Camry :: 2007 - DRL And High Beam Aren't Working
Oct 21, 2012
Where's the fuse for the DRL ...both my DRL and high beam isn't working ...I checked the bulb and is seem fine. I did check the fuse box on both locations ( under the hood and steering wheel) none of them says DRL fuse in there ...
View 14 Replies
Advertisement
This morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
View 4 Replies
I have an 07 with the AFS lighting. bulb error on dash- as I understand it, this has to do with a faulty shield for the high beam on the passenger side. Can this be repaired? Or should I just shell out the 300 for a used one on ebay.
View 3 Replies
I have a 2011 Camry XLE. My left high beam is not working not even for DRLs... I have replaced the bulbs and this is not the case.
View 3 Replies
I have a 2007 Camry SE V6 and noticed that my high beam/DRL won't turn off even when the car is off. I had to take out the fuses for both so it wouldn't drain my batteries. Its the exact same issue as the OP in this thread:
High Beam Headlights Stuck On. Is it a relay issue or switch?
View 1 Replies
My hight beam went off and doesn't work anymore ..my fuse box is the problem and i dont want to replace it cuz its too expensive maybe a chip inside not work right and in my car when i switch the gear to d the hight beam turns on On 6 volts day and night . Now its doesn't work ether the 6 or 12 volts .. How to fix it?
View 2 Replies
I have an '06 Camry, which has lost all power functionality. The follow items just stopped working
1. Key fob -- keyless entry and alarm stopped working
2. high beam doesn't come on when headlight is on. However, when headlight is off, it comes on--go figure
3. Power door lock also does not work, even from driver side door. Have to lock all doors manually
4. Interior lights don't come on when door is open.
View 4 Replies
I've ran into an issue with my high beams on my 07 Camry SE. All lights are working except high beams. When you switch to high beams the lows only stay on. The dash light comes on and shows high beam indicator, but no brights! Fuses look good, and so do both bulbs. Going to go buy a bulb later today just to try. Like I noted they both just suddenly stopped. I'm leaning towards dimmer switch on column now.
View 11 Replies
I have 2000 golf with a gli front end. Recently just did the swap and now I'm having issues with one blinker and one high beam not working. The running lights work on both sides. The headlights work on both sides. I checked the bulbs and they were good. I check for power it was all good. I checked the fuses and they were fine.
View 7 Replies
My high beam doesnt work. I have a Euro Passat with H7. I bought new H7 yesterday but still no luck.
I have switched fuses to new ones.
Is there anything else I can check?
Is there relays on this model for the high beams?
Low beams works fine and everything else in lights.
View 4 Replies
My high beam indicator in my dash is not working, I pulled the bulb and checked it and it is fine, so I did a voltage test and I am only getting 1.5 volts at the light terminals, I should be getting 12 volts. Is there a wiring diagram someone has so i can see if it is the dash display itself or that I could trace back to the switch to see if it is something in the headlight switch? or What it could possibly be. other than that, everything else works.
View 3 Replies
So, last night I go to turn on the high beams on my 2002 Passat (pushing the bar on the left of the steering column forward) ... and nothing happens. The bar clicks into place as it should, but no high beams. The little indicator light on the dashboard does not come on, either.
I try to flash my high beams, and that DOES work. The brights come on, and the little indicator lights up when the beams engage.
So ... I know it's not a fuse, since the lights are actually functioning. What part/switch/relay/whatever needs to be replaced to get this fixed? I feel like this would involve me needing to pull apart the mechanism in the steering column, but I hope not ...
View 3 Replies
Wanted to change my stock yellow high beam (DRL) bulb to an LED bulb i bought from jdmtoys I also changed the parking light to LED and it works perfectly, so after changing the high beam bulbs it worked for few seconds then stopped working... I put back the stock high beam bulbs and it still is not working did i blow a fuse or something? Now when I turn the high beam on my headlight turns on instead of the high beam....
This is the bulb i purchased : [URL] .....
View 14 Replies
I added plow lights to my truck and something quit when I had the high beams all on at once. All 4 shut off. Low beams still working. What I fried or where to check? Its a 99 F250 superduty.
View 14 Replies
I am planning to replace the headlight (high beam) light of my 2006 Toyota Camry. The original OEM light lasted for nearly 6/7 years.
I noticed in some forum that "Sylvania 9005SU SilverStar Ultra High Performance Headlight Bulbs" is good, but it has short life of less than 1 year.
View 9 Replies
2011 f350 king ranch... I have DRL, turn signals and tail lights. I have checked all fuses ( don't know if there's a relay) under hood and in cab. Still do not have any headlights, high or low beam nor do I have any fog Lights.
View 5 Replies
Just discovered that both high beams are not working. Regular lights ok. When switch to high beam both go off. I know some bulbs have two filaments, is this the case for this car? Are the bulbs burnt out or something else is wrong?
This is a 2007 Jeep Wrangler Rubicon Unlimited.
View 11 Replies
My car is fully stock, with all options available to me (cold weather package not available here). The low-beam triple-LED headlights are aimed way too low compared to all my previous cars, and where they should be. BUT high-beam is aimed properly. So if I adjust the low-beams up, my high-beams might end up lighting up the trees, not the road.
If adjust the headlights up on a fully stock car (not lowered at the front)? Are the high beams still lighting up the road fine? And if you can be specific as the number of turns on the screwdriver, it'd be good too to have an initial adjustment reference.
View 3 Replies
I drive a 96 Subaru Legacy. What does it mean when one of the high beams is dimmer (less light output) than the low beam? I am using a brand-new bulb. It's not an adjustment issue because I was looking at the bulb when it was outside of the housing and it clearly gets dimmer when you switch to brights. However, they are equally bright when on low-beam, so I don't think its just a crossed wire.
View 2 Replies
I replaced the low beam and high beam on my Subaru, now the low beam is very dim and the high beam doesn't work. Careful not to touch the bulb.
View 3 Replies
I have a 2002 Camry. The low beam headlights stopped working last night. All the other lights work. High beam, driving lights, marker/park lights. I checked all the fuses. I changed the headlight relay. Still nothing. Could it be the headlight switch on the steering column? Trying to do more research before I replace it.
View 2 Replies