Camry :: 2009 SE - Vibration In Steering Wheel / Tire Air Pressure Light Came On
May 2, 2012
We have a new to us 2009 camry that has a slight vibration in the steering wheel. Wife drives the car daily and says its rather inconsistent. The tire air pressure light came on so I was checking tires and noticed something and was wondering if this could be the vibration.
The outer edge tread on the rear tires seems to have wore unevenly. This is the best photo I could get. When you run your hand along it you can feel every other 'lug' is raised a little on the rear side of the tread.
REAR TIRE
The front tires are wore even, but it appears previous owner didn't rotate very often and plenty of tight turns were made or unproper inflation?
FRONT TIRE
Would rotate? The middle of the tires still have good tread left.
Link to tire on the car
View 7 Replies
Advertisement
At what point does it go off? Mine went off tonight, after about 15 miles on the road, the ambient temp is 60 degrees cooler than when the tires last got air (it was 40 degrees on the drive home).
None of the tires look low. If it had been on at the start, I could understand due to the cooler air, but it was after a few miles and the tires had warmed up some I am sure. (Two miles later when I stopped at my house, the tires felt warm to the touch, at least, noticeably warmer than ambient air.
View 14 Replies
I bought a certified pre-owned 08 Camary about two years ago and all in all it has been a good car. Over the past couple of months I had notice a little vibration in the steering wheel starting around 55 - 60 MPH and above. It seemed to be coming from the front of the car and at times I would notice a slow rocking of the front end around 20MPH.
I took it to a national repair shop recently and they said that it was the struts going bad. I have about 85,000 miles on the car and the tires looked new when I got it with about 30,000 mile on the car. All in all the thread on the tires look good with the exception of the outer threads on both front tires, you can see wear but only on the outsides. I also had shaking when I put my brakes on at higher speeds but they replaced the front brakes and turned the rotors and that fixed that issue.
Would struts going bad cause uneven tire wear and steering wheel shaking? If so does $1100 sound right to replace front struts, two new front tires and an alignment?
View 6 Replies
Have noticed lately 2012 4x4 sc with 42,000 k has a slight vibration I guess you would call it you can feel through your fingers at certain speeds. I looked and felt tires which are at approximately 4,000 k from being new and they are wearing on the inside, going to rotate and have it aligned asap.
View 7 Replies
I have a 2008 Camry SE, when its chilly outside the Low tire pressure light comes on, when its warm it doesn't come on. I have checked all the tires for correct air pressure and this light drives my wife crazy.
View 4 Replies
As the title says, I can't get the light to go off. I followed the procedure to reset it but after it blinks three times, the light is still on. I've also read that I need to take the car above speeds of 19mph and/or an hour, for light to disappear but still nothing. Although I didn't drive it more than an hour since my commute is short. I've made sure that the pressure is around 30psi on all four tires.
View 4 Replies
Around 30k miles ago (or so) I had some TSW 19" wheels installed and about 1k miles later, I had H&R lowering springs installed. Shortly thereafter, I've had a very inconsistent but horrible steering wheel vibration. Most often this happens when I'm going between 45-85mph. But the strangest thing is that the vibration doesn't always happen! Sometimes I will be on the same stretch of road and the steering wheel will strongly and consistently vibrate as if I had warped rotors. Other times it will be nearly as smooth as glass.
Not sure if this is related but after the most recent set of tires were installed (around 1.5k miles ago) the car now pulls fairly strongly to the left. I've had two shops do three alignments and the alignment seems to be ok.
My primary auto repair shop showed something to me the other day. There is a bushing between the vertical steering rack and the horizontal tie-rods, etc. Whenever I turn the wheel, the bushing flexes/stretches noticeably as much as 3mm but there are no visible tears/breaks in the bushing. The shop visually checked the tie rods and they seemed ok also. A couple of my friends that know a lot more about cars than me seemed to indicate that this bushing should not move much, if at all. Below is a list of the things my car has gone through since we first noticed this issue:
- Three different tires and sizes have been used on these wheels and all have exhibited the same problem over the past 30k+ miles.
- Tires balanced and rotated by several different shops by traditional and Hunter road-force balancing machines. No difference.
- Two shops have cross-rotated my directional tires to see if wheels/tires were the problem but the car still pulled and steering wheel still vibrated.
- My TSW wheels/tires have been put on another car and no vibrations were present.
