Camry :: 2008 - Clicking Noise When Turned Left / Need Replacement Of Hub And Bearing
Sep 14, 2012
I have an '08 Camry LE 4cyl with 80,000 miles.
I was hearing a clicking noise when I turned left. Which I thought was the CV joint, but turned out to be worn struts. Then I began hearing a roaring sound from the front end. I replaced the struts & that fixed the clicking sound but not the roaring. So I thought maybe it just needed an alignment. I took it to dealer After fixing that one they call & say right one was so loud they couldn't hear that left one was roaring too. So they say I need to replace that hub & bearing also.
Are these issues happening very prematurely? What could have caused these problems?
View 11 Replies
Advertisement
I have a 2000 Passat and brought it to a local shop to have the left front wheel bearing changed. He took the car apart and said he couldnt do it because the anti lock brake wire ran threw the control arm and had no plug on it and was wired right to the dash board. Should i find a different place to take it to or is it a dealer required fix. Can i buy the bearing myself and change it?
View 1 Replies
My 2003 Camry makes a a grinding noise when the wheel is turned even slightly left. The noise is present at any speed, and is the same volume no matter what. I'm fairly certain its coming from the driver side front wheel. I changed that CV axle in January so hopefully that's not the issue.
View 2 Replies
I have 2016 camry 4 cyl have roughly 2300 miles and I'm noticing a click click while turning the steering wheel left or right while stationary and vehicle running sounds like it's coming from under the dash.
I've seen there is a tsb for other year camry intermediate shaft issue, my vehicle is lowered on eibach Springs and would hate to take back to dealer and have them blame it on the springs in a vehicle that has only 2,500 miles.
View 10 Replies
Experienced a weird clicking sound when the steering wheel is fully locked either left or right, when turning at low speeds? Its more of a pop than click. No issues driving straight, or in regular turns, just when fully extended.
View 7 Replies
'08 F350 6.4l 4wd, I had the truck come in with a exploded transfer case. (See pics). Ive read all about this happening to many others. The truck still drove, hubs not locked, plenty of fluid in the TC, pretty sure it was the double Cardan that did it. Anyways I replaced thwith TC, replaced the front driveshaft, filled the TC with recommended fluid. Test drove and drives great, shifts fine. Only until I turned left.
At slow speeds turning hard or 15-20 taking a turn, it sounds like a ratchet clicking from somewhere on the left side, right around the drivers door, from what I can hear from the cab. Does it in 2wd, 4wd hi/low, hubs locked or not. I changed the vacuum pump, no leaks, changed the IWE solenoid, pulled out both locking mechanisms, tightened crossmember, checked everything from the hours of research I did on the internet. I cannot find the problem. I don't know what else to check. Front axles free spin and lock when they are supposed to. I'm at the end...
View 6 Replies
Just had an oil change and during inspection they noticed that the drivers side wheel bearing is starting to go. They brought me back in the shop and I was able to feel the play in the bearing myself. Only a matter of time before it needs to be replaced.
How to replace the front wheel bearing/hub assembly? I don't have a press for the bearing itself so I'm assuming I can just replace the entire hub assembly. I have already replaced the drivers side rear hub assembly about 1.5 years back due to a bad bearing
View 1 Replies
When I turn off my car I always get out within 10-20 seconds until today. When I shut it off after a errand I was checking messages on my phone and after about 45 seconds I started hearing this repetitive clicking noise from the left side of the dash near the vent area by the door. It clicked about 5 times and stopped for about 20 seconds, then clicked 5 more times, stopped for 20 seconds and again, 5 clicks, then it stopped and didn't start again. I am not sure if it is just the computer making adjustments, etc, but it is a little unsettling on a new car with 320 miles.
I thought maybe a bomb was in there. It was about 90 degrees outside and I had been using the A/C. I plan on listening again tomorrow evening when I get home from work and see if it does it again. (My car is a '15 SE 2.4L if that makes a difference). Maybe I am just paranoid, but you buy a new car to get rid of worries, not still have to worry if your car is breaking down, but I know new cars have a lot of features/settings/computers, etc and certain sounds may be normal.
View 9 Replies
What is causing the right front wheel bearing to keep going bad on my 06 f-150 2 wheel drive....
View 1 Replies
Wondering how I would take the A/C pulley off to change the bearing or fix the chirp squeal it is making.
I have spun this pulley by hand and it is the culprit making the noise.
It has an inner pulley and an outer pulley(belt pulley). Both spin freely and are not bound up. Just want the terrible noise to go away.
View 1 Replies
Not my video, but I have the same exact sound coming from my passenger side wheel on my 03 V10 4X4, 130K. Passenger side only, no noise from the other side.
YouTube .....
