Camry :: 2009 V6 Starts Fine Then Immediately Dies Out
Sep 6, 2015
I have a V6 with 162,000 miles. A year ago in the early spring we replaced the alternator, starter, fuel pump, lines, filter, dropped and cleaned the tank, fuel coils, repaired / replaced almost all injectors, spark plugs.Since April of last year, every few months my Car would have a hiccup of that it starts fine but would immediately die out. It would take anywhere from 5 to 30 minutes of trying to get it to start again. Other than that it would run beautifully. This week, while on the road it would jolt and die out. It happened 3 times. Yesterday morning it would once again crank fine and immediately die out. It will no longer keep running. We have not been able to keep my car started since then.
View 14 Replies
Advertisement
I have a 2010 Corolla XRS that been flawless until today. This morning I moved my car in my yard, it was about a 20 second adventure and all was good. About 2 hours later, I went to use the car and it wouldn't start. Now it just starts then immediately dies. If I try and crank it over without turning off the ignition, it just cranks. If I turn off the ignition and try again, it starts, then dies again. This is 100% repeatable.
Battery posts and voltage are good. No OBDII codes. Fuses all look good.
View 7 Replies
I'm going to preface this by saying I've already had the immobilizer problem and I know about the light on the dash of the car + key flashing when you try to start the car without the immobilizer chip in the key fob.
My car has been running completely fine, I go out to start it, it fires up then immediately dies. If I hit the throttle while it starts up it will rev up but still dies even if I hold the throttle all the way open. After doing some research I was pointed to crank position sensor. Bought a new one, didn't change anything.
The strange thing about it is ever once in a while I can get it to start up and then it will run for as long as I let it, so its obviously getting air, fuel, and spark. I have also disconnected the battery and left it for a few hours, didn't work either.
View 8 Replies
1999 4-runner 6-cylinder. starts and then immediately dies.
View 2 Replies
2009 Toyota Camry LE 4 cylinder. Our car got flooded last week. Water only got inside to the floor mats and we vacuumed it out. Now the car wont start. It starts and then dies right away. Only when I remove the key from ignition and restart it comes on and goes off again. I was thinking about changing out the ignition module with key. Checked all fuses and they are OK.
View 6 Replies
I have a 1961 International Scout 80. I picked it up about a month ago and have been working on it ever since. It has been running a little rough but ok. Carb definitely could use at least a cleaning. Recent history is as follows...Brought home a month ago. replaced clutch hydraulics and rebuilt rear brakes 3 weeks ago. Began rewiring 2 weeks ago including removing dash, choke and throttle cables.
Completed rewiring of engine and lights and most of dash. Some wires are still left open. Since replacing the clutch hydraulics I have been starting it up every few days to drive from a parking space, about 100 ft, to the garage. 2 days ago after finishing working for the night I drove and parked it. The next morning it will not run. It starts and then immediately dies. I know there is a number of things it could be I just don't know the best way to go about diagnosing the issue.
View 18 Replies
I have a 1991 Chevy Cavalier. It usually runs fine, but recently the weather has been colder and it is having issues when I start it in the morning. Granted, I live in Florida so "cold" is only in the 40s. The car will start, but then it immediately dies. I had taken to a mechanic (a family friend) and he said that it was fine the whole time he had it and didn't recommend any repairs. It was running fine for about 2 weeks and now it is doing it again. It does appear to only be doing this when it is cold out, because the issue began when we got our first cold snap.
View 11 Replies
I'm having an issue with the truck not staying idle after cold start up. The truck will turn over and start right away (not even 2 second crank) but immediately dies. The throttle will not work at low RPM. When I start the truck, it will instantly rev high, the revs will drop low, it will try to compensate and rev high again, then it will immediately die.