- Tried another car's wheels/tires and still had the same problem but it was slightly less intensive.
- Wheels aligned three times by two different shops since I had the current tire set installed about 1.5k miles ago. No difference other than the introduction of the car now pulls to the left.
- Replaced brake rotors and pads. No difference.
- Front and rear suspension checked and everything seemed ok.
- Removed Ultra Racing Strut Bar for several thousand miles. Minor vibration reduction but nothing major.
- Replaced hub-centric rings that came with TSW wheels with new rings from a different brand. Zero difference.
- Many other things checked but can't recall exactly what.
View 14 Replies
I have a 2006 Camry 4 cylinder that I turned the rotors on all four wheels and replaced all the brake pads on all four wheels with ceramic pads. I did this a year or two ago.
Now this doesn't happen every time you brake but sometimes you will get a vibration in the steering wheel when braking.
When I had the rotors turned at O'Reillys they said they were too thin. So I had them bring out a new one and that one was too thin as well according to whatever specs they were using. So they turned my old ones.
And the car doesn't pull to either side when braking. There are not grooves in the rotors and it doesn't make any screeching when braking. I did notice that there is a ridge on the edge of the rotor when you run your finger across it from the inside to the outside of the rim of it. My guess the rotors are warped.
And if the rotors need to be replaced is this rotor better than the stock ones and thicker? [URL] ....
View 7 Replies
I just bought a 2015 Camry LE 2 weeks ago and noticed a slight annoying steering wheel vibration when you hit 40 kph and above. You can also feel it on the floor and when you hold the door. Brought it to the dealership and they balanced the wheel. It seemed to have made a difference and you can now feel the vibrations from 80 kph and above. Did a road test with the mechanic and the service manager but they couldn't feel anything and told me it was normal road vibrations. Was advised to go to another dealership for a 2nd opinion. 2nd dealership found a slight excessive loaded runout on the LF tire and road force balanced it.
After 2 days i can again feel a vibration, but this time now at 115 kph and above.I thought I was just being paranoid so I drove a Maxima for 2 days and never felt a vibration.
View 7 Replies
2009 FX4... Every once in a while, I'll feel a vibration in the gas pedal. It happens under acceleration, and typically if I'm pushing down and it has not downshifted yet. Then once it downshifts the vibration is less noticeable.
I have had the mechtronic unit replaced due to harsh shifting and the vibration was there before and after that was replaced. The drive shaft was also replaced due to a click/clinking noise and the vibration was there before and after as well. The harsh shifting and clinking noise was fixed with those repairs, but the vibration is still there. I notice it more when I am towing.
View 13 Replies
My neighbor has a 2010 or 2011 Screw with only less than 10K miles. He complains that the steering wheel vibrates when he applies the brakes; not all of the time, but most of the time. Could it be pads/rotors? With this mileage, and no stop and go traffic, I cannot believe it would be the pads/rotors.........
View 6 Replies
I have a 2004 Toyota Camry that the steering wheel veers to the left while driving (not all the time) I have triedan alignment and a tire rotation and still have the problem.
View 12 Replies
Had snow tires on separate rims without pressure sensors installed today. Service rep said that the tire pressure warning light will come on and stay on. However I rode car home and the warning light did not stay on after the initial engine start up. Is this a problem and a concern, or a good thing ?
View 2 Replies
whats the limit for low tire pressure light (tpms light) to turn on in 2015+ camrys. My tpms light turned on, on a cold morning, few days ago, tire pressure was 28 psi that day. Now my tire pressure raise upto 30 in all tires by it self due to warm weather, but light is still on.
View 3 Replies
How do you reset the tire pressure sensor 2013 Camry. Could find the reset button.
View 5 Replies
I bought a 2010 toyota camry se. I have the most annoying vibration in the steering wheel, seats, gas pedal. Have taken it to several places, including a Toyota dealer.. They seem to not be able to find the cause. I've had wheels checked, balance, aligned, rotated. There is also an annoying clonking noise coming from the front passenger assembly. It's very sporadic as in only goes away when trying to have a technician hear it.
View 8 Replies
5.0L ... I'm having one of those moments, you know after you do a mod to your truck and all of a sudden you notice something about your truck that could have been there all along but now you notice it as something new? Ok earlier in the week I had my exhaust resonator removed and replaced with a straight-pipe by a reputable exhaust shop. IMO the work looks to be pretty good for what it is.
