2010 LE 4cylinder... Turning right has no noise, turning left of center gives a rumbling noise. Looked under the car for any damage or steering leakage and found nothing. Just 30K on the car still looks like new under there.
I could not find any steering problems in the stickies for this gen Camry. I could not find any TSB about this either...
I just replaced the power steering box on my 1979 dodge B200. now when I start it it turns hard to the right and I can't turn it to the left.
View 6 RepliesI have just had a 1956 Buick steering unit rebuilt to correct a seal leak. After installation,when the car is started, the steering wheel turns itself to the left. This occurs without moving the car. It seems that this has something to do with the power steering system, which worked fine before we had the steering unit rebuilt. How to solve this problem?
View 2 RepliesI have a 2010 Honda Civic with about 32K miles on it. Last fall, at around 23K miles, I needed new brake pads and rotors (because I waited too long on the pads). Got those replaced. A few weeks later (I think), it started making a kind of squealing noise when I make left turns. I mentioned it to my mechanic when I took it in for an oil change shortly thereafter, and he said it was probably the belt, but I could wait a bit on replacing it if I wanted to (as he knows I'm always broke).
Three weeks ago, I took the car in for another oil change and to have him change the belt. He put in a new belt, but alas, after driving the car about a mile the noise returned. I called my mechanic, and he said it might be my tensioner, but that such a new tensioner shouldn't need replacing already and that it would still be under warranty. I needed to take it to the dealer anyway because my window mechanism was broken, so while I was there, I had him check out the tensioner. He also said the tensioner was fine, and said that since the belt wasn't a HONDA belt (naturally), that might be making the noise. Last week, I took the car back to the mechanic, who ordered and installed a Honda factory belt free of charge.
Naturally, a mile later, the noise returned. I resisted every urge to drive into oncoming traffic. I used my phone to record the sound so that I could e-mail it to the dealer and my mechanic, give it a listen: [URL] ....
Lately my 2007 Camry (2.4 L, Auto) has developed a bit strange problem. When I'm driving on highway, even slight left turn results in a grinding noise and sort of resistant steering wheel. It happens only when I turn left. As soon as steering wheel gets back to straight, the noise and steering wheel resistance/hardness goes away. I don't really feel much when I'm driving slow on the city streets. Although some time when I am little bit fast, I feel slight grinding noise and steering hardness. No problem in turning right at all.
View 5 RepliesI just went to look at a 05 v8 toureg with 80k loved the car but on hard turns the power steering makes some noise. It was pouring rain and didn't have a chance to check fluid. is that a common problem or should I turn the car down?
View 1 RepliesHaving issues with Gen3 Prius steering column? I suddenly developed this clunking noise when I rock my steering wheel from left to right. It's steering correctly but I've never heard this noise before....
View 7 RepliesI have 2016 camry 4 cyl have roughly 2300 miles and I'm noticing a click click while turning the steering wheel left or right while stationary and vehicle running sounds like it's coming from under the dash.
I've seen there is a tsb for other year camry intermediate shaft issue, my vehicle is lowered on eibach Springs and would hate to take back to dealer and have them blame it on the springs in a vehicle that has only 2,500 miles.
I just recently replaced the inner and outer tie rods an got a 4 wheel alignment on my 2005 camry le and now whenever you turn the steering wheel all the way lleft or right, it makes a loud groaning noise, and it sounds like something is scraping kinda? What this could be an how to solve this problem? It is not low on power steering fluid...!
View 3 Replies2010 camry LE
A family member did a tune up on the car and did not realize that the power steering reservoir had a HOT and COLD min/max lines. He filled up to the max line for HOT while the car was completely cold. He also filled up with Prestone Power Steering fluid with Stop Leak instead of ATF/DEXIII.
The car was driven a few times for maybe 50 miles in total before I found out about all this and I drained the fluid out to the appropriate levels. However the steering at low/parking speeds is still very tight (tighter than what I used to remember, at least).
Did he royally screw up the power steering system here? What can I do?
2011 Hyundai Elantra, 42k miles. The car is my girlfriends which I drive once every few weeks. Yesterday I noticed a rumbling noise coming from the right front tire area. The noise only comes about when turning a fairly sharp left while above 20 mph. Taking a left onto a side street etc doesn't cause any noise, but taking one while going through a big intersection etc. Where the speed is up a little bit causes the noise. The tires are original, obviously not new, but they still have a decent amount of tread left on them, they're Continental Pro Contacts.
