Camry :: 2010 Manual Transmission - Hard Shifting Into 2nd Gear
Jan 13, 2010
Just curious if there are any other 2010 owners with any difficulty shifting gears in their manual transmission camrys? I noticed during my test drive that I grinded my way into 2nd once... I thought it might have just been my nervousness with a new clutch at the time. However, I've since put 300 miles on the car and I still have trouble putting it into second gear on a daily basis. Sometimes it grinds a bit, and sometimes it catches or a half second before it pops in. All the gears OTHER than 2nd gear go in like butter as you would expect with a new transmission. I'm not new to a clutch... this is at least my 4th car with a stick, so I don't think I'm doing anything out of the ordinary when shifting.
It reminds me of some older (100,000+ mile Nissan) cars I've had in the past... the syncromesh was wearing out and it would grind going into second or third, so I put in some RedLine MTL and got a little more life out of the transmission... but there shouldn't be a need for that kind of thing on a car with less than 1000 miles on it?!
View 14 Replies
Advertisement
2006 chevy 4.3 v6 5 speed manual trans. Very hard to shift into and out of gear , the truck has about 80,000 miles on it , its had the new trans fluid gm replaced for smoother shifting. If you hold the clutch pedal down on the floor hard it works fine. It all most like the pedal it screwed up. The pedal ass is plastic junk, I am thinking the pedal is bended. The clutch does not slip and I tried bleeding the clutch master cylinder and there are no leaks anywhere !
View 9 Replies
I have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
View 2 Replies
Have a 2000 expedition with 84,000 miles. Tranny seems to shift hard from first to second gear. Its been 24,000 miles since my last dealer tranny service. Thinking of getting a new service now before the recommended 30,000 manual recommendation. Whats happening?
View 6 Replies
In the last 8 months I'm having a shaking of the car when starting in first gear (manual trans).
I thought it was a loose engine mount - had it checked and one replaced and still the shaking is there.
I notice it is more pronounced when the engine is hot and starting on a decline.
Since I've had this Camry (almost 8 yrs), I've had the clutch changed 2x. First time was just wear and tear. The person who replaced it put the fly wheel on backwards! Drove it for 3 years until it just broke. Replaced by another shop who couldn't believe I got three years out of the bad job.
At any rate, this doesn't feel like a clutch-related issue. No slippage feeling or other issues when moving through the gears at higher speeds. But maybe they did a bad job too?
View 8 Replies
I've been working on a cruise control issue on & off for about a year now. Vehicle is a 2011 UD Elantra with a 6 speed manual trans. Problem is cruise won't set in 6th gear. Works perfectly in 2nd through 5th gears.
Cruise power light stays on but won't set. Upshift indicator working correctly. I've had Hyundai field service engineers look at it 3 times with no luck. Vehicle has no fault codes at all. All switch & sensor inputs are correct. The only vehicle I had with a man. trans. to compare to was a 2013 MD. Cruise worked fine in 6th on that vehicle. The last word we got from Hyundai (supposedly from Korea), was that this is normal and cruise on that model is not supported in 6th gear. I find this hard to believe but I wouldn't doubt this is a programming issue. 6th gear should be the most used gear for cruise operation.
View 8 Replies
I have a 2006 GS RWD the transmission started acting weird 4 month ago went to many workshops and no codes were found in the computer and my problem is that when i am moving in the car for more than half an hour and stop the car seems hard and jerking while shifting to 2nd gear and if i put it in tiptronic it go to 5th gear immediately it seems ok when the transmission is cold so what do you think it has got 125000 miles on it and what is the normal temperature for the transmission so i can test it with mini vci...
View 7 Replies
I am in the nasty position of having to remove my 6-spd manual transmission to investigate the nasty whine in it. The dealer says $2300 to fix it and the parts are $100, so I am going to do it myself. I have been unable to find a repair manual yet for the 2010 Camry and I was wondering for step by step for removal of the tranny. I don't need a lot of detail, but it is nice to know the order in broad strokes.
View 7 Replies
The tranny is shifting really hard between 2 and 3 if I feather the throttle it can be a little less of a jolt but still enough none the less iv never done a filter and fluid change as I just got it it has 235000 miles 99 v10 super duty 4x4....
View 8 Replies
I have a 2007 Camry V6 XLE with a rebuilt transmission. Since the rebuild I have had an intermittent problem with the transmission not shifting into gear properly from park. When shifting from park into drive, sometimes the transmission will pause, leaving the vehicle in neutral, then slamming into drive.
The transmission was replaced in April of 09 with a leaking transmission seal. Since this time I have has this problem but have not been able to get it to be reproduced for Toyota to observe.
Purchased: February '08 (ish)- New
First Transmission Replacement- April '09- 35980 Miles
Transmission Repair- Internal Temp Sensor/leaking o-ring/Transmission Flush- 9/13/11- 101k miles
View 9 Replies
just bought a 2003 camry 4 cylinder with 126xxx miles automatic, everything seem fine when i was test driving and all. I bought the car and finally drove the car for around town running errands and all of a sudden i started to noticed a stutter in between shifting from 2nd to 3rd gear.
