Camry :: 2009 XLE - Removing Back Deck Cover To Replace Speakers
May 20, 2012
I have a 2009 Camry XLE with the split reclining rear seats and the retractable (stupid) sunshade. I bought new 6x9's to replace speakers all around (Infinity 9632) with adapter plates. Got the door speakers replaced easily enough, but for the life of me I cannot figure out the rear deck. It is all one piece of plastic, no removable speaker grills. And of course the speakers are screwed in top down. Most of the posts I have found on the internet are either for previous gen Camry's or people who have the folding down rear seat.
So after a lot of manual labor I was able to remove the back seat completely and the center console. I can pop the front of the back plate up and peek in, but cannot get it to come out. I think something is odd with the models with the retractable sunscreen and reclining seats.
I have scoured the internet endlessly. Closest post I found was "take off the rear side panels (by the back window) and the deck should pop out. There are airbags in there, not very keen on forcing anything.
The car has the "premium" JBL sound system which I found to not be so "premium" and was a serious step down from my last car's factory stereo.
View 6 Replies
Advertisement
I recently purchased a 2009 Camry with 95,000 miles. The Camry was purchased new at the dealer that I bought it from and all of the maintenance had been done at the same dealer so I have records of everything.
I did not notice any rattles when I test drove the Camry but driving it the next day I noticed two rattles. The first rattle was the deck area behind the back seat. That was easily fixed with some card board shims placed the right places. I will do a permanent fix later.
The other rattle was driving me crazy. It did not do it all of the time and to me it sounded "exactly" like it was coming from the area around or in the glove box. I took the glove box and the area around it off and could not find the source of the rattle. I had my daughter drive the car while I set in the passenger seat and the rattle never occurred.
I finally found the source of the rattle. It was the lid for the center console. The lid originally had two rubber bumpers. Both of the bumpers were either missing or worn completely down. When I had my elbow on the center console lid the rattle did not occur. I fixed it with stick on drawer stops.
View 1 Replies
I have an issue with what sounds like the rear deck rattling in my 2010 SE Camry. I can hear it almost every time my back wheels hit any small bump in the road.
I also have subwoofers installed along with dynamat in most of the trunk (just not on the rear deck). This is my main reason for wanting this solved. The rattle is very noticeable when the bass hits in almost every song. Is that where the rattle is coming from?
View 14 Replies
using a can of compressed air to clean the dust in the vents and the straw came loose and now its stuck inside the vent and whenever I make a turn I can hear the straw rolling around.
How do I actually remove the passenger side air vent cover? (nearest to the door) I tried to pry on it with a screwdriver but it doesn't seem like it wants to move. I actually asked the local dealer and they said I would have to remove the whole dash to access inside the vent. Do I really need to remove the whole dash or should I try to apply more pressure?
View 9 Replies
I recently removed the top plastic cover on my '05 Camry LE V6 to pull a plug and inspect/decide if I was going to change them out. While I felt I was being careful handling the plastic cover, I grabbed it by the access hole for the oil filler cap. Walking back into the garage, some black carbon came off, and looking at the bits on the ground, and what was left on the inside of the cover, I'm not sure if there is supposed to be a gasket there.
Maybe it was just an accumulation of spilled oil over the years that has trapped and "cooked", or something put in place to capture spilled oil. I scraped the rest of the carbon off using a razor blade and cleaned it up before installing the cover.
View 13 Replies
Can I buy a replacement leather cover for the driver seat in my '04 LE Limited Ed.?
There is a tear in the outer side panel, right by the seam where it meets the back seating panel. I know there are companies that make leather interior kits where you pull off the fabric seat upholstery and pull on the leather, and that these kits are popular with new car dealers.
Where I can find an OEM replacement to match the rest of my interior, which is still in good shape? Would it make better sense to take the leather off of the setback and have a seamstress/upholstery shop set in a new side panel? Or, would I be best off to just find a complete seat that matches and just bolt it in?
View 7 Replies
I am rocking an 09 Tiguan which unfortunately is out of warranty. Last night while listening to music my back two speakers quit working and still aren't working. I don't see how I could have blown them both at the same time, my volume was only at 16.
