Camry :: 2007 V6 Speedometer Stop Working - Brake / ABS And Check Engine Light Came On
Nov 16, 2011
I have a Camry 2007, V6 and 3 weeks ago speedometer stop working and brake light, ABS light and check engine light came ON.
I had the car checked and P0500 code saying speedometer malfunction. All 4 speed sensors has been checked OK, computer engine replaced nothing change, all 3 lights are on and speedometer is not working.
I also noticed if I pull the connector from SKID control ECU I do have the same lights ON so with or without the connector plugged the same lights are on. Looks like no communication between SKID control ECU and....
View 4 Replies
Advertisement
The 3rd central brake light is not working. I looked at the manual to find where the fuse is but could not find it.
View 13 Replies
I recently bought a Santa fe 2007 Limited 3.3L, it has 101500 miles. The issue is that when i run the scan it has 3 minor sensors that needs to be replaced but my biggest concern is that the check engine light does not come on in the dashboard even when i turn the ignition to on.
I need to know if there is a fuse that can cause this or a bulb in the dashboard that i can replaced for myself or if it is something else.
View 7 Replies
A few days ago I noticed a whining noise coming from the engine and thought it was the power steering unit or the alternator. I was going to bring it in to the dealer this week but last night while driving, the check vsc light and the ABS light came on momentarily and then went off. Then it happened again and again until the lights began to dim and the engine started to shudder. So I quickly started driving home and saw the speedometer going from 0 to 60 mph, the headlights were practically off, the power window would not close, the console lights alternated from dark to lit repeatedly and the car was bucking as I sped home.
I knew the car was running on the battery alone and it was now very low.When I finally had to stop at a traffic light it stalled and would not start. After waiting 20 minutes for a tow truck, I tried to start it and it started. So I immediately drove approximately 3 minutes to a Service Station near my home and parked it there and then canceled the tow truck. Does this sound like the alternator went bad? I should also mention that yesterday before this whole incident took place, while I was stopped at a light with my food on the brake I noticed the brake pedal depress ever so slightly. I didn't think much of it because I knew I had an issue with that whining noise and was going to bring the car into the dealer Monday.
View 8 Replies
My wife's car has 83000 miles on it. We bought it as a factory certified pre-owned vehicle with about 1800 miles on it and it came with the warranty. For the last two years the check engine light comes on with code 441 I don't worry about it till time to get inspection sticker here in Texas. I have been about to reset the computer and drive it till the computer is ready to be inspected and it has passed for two years. Now it won't reset and I have tried to test the vacuum switch and it seems to click when I apply voltage but light won't go off. This code can cost up to about 2000.00 to try and detect. I am not interested in having the dealership keep guessing on my dime.
View 2 Replies
I have a 07 Camry XLE. My previous battery started dying on me so I changed to an Optima Yellowtop battery. Next day the check engine light came on, and sometimes while idle the car starts stalling, it never turns off though just that the RPM goes really low and the acceleration is really slow and it feels like the car is having trouble accelerating. Today it happened again but I was over 60MPH and hitting the gas pedal and it seemed to stop accelerating a few times.
View 2 Replies
Im a newbie to the Camry's. Picked up from a relative a 07 Camry for $5k. It has 103K on it.
It has an issue to where it has some codes and the check engine light on with P0018, P0019, P0300, P0302, P0306 codes. They just all cam eup al lof a sudden while driving. Slight miss at idle which is the misfire codes but I can't pinpoint the issue for the P0018 and P0019 codes.
View 14 Replies
Today my check engine light came on and the code is P0712. When I drove off from the parts store, the check engine light suddenly went off. What should I do at this point? What are the most likely problems/solutions.
View 1 Replies
I recently bought a 2007 toyota Camry le v6 with less than 38,000 miles it currently has 39,300 miles and my check engine light is on along with the VSC and a skid control light (car with squiggle lines behind it) we have a had lots of rain here where I live and I had to drive through a couple deep water puddles. I looked up online and it said The engine light may turn on if the VSC and skid control lights are on. Could this be that the sensors maybe got wet? I don't think anything should be wrong with this car considering it's a toyota with less than 40k miles
View 14 Replies
While driving my 2009 Camry the abs light and break light pop on and the speedometer stops working as well as the tacomitor and the odomitor stops ticking off miles as well, also the ac fan will run but the compressor stops.
View 2 Replies
I was able to quickly diagnose the problem with our 99 T&C LXi w/3.8L.
Problem: No speedometer, wouldn't shift, check engine light came on.
Many posts suggested speed sensor. There are actually 2 of them. An input and an output. Both cost approx $20 each.
