Camry :: 2007 - Changing Out Headlight From Halogen Bulbs To HID Kit
Jul 20, 2012
I have a couple of questions regarding changing out my headlight from halogen bulbs to an HID kit.
1st) What size bulb are the low beam (headlights)?
2nd) What HID kit would be recommended? I am trying to replace the halogen bulb with an HID bulb, a plug and play HID kit that will last but also does not reflect every where such as replacing reflectors with halogen to an HID kit.
View 1 Replies
Advertisement
I have a 2007 GS 430, 126,000 miles. Initially I had one faulty headlight that would not work but after turning the switch off/on, it would work again. Eventually both headlights started malfunctioning. After reading other forums, we elected to change the headlight bulbs. So far that has worked. However, after changing the bulbs, the VSC (Vehicle Stability Control) and check engine lights came on. After running the headlights and using the car to go to/from work with about 4 stops and restarts, the car reset itself and the warning lights turned off. Scared me at first because I had also just had suspension work done. However, the Headlamp Level Control System is part of the VSC system, which makes sense, just wasn't prepared for the warning lights.
View 1 Replies
I changed my headlight bulbs yesterday with D4S bulbs with 12K purple. After driving about an hour, the dash popped up a message saying headlight system failure, have dealer check headlight system. Both headlights are still on. I'm wondering why it is doing that? Hate to go back in and change it out again. It was a pita to change the bulbs.
View 2 Replies
Looking for a rundown on LED versus halogen headlight bulbs, especially output and life? Stock halogen bulbs using 55 watts have a 4000K output, and I notice the Chinese imports' output is 3200-3500K. Does that translate into less bright? Also, the windshield wipers shudder across the windshield a lot unless there's a huge amount of rain--changing to new blades didn't make any difference.
View 5 Replies
Is this any easier in my 2004 VW Passat than it was in my 2001 VW Jetta? In the Jetta, I had to disconnect the battery and dislocate my elbow and wrist in order to get my hand in the awkwardly placed compartment. Also, is it worth stepping up the original OEM to high intensity bulbs?
View 11 Replies
So I think someone reset the headlights on my r32 with a different setting (previous owner) The h7 halogen bulbs do not come on while your driving regardless of the position of the light switch. was wondering is it possible to get a euro switch and program those H7 to be a fog light? I plan on doing a lot of winter driving when the time comes and having a set of yellow fogs support a ton.
View 6 Replies
My friend with a 2007 SC430 has been having weird electrical issues for the past few years. He's owned the car about 6 years now, and probably 3 or 4 years ago things seem to have started acting up:
- the car burns out headlight and foglight bulbs very often, usually after less than a year since they are replaced. It hasn't mattered if the replacements he tries are OEM Lexus or aftermarket, they burn out within a year or so - sometimes within only a few months. He previously owned a 2002 SC430 for about 4 years and never had to replace any bulbs. On the 07, it's usually always one of the driver's side bulbs that will go first, and then within a month or two the passenger's side goes. Sometimes a headlight goes, then the foglight on the same or opposite side goes. Other times a fog goes out and a short time later the headlight on that side goes out.
- his driver's seat heated seat stopped working earlier last year. First the "bottom" stopped working, then a few weeks later the "back" section stopped too. Lexus diagnosed blown heating elements, which can't be replaced without replacing the entire section of the seat. So he found a complete seat from a wrecker and swapped it in. Everything worked fine for about 3 months, and now he is back to no heated seat again (this time both the back and bottom sections stopped working at the same time)
A Lexus dealer spent 4 hours "diagnosing" the car and came back saying all electrical systems are normal, so they can't say why the bulbs are always burning out or why two different seats have stopped working. The car is getting up there in mileage (closing in on 200K miles) but has always been properly maintained.
View 5 Replies
I have an '06 Toyota Avalon XL and I bought some Silver Star 9006 bulbs at AZ the other night, but when I got back home, pulled into the garage and popped the hood, I was amazed at how much of a PITA it looked to remove the low-beam bulb, especially on the driver's side. I'd hate to take it to the dealer just to get the frickin headlight bulbs changed.
View 2 Replies
So I bought a set of Phillips XTreme Vision bulbs for my GTI VII S. Problem is that I cant seem to open the rear housing of the headlight on the drivers side to gain access to make the switch. The gearbox is right behind and there is barely room to get my hand back there. Is there some trick I am overlooking?
View 3 Replies
My husband is rebuilding our 07 Prius that has HID Headlights that were both broken and does not want to go back with HID due to cost. He wants to install complete Halogen Headlight assemblies from our parts car. He has rebuilt several Prius' for friends and family but has not done a change like this so he understands the basic differences but is stuck on the Wiring change to handle the low and high beam differences. Wiring is not his strong point!
