Seems like problem is at lower RPM after shift. This condition improves after 30-40 miles. About 60K miles now.
View 11 Replies
I own a Camry SE 2012. Like a title above, driving with the ECO button on? I used to turn it on all the time, however, I've noticed something strange on my car recently. The transmission doesn't get smooth! I mean with the 6-speed auto transmission, it is supposed to change speed smoothly from 1 to 2, 2 to 3, respectively. It's like when I change from 1 to 2, the transmission is smooth enough, however, when I get to higher, it doesn't get smooth. I'm not sure if I turned the ECO drive off and it would get better or I just feel it so. My first thought was about the engine oil was not lubricated and out of date but I did maintained a week ago. It still happens on my car, but less than before.
View 5 Replies
I've always wondered why the transmission automatically shirts to 4th gear when I switch to sport mode! Is this normal??? It's an i4
View 14 Replies
I recently bought my GL less than a week ago with under 10km on it. Its been great so far but I noticed a weird movement when shifting into 3rd gear (both up and downshifting). It started happening about 2 days into driving the car.
As I shift into third gear I feel a little kickback against the forward motion. It doesn't happen all the time and it doesn't seem to be dependent on the car speed or the speed of my actual shifting. Although it happens a lot more when I shift quickly into third.
I've been told that 3rd and 5th gears are the longest and I might just need to get something adjusted at the dealership.
This kickback doesn't happen on any other gear except third (MAYBE I felt it a little on 5th but I may have been searching for it after being told about 3rd and 5th gear being long).
View 24 Replies
I have a 2014 2.0T AWD Limited, now it's about 9000 kms so far with regular maintenance at dealer. Recently I have found the tranny is shifting a bit lagging, in particular shifting from 1st to 2nd gear. I didn't think it was like this when it was new, not sure if it's something wrong, or now I'm getting more used to the shifting and start complaining.
View 3 Replies
So my r32 is the first DSG car I've owned. Been about over a year now and the gear change from 2 to 3 is not rough, but I can feel it. Almost like a bad dogbone mount...but only up shifting from 2-3. It does always happen. There are a lots of factors that come into play, throttle input, load, rpm, whether spark cut kicks in or not. DSG fluid is changed every 30k, UM engine/DSG combo. HPA puck.
The second issue happens much less frequently. Under heavy load, 2500-3200 rpm, in 3rd or 4th gear, the following upshift to 4th or 5th does something very strange. For some reason, when spark cut kicks in a too low an rpm in too high of a gear it engages the next gear then very quickly disengages and engages again. Almost as if it were another upshift.
VCDS doesn't allow me to access the PIDS for each individual shift solenoid, or the metering valve. Neither does the factory scan tool. I've been trying to catch the strange clutch activity in a log to post but every time I take my computer in the car and log the clutch activity it behaves normally.
View 4 Replies
Background facts:
Tranny swapped from my 4 speed auto to a 1.8t o2j 5spd
13lb. Light flywheel
Powerflex dogbone mounts
Peloquin LSD
The problem: Very hard to get a smooth shift from gear to gear. Trust me, I know how to drive, but I can always feel the car shifting into a different gear if you know what I'm saying. On my friend's bone stock Jetta, I just let the clutch out without gas in between shifts and you don't feel a thing.
On my car, you feel EVERYTHING. People have told me the light flywheel will make the ride more uncomfortable in many ways, especially since the RPMs drop much quicker in between shifts than stock.
View 9 Replies
I have an 86 celica with a 3sgte swap. 92 Camry v6 transmission . It feels rough when going into gears. Not smooth. I just replaced the transmission and it feels EXACTLY like the old the.
View 1 Replies
When I start the car for the first time of the day, the shifting is not as smooth as when the engine is hot. Is this normal ? When I checked the trans fluid, it was between 25 and 75...(the second little mark on the dipstick) but I just drove about 5min so maybe the engine wasn't warm enough..
View 6 Replies
I have a 2004 Honda Accord EX 4 cyl. with 156k miles.
A couple days ago, the CEL came on. It drove fine, but if I accelerated it wouldn't shift smoothly. It felt like it was hitting the rev limiter.
I took it to get scanned, but the reader didn't work. On my way to another shop, the light went off.
Today, the light came back on with the same symptoms. No shops were open, so I disconnected the battery hoping to reset things, and it worked! No other issues on the way to work. Smooth shifts, smooth idle, simply normal.
Obviously there's an issue. Getting it scanned is a pain; AutoZone and the like cant scan in CA any more. What is the culprit? I'm guessing O2 sensor.
View 2 Replies
I have a 2012 GLS automatic with 78,000 miles on it. Till now I never had any issues but recently I started having issues with starting the car. Its taking few tried to get it started. This happened 3 times and I got it checked at 2 places and they said everything (battery, starter, alternator) looks OK and they may not be able to find the issue until car breaks down as issue looks intermittent.
Later one time, I was driving on local road and car kept moving but I felt a small jerk like engine is stopping or gear shifting...and RPM fell to 0 but car kept moving. I stopped on the shoulder and turned off the ignition. After few trials, car started again and moved fine. This same issue happened today morning on the fwy when I am driving at 70 mph. It started after few trials.
View 13 Replies
i bought a used 2011 F250 and really like the truck and there is no comparison when towing the trailer.
1.) I've noticed the truck doesn't shift smoothly from 3rd to 4th. Under light acceleration the RPMs climb, then drop slightly, then climb, and finally the truck shifts into 4th gear. It's almost like the truck wants to shift but doesn't. I believe a selenoid was replaced on the truck.
2.) From a dead stop, when pushing slightly on the gas pedal there is a slight hesitation or unresponsiveness with the truck wanting to proceed forward.
View 14 Replies
I just bought a 2003 Camry, 4 cyl (154000 mi.) and the accelerator is a DBW. It feels different than a cable in that it seems to hesitate and after it shifts into second the car accelerates on its own a little bit. This is not a rev up in between shifts, it actually feels like a lurch. It is most noticeable when speeding up slowly. I may be able to get used to it but it doesn't seem right to me. The dealer wants $120 to hook up their computer.
View 1 Replies
I've noticed my Camry hesitating shifting lately. My initial thought was perhaps my transmission fluid was low. But after further review of some articles I don't believe that's it. I saw one mention of the computer and maybe having the transmission fluid levels adjusted?
View 6 Replies
Whats the right way to shift the car, when I reverse the car and want to change it drive D, should car be at complete stop OR we can still change it from R to P with with car slowly moving back. I usually apply brake, and let it complete stop, then change the gear shifter. But yesterday I was in hurry and didn't wait for the stop, car was very slow, but I didn't notice any jerks or anything wrong with it.
View 5 Replies
I have a 2007 Camry V6 XLE with a rebuilt transmission. Since the rebuild I have had an intermittent problem with the transmission not shifting into gear properly from park. When shifting from park into drive, sometimes the transmission will pause, leaving the vehicle in neutral, then slamming into drive.
The transmission was replaced in April of 09 with a leaking transmission seal. Since this time I have has this problem but have not been able to get it to be reproduced for Toyota to observe.
Purchased: February '08 (ish)- New
First Transmission Replacement- April '09- 35980 Miles
Transmission Repair- Internal Temp Sensor/leaking o-ring/Transmission Flush- 9/13/11- 101k miles
View 9 Replies