That said I have always been nervous about getting exhaust work on any vehicle because it always seems like tampering with or removing the OEM plumbing for aftermarket or custom work tends to develop a vibration at some point.
So here is what I've noticed over the last couple days, when driving my truck it is extremely smooth, almost like glass. When I come to a complete stop say at a traffic light about 1-2 seconds after making the complete stop I feel this slight harmonic vibration in the steering wheel. For those of you that have an iphone it would be like having your phone bolted to the steering shaft somewhere and it on constant vibration if that makes sense.
Just to prove it only happens when I'm sitting still and idling in (D)rive I sat in my driveway with the truck idling, set the park brake and released the brake pedal holding the truck in place in (D)rive with the parking brake. No vibration, smooth as glass engine idle, as soon as I put my foot back on the brake pedal the vibration comes back. It's as if the extra draw of applying the brakes puts an extra load on some sort of accesory drive or componant under the hood and the result is this harmonic vibration.
Just so everyone knows, the vibration is very noticeable to me because I drive the truck daily, most people wouldn't pick it out if I didn't tell them first. Case in point if my wife drives the truck she can't feel it unless I tell her what to look for. There are going to be some of you that just say my truck doesn't do this and has had a smooth idle for XX,XXX miles I believe you but let me know now that I have explained exactly what to look for. Like I said for all I know it's done this since day one.
I have a feeling that the straight pipe might have been welded in slightly longer than the oem section that was removed thus putting more tention on the exhaust and engine if that makes sense, the end result being a slight vibration?? I know that manufactures put these little rubber bushings along the exhaust system on cars/ truck to absorb harmonic vibrations and for all I know my resonator might have been designed to balance out harmonic vibes in the exhaust system as well as quiet down the exhaust.
View 2 Replies
I bought Toyota Camry 2013 LE and couple days ago Tire Pressure Warning Light appeared!!
I checked all tires and the pressure is 35 PSI but the warning light is still on, how to turn it of or reset it?
View 4 Replies
2009 Ford Explorer, 6cyl, 4L, 33K miles. When its started up, the message "Tire Sensor Fault" appears along with the low tire icon flashing (steady light after ~30 seconds). I can then press the reset button on my dash to clear the message. However, the tire light icon stays lit. I've checked and re-checked the tire pressure in all the tires (spare included) and I'm right at the recommended 32-34 psi on all the tires. No signs of leaks at all. I'm assuming one (or more) of the tire pressure sensors have gone bad and there's no way for a garage (or myself) to identify which one or repair this. Should I assume a trip to the dreaded dealer for this problem ???
View 10 Replies
What is the tire pressure that will trigger the TPMS to activate the warning light on the dash? I had 31psi in my left front and got no warning?
View 4 Replies
2002 Camry LE 4cyl. automatic. I bought this car with 7500 miles on it in 2010. It had been involved in a low speed parking lot collision and apparently the left front corner and front took the hit. It'd been repaired and looked like new when I bought it. It still had the factory tires on it, but they were 8 years old, so I put a set of new Kumho Solus' on it. This was a friend's mothers car, so I know the history of it.
The left front suspension has always felt odd to me. Nothing serious, but just "off." When backing up and turning it has a sort of wobbly feel on that corner at times. I've been assured by several mechanics that they can find no problems. It feels to me like maybe sometimes the strut piston sticks on that corner. Don't know if that ever happens or not, but that's the best description I can come up with!
It has always vibrated from 45 on up. It's not a hard shudder, but just a constant vibration at highway speed that you can feel in your feet and the steering wheel. I've had it balanced and re-balanced to no avail. Sometimes it gets a little better, sometimes worse, but it's never gone away. Recently it seems to be getting worse.
I put it up on jackstands and accelerated to 60, and it vibrates like the wheels are out of balance. Yesterday I replaced the Kumhos (they had bad road noise anyway) with Michelins. The Michelins cured the road noise problems and have a much better overall feel, but I've still got the balance problem.
Just put it up on jackstands again and spun it up, and I still have the same vibration!
What to look for? The car has just now turned over 35k miles. I'm wondering if the CV joint on that left side was damaged and is causing the vibration. I've got new wheels as well instead of the factory steel rims. Also, with the car up on stands, the wheels spin true. No bent hub, etc.
View 10 Replies
