Camry :: 2007 - Code P0606 / ECM Is Bad On The Car?
Dec 19, 2015
My friend has a 07 Camry 4cyl and has code P0606, Engine control module/Powertrain control module processor. The car runs and drives good. My friend recently got the piston rings replaced about a month ago for the recall, and he told me the service light was not on when he dropped off the vehicle. After he got it back it wasn't on and just came on a few days ago. Hard to believe the ECM is bad on the car, I'm thinking it was something with the removal and install of the engine causing P0606. Does it need to be reflashed?
View 1 Replies
Advertisement
A few days ago I managed to replace the front and intermediate exhaust pipes using new hardware and new gaskets. Prior to this (see my other thread about the rusted flex line), I did get P0137, but that was probably due to the fact the pipe broke before the O2 sensor, giving it a strange reading.
Two days ago after replacing the exhaust with Dealer parts, ensuring everything was tight, and putting the old O2 sensor back, I started the vehicle up, and upon idle, there were no lights whatsoever. Today several minutes after I started driving, I received the check engine light, and with the code reader, came up with the codes P0138 and P0606.
P0138 is O2 Circuit High Voltage (Bank 1, Sensor 2), which is the sensor I removed and put back.
I assume that this sensor needs to be replaced, and I assume that this has caused the P0606 ECM code as well.
Before ordering a new sensor, is there anything else I should check? I did make sure to plug the old sensor back in properly, and checked all the connections on the exhaust to ensure they were tight. All parts were Dealer parts, and nothing else was touched, changed, or modified.
The car sounds, and drives great since the exhaust change.
View 2 Replies
So I had a P0606 code which points to a PCM/ECU fault. It would come and go and not really cause much of a problem with driving. It did stall once but it started right back up. The light would come on for half a day and go off. Rinse and repeat......
The dealer replaced it today under my extended warranty. Sure enough, the CEL returned today. I haven't had the code read but I can only assume it will be P0606 again.
View 10 Replies
The code the R threw was p0606 which is the Powertrain/ Engine control module? Where these components are in my R? Or how I can go about trouble shooting this problem?
View 9 Replies
2 weeks ago a check engine light came on with P0351-Ignition Coil "A" Primary/Secondary Circuit Malfunction, took the car to Toyota dealer and replaced ignition coil for cylinder No1. I drove the car for about 10K and check engine light came on again with P0606-PCM Processor Fault.
For the past week I was monitoring the DTC's using INNOVA- CanOBD2 Code Reader 3030 (ordered ODB2 USB tool to check live data on a laptop, on it's way...). I had P0606 on all the time, about everyday. For 3 times I had P0157-O2 Sensor Circuit Low Voltage (Bank #2 Sensor #2) on.
What's the link between the two DTC's? Why not P0157 alone? Or P0606 alone? What is the procedure to diagnose this?
View 14 Replies
My 2007 F350 6.0l DRW LARIAT battery voltage was too low to restart her while out and about today. I did notice that she seemed kind of when I started her up leaving my town to got over two towns away. So i set my Scan Gauge to check voltage and it was low considering she was running, in the low 12V range with radio and a/c running. So I figured the regulator is on it's way out but I this be able to restart her up. Anyway after a jump she started right up and I was able to get home no issues. After I jump started her the check engine icon was illuminated with DTC P0606. I'm not 100% on why this trouble code was recorded other than the fact that I tried to start her up which caused battery to fall below the 9.6V threshold to power the PCM. The voltage was still low after jumping her, so I figured i better swap in a new alternator but what kind. I hear that the alternator is an issue with this truck, so what should I get?? What alternator is proven to last on these trucks?
View 14 Replies
My 2007 Camry SE has an intermittent electrical issue. The problem started yesterday, no accidents of any time ever in the car. 195,000 miles on car.
As I was driving along the speedometer, tachometer, temp gauge all started bouncing. Simultaneously the ABS and Emergency brake light came on. The engine did not change, still drove fine. I got the code U0073. I checked a couple obvious fuses like ABS and Alternator as well as cleaning the contacts on the computer at the actuator. I've also checked my battery terminals -- fine.
I am hoping to narrow something down other than just going straight to replacing that ECU by the actuator. That is an expensive part not to be 100% sure of it, but as it stands now I would almost rather it be something "simple" like that because chasing these electrical phantoms is quite aggravating.
Also all the items I have focused are based off the assumption it is something electrical revolving around the ABS unit. Is it possible the instrument cluster is the culprit, wiring in the harness or a simple fuse related to that panel?
