Not a huge deal, but my '06 XLE has a steering shaft clunk, I'm assuming that it's the collapsible shaft making the noise. I notice it, I don't dare mention it to my wife who drives the car. I'm at about 60K and I have read about the problem before, I was just wondering if there was ever a TSB on it.
View 8 RepliesI have a 2009 Camry 5Speed Manual and have had a noise and loud thud coming from my steering whenever i turn the wheel when I am accelerating out of first gear when disengaging the clutch and turning the wheel. For example, if I am in a parking lot and am traveling at extremely low speeds and turning the wheel while in first gear I can hear and feel a thud in the steering wheel.
View 2 RepliesTruck is 2002 2WD 4.7L Durango and around 164K
I am looking to replace the intermediate steering shaft as it making noise it seems they are common to this problem due to a weak U joint. The problem I have is I can track the correct part. Here is what I have research so far:
Have found this one 55351246AA but it says it will not fit.
Also found the Dorman 425-257 but it says is for 4WD but it reference to this OE part numbers: 55351208AA, 55351208AB, 55351246AA
Have try the Dodge parts website but that is even more confusing. I have already replace the ball joints, wheel bearings and inner and outer tie rods and this is the last part that needs to be replaced if I can track the correct one.
I've noticed lately that I have a slight clunk that I can feel through the steering wheel, normally at very low speeds as when first moving. I can sometimes feel it at higher speeds but it tends to fade into the road noise and vibration. Acts as if it is not brakes but either a u-joint in the steering column itself or ball joint or tie rod end. Car is an 07 V6 with roughly 43k miles...
View 3 RepliesOur 2012 Prius with now 17,000 miles in 8 months has developed a clunking noise when turning the steering wheel, especially far to the right at low speeds.
The first time the dealer identified it as a failed intermediate shaft and replaced it under warranty. Shortly after we told them it was starting to make the noise again, but they claimed they couldn't replicate the sound and anything they heard was normal 'linkage' (whatever that is). Shortly thereafter the clunking progressed so we took it in for now the third time, and they confirmed the problem, spoke with Toyota who said we must have had a bad part, and replaced it again.
When I was reversing back and turning the steering wheel. I heard a metal clunk sound and it had happened twice in the past two days. Today happened after I released the parking brake and set it to reverse. What is the problem? Miles on the car is ~30700 miles.
View 2 RepliesA few weeks ago I noticed a 'clunk' noise when turning the steering wheel. It only did it the first turn on a trip. Over time it has gotten worse - the sound is the same, but it happens for several turns, maybe 10 or so, before it stops. After the car sits, turned off, for a while, the cycle starts again.
I replaced the rubber coupler on the MDPS, but my old one looked fine, and it made no change in the noise.
This car has a V6 engine with 50000 miles. Nearly every time you turn the steering wheel you hear a clunk sounding noise. This has been going on for quite some time now. A mechanic said this is a common problem with this car. 2008 Pontiac G6....
View 2 RepliesI have a 2003 Camry 'SE Automatic with almost 18,000 miles - that's right, low mileage. This week the steering wheel started making squeaky noises when I turn it. It doesn't matter which way I turn, it will squeak and it doesn't happen all the time. Should I be worried and what can I do about it?
NOTE: This started happening the day after we had got an 1 or 2 of snow. That morning when I opened the door to get the brush/scraper and little snow fell in the driver's side of the car. Perhaps a little fell on the steering wheel.
I have a 2007 Sonata Ltd (63000 miles) and had a clunk in the front suspension. I had the front upper control arms replaced (which were visually badly worn) and that fixed the problem. But now, a several months later another similar clunking noise has developed when I go over those small speed bumps in parking lots.
View 18 RepliesSo when turning my steering wheel i get this croaking noise. At stand still and while driving. Its annoying the heck out of me. You can hear it in the car and outside. What it could be? Power steering fluid level is normal.
View 11 RepliesI have a UK 2006 Mk2 CDX+ which I was driving last night - seemed ok, got to our driveway, turned the steering wheel fully left so I could manoeuvre the car into the driveway when I heard a loud "clunk" noise.
I thought I ran over a bottle or something so carried on reversing, when I got out I noticed the car was parked diagonally! Thought this is strange, I don't park like that and tried again, a bit better but still not parallel! I then noticed the steering wheel was hard to turn, a grinding like noise is heard when I turned so I decided I would need to take into the local in the morning.
