How to disable or completely take out the steering wheel lock. The part where the gear goes into the disk to lock the steering wheel into place. I heard it was simple and yes I have been looking around but I still can't seem to figure it out.
View 10 RepliesI just changed the power steering fluid for likely the first time on my 2007 Camry 2.4L with 76k. Put in Maxlife. I noticed when the engine is running that there is a slight... buzzing sound... when the wheel hits the lock in either direction. Everything else is fine and no leaks are present. Im not sure if it has always existed and I only noticed it now because I was listening for irregular sounds, or if it is something new.
Everything else seems fine and the sound only occurs at lock. And it is minimal, but there if you listen for it.
Today my car came back from service, now when I reverse park I get this display where when you move the steering wheel you can choose the spot you park in. Before I was just happy reverse parking my car myself and get a different display showing me the back view with with green and red lines I think where the car is moving towards etc. I can't figure out how to disable this steering wheel park assist.
View 1 Replies2012 Camry LE. When I am already talking to someone using the Bluetooth and another call comes in, I get a Caller ID pop-up on the screen along with a green phone and a red phone. Neither button does anything. There doesn't seem to be any way to switch to the second call. I can't even end the first call. It's as if that second call has disabled all functionality of the screen and steering wheel buttons.
View 12 RepliesMy car used to vibrate at a speeds above 50mph and I took it to NTB for wheel balancing. They did the balancing and when I first drove, the steering wheel was wobbling very badly and the wheel is stiffer than previously, Also the car is drifting to the right which did not happen previously. They said they didn't do anything other than balancing and reducing the tire pressure. They also gave me a quote for 2300 $ for the services to be done (many services shown there were done a month back..!!!). Then I took it to another NTB for alignment and they did the alignment first time and problem not solved. I took it the second time, they said toe was little off and they fixed it.! The problem is still not fixed and then I took it the third time and this time I got the car the TPMS was on.!!!!
View 4 RepliesFor a 2011 Camry, how can the automatic door locks (shifting to park/unpark be disabled?
View 1 RepliesI'm having problem on my camry 07 lights I checked the fuses under the good and under the steering wheel but everything seem fine...
View 4 RepliesMy 2007 Camry makes clunking noises when I turn the steering wheel to the left mostly. This happens most often when the weather is warm and hot but not during the winter time.
The noise seems to come only from around the steering wheel area inside my vehicle. Hence, I don't think it has to do with the CV Joints or anything like that but the steering wheel unit.
Lately my 2007 Camry (2.4 L, Auto) has developed a bit strange problem. When I'm driving on highway, even slight left turn results in a grinding noise and sort of resistant steering wheel. It happens only when I turn left. As soon as steering wheel gets back to straight, the noise and steering wheel resistance/hardness goes away. I don't really feel much when I'm driving slow on the city streets. Although some time when I am little bit fast, I feel slight grinding noise and steering hardness. No problem in turning right at all.
View 5 RepliesIs there a button, function etc that will allow me to disable the telescopic steering wheel tilt-away feature ? I would rather not have the steering wheel move every time I insert/remove the key. LX570 2014 ..
View 8 Replies2007 camry le with 85k miles, there is a bad vibration in the front end, the steering wheel rocks, and when you turn right or left at slow speeds there is one knock, not a clicking, just one knock, also noticed the front driver side wheel has heavy wear on the outside corner of the tire, cv joint, bearings...
View 3 RepliesFor the past few months when the vehicle is cold (by "cold" I dont mean physically cold, just mean it has been sitting all night in my driveway and it's still 90+ degrees outside) and I start driving, I seem to have this shimmy or shake in the tires/steering/steering wheel. Once my car seems to "warm up" (driving a mile or two) it goes away and my car is extremely smooth.
Could it be tires (I've tried rotating)? Suspension? Wheel bearings? I'm lost for even imagining what it could be. I don't believe it is engine/trans related, as it idles/revs just fine and shift perfectly...
