My A/C works fine, but the A/C switch light is not working. So i don't know if A/C on&off when i drive in the evening. Which part I need to replace and what is the part number?
View 7 RepliesI can hardly see at night when i switch on the low beam light on my 09 Camry. How I can make them a little brighter. Have difficulties seeing when i meet another vehicle and have to change to low beam at night.
View 7 RepliesThe door lock switch on the driver's door isn't working. All other lock functions work. Is there a setting like auto lock or something that disables this, or is it another issue.
View 3 RepliesOn my 09 Camry LE most of the time at least once or twice when driving at night with the headlights in AUTO mode if you go to hit the turn signals to switch lanes or make a turn the switch will change to either the off position or on position. This is especially annoying as if you do not realize the headlights are on you can park and leave them on draining your battery.
I have driven plenty (hundreds) of Gen 6 Camry's and have never experienced this. My Corolla switch has never so much as hinted at moving although it only stays in the off position since DRL are always active but anyway. If I am going to replace the switch might as well opt for the XLE/SE switch for my fog upgrade.
My master window switch stop working. All of the other window switches work from the other doors. The driver side one will not work any of the windows. the power lock works but I cannot control any of the windows from the driver side.
View 1 RepliesMy wife has a 2009 Camry LE, 4cyl with approximately 63,000 miles on it. Yesterday when driving it, I went to turn the cruise control off and my finger slipped, causing the button to pop out. Both of us have tried to fix it and I know I tried at least three or four different ways to reinstall the little three prong copper piece and no luck. The cruise control still refuses to work.
Having problem with the button popping out and been able to fix it? If so, how did you fix it? I hope it's something simple, such as re-installing the copper piece a certain way.
I haven't been on in a while due to my laptop breaking on me well recently i purchased the V3 triton switchback from vleds as well as just red V3 triton leds. After the install i blew my flasher fuse which i replaced then when i attempted it again i must have blown something else because my corner lights no longer go on and when i turn my lights on i no longer get the sign on the cluster notifying me that they are on. I have removed the lights and the issue was i did not order ck socket adapter. So what i have done so far is checked all fuses and i have nothing burned under the driver side and under the hood. I must have looked over everything 10 times checked all fuses with a test light and i don't see anything with DRL or Corner lights labeled anywhere on the fuse panels. Is it possible i burned the module DRL module?
View 9 RepliesI have an 05 4-cyl LE. The dash/cluster dimmer switch isn't working, but all the lights are on and at full blast. I removed the fuse panel cover and coin try. There was a set of wires and a plug just free floating back there (3 wires and a black clip). I could not see anything plugged into the dimmer so I figure that's there the plug goes? I can't get my chubby fingers up back there to plug it in and would like to remove the trim panel to gain access. I can't find anything out there on how to remove that panel.
View 1 RepliesS4. The a/c light on the dashboard switch (2002 V6) started flashing when the light should be solid steady light plus No Cold Air. I Google it and it directs me to several sites, people are saying just change the cabin filter and that often fixes it and if not change the a/c relay (disconnect the battery first they pointed out).
I got a new cabin air filter from O'Reilly for $14. (The PurolaterC35479 "breathe easy" fits 2002-2007 camry) To change it just empty your glove box and leave the door down. On the right side of the glove box hinge there's one philips screw. Remove that and wobble down the right side then pull out the glove box door.
Look straight in at the firewall behind that now you can see the slot the filter goes in its about 1" high by 8" wide. Yank out the old filter and carefully note the orientation of it as it comes out. Shove in your new filter. Replace glove box.
The light did not go out at first. It took about ten minutes running the fan turning the a/c switch off and on while driving but the a/c light finally stopped flashing and changed to a solid green light again, and the cold air came back.
I just recent bought a 2012 Toyota Camry LE and it seems to have had fog lights installed (not stock ,as far as my research has proven) and the LED on the switch is green and never shuts itself off. I'm not sure if this is normal. I have a decent mechanical background and never see anything other than security lights on when the key if off and out of the ignition. Seems like it may be a little wrong wiring. I checked the DIY OEM install of the fog lamps, but nothing there stood out to me as a cause for the light to remain on.