View 2 Replies
I've had 2 Elantra 2012 models 1 a gls the second a limited. As far as transmission issues both Elantra's from a cold start after allowing RPM's to idle down before taking off they both have started shifting hard going from 1st to second gear 1st car was around 8-9 k miles now 2nd started at 3 k miles. Since owning 2 cars same make same year same transmission and many times to dealer 1st car ended with Transmission replaced 2nd has now started doing the same thing they reset adaptive and next day did it again its now back at dealer waiting for them to diagnose again.
View 13 Replies
I have a 2009 camry 4 cyl with 104k miles. I recently change my trans fluid by doing drain and refill. I used the toyota WS fluid which they recommend changing every 100k miles. After driving the car, I noticed that when coming to a stop, I can feel a hard thug when going into 1st gear. I did checked my fluid level and is on the hot mark.
View 13 Replies
2007 V6 Mustang Manual Transmission. I recently got stuck in my drive way due to a poor plowing job by the plow guy. I had to turn the traction control off and aggressively shift transmission between reverse and 1st to rock the car and spin the tires. I eventually got unstuck but now the transmission doesn't feel right.
I thought it was the clutch but the issue seems to occur only shifting from 1st to 2nd. The higher gears all seem relatively fine. There is just a catch between 1st and 2nd now that sometimes causes me to not be able to shift into second gear without forcing the shifter down roughly.
Is it possible that I just threw something out of alignment inside the transmission itself? It doesn't make the car undriveable but i get ticked every time i drive it knowing that it was fine before the poor plowing job.
Should I even bother having it looked at? I know transmission repairs are expensive.
View 1 Replies
I've been hearing a quiet 'thump' when shifting. In particular, when first letting up the clutch starting out in 1 but also when shifting between gears when the clutch is fully down such as from 2->3.
I thought perhaps a fluid change was in order since I'm at 110,000 miles. It didn't make any difference. (I used Mobil 1 GL5 which according to independent tests is safe on yellow metals.)
So then I wondered if it's the engine mounts, but I'm not sure what it sounds like when they need to be replaced or if simply shifting between gears while driving as described above would cause a worn one to 'thump'.
View 11 Replies
I've got a 1996 BMW 328i manual. It has 175k miles. I purchased the car about a year ago. Several weeks ago, I began hearing a screeching noise when shifting when the car is cold. The screeching happens when you let the clutch out when going into gear. It happens much more frequently when very little throttle is used. If you shift it harder, it is less likely to make the noise. If it starts making the noise, you have to shift several times for it to go away. It'll still make the noise while in gear at that point. When the car is driven for about 10 minutes, it never makes the noise afterward, until the car cools down completely overnight. The clutch does not appear to be slipping at all, and once a gear is engaged, it does not have any issues staying in gear. What is my car's issue?
View 1 Replies
I have a '91 Camry that's my daily 50 mile round trip commute car. It runs well and still has lots of pep at 156,000. There are oil and tranny leaks (tranny leaks around the pan seal) but I check the levels and keep everything topped off. Tranny fluid and filter were changed about 20K miles ago. I am the original owner. Shifting is OK unless I accelerate hard, then it "bumps" into gear. On hard acceleration it is a pretty good bump but if I back off the gas it shifts much better. There are no other symptoms, at lower speeds it shifts fine unless the A/C is on, then I get bumps above the 1-2 shift. What the problem is?
View 3 Replies
I bought a friends 95 f350 7.3 powerstroke with an E4OD. The truck quit driving.the OD light is not blinking. I confirmed the OD light does light up.The trans fluid is full , red and does not smell burnt. I have tried to manually shift 1st and second nothing happens. No reverse. Where should I look for the problem? Solenoid pack, loose valve body, bad relay?
View 1 Replies
Driving in normal mode and the transmission in auto. Once the car gets up to temp, (usually at a stop), move the gear selector to manual mode. If you punch it, I have not issues shifting from 1st to 2nd gear, but sometimes, the up shift paddle will need to be hit multiple times in 2nd before the car will shift to 3rd.
It seems to only happen the first time I go from auto mode to manual mode during a drive cycle. It happens on my car and another car I test drove.
View 8 Replies
Why my vue manual tranny only goes in first third and fifth . Can't get it in second fourth or reverse . Bought it like that .
View 1 Replies
1997 Saturn SL ... It's like 3rd gear is where 1st used to be and 4th is where 2 used to be. 5th and reverse work but are more towards the center. It's as if the stick shifted over to the left.
Is it possible for the shift stick and it's linkage to become displaced? The temp did drop today about 40 degrees and it snowed but the car stays in the garage and was only parked at my work for a couple hours after a 2 mile uneventful drive.
No warning lights that I can see but the check engine lite has never worked. The engine is a 96 rebuild but the transmission should be a 97 like the rest of the car.
Great mileage and otherwise drives fine.
View 4 Replies
