I have a 2011 camry le, just got its 10,000 service the other day. When I am stopped with my foot on the brake and the vehicle in drive gear, I can hear a rattle coming from the front. But when i let go of break and accelerate it stops rattling. I told the dealer at the service but they told me they could no duplicate it.
View 12 RepliesJust changed out the struts on my ACV36R Camry Altise. Fitted up some nice Monroe GT struts and Kings Springs (front and rear) as well as new Nolathane bushes throughout.
Now, everything is tight, checked over every nut and bolt with a torque wrench to the correct specs but I have a loose rattle sound coming from the front right strut. What it could be before I tear the whole lot out again? I've been around it with a rubber mallet trying to isolate the rattle but I can't replicate it by hitting any of the components that I've replaced.
I have a 2003 Volvo C70 that I've owned since 2004. In February, I ordered struts for the front with all the trimmings, (spring seat, strut mount, bump stop, etc) from FCP Euro. The struts were Sachs 553-058, which are supposed to be as good if not better than the original struts. I installed them myself, meticulously following the instructional video FCP publishes on YouTube. Installation went very smoothly. Afterwards, I noticed a rattle/knock coming from the right front when I drove over a bump or rough area.
I took it to a local tire/brake place that I have a good bit of confidence. After driving the car, the guy says, "You gotta bad strut!" Called FCP. They sent me a new strut. I installed it and sent the other back. Sounded a LOT better—for about two weeks. Now I am hearing the sound on both sides. I took it to a very reputable Volvo mechanic, I have used since the warranty expired. He drove it, confirmed the sound was not normal. We put it on the lift and he checked everything on the front suspension and was stumped. He said there was nothing wrong with my installation, no problem with the suspension.
Okay, FCP has an unconditional satisfaction guarantee, so I could replace these with a more expensive strut for say $50 more, but is the problem with the struts? I would hate to have to do this installation again and still have the same problem.
'03 C70 Convertible LT110,000 mileswell-maintained, great-running car
I was coming home from a trip and started to here this banging sound coming from the passenger side in the front under the vehicle. It already sounds like it busted up some gears cause you can here it being tossed around inside the casing. The vehicle will drive but once I get to around 10 mph it would start banging sounding like gears are messed up.
There is no binding there is nothing that makes the car slower but something is broke. I am wondering if there is a gear box under there near the center console and over to the passenger side in the front. Funny thing is... Is that it started in the back rear but stopped then the front started and then broke something. The back is fine though. Think this could be the All wheel drive also or some part of it.
For a few months now, I've had a slight rattle coming from my car's front end (2002 V6), but it has been getting louder. The noise is most pronounced at 30+ mph on rough (old) road. Yesterday, I jacked up the front end to do the tie-rod and ball-joint tests. There is no play from either top-bottom or front-back wiggling.
Here's what I did notice while doing those tests:
1. It looks like the hockey-puck sized control arm bushings are cracking. Is there a source for poly replacements (and how much do they effect the car's ride)? Or is there a better-than-OEM rubber replacement?
2. When the cars was jacked up, I could turn the wheels a little bit (maybe a quarter turn while the tranny was in park). There was some noise coming from behind the hub. It sounded like the meshing of gears, or metal parts intercoking with each other. Is this normal? The bearings don't make any noise when it's driving.
Experienced this issue with the the 5th get camry at all. It seems like it is coming from just above the door handles in the front and can hear it when driving over bumps and bad roads.
View 3 RepliesHave a new 2012 Camry XLE V-6. The car has an intermittent rattle/vibration coming from the front of the car. I have 5000 miles and the noise is getting worse. Taken back twice to dealer but no luck. The dealer has checked the front end and suspension, but can not find anything loose. The noise starts around 45 MPH. I know this sounds crazy, but the noise is worse if it's a windy day. A sudden guest of wind will start the noise. I've tried trouble-shooting by turning the wheel, hitting the brakes, even placing the car in netural while driving, but nothing affects the noise except the wind.
View 14 Replies'01 Taurus with an occasional rattle/clunking sound coming from the front end when going over bumps. Took it to the local shopping center auto. service dept. (probably 1st mistake I know) They say the only thing they could find was the RH CV boot was bad and was probably the source of the noise. Doesn't sound right to me since the boot is rubber and what I hear is more of a metal sound..what I was thinking possibly a suspension link or tie rod end. I know what a bad cv JOINT sounds like and it's nothing like this. Now if the CV boot is bad I don't mind to replace it, but I don't want to spend the money if it is not going to solve the problem. I've never heard of a boot making noise before.