If the RPMs are under under 2.5k, the truck will immediately stall and die. When I attempt to use the throttle under that RPM, it will not work. No matter how much I depress it, the engine will instantly cut and stall out. It will not attempt to deliver fuel. The only way I can get the truck started is if I rev the engine high and hold it. I need to hold the truck at 2.5k+ RPM for atleast 30 seconds. It generally takes me about 5 tries to finally get it running (mainly due to the throttle immediately cutting out and I have to 'catch' and hold it.) After that, there is no sign or issue. The truck will start immediately back up after it's been running for a couple minutes.
CEL: MAP sensor (0069?) -- Sensor is spotless. Harness looks fine. I replaced the injectors, both batteries, and the alternator this summer. It doesn't sound to be any these either as the truck sounds extremely healthy and immediately turns over.
View 8 Replies
When I try to crank the truck , it starts and immediately dies. This happened several times. The last attempt I began patting the accelerator when I turned the key. The truck cranked and I was able to keep it running by feathering the throttle. it ran rough. At higher RPM it ran ok. When I let it idle it idled rough. After engine warmed it idles and runs fine. Engine started without trouble when warm.
View 1 Replies
I have an 04 w12 with 80k miles on it. It will start fine but will not run for more than 10 seconds. As it idles down from startup it settles to about 700 RPM's where it normally does then dies. If u drive it it will start and go into gear fine as u go to pull away it loses all power and dies. I have checked the minor things i know like air filters, oil, tranny juice all appears normal. New batteries less than 3 months ago also.
View 11 Replies
Have a 2004 6.0 that stalled out while driving. Wouldn't restart. Took readings this morning. ICP was very low (below 100) and IPR was at 85. After a few times of taking readings I could get the truck to start up with an ICP reading over 500 but IPR was still at 85. When it did start up it would almost immediately die. Does this sound like an IPR problem or a oil pressure problem?
View 5 Replies
I am working on my father's boss' 2004 Phaeton V8. The car usually sits on the weekends. What it is doing is, it will start and run smooth, but after 15 seconds, on the dot, it stalls and dies. It sounds like it is starving for fuel.
What I have done so far:
LH intake actuator arm found broken, replaced both with "Gruvenparts"
Checked all fuses and relays
LH fuel pump reads 14 volts until the relay kicks it off
Tested fuel pressure-good
Batteries fully charged
LH fuel pump reads 0.7 ohms w/key off
RH fuel pump reads 6.0 M-ohms when first connected and gradually climbs to 31.5 M-ohms
(I assumed this meant RH pump was bad and so I pulled it out and bench-tested. Ran perfect and tested at 0.7 ohms out of the car)
Re-assembled everything to pull the car out of the shop, and wouldn't you know it started and ran like normal.
Road-tested for 2 hours the next day without any problems.
So, I call the customer to pick it up and he says he will be there 2 days later.
View 15 Replies
Our car starts, then dies. It starts fine, then dies. This only happens in warm weather, which we have finally been experiencing in Northern Illinois. It eventually gets to the point where we can drive it, but then might die at a stop sign, or it can go the rest of the day and not have any difficulties. I know later models have timing chains, not belts. Does our car have a timing belt problem or maybe fuel pump? And why only in warm weather?
View 7 Replies
A few days ago, I went to start the car, and it will start, and idle fine for a few seconds, and then begin to run crappy, idle down, and die. I tried starting it, and giving it some accelerator pedal, and it dies. I changed the timing belt, idler pulley, and tensioner this summer, so I'm ruling out a bad timing belt. There is no check engine light, and I replaced the plug wires because when I removed the cover, I noticed one of them was worn in a spot, and the wire shielding inside the rubber insulation was visible.
View 11 Replies
I have a 04 late model F250. I have done the EGR delete, oil cooler upgrade, and blue spring upgrade. I have a SCT tuner but truck is currently set to stock.
My issue is it starts fine runs good but dies after about 2 minutes. No stutter or stumble. It acts as if some one just turns the key off. I have to let it sit for about 2 minutes and then it will restart. If I try any sooner then it just cranks but will not fire. This started about three weeks ago. At that time I would be driving and it would just die. I could slip into neutral turn key and it would fire right back up and I could continue down the road. As time has gone by the issue has reoccurred more often and now I have to let it sit for about 2 minutes to get it to start again but then as stated only runs for about 2 minutes and then dies again.
