My power steering fluid reservoir is a little low. Which type or brand of power steering fluid should I fill it up with?
I know that I should use Dextron III, but does the brand matter? Or can I mix the OEM fluid with an aftermarket fluid.
So I've been noticing my power steering in the reservoir has been going down for quite some time. Now its more noticeable than ever. Just about a month ago I topped off the tank to the "max" line and now its at the "min" line. I also notice the fluid on the garage floor. I've always had a lot of grease (I assume the fluid) all around the body and under the reservoir under the hood. It seems to be leaking from the hose where it connects to the actual reservoir. Maybe the clamp is bad or something.
View 14 RepliesJust checked out at 2003 V6 LE with 120k miles for $5500. Car seems to be in excellent mechanical condition but I did notice quite a significant power steering fluid leak, seems to be coming from the reservoir. I see that there are two hoses for about $80 each listed on Partsgeek.
Is this a common problem, can the clamps just be tightened, Could it be the reservoir it's self or even the pump too high a pressure?
Seems to be quite a lot of fluid running down the side of the car but after taking it for a test drive I didn't see any signs of it squirting out so perhaps it's a slow leak and been leaking for a while.
2002 camry: my boyfriend just told me he accidentally added power steering fluid to the brake reservoir a couple monthes ago....while i floored it on highway, i only reached 40, when let off gas, car came to a quick stop. later i jacked up rear and was able to turn back tires to rule out e-brake being stuck,when car is in nuetral and pushed (forward or backward) it comes to a stop whithin a foot or so ( it seemed like the brakes were being depressed) possible transmission or brake issue?
View 2 RepliesI have a 94 Celica 2.2. I'm having issues with power steering fluid leaking from reservoir cap. I replaced the cap due to the old ones seal had dry rotted and dip stick was broke off, also replaced the 2 small short hoses and new clamps. The return hose is working right and the high pressure hose seems to be working right. None of the hoses are leaking but pressure is building up and pushing fluid out the reservoir cap. What else could be the problem to cause this??
View 14 RepliesI've a problem with my 2000 Nissan Maxima GLE. Recently I started hearing noise from Passenger side of the car, and I noticed that the Power Steering Fluid Reservoir is almost empty. Looking more closely, I see some kind of leak. Could this problem indicate something wrong with the Rack and Pinion or the Pump itself.
I went to autozone today, and bought a Power Steering Fluid with Stop Leak. I added the liquid, and turned Steering Wheel to the right and the left. After doing this, I checked the reservoir again, and I saw the reservoir level was very low again. I repeated the above steps until I reached the point where the reservoir level was to the high point.
I would drive for couple of days and see if the reservoir level goes down again which point to leak still existing. While waiting on this test, thinking what could have gone wrong here that is causing the Power Steering fluid to leak. I've also attached the picture which point to suspected point of leak.
I own a 2009 Corolla. Cannot locate where the power steering fluid reservoir is. I googled and also looked under the hood, no luck.
View 6 RepliesI have an issue with my 2004 GLS 3.5 L w/ 68000 miles. After the SUV warms up for a few minutes I can hear a whine or rattle on the passenger side. I noticed a little power steering fluid leaked out the top of the reservoir (a few little bubbles in the oil). Then reading on the HMA website it says the filter in the reservoir can get clogged and restrict the flow. I took the reservoir off and flushed it out then replaced with new oil.
Unfortunately this did not fix the issue the noise is still there. It's most prevalent when you turn but the noise also picks up a little when you hit the gas. I have checked for hose leaks but cannot find one. My next step is to have the steering pump changed out. While the mechanics in there I am going to have him check the hoses/pulleys really close and look around for another leaks anywhere. Noise is annoying but the steering works fine.
2000 Honda Accord. Power steering fluid is coming up and out of the reservoir when the car is shut off. I recently had to take the hose off and move it out of the way just to make it easier to replace the belt. Lost some fluid and put more back in. And now this. Also is whining when you turn the steering wheel. What do I do?
View 7 Replies2.7 Power Steering Fluid boiling/foaming leaking out a reservoir cap!
1) Recently had Timing Belt/Water Pump and spark plugs/wires replaced.
2) Issue started immediately after.
3) Removed most of old PS fluid, cleaned out reservoir w/brake cleaner. NOTE: nothing appeared to be clogging reservoir. Refilled with new PS fluid. Repeated these steps a second time. This appeared to immediately resolve the issues for several weeks.
4) Now the power steering is getting rough and noisy again. Also, the PS reservoir is leaking out of the cap worse than before. It looks like the fluid may be "boiling", but it is definitely foaming up pretty badly.
What my issue(s) may be?
I am trying to remove the engine cover on the passenger side of the engine bay so that I can access the power steering fluid reservoir. What is the procedure for removing the plastic clips, rivets or whatever they are and also how do you reinstall them? This is a hair brained design if I ever saw one!
View 14 RepliesI have a 2004 Santa Fe 3.5L with 85K miles. TB, WP and all belts changed at 75K. Have had this whine noise when I turn right, very high pitch noise. On top of this there is now Power Steering fluid leaking from the reservoir and base and brackets are full of fluid... Needless to say I assume it is the reservoir seals giving up but why the noise only when I turn right? No noise when I turn left.
What could it be? Also where can I find parts online that are cheaper than the stealership? I called them and they quoted me $72.00 for this piece of plastic!!
What else should I change? There is also some "oil/fluid" coming down a pressure hose but I believe this is due to the oil dripping from the reservoir...
