Camry :: 2007 - How To Change Headlight Ballast
Aug 30, 2013
Steps or pictures to show how to change the headlight ballast on 2007 Toyota Solara....
View 6 RepliesSteps or pictures to show how to change the headlight ballast on 2007 Toyota Solara....
View 6 RepliesI have an 07 Prius and the headlights started going out so I bought new HID D4R bulbs and they do the same thing. I want to replace the ballasts. How to do this? Any thing special about it?
View 1 RepliesSo I started having the issue with my drivers side headlight going out and saw the many threads regarding issues with the bulbs and ballast.
I started out purchasing a new bulb, from ebay TOYOTA PRIUS GENIUNE PART PHILIPS D4R 42406 XENON HID HEADLIGHT LIGHT LAMP OEM
Came in "Toyota" box. Got the bulb in and still had issues with the light turning off... so then I bought the after market ballast and replaced it yesterday. Light still going off.... What to check? Just read the article regarding bulbs, going to pull out the one I just got and have a better look at it.... Not all HID Bulbs are created equal.
So I recently got a 9006 8000k HID Kit off of E - bay and I'm planning on installing it in place of the stock HIDs. However , I just realized that the stock HIDs have a D4S ballast and connector which do not fit the 9006 HID kit that I just got.
So should I remove the old D4S ballast and put in the new kit, or buy D4S bulbs that fit the stock ballast ? Also, the driver side headlight is flickering and goes out at times so I don't know if the stock ballast is acting up.
I have a 07 Camry LE and I just realized my passenger side headlight is dim. I changed the bulb but still the same. Check the fuse and it's fine. I search through the web and it might be a bad ground. What might cause this or the location of the headlight ground?
View 2 RepliesI'm trying to replace my dads 2007 Camry XLE japan built headlight assembly because his are insanely oxidized. Besides OEM's and CAPA's, what else are there? Any good aftermarket headlight assembly and achieve great results?
View 8 RepliesI have a couple of questions regarding changing out my headlight from halogen bulbs to an HID kit.
1st) What size bulb are the low beam (headlights)?
2nd) What HID kit would be recommended? I am trying to replace the halogen bulb with an HID bulb, a plug and play HID kit that will last but also does not reflect every where such as replacing reflectors with halogen to an HID kit.
It appears that after you unsnap the three clips you have to loosen the clamp between the air cleaner box and the intake manifold and separate the air box top from the rubber tube before you can access the air filter. However there appears to be hinges on the back of the air filter box that gave the impression that after you unsnap the three clips you can open the lid.
I have not found any step by step instructions to tell me the correct steps to perform to access the air filter
Original owner of a 2007 Toyota Camry XLE with 96,000 miles. Here's my problem.
Right about a month after I bought the car, I noticed that the car would jump/speed up suddenly when the car changed from 2nd to 3rd gear. Here are some additional symptoms of the problem.
-This only appears to happen when the car is shifting these gears for the first time of the trip. All other times of the same trip, the gears change finely.
-During the first few years of owning the car, this problem only happened when the outside temperature was cold. It wouldn't happen in the summer time.
-Over the years, the problem appears to be independent of temperature
-This problem hasn't caused me to make any repairs to the car and the car runs without problems.
-I'd like to understand what the problem may be so that it doesn't get worse. It seems like it's getting worse and more noticeable.
I have a 07 camry I4 with 56,900+ miles and it was using 10w30 conventional oil, but recently (2 weeks ago) I change it to 5w30 Mobil1 synthetic and today notice at start up white smoke, it didn't do this before with the conventional oil.
Is this normal with this type of change from conventional to synthetic or should I worry and try to go back to conventional and see if it stop.
I have a 4-cyl 2007 Camry XLE. I changed out the plugs, simple enough. but now the car seems to be idling too low, just a tick below 500 RPM. Its causing some minor vibrations as also the AC is not working at a stop, it just blow warm air. As soon as i push on the gas the RPM jerk up pretty sudden, the air pressure from the vents increases and its cooler. So it seems the AC issues is related to the RPM being too low so once i get the RPM's back up it should be good to go.
These are the stock Denzo SK20R11 plugs that were in the car : [URL] ....
And these are the equivalent NGK IFR6T11 plugs i put in [URL] .....
So, I thought maybe because the ECU got reset maybe some re-calibration, but I have driven a good 100 miles on it and no change so i doubt that's it.
I have a 07 Camry XLE. My previous battery started dying on me so I changed to an Optima Yellowtop battery. Next day the check engine light came on, and sometimes while idle the car starts stalling, it never turns off though just that the RPM goes really low and the acceleration is really slow and it feels like the car is having trouble accelerating. Today it happened again but I was over 60MPH and hitting the gas pedal and it seemed to stop accelerating a few times.
View 2 RepliesI recently did an oil change on my wife's 4 cylinder 2007 Toyota Camry which has about 126.5k miles so i was suggested at Autozone to use synthetic 10w30 instead of the conventional 5w20 they put at the shop when my wife gets an oil change. So i did a oil flush and did the oil change with the new synthetic 10w30 and now the Camry feels really heavy and has difficulty accelerating at first. It also makes a really loud squealing noise (like when your breaks are bad) when it first accelerates. Should I go back to conventional 5w20 even tho it has so many miles? Is there anything else wrong that i should get checked?
View 14 RepliesHow do you change the headlight on a 2010 Malibu...
View 14 Replies2004 W12 Phaeton ... I remove the Air Filter cover and filter, I am not sure if the round fixture on the Air Filter housing is the headlight fixture or how to remove and replace it. I am able to move it inward and outward, but not able to remove. should I remove the Air Filter housing to get to the bulb??
View 5 RepliesSo I bought a set of Phillips XTreme Vision bulbs for my GTI VII S. Problem is that I cant seem to open the rear housing of the headlight on the drivers side to gain access to make the switch. The gearbox is right behind and there is barely room to get my hand back there. Is there some trick I am overlooking?
View 3 RepliesI am lost on how to change the headlight bulb on my girlfriends 2001 passat. I am wondering do i need to pull the whole headlight out to do it?? or just take the bulb out.
View 8 RepliesOn the gen III Prius the owner's manual states that the delay for the car to automatically turn off the headlights can be changed from the default of 30 seconds to 60, 90 or zero.
View 8 RepliesSo on the way home tonight my passenger side bulb went out. No big deal, I pull into the auto store and pick up a set of new bulbs. The problem is now that the light that went out is not working at all. I replaced it and reset the bulb to make sure it is tightly connected and nothing. Next I try the other working bulb in the passenger socket and still nothing. All other lights work. City bulb, high beam and turn signal works in the housing.
View 3 RepliesI've got a 2010 GTI with xenons, fogs are vag'd to turn on at low speed and when the turn signal comes on. Now there's a loud noise shortly after driving. Go to turn at low speed and noise can be heard and message comes on to check low beam light. Headlight, fog and turn signal are all affected at the same time especially if I'm stopped at a light with turn signal on. Talked to a friend that's a tech at VW and he said its most likely the ballast and when I talked to him and his parts guys they had never replaced one.
View 2 RepliesI have installed an HID kit into my Passat, however once in a while, I get a problem where the left hid will not start, so I have to shut lights to off position, and then back to AUTO, and then both turn on. Sometimes both turn on, sometimes only right turns on start-up, however, if I manually turn them off and back on, they always turn on. It is strange, but I am not sure why it is doing this...possibly a bad ballast or bulb? I have relay harness, so I don't think it should be a wiring problem.
View 5 Replies