Camry :: 2011 - Get Yellow Tail Light Turn Signals?
Mar 27, 2011
Just bought my 5th Camry... a 2011 LE model.
Hate the LED tails, but I can live with them if I must.
Very disappointed the tails have red turn signals.
how to modify for yellow turn signals?
View 14 Replies
Advertisement
Recently my tail lights went out and my turn signals dont work either, the light for the turn signal on the dash doesn't light up either. My brake lights do work tho and so do my reverse lights.
View 3 Replies
Turn signal lights into parking/turn signals (6th gen 2011 Camry LE)? I replaced my parking lights with a bright led that matches my headlights, but I would like my turn signals to be on when my parking lights are on.
For some reason I thought they turned on with the parking lights (my other cars do), so I bought some switchback led's and after I installed them I realized that my turn signals don't come on with the parking lights. Is this something I can do by swapping out a relay or with some minor wiring changes?
I am planning on getting the relay below to stop the hyper-flashing and am curious if it would do anything else, common sense makes be believe it will not since the lights don't currently don't turn on, but I am not 100% sure. Also, is 1 relay better than another? They all seem to be the same with the exception of some have controls to adjust the flash speed.
[URL] ....
View 3 Replies
My '99 F150 is having wiring issues. It started with a left flasher being fast and the rear bulb not working. I put in new bulb and that didn't fix it. Then I realized that I also had no tail lights. The reverse lights are good and the brake lights work too.
So far I have searched for and repaired suspicious splices done by PO, added a ground wire that was cut off from the trailer wiring harness, checked every fuse that I could with an ohmmeter and I pulled the multi function switch and tested it with an ohmmeter also. It tested fine but I did find one of the female pin connectors had pulled out of the harness. I managed to get it back in and seemed to click into place alright. Somewhere over the course of all that I now have both sides of my flashers fast and still no tail lights. Good news is that I haven't broken my brake lights or reverse lights yet.
Could I have a bad flasher relay? Earlier in the process I did have my 4 way flashers working correctly and a couple times I even had the turn signals going. Now, none of the rear blinking lights work but the front ones go 90 to nothing and I still have no tail lights. My truck does have the auto lamp thing.
View 10 Replies
I have checked all fuses, checked wires on top of steering column all checked out ok. Hazards work but when I press brake tail lights just blink with no brake light but the 3rd brake light works??? Signal switch maybe??
View 14 Replies
I found out last night that all 3 of my brake lights are out. However, my tail lights work, and my turn-signals work. So obviously its not a big wiring deal. I was looking for the brake switch but i don't know where its at because i looked underneath. What fuse is the brake lights cause my manual doesn't have it listed. I drive a 04 Elantra GLS.
View 6 Replies
I remember reading a post here a while back from member who had replaced almost all (if not all) of his lights with LEDs, but I can't find it now. I already replaced the interior lights and the rear license plate lights with LEDs. Now it's time to replace my front turn signals as one is very dim and sometimes doesn't work. I'm looking for info on the proper LED bulbs for it. I know the stock bulb is an 1157, but I'm looking for an LED that doesn't need a separate resistor installed. Also, I'd like to replace my stock DRL bulbs with LEDs.
View 11 Replies
I have a 2011 f150 xlt it didn't come with the mirrors that have turn indicators on them they have the dummy covers. Putting the indicators in there....
View 3 Replies
How to fix or solve front turn signals that are not working? I just realized that both the front signals on my Prius doesn't light or flash when making a turn, the rear are working fine. Is this an easy fix or should I bring it to the dealer?
View 4 Replies
PCS blinking yellow light? I know what it is for but just got the car (2011 ISF) on Saturday and no PCS light. Drove it for about 10 minutes the first day I got it and then couldn't drive it again until today. Today = PCS light.
I was investigating wiring yesterday in the sunroof area for possibly hooking up a radar detector, which I didn't do yet. I replaced the car battery the day before. Drove it around today for really the first time and the PCS light remains.
View 1 Replies
I did my research and it turns out I need a relay switch for my blinkers. these bulbs are bright but flash too fast..
How do the relay switches work, what do i plug them into and do I need one relay switch per blinker?
View 14 Replies
The tail lights do not turn off- the head lights do not turn on. every fuse was pulled and still the tail lights stayed on. Headlight switch was swapped out with a new one to eliminate it with no different result. No modifications known to have been made to the electrical system. This thing did spend a lot of time in NY state, so corrosion is likely. But this does not explain how/why the tail lights would stay on even if the headlight switch was off... IMO this would have to be an ignition switch issue.
View 9 Replies
As i kid i hated seeing people make there turn signals blink faster but know as i got older I like it, so on my 2011 camry and i want to make the turn signals blink faster. Not too fast but a little faster. I know I need a flasher but i can't find one for the Camry. I know I have to remove the instrument cluster.
View 14 Replies
I used the volt meter wrong while testing my turn signal bulbs for power and not they do not work (or hazard lights).
View 3 Replies
How would I go about wiring the turn signals to be DRL instead of the high beams?
View 8 Replies
My turning light needs a bulb replacement (I believe, since when I click to turn right it makes quicker clicking sounds). Does this mean bulb is out or wiring is out?
As for the side light (also on the right) has fallen off and can no longer be screwed back in place as that part has broken off so I will be buying the replacement part/lamp. However, when it fell, the wiring was disconnected so i have lost the bulb and any connection to it. I think I still have the rubber wiring harness, just missing the wiring & bulb.
View 1 Replies
Coming back from a trip I got a e-brake light show up on the dash then noticed the signals stopped working and the heated seats no longer turn on. I scanned it with my AE and got a brake fluid sensor error come up but nothing about the signals .... is this a common problem or is there a connection between all this? 2003 F350 6.0L .....
View 2 Replies
A few days ago my speedometer stopped working. Then yesterday all of my gauges stopped working, as well as my turn signals. If this is a fuse issue then which fuse it is?
View 9 Replies
How to make the 2012 Camry SEV6 turn signals do the little 3 blink for changing lanes, llike the newer ones, or the corollas do... Is it impossible???
View 14 Replies
Below in this photo-shopped picture the camry headlights have clear reflectors for the turn signals ..
I am going to be doing a HID retro , and I want to swap out my reflectors for some clear ones. Anything or anyplace I can get large non-vehicle specific reflectors and i can manufacture my own ? I want to keep the car as legal as possible, after my illegal retro (all retro's are illegal )
View 14 Replies
I bought a used 2002 Camry (at a discounted price because of a few dings and dents) and the headlights are not working. The high beams and turn signals work but not the headlights. I changed the bulbs, checked all the fuses and got a new relay but still nothing. I brought it to an electro-mechanic and he told me the ECM was busted and that he could maybe grind it down. This seemed odd to me so I called my old mechanic in the states who said he has never heard of an ECM causing headlights not to work and suggested I install a toggle switch. Does this sound like it could work? Could I do this on my own? I'm pretty handy but am a little hesitant to try any electrical work on my car as I have no experience with electrical work.
View 3 Replies