Before I spring for the Timkin, does this sound like a bad bearing? No play in the wheel, but it's a clicking sound.
View 7 Replies
Having issues with noise from either LT or RT front wheel bearings? My 2011 Elantra has some sort of noise coming from the LT frt wheel
View 10 Replies
I have a clicking binding noise while at idle, with the clutch out it goes away, when depressed its there. So, is this a bad throw out bearing? Clutches and flywheels?
View 12 Replies
Immediately after I had four new tires installed on a 2000 Blazer 4wd, the front wheel bearings started making noise. At the time I thought the noise was from the new tires. A few thousand miles later my mechanic told me I needed two reman hub assemblies (sealed bearings) for ~$350 apiece plus labor.
Is there anything that the tire shop (independent not chain) could have done (accidentally or otherwise) to damage the bearings during the tire installation? I have to get 4 tires for my 93 Chevrolet Caprice and don't wish to repeat the experience.
Whoops, forgot to mention this happened at 56k miles when the truck was five years old. Is it possible that the bearings were borderline and the process of mounting the wheels put them over the edge? For instance, someone being a little over enthusiastic with an impact wrench.
View 4 Replies
I had the front right wheel bearing replaced on my Toyota Corolla (60,000 miles) replaced a couple days ago. One day after the repair, I heard a high pitched clicking noise which was noticeable around 20-30 mph. Yesterday, I still noticed the high-pitched sound but also a grinding/popping sound in front left side when coming to a stop upon every rotation of the tire. Took the car back to the shop to let them listen to the noise, but really weren't very compliant since it doesn't sound like a wheel bearing problem.
Here is YouTube link to noise car is making : [URL] .....
View 5 Replies
09 Camry steering wheel clicks when going over speed bumps or if turning the wheel left and right somewhat rapidly at a stop. Seems to not be as bad when the tilt is all the way down.
View 1 Replies
I've got a 2004 Cavalier and when the heater is turned on it makes a clicking noise (sounds like someone on a snare drum playing over and over again) You can feel it if you touch the bottom of the Heater/AC module on the passenger side of the car above your feet. It stops when you turn the heater control to the recirculation position.
My guess is it's the recirculation door actuator motor, but I can't find it through NAPA or any automotive parts online sites, what the Chevy part number is for this, and/or a parts blowup of the HVAC module? Also, the factory service manual I've got says that the entire HVAC unit needs to be drained of 134 and removed from the vehicle to replace this actuator, does it can be done without removing the entire unit? From the few pictures it shows of where the actuator is, that part appears to be near the top (that's why I'd like to see a parts blowup if possible).
View 9 Replies
Just got back from the supermarket. Unloaded groceries and my Passat wouldn't start when I went to park it. Turned the key and it just makes a clicking noise - clock and trip odometer reset themselves also. If I turn the key the car just makes a clicking noise and the lights on the dash all flash on and off.
I am going to see if it starts after being jumped in a few minutes.
Other potentially useful info - I was testing a radar detector for work the other day and it has a battery voltage meter. It was reading in the 11.0 - 11.6 volt range. Is this too low - just wondering if the alternator was not supplying a sufficient charge. Not sure how accurate these are. The battery was changed around a year ago so I'm sure it's not the battery. I am assuming starter or alternator.
View 4 Replies
So the other day driving to work i was driving my car to work, i put my turn signal on and after i turn it off it still kept doing the clicking noise. At first i thought i was just hearing stuff cause it was early and i was tired, so after work i checked it out again i sure enough it was doing it. It even does it sometimes without even first putting the turn signal on. My buddy and i thought it was a relay or a fuse. Is that right?
View 7 Replies
I have an '02 Camry with 82,000 miles. I recently noticed a clicking from the front left wheel starting at 68-70 mph. The click varies in frequency with slight bumps in the road. It seems to stop if I touch the brakes, and it might get less if the road turns enough to increase the G force (not too many times on highway going this speed on a curvy road, so I'm not sure.) It never happens under 65 mph.
We recently had local flooding and I drove through about 8 inches of water. The noise was a few days later in dry weather at 80 degrees. It did not occur when the car was starting off cool, but not until I was driving for about 5-10 minutes. The tire and wheel look OK, but it has not been on a lift nor have I been to a mechanic yet. I don't want to get talked into expensive repairs that I don't need, but I don't want to put off something now that is dangerous or will turn into a bigger expense later.
View 2 Replies
The prius alpha i own has this rattling noise when the steering is turned left or right. A local mechanic advised to lubricate the opening on the top of shocks, I couldn't find the Lube spray by Liquor Moli or 3M liquid Grease. I tried a spray by WD-40 Specialist Water Resistant Silicone Lubricant, but no result .
I have this Grease (attached pic).(desperate measure). Shall I apply this? And how?
View 6 Replies
