Camry :: 2009 SE Convert Interior Lights From Regular Bulbs To LEDs
Dec 16, 2011
I am looking for some feedback I'm looking to convert all my interior lights from regular bulbs to LED's I know there's a DIY thread which I read. But I want to know whats the brightest led that i can use while still fitting in my 09 camry se. (2 reading lights, 1 dome light, 2 reading rear lights, 2 Door courtesy lights, 1 trunk light, 2 license plate lights) I want those lights to blind me when I turn them on.
View 5 Replies
Advertisement
I would like to convert my "regular" trunk on my Luxury ES to an automatic, open-all-the-way trunk.
View 12 Replies
I recently tried to install some LED bulbs in my ride. And they all worked except the map lights in the front. I removed them all and now no lights work when I open my doors except my foot wells.. Any one know whats up?
View 7 Replies
I wanted to change my license plate bulbs to LED's. Can't figure out how to get to them. The book says have the dealer replace these bulbs if burnt out. I Always like to try to do things myself.
View 7 Replies
I have a 2010 f150 super crew, last night when leaving my baseball game I was shocked to find my running lights and my regular beam lights don't work. My high beams work fine but nothing else. I'm pretty sure the lights are an after market light, but I'm not positive since I purchased it used. I looked in manual to check for a fuse issue but I don't see anything regarding the headlights.
View 1 Replies
I am looking into replacing my cab light bulbs with amber led's. What ones do you recommend? There are so many available out there. I don't want some cheap crap! Also, what is the bulb type in are in the mirrors for the parking light and turn signal?
View 2 Replies
Swap out the LED dome lights in a 2012 Camry SE? I'm considering switching the bulbs out from the yellow tone stock lighting to the white lighting LED bulbs. I am also considering floor lighting that can be activated with the dome light switch and/or with the doors opening. The issue I'm having is that I would like them to be hooked up to the same switch that the stock lights are set up with. (So I can use the dimmer switch for lighting). Where I would be able to tap into the wiring for this? Is there a DIY thread somewhere?
View 3 Replies
I moved over some interior LED's from my past cars (MKV R32 & MK6 GTI, same fitment for basically all of the bulbs) and they're flickering a lot.
From what I've seen, it's only the dome lights -- the vanity lights, trunk lights & footwell lights are all fine...
I think it's important to note that these LED's worked fine in my past cars. I've reached out to deAutoKey to see if they can replace them...
View 5 Replies
I'm looking for a source that sells high quality LEDs. I already have LEDs in my R but they flicker horribly. I've sent the LEDs back for replacement twice and each time they were replaced they started to flicker within a month. I don't use the lights very often but I can't deal with the flickering anymore.
I won't mention the company I purchased the LEDs from to avoid any favoritism or slander.
View 14 Replies
Installed an ecs LED interior kit last night. Didn't go for a drive, just installed the LEDs. this morning i change some codes 1 at a time starting with rear tails byte 18. moved on to byte 4 bit 4 and made the change to allow for window up and down after the doors are opened. after making this change i noticed the interior LEDs blinking on and off every few seconds.
They didn't do that last night but I wasn't sitting in the car for a few minutes either. so i change what i did back to stock and the LEDs are still blinking. Not sure if I accidentally clicked on something I shouldn't have or what. And my computer crashed the other day and i lost my full scan and copy of coping. is this normal for LED interior lights? if not can someone hook me up with the long code for a NA car?
I did do the factory reset on the mfi computer and the rear head liner lights stopped blinking but the fronts still blink.
View 6 Replies
I want to start swapping out the stock lights for LEDs, beginning with the interior ones. I have read the de facto standard thread about LED swap here: [URL]...
For interior lights, the tacked thread mentions 39mm Festoon. However, when I go to Super Bright LEDs and put in my year, make and model (2002 EX), I get 578 LED Bulb - 8 LED Festoon - 44mm for replacement interior bulbs. Which is correct? 39mm or 44mm? Is there that big of a difference between the two? Will either size work?
I just want to make sure I order the right size to fit a 2002 EX. ETA: I want to start with ordering a few each of 5900K and 4300K just to see the difference in the truck and want to make sure I get the right ones. I don't want the Close Encounters look going on inside.
View 10 Replies
The taillight indicator on my display is on, but no bulbs are out.
View 4 Replies
I just picked up an '03 Golf and decided to put in the euro switch I had from my old Jetta. When I turn the headlights on (either parking or full) the instrument cluster blue back lighting and the red interior LEDs work only sometimes. When they work, they all work, but probably about 9 out of 10 times, they just won't come on at all, so I have to sit there turning the switch on and off repeatedly until they do come on. What could be causing this? It's definitely not a fuse since they do come on eventually, so my first thought was maybe a relay, but which one? What else could be going on?
View 5 Replies
My center console, gear lights, and steering wheel control buttons are not illuminating. Could it be a fuse? If so, which one would it be? I looked through the fuse section in the manual and could not find anything about it.
View 2 Replies
Recently picked up a 2013 F150 XLT. Reasonably basic truck. Supercab, 2wd, 5.0L, 6 speed, trailer towing package with brake controller......
We are about to head out on a 2 week camping trip. We will be at one site for the entire 2 weeks, and the truck will be driven very little during that time. Problem is that numerous people go in and out of the truck many times per day, x2 weeks. My previous tow vehicle had a means for turning off the interior lights during the daytime, when the doors would be constantly opening and closing.
This truck has interior lights and exterior lights and puddle lights and probably lights I don't even know about that come on and stay on for about 15-20 seconds every time the door opens. It has a funky rocker switch, that I hate, for the dash lights, that doesn't seem to turn off the interior lights. (I forgot the owners manual for the truck at a relatives place a week ago, so I can't check in there). Is there a way to manually keep the lights off during the day to save my battery?
View 7 Replies
Is there a way to turn all interior lights on the dash off when the headlights are off?
It is so bright that you can't see in the dark with everything off without being blinded.
View 6 Replies
I am switching my dome lights map lights etc to LED, and is having trouble removing the original bulb, any special ways to remove it, it seems stuck in there....
View 11 Replies
I decided to put white LED lights in my map light(the front 2 light) and after I put on the bulb I turn the light on and all my interior light including my dome light went off. My car clicker the trunk, alarm, door lock, and unlock doesn't work either so how do I fix. I don't know if I blew a fuse and I can't check as I don't have my car manual.
View 11 Replies
Just installed my new fogs in my 2012 LE and the install went GREAT! The switch has an LED in it to illuminate it AND one that comes on when you turn fogs on. What circuit I could tap into to dim that led? In lieu of that can you just put a resistor in the circuit to permanently dim it? I have the factory Wire diagram, so I will look for a light that is dimmed with the dash lights.
View 4 Replies
For my 2013 with HID lights, I'm adding a light bar, and trying to find a good wire to tap into so I can wire in a relay to turn the light bar on with my high beams. As it's going to a relay, I originally thought to use a fuse tap, but the high beam fuse is always powered. Any other wire I can use in the cab?
I'm also looking for an in cab wire for the reverse lights I'm adding. I've been trying to make sense of the wiring diagrams online, but I am not having any success.
View 2 Replies
My alarm and interior lights dont work after a vled installation. Basically when I was installing the interior LED's and I had the Map lights working and as soon as I tried to replace the Dome light my map lights, my Map lights lost power including my OEM alarm failed to work again. What to do because I atleast need my alarm to work....
View 4 Replies