Started the car today and drove out and got immediate sensation that steering was not connected to the wheels, the SW was off centre by miles and turning left/right was very sluggish. Lucky the garage is only down the road (but it's not Hyundai specialist) from me as I would not risk driving it down main roads in this condition. Guy at garage asked me to fully turn the SW left to right and we can see that the front of the car actually moved during the process. He is going to take it up on the lift to look underneath.
I took my truck to an alignment shop to have him look over my truck to find a steering wheel jerk and a loud clunk noise. He believes it's in the transfer case driveline. Said to remove the driveline then drive it around and see if it goes away, if it does then that's the problem. So to the question, how to properly take this out? Do I need to make marks with a paint pen anywhere to line things back up or does it matter?
View 14 RepliesSo I was searching around online and it seems this thing happens to some ppl after lowering their cars. I'm getting a loud pop/clunk noise from the front left side only. Seems that's the most common place ppl are having this type of issue with. What it could be? My mechanic wont be able to look at it till Friday. So not sure on what to do. The sound only happens when I'm hitting bumps on the road.
View 6 RepliesI have a '13 SE that I purchased new last year and recently I've noticed a noise in my steering when I am turning the wheel at slow speeds.
It's like a clunking or knocking noise when I turn the wheel either right or left all the way. I'm totally clueless as to what could cause this sort of noises.
I have a 2002 camry and I flushed my power steering fluid today using the following procedure:
- emptied the reservoir
- connected return hose to a bucket
- added new fluid (ATF dexron III - from toyota dealer)
- jacked front wheels
- turned steering wheel side to side till new fluid came out of return line (my reservoir did get empty couple times in the process so air may have went in)
- lowered the vehicle
- reconnected the return line to reservoir
- ran the engine and turned side to side couple times (did not see bubbling and fluid level did not drop)
I took the car for test drive and noticed that my steering wheel was still making noise when turning. Also, when i was turning the wheel side to side with hood open, I noticed a change in the sound. There was a sticking sensation and steam pressure release noise when I locked the wheel on either side.What could be the problem?
Where the power steering reservoir is located on an ES 350 (2013)? I am looking to change the fluid out since my steering wheel is making some noise at full lock. I have been looking under the hood for 2 days now and cannot seem to locate it. I have located the brake fluid reservoir which was flushed out today...night and day difference in braking btw. Now this power steering is bugging me but i cant locate the reservoir.
View 8 RepliesI finally have a first 'major' problem with my Camry 2004 V6 XLE right at 75K ish.
The last two days I've been hearing my power steering pumping making that familiar 'whirrrrr' noise. I thought it was just the pump going out because it has always made some noise when it was cold. Lo and behold, I checked my fluid today and found it was completely dry. I knew it wasn't a good thing because when fluids are dry, they must go someplace. Either way, I got a gal of Dextron ATF in the trunk now.
I filled it up and all was good, so I started to look around for obvious leaks. I did find a hose going to a metal line that DID seem to be dripping, but I wanted to see if maybe others had the same problem and found it was to be a different thing leaking/running down or if this is a common issue.
Not sure if the hose is a dealer only thing. It does look like it's leaking from the end. I could get one of those screw tightening clamps to see if the clamps isn't putting enough 'squeeze' on it. I couldn't see a tear on the hole, but I'm assuming it's a high pressure hole, so it won't leak unless I'm doing a lock to lock turn.
So 2 weeks ago I noticed that after 30 minutes of driving on the highway my steering wheel started making a loud growling noise and vibrating really hard! When I hit the brakes it got worse but got better as I slowed to 30 mph. It doesn't happen all the time and not right away, only after a while of driving and the dealership says without codes they can do nothing...
View 7 RepliesOk, so I leave the fire station this morning headed home and my steering felt weird. About 1/2 mile from home I hit a bump and my drivers side front wheel started making a screeching noise. I stopped and looked out the window and it appeared fine. I limped home and as I pull in the driveway, I lost all my steering. I look under the truck and this is what I found.
Not sure what to do. This is my daily driver and neither of my 2 mechanic friends will answer their phones.
I drive a 2006 Volvo V50 with 65k. Recently the car started making a noise and the dealership told me that I need new front wheel hubs because my bearings are shot. The car has always been well within the weight limit, has never been through deep water (we do line in the pac NW so there is a decent amount of rain), and has had complete service at all of the maintenance times. I think that under 125k bearings should not be giving out and that volvo should replace the bearings for free - the mechanic is telling me that there is no set time for bearings to wear out - it can happen at literally any time/mileage/age and it would not be the company's fault. Who is correct?
View 10 Replies