After starting my 09 Camry, the Maintenance light flashes a good 15 times before it turns off. I just started noticing this. I understand all the lights on the dash will flash upon starting the car, a few times, but this is longer than it has done it in the past.
View 10 RepliesMy "Maintenance Required" light on the dash is flashing 4-5-6 times when I start up the Prius every time, why?...
I went through all of my Maintenance menu items and most of them arent set to begin with, but the ones that ARE set, still have 4000+ miles til the next service...
My wifes 2012 camry se just started having the maintenance light start blinking. it blinks 8 times when started then stays off. I check the manual but couldn't find any answers to what it means. Whats going on?
View 4 RepliesSo for the past week or so when I start my car the maintenance light would come on, flash a few times then go off. Now it's on constantly. What's this mean? I looked in the manual but couldn't find anything about it. I read on line it means I need an oil change. Is this correct? I'm just about to hit 47k miles. I just wanted to make sure it wasn't for low fluids or like that. It's a 2013 camry se
View 2 RepliesI just got an oil change, and my maintenance light is flashing when I start up. It has about 36 thousand miles on it. I don't know when the previous oil change was before the one I got two weeks ago.I have read about resetting the maintenance light, but this is my first car and I have only had it for about 8 months, so I don't want to ignore a potential issue here.
View 4 RepliesMy daughter has a 2011 corolla and when she first cranks the car the maintenance required light flashes a couple of times and goes out. I think last time I changed her oil, it was steady on. What is causing it to flash?
View 6 RepliesMy maintenance light started flashing @ the 4500 mile mark so I checked the oil and was half a qt low. I was a bit surprised. I was not at any type of incline and I drive pretty light. Def don't drive hard. Normal or no?
View 14 RepliesI have an 09 Camry LE with about 59k miles on it and I just noticed today that When I turn my car on the maintenance required light blinks. But as soon as I put the car in drive it goes away, and does not return when I put it in park again.
I know all of your dash lights should come on at start up to show you that they work. But they all go off and that one remains flashing. I never looked at it before to know whether or not it's always been that way. Also when I first turn on my car, it idles at about 1.5k-2k rpm's. But if I keep my foot on the break and put it in drive then park again it sits at 1k or below. Is this normal? If not what should I be checking out?
I had been having battery issues with my 97 ford f150 4.6 liter for the longest time, thought i had a short under dash, i pulled entire dash out, disconnecting bat first of course, and inspected all wiring harness connections and fixing my issues and putting it all back together. now with new bat and all put back together i am now getting the airbag light flashing 5 times then 2 times (error code 52) i know it has some thing to do with power failure or backup battery, but now with the new battery in i cant seem to get it to reset. How to do this?
View 3 RepliesI'm still trying to get a manual for my recently acquired 2004 Prius, so I can't trace down what this means....
When I start the car, recently, a "Maint Required" light comes on and flashes about three or four times, then goes away. This is after all the other dash lights during the test phase go out. When I took it to have the codes read, the device said "No Codes" stored.
What does this mean? And is it a serious problem?
The maintenance required light just started flashing on our Camry last night.
It just went to the dealer at 4,200 mi for an "early" oil change (I had wanted an early oil change done, and the the dealer said it wasn't required til 10,000 miles). So no new oil.
It's about 7 months old, and mostly driven on short trips - our other car is used for the long trips. Tires were rotated @ last service.
Does it actually want an oil change? I'd take it to the dealer, but their next appointment is 2 weeks out.
So just trying to find out if this is normal. This is my wife's car so I don't drive it every day. I started it up to pull out of the garage and noticed the maint Req'd light blinking, it blinked about five times and turned off. Does it mean anything? if so, what? Just rolled over 100K. We bought it in late january and all the PM was done just wondering if they reset the oil reminder or what.
View 4 RepliesMaintenance light is Flashing on and off after initial startup, could it be that its trying to tell me its time to change oil or could it be something else. It is time to change my oil based on the mileage that it was last changed.
View 3 Replies09 corolla. Wife said it was hard to start this morning and when she got off work. it started fine right after she got home. i waited a few hours, after dinner and went out to start it and it takes the engine about 3 seconds to start.
Normally when I turn the key the engine cranks up and starts. today it cranks or turns over about 3 times before starting. and there's no error/engine lights. tested the battery, full charge. not sure what else to check.
We are in Houston TX, with about 95'F day temps, you could call it a cold start since the engine has been resting and cooling off. but not cold like freezing temp.
So I had a random issue today. I went to start my car this evening, and it wouldn't start. The lights on the dashboard (warning, maintenance, etc.) lit up, and the headlights and interior lights were extremely dim. Figured it was an issue with the battery. Used my husband's car to run errands and came back about an hour later. We decided to try starting the car again, and it turned on, headlights and interior lights were normal brightness, but the gas gauge is at one bar, which I know isn't possible because I have only put 166 miles on this tank of gas. I reset the gauge at each fill-up so I can track how my mileage changes. The maintenance light is also still flashing. None of these were issues I had last night, so what could be causing all these problems? Can I fix it myself, or do I need to take it into my Toyota dealership?