Today I am getting a "squeaking rubber" sound coming inside the car from the steering wheel when its turned. Not from under the hood! We had a sudden temperature drop over night but this has never happened before. Car has over 180K on it. Power steering fluid is between the lines. I don't see any plastic that is rubbing.
View 2 RepliesOn my '88 Ranger, there is the key lock that needs to be pressed to remove the key. When I changed the ignition cylinder, I darn near went ahead and removed it. I though I better check here first, and see if I was going to disable some other function I don't know about.
View 1 RepliesMy son's Intrigue had an issue with the steering rack, and it was replaced. I noticed that the steering wheel didn't lock when the problem occurred and even though the rack was replaced, it still isn't locking. If the ignition were in the column, then I would suspect that the cylinder needed to be replaced, but it's in the dash.
View 5 RepliesI wear seatbelts and make sure passengers wear them too while driving. However, many times I keep heavy boxes on the passenger side seat...
And I am sure you all know how irritating that warning sound is (for 24 secs)
How do i disable it in 2007 Toyota Camry LE ?
I get in my car this morning, start it and in my MFI for a brief second or two, it flashes Wheel Lock Malfunction, going to do a vagcom scan after work. But sure enough, my steering column no longer locks.
View 3 RepliesWell, up until a week ago, I had a 2013 GS F sport, and I believe that the steering wheel on that car was able to lock in a perfectly centered position when parked and turning the vehicle off (and then opening the door and moving the wheel slightly so that it clicked).
However, I just picked up a 2015 F sport last week and am finding that its steering wheel will only click into its locked position at about 10-15 degrees to the left or right of center (a little before the 11 or 1 o'clock positions, respectively). It does this, despite the fact that I park the car and open the door while the steering wheel is perfectly centered. I must then turn it those extra degrees before it clicks and it then stays off-center.
Shouldn't the steering wheel on my new car be able to lock on the center position? Or am I just imagining that my 2013 was able to do this? The steering itself seems to be fine, but just want to make sure nothing is wrong here.
since the cooler weather, i have noticed a short squeal on start after sitting for a while and a squeal when i turn the steering wheel to full lock either direction. question, is the squeal at full lock normal for our cars?
another question, when adjusting the ps belt, do you all use a tool to put tension on the belt till you tighten it or do you just pull back with your hand? I am thinking and hoping the belt just needs a tad more tension on it.
i replaced belts about 2 months ago with gates brand- replaced originals with 30k miles on them. I had squeaking before while running which the belt change fixed.
I have an 02 Elantra GT. I was dropping off a friend who knows cars and went to turn around, turned the wheel to full lock to make the turn and heard a squeal. I asked my friend what it was and he said it was the P/S and I just needed to add some P/S fluid. I got some fluid and sure enough when I went to fill up the reservoir it was below to MIN line, not too much below but still below it. I filled up the fluid and didn't hear the problem for the rest of the day but this morning I heard the same noise when I was leaving for work. I figured the fluid had to work its way though but am not sure if there is something else I should check or do.
View 3 RepliesI purchased a 2001 Ford Focus 7/17 from a Ford dealer. While my daughter was driving, at a left turn, the engine light came on, the car stalled, and the steering wheel and gas pedal locked up. A friend did a computer scan and said the code came back that 2 sensors, the crank shaft and cam shaft sensors, needed replaced. So we had them replaced.
About 4 days later, while driving home from school, on a right turn, the car broke down again on my daughter. She said the symptoms were the same, engine light came on, car stalled, the steering wheel and gas pedal locked up. So we had it towed to a local Ford service department. They said the ignition coils needed replaced and the valve cover gasket would eventually need replaced (per the mechanic, this wasn't directly related to the issue but a small leakage was found). So we let the Ford mechanic replace the coils and the valve gasket cover. They ran several tests and put 20 additional miles on the car without failures or issues, scans came up clean.
So while driving to school this morning, on a u-turn, my daughter experienced the issue again....car stalled, engine light came on, steering wheel and gas pedal locked up. After sitting a few minutes, the car started up so she drove it home and hitched a ride from dad to get to school.