By removing the aircleaner box assembly, I had the best (relative word) access to the sensors. A 1" socket w/3" extension did the trick. I understand the access for 2000+ models is different.
View 9 Replies
Driving on highway, check engine light goes on, speedometer drops from 60 to 0 but nothing else happens. Come to a stoplight and engine light stays on and speedometer works again. Any diagnostics?
View 1 Replies
My Mom has a 07 Camry with only 40k miles. Today she's coming from the store & said the Brake, ABS lights came on and Speed, RPM & Temp gauge stop working?
The car still drove fine but it freaked her out! After 1/2hr everything worked again?
View 12 Replies
Bought the car used a few months ago with a little less than 72k miles. At 72k miles, I replaced all brake pads. Car now has 75k miles on it. Wife just got back from a 1k mile road trip with it.
I took it for a little ride, and noticed this problem about 3 times, it doesn't happen every time. There is no vibration or anything when slowing down and stopping. But, a few times, when the car was at, or almost at a complete stop, the brake pedal would feel like it was buzzing a little bit, and I could hear a springy sound. I tried to reproduce it with hard braking, but couldn't. Seemed to only happen with slow, gradual breaking, and when the car was just about at a complete stop. Brake fluid is full. No lights on dash. Asked my wife if she slammed breaks at all, or had any problems, she said no. Then she said she experienced what I did once, when she was at a rest area, stopped
The only thing I can think to compare it to is how the brake pedal feels and sounds if you lock up your brakes, and the ABS is doing its thing....which I haven't ever done with this car...
View 11 Replies
I have a 4-cyl 2007 Camry XLE. I changed out the plugs, simple enough. but now the car seems to be idling too low, just a tick below 500 RPM. Its causing some minor vibrations as also the AC is not working at a stop, it just blow warm air. As soon as i push on the gas the RPM jerk up pretty sudden, the air pressure from the vents increases and its cooler. So it seems the AC issues is related to the RPM being too low so once i get the RPM's back up it should be good to go.
These are the stock Denzo SK20R11 plugs that were in the car : [URL] ....
And these are the equivalent NGK IFR6T11 plugs i put in [URL] .....
So, I thought maybe because the ECU got reset maybe some re-calibration, but I have driven a good 100 miles on it and no change so i doubt that's it.
View 2 Replies
I have the "check stop lamp" message showing up. Both right and left brake lights are fine but the third brake light is totally out. I've heard of other Volvos having issues with the wiring harness near the hinge.
View 8 Replies
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
View 7 Replies
I changed my plugs a few days ago on my 96' Taurus GL 3.0LI checked under my hood to check the recommended gap size and it said .42 to .46.. I went with .46. after putting them in i started the car up just fine, but later in the day i noticed when I came to a stop at a red light my car would sputter and my check engine light would start blinking. When I'd accelerate and drive it again everything would clear up and the light would stop blinking. I didn't change the wires, just the plugs in case you were wondering but I am unsure of how much that would influence my problem. Today after work i had a little trouble starting my car. After a few tries it started and my exhaust smelt rich in gasoline. Did i gap them too much? Should i get new plugs again and regap them? should i buy new wires also?Is my ignition coil going bad?
View 19 Replies
I was at a stop light. The light turned green and I let off the brake. Just then the car died while I was in drive. I couldn't put it in park. I was a little panicky. It broke down on a major road in morning traffic. I tried starting the car. Nothing. I think I managed to move the shifter into neutral and tried starting the car again. Not a problem this time. Maybe a few minutes had lapsed. It bothers me of course because I've only made 4 payments on it and I'm planning on a trip out of town this weekend. After I dropped my son off I made it home without incident. What caused this?
View 1 Replies
I have a 2010 Chev Cobalt LT, bought brand new off the lot- at about 15,000 km's, I started to experience some electrical issues.. Basically, what it is the parking brake light comes on in the instrument panel along with the all the other warning lights, both speedo and rpm gauges stop working, -- basically EVERYTHING electrical, but the lights, and turn signals, hazards work-- took it in to the GM Dealer- they cleaned the BCM Connectors, it was fine for about 4 months- now it's doing it again... Same thing as before warning lights come on, and everything stops except last night the Keyless Entry would not work at all... This has me stumped and it's annoying having to take it all the time..
View 4 Replies
My cousin got a 2007 Toyota Camry. Every time we did a oil change put 5 qt Synthetic ow-20, once he hit to 3000 mile on hard brake stop, the oil light is on, we check that has low oil level and oil change. came out 2 half qt oil.
View 11 Replies