View 2 RepliesI have the dreaded click-click-click noise when turning that is indicative of my CV joint going tits up. Checking it out the boot is split and there is some grease. So, I plan on going ahead and changing both sides drive axles out, since the Camry has 178k on it (yeah, 178k on a 2009.)
View 14 RepliesLast night, I replaced both front struts with Monroe complete sets (new springs, mounts, boots, struts, etc) and I had my front rotors smoothed out. That cleared up about 75% of the noises coming from the front of my car Except for one.
Whenever I'm braking, there is a noise coming from my front left wheel. It's not a brake squeal, but more like a creaking sounds that comes around with each rotation of the wheel. It slows down with the car, and I can make it last longer by doing a slow roll with the brakes one. So when I'm fast it sounds like "Crk! Crk! Crk!" When I'm going slow it's "Creeeeeak... Creeeeeeak... Creeeeeak..."
Last night, I also replaced the sway bar link on that side. The brakes are smooth and the tires were balanced a couple months ago (no steering wobbles at any speed)
I'm having a squeak/rattle type sound coming from my front drivers side wheel (more rattle). It only happens when I go over a quick bump and happens going straight and while turning. 2012 f250. 87k miles. 4x4. I have a two inch block level (southern truck) up front..
View 14 RepliesOn my 2012 Camry XLE with 22,500 miles, just had the drivers side drive shaft assembly replaced, under warranty. Was getting a clicking sound when turning. Not too happy, car comes off warranty in September. They also updated computer on a recall for the torque shutter.
Then he tells me I need an oil change (was just done, oil shiny clean). He said oil looked dirty. Also said I needed a fuel injection cleaning (at 22.5k?), and new tires. OEM tires are garbage. Wheres the Toyota quality and integrity?
I have a 2002 Santa Fe that has started to have a very loud rattle. It sounds like it is coming from underneath the vehicle toward the rear, possibly the passenger-side wheel-well, but that specific location just may be an auditory illusion.
[URL] ....
This only happens to me while on DRIVE with my foot on the brakes... [URL] ....
View 1 RepliesHave a 2012 Camry LE with about 12,000 miles on it. Lately the weather has been warmer so I'm driving with the window open and I've noticed a slight clicking sound coming from the front end (only when turning right) when going through a corner like an off ramp on on ramp. I tried tapping the brakes but that had no effect. It almost sounds like the brake scraper, but not as harsh. The original brake pads couldn't be worn out yet.
View 4 RepliesHow to remove the drive belt on my 2003 camry 4 cyl.
View 5 RepliesMy 11 cc lb 4x4 6.2 has a clunking/loose sound coming from the front end. It is prominent when going over small/medium bumps but not so much large bumps. I have had my local dealer and a couple local shops look at it and they all say everything checks out. It definitely seems like something is loose in the front suspension. I just put new Gabriel max control shocks on all four corners. I have no play in wheel bearings or ball joints. Tie rod ends also look fine.
View 12 RepliesI have a 2004 camry xle with a V6 motor and it had 38k miles on it. Recently I'm starting to hear a weird sound coming from the front passenger dash area during the initial move off. It will happened when I drive the car at a speed of 5-10 mph after it has been stationary for at least 4 hrs. The sound itself sounds like something is moving and follow by at "clunk" sound, indicating that it has seated properly. All this last for maybe 1-2 sec during the initial move off and did not return for the rest of the drive. This weird sound become slightly louder on colder temperature. The car runs well and shifts well.
I had my tranny flushed by a toyota dealership, rack and pinion replaced and passenger side drive shaft replaced, before this weird sound started.
I've a loud squeaking sound coming from the front of the engine on cold start. This only happens when I start the engine after overnight parking . There are no squeaks when the engine is warmed up or when I start up with a warm engine.
I'm driving an 07 Camry and live in a region with hot tropical weather.
Video link to the sound [URL] ....
What could be the probable cause of the this and how do I rectify it?
I have a 2004 Explorer 4.0L with 190,000 miles. My wife was driving it and the vehicle stopped moving. Sounds like the torque converter whining and will not drive in any gear or 4wd.
View 1 RepliesIs there a programming sequence that will keep my 2002 Camry from locking all doors when the vehicle is put in drive/reverse. I realize this is considered a safety feature but I prefer to lock them myself.
View 10 Replies