View 1 RepliesCamry 2002 XLE 4Cyl. 2.4 ... When I switch ignition key on, there are no ABS and Brake light come on. Why is that happening? How to fix it? Normally, when we switch ignition key on, what are indicator light on?
View 6 RepliesWhere they've hidden the switch that turns the trunk light on--and the switch that lights up the instrument panel warning light that the trunk is open, and that causes that annoying bleating when you're driving with the trunk unlatched?
I have a 10' kayak that I slide into the trunk for a 1/2 mile drive down my private road to the dock and I'm sick of listening to that warning beep--hoping I can put tape over the switch or something to shut it up.
What is the likely culprit? No other electrical issues, brake light quit working when brake is depressed, all other lights work including blinkers/running/head. Was going to break out a wiring diagram....
View 7 RepliesMy wife's 2010 Lariat, has a problem with the heater switch. Its stuck in one speed.
Also the rear defogger switch doesn't light up. We don't know if the switch to it is just bad, OR if the whole system is bad.
Was also wondering if the blend door would be bad??
My 2015 camry front dome light switch is broken. This is the push type light. I am not sure how but today i was trying to turn the light on and noticed it wasn't turning on. When i opened the lens cover to switch the bulb i noticed the button was missing and the other side has a button. I don't understand why the light will not turn on when i open the door either. I tried sticking some thing small in to the broken part where the button used to be and it turns on if i do that, but i would have to hold it in place which is pretty inconvenient. What can i do to fix this? it seems like i have to replace the whole overhead assembly. Is there a cheap fix? i would be happy if the light comes on when i at least open the door.
View 9 RepliesWe had a replacement rear windshield on 2009 camry , and now rear defrost does not work. Where would I look for a loose wire connection?
View 5 RepliesI have a 09 Camry 2.4L Installed veep core an now have no power to fuel pump . I have checked for ECM sending signal to turn on (it does)have had locksmith redo security (no luck) and will run if fuel manually induced . Has rpm signal on my diag so it's reading rpm also
View 1 RepliesMy AUX cable stopped working on my '09 Camry SE. I've tried switching cables and the problem persists. People have suggested that I go to the dealer and get it checked but I'm afraid of the big bill they will have waiting for me.
The problem started as just the AUX losing connection when the car hit a pothole but after a couple of days, it stopped working altogether. there is any easy and cost efficient fix to it.
Having a problem with my truck and I'm stuck. About 9 months ago my 4wd stopped working. Turn the switch and no light or noise. I took a look at fuses and everything was good there. I let it go but now I need 4wd. Today I checked every fuse and all of them were good. I moved to the relays checked them and they were good but for the heck of it replaced them. Checked for power at the pins. The one that needed power had power. Next I went to the switch had 12 volts there. Pulled switch and test with a multimeter and ohms were good. Went. Down to the motor and tested for power there not power to the motor. Is there anything else I'm missing Esof not working. 2002 f350 7.3 auto....
View 2 RepliesJust stopped working. The fans of course blow fine and the air vent changes from top to bottom and the like. I checked the fuses and looks OK. I measured the voltages on the pressure switch and they read +5.0VDC and +4.7VDC to ground. The pressure switch itself measures 10.9K Ohms and 6.2 KOhms to ground from the two left pins. Is that the Ohms for LOW R134 ? I will try measuring with a manifold later but thought this might ring a bell. Is this style switch able to be JUMPED ? To see if it is only low pressure ? The ones I am used to have only 2 pins and this has three. I read +2.6VDC on the compressor clutch.
View 7 RepliesInstrument cluster (speedometer, Tachometer, Break & ABS light) is not working while driving.
My video for my 2009 camry 2.4 LE is here: [URL] .....
Toyota service center asked $6000 to replace wire harness and PROBABLY electronic control unit.
I found some posts, but the answers are not that clear to fix it. [URL] ....