Tire, ball-joint, brake pad rubbings? I'm going to take it to get looked at tomorrow, I did spray the area with a hose in case there was something caught in there, but that didn't change anything. The tire looks fine, no abnormal wear or bulges, the car is in alignment and makes no other noise except in the circumstance noted.
Back in January I had my right front wheel bearing and u-joint go out, so I replaced them both. At the time I didn't realize my outer stub axle shaft was wore so I just put it back in. After a little driving the right side started to "thump" and "pop" when I would make hard left turns driving around town.
I replaced the outer front stub axle shaft and seal again because the old one was worn down. This eliminated any play in the u-joint. After a bit of driving the thumping and popping noise came back.
I decided to dig into it today so I pulled it all apart. When everything is apart it turns easily, no issue at all. When I assembled the wheel bearing, torqued it to 55 ft/lbs and installed and "locked" the hub I noticed something peculiar. I can barely turn the whole assembly by hand. I have to put a good amount of force to get the whole assembly to turn at all. When I walk to the driver side with all the same parts there i can turn the wheel bearing and locked axle shaft with one finger on the studs.
I have been in this thing 5 times and can not figure out what the heck is wrong. I can't figure out why this stupid axle shaft and wheel bearing are so hard to turn, together or separately, and I can't figure out how to get my front end to stop that thumping and popping.
2013 Camry SE; I am experiencing a plastic buzzing noise coming from the left side of the steering wheel, the noise seems to be coming from the small compartment area (below the AC vent). If I press my hand against it, then the noise stops.
View 3 RepliesMy daughter's 2004 Santa Fe (2.4L standard transmission) is making strange noises on start up which I think is due to a power steering issue as the noise is greater when she turns the wheel while stationary or when driving for the first 5 minutes or so until it warms up.
She came over tonight I she is about an 1 to 1.5" below the MINIMUM line on the Power Steering Reservoir.
Is there any special or proprietary Power Steering Fluid I need to be buying or what should I be buying to top this up?
I know there has been much discussion on using only Hyundai automatic transmission fluid over the years, but in this case it's for the power steering?
2013 Camry SE. I hit a curb pretty hard on the right side. Dealer replaced both tires and wheels and lower control arms on the right front. $2,400. Now I notice a low level rumbling starting at 45MPH or up. Very little change in the noise as speed increases.
I'm wondering if they missed a damaged bearing that is causing this noise? I had the dealer test drive it and they can't seem to hear it.
I have a 2005 Toyota Avalon. When you turn the wheel it will make about 1 1/2 turns to the right and then locks, but when you turn left it will turn almost 2 1/2 full turns, if you move you will hear what I believe is the tire rubbing, haven't done it since I first noticed this problem. What could be causing this?
The alignment and everything seems fine on the car and there is no other issues with the steering. Just that the wheel turns too far to the left.
2006 camry LE - 4cyl - 140k miles
[URL]....................
The car idles pretty rough & loud but ive noticed its only when im in 'drive' with my foot on the brake, at stop signs/lights. Its also much worse when the engine is cold. It settles right down if I come to the stop and shift into 'park'. So as I roll to a stop and hold the car in place with the brake the engine starts vibrating.
I dont know much about these things but it almost feels like i'm restricting it by having my foot on the brake and the engine wants more gas or air or something (could be way off base, but thats how i perceive it)
The RPMs sit around 1,000 and as the engine idles/rumbles it gets up to maybe 1,200-1,400 RPMs which i didn't think was significant but im pretty new to this.
Forgot to mention the most important thing- there is a rumbling noise that goes along with the vibrating, again only while stopped, goes away immediately when i pull off the brake and hit the gas.
I have noticed on our 2009 F-150 there is an audible "click" (and you can feel it in the steering wheel) in left hand turns at about 1/4 revolution. You can also hear/feel the same thing coming out of right hand turns. It doesn't happen EVERY time, but pretty often. My wife had the service guy drive it when it was in for an oil change, and of course he didn't experience the same thing. What it might be or where to start?
View 8 RepliesMy car started making a kinda rubbing noise when I'm driving and turning all the way to the left or right, do I damaged the power steering? I know there was a thread about this but I can't find it,
View 4 RepliesThe engine of our 2003 Camry (4 cylinder, automatic) is making a loud rumbling noise when stationary, both in drive and in park. The rumbling can be heard and felt, especially via the brake pad, and it persists when the car is driving at below highway speeds.
View 2 RepliesAt center, my truck is able to turn 2 1/2 revolutions to the right and only 1 1/4 turns to the left. Making sharp left turns is not possible currently. What needs to be adjusted in order to get the steering centered and even?
View 4 Replies