Any manuals I could use to view this? I bought the Haynes manual and it's worthless!
2005 Santa Fe (88K, 2.7 V6).
For a month or two, after the car got warmed up, I'd hear a whine/hum noise when I slowed to turn or reduced speed. The noise was much more noticeable when the car had been running at least 15-20 minutes, but I did occasionally hear it when the car was somewhat cool still. Never had a problem steering during this time, even with the noise... but I eventually figured out that slowing down and/or turning brought it on. So I took it to a mechanic.
They showed me bubbles coming from the power steering reservoir, and said I needed a new PS pump and pressure hose, along with a flush/new fluid. I paid for all of that.
Next day: The car would become hard to turn when I made a tight turn into a parking spot... again, not a constant thing, but only when turning to park and going slow. The noise APPEARED to be gone, but this new issue worried me so I took it back. They put a different pump on (no charge), thinking the other may have been defective.
Next Day: I hear the whine again on my way home from work. When I get home, I park, leave it running, and pop the hood. There's a fast drip bubbling from beneath the reservoir cap and running down to the pavement. First thing the next morning I return to mechanic. He says the first two pumps were the same brand and both "remanufactured" so he switches to a different brand -- this one brand new, not "remanufactured" -- and installs that one.
A half hour later, I get home. Hearing that same whine/hum, I lift the hood. Fluid is pouring out from beneath the cap in a steady, unbroken stream (not a drip, but a stream). So I took it back to the mechanic (who to his credit, has charged me nothing since the initial new pump installation). What could cause the power steering fluid to gush out from the reservoir cap when the car gets hot? I have a brand new pump and pressure hose. What could cause this condition..
I have a 2010 F150 4.6 3V... The power steering reservoir is constantly losing fluid. I've purchased the truck,used, a few months ago, bought a warranty. The dealership has had it multiple times now and can't find the leak. They just keep replacing hoses and the problem keeps occurring. Also worth noting, the truck has 6" lift with 35s. I've have also pulled the radiator cap and found a decent amount of what looks to be sludge/oil inside. Dealership says it's probably just bad coolant.
View 1 RepliesMy truck had a slight vibration at idle today and what i noticed the most was i was looking at the top of the motor and i noticed that the fluid in the power steering reservoir was shaking back and forth like i was shaking the container. Is this from the vibration or is the power steering system vibrating. I have had this truck for two weeks and it has 135k on it. It is the 5.4 motor...
View 1 RepliesI lost my power steering on the way home from work today (40 mile commute). Stopped at a gas station half way. About 5 miles after noticing the problem. Lifted the hood and noticed fluid along the line towards the radiator. Reservoir was empty. So I added a quart just purchased from the station and noticed the fluid level immediately began to drop. Decided to finish commute home. Stopped after 10 more miles, reservoir was empty so I added another quart and finished the drive home.
My camry has 150k miles so I am not surprised. So I parked it at my house and looked under the hood/car, I definitely have one hose leaking in the engine area. It is the hose located near the radiator on the passenger side that comes from the reservoir. The "U" portion is metal and has corroded away. It spits fluid when the steering wheel is turned. The pump actually is pretty clean with no leaks from it.
But when I was underneath the car, there is a hose completely severed. Roughly 2inches of exposed hose before it disappears into a manufactured hole in the car floor with a rubber gasket around it to hold in place. Where this hose is supposed to connect too. It drips P/S fluid, but nothing changed when turning the steering wheel.
So the big rubber hose attached to my power steering reservoir is leaking and my mechanic told me to replace it. I went to a couple of different Autozone stores and they both couldn't identify the correct dimensions of it. They told me to take it out and then bring it to them. This is very hard for me since this is my only car and how to pull the bottom bit of the hose out from whatever it's attached to.
I've measured the length to be about 2.4 feet but I'm not sure on how thick it is. I've taken a pic of the hose here:
2010 camry LE
A family member did a tune up on the car and did not realize that the power steering reservoir had a HOT and COLD min/max lines. He filled up to the max line for HOT while the car was completely cold. He also filled up with Prestone Power Steering fluid with Stop Leak instead of ATF/DEXIII.
The car was driven a few times for maybe 50 miles in total before I found out about all this and I drained the fluid out to the appropriate levels. However the steering at low/parking speeds is still very tight (tighter than what I used to remember, at least).
Did he royally screw up the power steering system here? What can I do?
The steering fluid pump reservoir has a leak ive been told by my trusted mechanic. The first bout of cold below freezing weather, the steering fluid drains out and I have to refill it. After refilling, I'll have to fill it again in a few days sometimes lasts a few weeks. Might not have the car for much longer. How to cope with this rather than get a (expensive I was told) new steering pump.
View 2 RepliesI need to replace the power steering hose because my power steering fluid is leaking. Is this the right part? [URL] .....
View 14 RepliesThe Power Steering Reservoir has a small leak that makes the area under it looks oily and messy, so i followed a member's DIY PS flush, I used Walmart Supertech ATF Dexll/lll fluid but now I am thinking about using Mobil1 Synthetic ATF once I get the reservoir out.
The new red color shoes the leak is coming from the edge of the connection between the top and bottom plastic parts of the reservoir.
so my questions are:
1- How do i remove/pry or pop the reservoir out of its bracket?
2- Can i use JB Weld epoxy to glue/reinforce them parts together or just pick a used one from junkyard?
and last question: What size ID/OD is the PS fluid low pressure hose?