View 14 Replies
I have a Air Bag Light on and Code B1811 2007Camry, same thinking clock spring?
View 1 Replies
2007 camry xle 4 cylinder engine, 2.4 liter I'm getting a P2195 code, which is the A/F sensor B1 S1. I have a few questions:
1. Any diagram of the location?
2. I've been trying to figure out the correct part number, so I can search for a replacement. I've found 4 or 5 different numbers already. What is the correct part number?
3. Should I only by the OEM part? Or do the aftermarket brands like Denso work?
View 4 Replies
2007 camry 3.5q... I got my engine scanned and the code was p0057. I already replace my two oxygen sensor but the check engine light and check vsc system still on. What will i do?
View 1 Replies
My wife's car has 83000 miles on it. We bought it as a factory certified pre-owned vehicle with about 1800 miles on it and it came with the warranty. For the last two years the check engine light comes on with code 441 I don't worry about it till time to get inspection sticker here in Texas. I have been about to reset the computer and drive it till the computer is ready to be inspected and it has passed for two years. Now it won't reset and I have tried to test the vacuum switch and it seems to click when I apply voltage but light won't go off. This code can cost up to about 2000.00 to try and detect. I am not interested in having the dealership keep guessing on my dime.
View 2 Replies
P0340 code appeared on my camry 07 said cam shaft position sensor was bad what other things can be the problem ? Also I just replaced alternator because car wouldn't start with out getting jumped once I replaced alternator it started up good for a couple of days then when I wanted to start it up it would crank then stop and crank again till it would turn on also car stereo would turn off while running and dashboard gauges would go off and would make the gauges go Dow to zero then it would go back to normal while still driving.
View 1 Replies
Today my check engine light came on and the code is P0712. When I drove off from the parts store, the check engine light suddenly went off. What should I do at this point? What are the most likely problems/solutions.
View 1 Replies
I have a 2005 f250 just hit 180k last week and it has the 6.0 in it, egr deleted, sinister diesel oil cooler, stc livewire tuner with street tune installed, air raid air intake. Wicked wheel 2 in the turbo. Its throwing codes P0606 and P0341. Cam sensor has been replaced and the other code is a mystery to me. Its been randomly shutting off like you turned off the ignition all day today.
When it stalls it takes 3-4 times to get it fire back up. When you first go to start it the pressure gauge reads 0 but once it fires up it says theres pressure. Also some of the days it never stalls and runs like a champ but other days i cant drive more the 10 feet and then it stalls. I have no idea whats going on with this truck and ive put lots of money into it doing customization and stuff like that so I am hoping that its not on its last leg....
View 11 Replies
I have a 07 Sonata V6 that misses only when warmed up, runs fine when cold. code p0301 for cylinder one misfire, I have replaced the plug, coil and injector for cylinder one and still the same. idles and runs perfect when cold, dead miss on number one cylinder when warmed up.
View 1 Replies
Check engine like on my 03 Camry with 2.4L is own & got an OBD code of P0031. Just bought the car with 38k miles one owner & can't pass local emissions.
View 10 Replies
Like it says, 2007 Ltd. Recently swapped the alternator and changed the fuel sending units. Had a CEL previous for the fuel gauge not working. Fuel gauge works fine now. Had a CEL with no code being thrown? What could it possibly be? I need to get her past smog here soon.
View 10 Replies
I recently had a CEL code for bank 2 cat converter.. I drove the car with the CEL for 8 months and one day the VSC and TRAC OFF light popped on and wouldn't go away. I took it to toyota and they told me that it is because the check engine light is on and once the CEL goes off the others should as well. Well i recently replaced the bank 2 cat and cleared the CEL and iv driven over 300 miles already the CEL has not come back on but the VSC and TRAC OFF light remain ON....
View 2 Replies
I have a 98 camry 4 cyl and am continually getting egr code po401. I've cleaned out and tested egr, replaced modulator and the vac switching valve. Replaced several hoses also. Car runs fine, in fact this code came the day after traveling 700 miles. It comes back on fairly quickly after properly resetting computer and 1 or 2 drives.
View 3 Replies
I recently purchase camry 09 and when I did the computer for the car it returns me P0012 and C0205 errors. I have searched for P0012 error and got an idea to check the oil control valve. but for C0205, what exactly I have to check for?
View 2 Replies
My 2009 Camry came down with the p0157 code which I looked up & is oxygen sensor circuit, low voltage bank 2 sensor 2. I'm trying to figure out which side this is(driver or passenger)? Also have a p0430 code-catalyst system efficiency below threshold.
View 2 Replies