View 14 Replies
I have a 2002 toyota camry xle 6 cyl i believe i have a valve cover gasket leaking vehicle has 112,000 miles. is there a step by step removal proccess i can access. I have done one on a 1995 honda passport 6 cyl how difficult is it
View 2 Replies
I drive a Sport and have installed a subwoofer and amplifier to work with the stock head unit and speakers. However, I find the subwoofer sounds a bit muffled and I think I need to create a bit of an air flow between the trunk and the cockpit.
I did notice the rear deck has a big hole where the 8 inch subwoofer sits in higher trims. The hole is however, covered with a plastic dummy or cap or placeholder or whatever it is Hyundai calls it. If I can remove that, I can make some air flow and believe the subwoofer might sound better. How to remove it?
View 11 Replies
How to remove and possibly replace the rear bumper cover on a 2003 camry?
View 4 Replies
I have a 2013 FX4 with the 3.5 twin turbo engine. How to remove the right side valve cover to replace the gasket? I have loosened the perimeter bolts and was able to get it to move slightly but nothing more. I also removed the spark plugs thinking that they might be holding the tubes which are connected to the valve cover by round seals. I have not removed the seals since I was concerned that I might damage them. Do they need to come off? If so how do I do it? It's amazing how complicated this job is! Short of calling the dealer service, I have just about exhausted all my usual tech resources.
View 4 Replies
I recently started to have problem with my back window panel where large speakers at. It makes a lot of noise whenever even the slightest base is on.When I push it down it stops. I never put anything there. My assumption is that is finally shrunk during hot summer days and now loos and there for makes that noise.
View 1 Replies
How do I replace the rear speakers in the 09 Camry? I put in door speakers no problem but can't find anything on for an 09 camry rear deck.
View 5 Replies
When driving my 2013 Sonata with the rear windows open the deck below the back window starts vibrating horribly. You can actually see it moving up and down. If I also have the stereo on the vibrations distort the sound something awful. Close the window and the vibration goes away. Is it a defect, and is there a quick fix? Only problem with the car so far.
View 2 Replies
I finally picked up a cell phone cup holder so I could dock the Android and tether the millions of cables (two) for power and audio when I ran into a roadblock. The holder has an expanding base so it can fit into any size cup holder. Perfect! Except that if I try to use it in the "top" cup holder that has the closing lid, it never quite expands to fit because the lid offsets the interior dimensions. The holder fits fine in the lower cup holder, but because of it's size and angle for the phone, it presses it too close to the armrest so it's essentially a no-go.
How to safely and easily remove the lid cover for the top cup holder?
View 8 Replies
How to remove the plastic engine cover on the 2.5 liter engine? I am trying to do the "Big 3" but don't want to break the cover.
View 4 Replies
So I want to remove a sunroof cover from a GTi that's being parted out but the problems are there is no power in the car. I know that you need to be able to tilt the sunroof up in order to remove the cover. So, is there any way to do this without power?
View 6 Replies
After an oil change I noticed my lower engine cover hanging loose in the middle. Much searching has not found the part number. Underbody engine shield fasteners. Any quick reference for these? 2009 Camry 4 cyl XLE.
View 11 Replies
I recently got my UW F-Sport roof vinyl wrapped with gloss black. A local shop didn't want to wrap the antenna cover and recommended I get an obsidian black cover instead. So, I went to the dealership, ordered the part and now I have the cover. I looked up threads here on CL thinking it'd be an easy 5 minute DIY but apparently that's not the case. One member said he had to remove the interior c-pillar trims, part of the headliner etc. etc. Another said to just remove the rear seat light dome and someone else said the a dealership just prys it off. I tried the light dome, all I was able to get to were the bulbs.
View 4 Replies
I am trying to replace the MG2 on my 2002 Prius. I have to lower the Engine to get access to MG2. I have already lowered suspension member (sitting on ground with rack on top of it but still connected on sides), removed the torque rod and moved the inverter enough to get access to the LH engine mounting nut. My plan is to start lowering the engine from LH side to get access to MG2 without removing anything else. Is this going to work or should I remove more things?
View 3 Replies
How to take the door panels off ? I have to take mine off to replace the mirrors the wires run into the panel. Just thought id ask before I have at it.
View 2 Replies