View 19 Replies
I have a 2008 Prius pkg 6, passenger side headlight goes out, and then later comes back on. Went to parts store and they sold me a lamp to replace it with. Not only do I not know how to replace it, I do not know whether it is a Halogen or HID lamp?
View 10 Replies
Well one of the bulbs in my regular halogen housings went out, so I went and bought a pair and replaced the bulbs. Everything was great until I took a testdrive and noticed I was signalling MIR (or I guess the ISS this millenium) illuminating road signs very well, and the ground not so well...
View 2 Replies
I finally purchased an RX30 for my wife. The Halogen headlight isn't all that bad, but I am used to drive with HID. Therefore, I am buying HID kits for my RX350 Headlight. Whenever it is shipped to me, I will take pictures of the progress.
1/ Link to buy HID kits, OEM is 55W (no need for extra Hardnes) and 6000k is common factory color.
This will come with everything needed to convert your light bulbs into HID white colors. For more Colors please check out the guide on the website.
I recommend this site, because I have used it, purchased it, and have had no problem with it so far.
2/ According to Manual Book
****Low Beam is H11****
Fog Lights is *****H11*****
****High Beam is H9*****
**** 55W *****
3/ The installation should be Relatively Easy
--Take off engine plastic cover on both side--
--Access the Light Bulb--
--Use the OEM Plugs into the Ballasts input of the HID KID--
--Mount the Ballasts at a convenience locations, I had great success with Plastic ties--
--There is a Plugs output from the Ballast, Plug it into the HID Bulbs--
*****If the lights don't turn on after installation, try to switch Polary, or turn the original plugs around
****** Halogen doesn't care about Polary, but HID Ballast does.
--Install the HID Bulbs the same as regular Halogen Bulb--
--Check the HID carefully, make sure that both will work--
First time Installer common trouble shoots.
1/ Only 1 light is working......Switching the bulbs, or Polary will solve your problem
2/ Lights common for a short time then turn off, until engine restart......You will need the Hardness Relay, which should not occur in our car. The factory hardness is good for 55W
3/ Bulb Visually contain Contaminants, or White particle inside.......HID Bulbs has Special Salt in it, which is required for a longer life in the Bulbs. This is the way the bulbs are.
View 13 Replies
2007, 6.2l Yukon Denali ... Last week I had to change the headlight lamp on the passenger side. I had to remove the air filter box to get at the darned thing. I put everything back together and everything seemed to be working just fine. Except for one little detail, the gas mileage dropped from 15 to 16 mpg to about 13 to 14 mpg. This doesn't sound like much, but, when I towed our travel trailer the mileage dropped to 9 mpg (from around 13mpg before I touched anything). What I might have done to create this situation???
View 2 Replies
I want to replace my headlight bulbs; I want to install 8000K in my low beams, and maybe 3000K in my hi beams. But all of the bulbs that I ever installed either; A the burnt out within few weeks (lost color), or B they stopped working.
Now, regular WHITE bulbs seem to work forever; but the color ones, burn out/break. Low quality?? I need a pair of very good 9006 8000K, and 9005 3000K. Again, but I don't want to change them in a week or two. I want them to last!!
P.S. 2005 Toyota Camry
View 7 Replies
I got the HID kit for the fog lights of my C4 but couldn't figure out how to change the bulbs. I might get to the bulb on driver's side but it's impossible on the passenger side.
View 3 Replies
I am changing headlights taillights etc every 6 to 9 months. The dealership says it's normal. Its usually a different light but still it seems so often. Is this normal?
2007 rx 350....
View 3 Replies
I was just wondering if there was a write up on how to swap out the headlight bulbs.
View 4 Replies
I thought it would look much cooler if the front turning signal light bulbs are LED bulbs. So I bought two, took the original bulbs out and put the LED ones in. It fitted perfectly but they do not light up. Don't exactly know why but I believe it's because the poles are reversed. Is there anyway to get it working?
View 19 Replies
I have a 2006 VW Passat which has been eating low beam bulbs. I've probably replaced this one 4 times in the last 12 months. The last time I replaced was 2 days ago with a Sylvania bulb. Yesterday on my way to work it burnt out. Then on my way home last night I was pulled over by a cop for it. That really annoyed me.
Having issue with Passat burning through headlight bulbs? Do I need to have the wiring assembly checked or possibly replace the entire headlight assembly? I'm getting really tired of changing these bulbs so often.
View 7 Replies
I installed new headlights today and the headlight bulbs are not lighting. When I turn the headlight's on the high beam indicator remains lit no matter if the high beams are on or not. I should note that this style headlight has a separate bulb for low and high beams. I am skeptical that all four headlight bulbs are bad. Is it possible the wiring for the connector is not correct?
View 14 Replies