Camry :: 2007 SE - Route Power Cable From Trunk To Battery?
Jan 31, 2013
I am installing a wiring harness in my 2007 Camry SE so that I can tow a small flatbed utility trailer I have to carry my kayak on trips. I have the wiring harness all installed except for I now have to route the power cable for the harness from the trunk to the battery in the front of the car. The instructions give no suggestions on how to get the wire to the battery other than to avoid hot parts and suspension parts.
What would be the best and easiest way to get the wire to the front? I'm not well versed in car mechanics or how to take things apart so I would prefer the easiest, most direct way if there is one.
I have already found a grommet in the trunk with a factory wire harness going through it to the bottom of the car so I can route my wire through there, but after that where to go next. The only thing I can think of is there is several brackets holding the 2 fuel lines and the 2 rear brake lines, there is a open spot between the 2 fuel lines so I could use the empty spot in those brackets to hold the wire for most of the way to the front, do fuel lines get hot at all? Do you think it would be safe to route the wire that way?
As for getting into the engine compartment, how to do that without getting in the way of the front suspension while keeping the wire away from the transmission and axles.
If this is too complicated to do myself, my dad has a friend who is a electrician and likes to restore cars that could do it for me but he is almost always busy, thus hard to get a hold of and I like to try and learn some things about my car and do as much as I can on my own.
This is the trailer light wiring harness I have, there is a link for the instruction manual there too
[URL]
View 14 Replies
Advertisement
I use a vent mount for my phone and my old car had the aux-in by the radio so I used a little retractable cable to my phone. Now in the prius the aux-in jack is way in the back of the arm rest what is the best way to route the cable there?
No nav, so no bluetooth streaming for me.
View 1 Replies
I bought 2000 Ranger with rear half of the frame cut and welded.
The mechanics who did this did terrible job of putting things where they belong. I rerouted wiring harness and rebuilt EVAP lines, but cannot figure out what is the correct route for parking brake cable.
Currently some part of the parking brake cable is sitting on the leaf spring. It may also be missing some mounting brackets or clips. Looking for a picture or diagram showing parking brake cable routing?
View 2 Replies
When I dropped my 2 frame rail batteries I noticed the clamp on the positive battery cable was broke. How to splice in a new clamp?
Pick and pull is an option. I would rather repair my OEM cable and be done.
View 4 Replies
So my wife's 2007 Camry just got a new battery a week or two ago. The other day she goes into the garage to her car to find it dead, with no power to the locks (had to use key instead of FOB), no accessories, no dash lights and no dome light. When she tried to start the vehicle it gave her a single click, did not crank and did not start.
Initially I approached it from the perspective that maybe the alternator was not charging the battery, so I charged the battery with my portable charger. The battery charged fast and checked out okay.
I then used the key FOB to unlock the door. Adjusted the electric seat to better fit me. The dome light came on. I also checked to see the head lights came on. I turned the ignition to start and I got a single click. Tried it again and got no feedback. The dome light was no longer lit and no other accessories worked. All of the power seemingly drained following the attempt to start.
Now I am wondering if the starter is shorting out or if something more mysterious in the electrical system is malfunctioning in a way that I have never faced before...
View 14 Replies
For some reason, I didn't close my trunk door good last night and I discovered that the trunk remained open all night long, about 12 hours. I am worried that the trunk light may have drained my battery. The car started up just fine with no delays or odd noises.
View 3 Replies
Today I changed my LH battery due to some issues i had when leaving the can unused for a day or two. I followed the changing procedure listed on the forum and everything went as planned. However now my power trunk wont work. I used the procedure to sync the power trunk but now when i hold the trunk button on my keyfob the lights flash etc but no sound or movement from the trunk.
View 4 Replies
Water is getting in the trunk of my 2007 Toyota Camry. I need to replace the seal or weather stripping around the trunk, because it's come unattached in some places. I did some looking, but I am not familiar with some of the brands and vendors I see. Most of it is generic.
Are there particular brands with which you have had good luck? I've never replaced this sort of thing before.
View 9 Replies
Wiring power from car battery to trunk for amplifier for subwoofer? How to do that easiest way?
View 2 Replies
When ever my Camry its a rough road the trunk rattles like their is something moving around in it, however there is nothing in the trunk, I checked to make sure the spare was secure and it is. What could be the problem?
View 2 Replies
Just finished setting up a new HU! Next step is setting up my amp and subwoofer. I already ran the RCA and Remote Wire cables when I hooked up the Head Unit. I don't know where to run the power cable through the firewall?!
View 4 Replies
Removing the negative battery cable piece that connects the cable to the terminal. Where I can get the screw that tightens the connector around the terminal.
View 4 Replies
I don't have ready access to my truck and I'm trying to buy new cooling parts when I rip out/replace my transmission. I searched the forum but can't find the simple answer I'm looking for regarding the route of the transmission fluid for cooling.
In my 2001, I thought the fluid comes out of the transmission to the radiator, then back to the transmission from last time I was looking at it underneath. But in the forum, it sounds the fluid would come out of the radiator and then into the air cooler in front of the radiator before back to the transmission.
View 7 Replies
It is very cold up here in WI and this week, I found that the trunk lid would not power open. It would unlatch and then just sit there. There was no ice in the way and it would power down normally. When parked in the garage overnight it was ok but at work at the end of the day it would not do its thing.
View 2 Replies
how to reset the power trunk lid on a 2007 LS460. I disconnected the wiring harness to remove the deck lid, to repair and paint a scratch. And now the power lift will not work? I hit the button on the trunk and in the car, and it just beeps...
View 10 Replies
my power trunk normally works fine when level. When parked on an incline it stutters/slips going up and have to manually close . Sounds like a gear slipping in a ratchet.
Works completely fine on level surface. Normal?
View 2 Replies
How to activate the power trunk release on a 2012 Camry L series? My car came with dealer remotes that don't have a button for the rear trunk lock which I saw is in the vehicle when I added the trunk spoiler. It would be nice not to have to open the DS door and pull the trunk release lever to open the trunk all the time....
View 5 Replies
I'm no pro but I've installed and uninstalled a good amount of systems in my time. Working on my new (to me) LS is like no other car I've had. The thing is built like a tank.
Usually, running the power into the trunk is the easiest part. Snap up the bottom part of the back seat and then a few bolts to remove the upper part of the back seat and your basically IN the trunk.
Not on the LS...best way to get this from the back seat into the trunk?
View 14 Replies
just tradred my IS for an LS and cant seem to open the trunk with the oem remote , even while pressing the button and holding it? i tried the override switch in glove box, no luck. if i open with key and press button on trunk lid, it will close!
View 3 Replies
We have a 2009 BMW X5 with an AGM battery that leaked and damaged the negative cable. We don't know what caused this, and we're concerned it might be due to a problem with the battery sensor, voltage regulator, alternator, or electronic system/software. The dealer says there's no way to tell, and that "batteries just leak." However, we pointed out that BMW's online marketing info states that "The acid cannot leak and damage the battery housing." Based on this express warranty, the BMW dealer refunded us the cost of the new battery, cable, and labor. However, since we've read that battery failure is rarely due to the battery itself, but rather a symptom of some other problem, we're concerned.
View 2 Replies
I'm working on a 95 Explorer, and I need to know where the end of the negative battery cable should be bolted to. Right now, it's hooked to a bolt on the back of the starter. That just doesn't sound right......
View 3 Replies