View 3 RepliesWhen I start my camry (06 v6) the check engine light flashes 6 times then goes off. I brought it to auto zone this morning to have the code read and they said it wasn't throwing anything. Car seems to be running fine, haven't done anything to it in the past few weeks other than open and close the hood once or twice.
View 1 RepliesI have a major issue the wife 09 camry won't crank nor start. It all happened after i touched the alternator and heat shield with a rachet . She was complaining about her battery light coming on and flashing so I goes out to see and noticed the ark coming from the alternator so i reached down to touch the wire while the car running and hit both the heat shield and alternator together sparks jumped off of course . I shut the running car off then tightrb up the alternator loose bolt. When I tried to restart the car it wouldn't turn over. I checked most of the fuses and now I'm lost and stuck....
View 2 RepliesMy bride's 2013 v5 is flashing "Maintenance Required" at a little over 4600 miles. Way too early for the recommended 10K oil change (though we will probably do the first change at 5K)...
View 9 RepliesI have a 2002 Honda accord SE. It has about 194,850ish miles on her. The maintenance required light starts to flash when I turn on the car and then the light stops flashing after a bit. What it means?
I checked for any codes and there's nothing. My oil is a bit low, but not at the marker. My next due for an oil change says 195,300ish. I've never seen it flash before.
Sometimes my battery light will come on. It started happening about a few weeks ago. At the time i was on the parkway so i couldn't pull over and it was flashing a few times then stopped. It started doing it more often, now it did it around town so i would slow down and i could hear the belt squealing. It just happened again and this time my car sorta lost power but only for a second. Now my question is, how would i check if its
a) alternator,
b) the belt or
c) the tensioner?
Or, I won't know til i start messing with it?
So I just bout an 03 explorer with 85k miles on it last month. the 4wd high light keeps flashing 10 times. i read the thread below and found this...
Diagnostic Flash Code Information
NOTE: The following flash codes 1 through 16 are
On-Board Diagnostic
(OBD) codes generated by the control module. If a system fault is detected, the control module will "flash out" the corresponding fault code on the electronic four-wheel drive Malfunction Indicator Lamp (MIL) on the instrument panel. Also, notice that all the codes that can be generated pertain only to the speed sensors, the clutch coil and clutch with the exception of the first flash code.
The electronic four-wheel drive system also includes the brake switch input, Park/Neutral Position (PNP) switch input, one power and two ground lines, along with the E-4WD MIL. The following pinpoint tests include testing on every electronic four-wheel drive circuit and not just those covered by the flash codes.
DIAGNOSTIC FLASH CODE CHART
Flash CodeDescriptionAction to Take
Inoperative or Erratic System Errors.Complete Tests AA through DD.
1Microprocessor RAM (Random Access Memory) access error.Replace Control Module.
2Clutch connector or clutch coil has discontinuity.GO to Step FF1.
3Front output speed sensor connector or internal circuitry of sensor has discontinuity.Go to Step EE1.
4Rear output speed sensor connector or internal circuitry of sensor has discontinuity.Go to Step EE1.
5Both front and rear speed sensor connectors and/or internal circuitry of sensors have discontinuity.Go to Step EE1.
6Clutch and front sensor connectors and/or clutch coil and/or internal circuitry of sensor have discontinuity.First see Step FF1, then Step EE1.
7Clutch and rear sensor connectors and/or clutch coil and/or internal circuitry of sensor have discontinuity.First see Step FF1, then Step EE1.
8Clutch and both sensor connectors and/or clutch coil and/or internal circuitry of sensors have discontinuity.First see Step FF1, then Step EE1.
9Mechanical problem that allows clutch plates to slip during clutch engagement (or faulty sensor output signal).First see Step FF1, then Step EE1.
10Both Code 9 and Code 2.See action for Code 9.
11Both Code 9 and Code 3.See action for Code 9.
12Both Code 9 and Code 4.See action for Code 9.
13Both Code 9 and Code 5.See action for Code 9.
14Both Code 9 and Code 6.See action for Code 9.
15Both Code 9 and Code 7.See action for Code 9.
16Both Code 9 and Code 8.See action for Code 9.
Regeneration (Recovery) of Flash Codes
If the ignition is turned OFF and the code is lost, the ignition will have to be turned ON again to regenerate codes 1 through 8, if the condition or conditions still exist. To regenerate codes 9 through 16, the vehicle must be driven again.
How accurate is this information? also where can i find a replacement clutch connector? New to fords so I am not sure where to get parts.