I have a scangauge and here are the readings I can get.
FICM main power is 47.5 - 48 volts at all times = good
FICM Logic power is 10.5 - 11.5 volts at all times = ???
IPR is 33% at idle = good Scangauge does not react fast enough to get info at startup.
ICP voltage KOEO 0.25 volts
Start 1.33 volts
Idle 1.11 - 1.13 volts dips briefly to 0.96 volts
ICP pressure Start 900+
Idle 830ish
Sync between CAMshaft and Crankshaft is 1 = good
Have not gotten fitting to do fuel pressure test yet.
View 14 Replies
Starts fine. Runs fine till warmed up. Then dies at idle and runs rough on gear till 1000 rpm. Has only coded iac when unplugged. But would idle with it unplugged. I replaced it. Also got crank can code once while checking it ...
2001 dodge ram 1500 318 engine ....
View 2 Replies
My wife's 07 Camry cranks then immediately dies. I tried to crank it again and it want even start at all.
View 14 Replies
I have a 1999 Camry. I just spent $1250 (half of it borrowed) to have some basic maintenance, diagnosis, and serious repair work done. More than half of the serious (translate: expensive) work involved replacing a charcoal canister and installing a thermostat. The check engine light had been on for at least 10 years. And I had a gas pumping problem by way of the pump shutting off after only pumping a few cents worth of gas. Needless to say it was a royal PIA to fuel up my car. As far as the check engine light, a friend would clear the code so I could have it inspected.
Then more than 2 years a shop took out my thermostat because a hose had sprung a leak and they rigged up a temporary hose until they could order the part. I never went back because I couldn't afford it. I know it wouldn't have been a terribly expensive repair, but at the time it was more than I could afford. So for almost 3 years I have driven with out a thermostat and also couldn't get it inspected.
Fortunately I was finally able to get the necessary repair on my car--replacing the charcoal canister and thermostat--so that it could be inspected. I picked the car up yesterday and everything felt fine and the car ran fine.
Today I drove it about 12 miles from my home, made 3 back-to-back errand stops of not more than 15-20 minutes each and everything seemed fine. Nothing felt or sounded out of the ordinary. Then when I was leaving my 3rd stop, the car would not start unless I gave it gas. And it wouldn't stay started unless I gave it gas. In other words, the car would go, but as soon as I would take my foot off the gas to press the brake to put it in gear, the engine would die. There was no problem restarting it as long as I gave it gas, but I could not let off the accelerator at all or it would immediately die.
The car would go just fine, but if I let off the gas for any reason, even if I was driving 40 miles an hour on the street and let up completely off on the accelerator, the rpms would immediately drop to 0 and the engine would immediately die---no noise, no shuttering, no nothing---just die. This problem occurred almost the whole 12 miles back to my home. Then when I got about a mile and a half away, it went back to behaving completely normal and did not die when I let off the gas.
View 10 Replies
I just got my '09 Corolla last night and it's doing something I'm not sure it is supposed to do. When I go out to my car I press the unlock button and open the door. A beeping noise starts immediately before the key is even in the ignition. When I do put the key in the beeping continues and does not stop until I close the door. The car I had before this was an '89 Corolla so I don't have any experience with these keyless entry things.
View 14 Replies
Starts up fine but the car does not move. Car also has loud whine on cold starts coming out of driver side fender. It will also whine above 2000 rpm even after sitting out in the sun but goes away after driving. The car is at my parent's place and will be able to look at it later today..
View 4 Replies
It is very cold here today about 10F. I started my 2009 Corolla about half hour ago just to make sure it would start. Started fine let it run at fast idle for awhile and shut it off. Went back out to start it again to head out and it will only run very briefly, maybe 1 second or so and then cuts off. It will continue to do that but will start and run normally. I tried for about 10 minutes but didn't want to run down the battery. I hope it is just the cold weather.
View 4 Replies
