Camry :: 2005 1MZ-FE Rough / Low Idle On Warm Engine
Feb 14, 2013
Recently I have been experiencing some rough and low idles with my 1MZ-FE 05' Camry. The car runs idles perfectly fine and drops to the correct idle when cold, however if the engine has been running at normal temperature and started again soon after the idle drops extremely low until the throttle is opened.
I have cleaned the throttle body with with throttle body cleaner a number of times, although I haven't taken the IAC valve out and cleaned it separately. I have also heard that the Engine Coolant Temp valve may be going bad. Could my symptoms fit this?
I had a dodgy EGR sensor not long ago that was giving me rough idles on a cold start, however I managed to mitigate that problem a by cleaning simply removing the sensor and giving it a quick clean. I don't think that this is the cause but I can't be sure.
I haven't had the spark plugs or fuel filter changed in a while although I'm unsure that these would be the problem if the idle was rough and low only when the engine was warm.
View 12 Replies
Advertisement
I have a 05 fx4 5.4L with 85k on it. It has started idling rough when i come to a stop light or slow down to 10 mph or less. It only does it once in a while. There doesn't seem to be any real pattern. The motor shakes until you rev it up and then it goes away.
I have cleaned the maf, put in new air filter and fuel filter. And put in a new battery. Would a coil act like that? Maybe plugs? Or a vacuum leak?
View 14 Replies
I have a 1986 Celica GT-S with 50,000 original miles on it. Car starts perfectly fine in the morning, runs fine, no issues. Problem happens when the engine is warm, and I let it cool off for about 10 minutes or so, at that point, when I try and turn the engine over, it would sometimes turn over and idle very rough, or sometimes it would die and I have to give it gas to keep the engine running. Once I am able to get it in gear and drive, the engine rpm would recover and go back to normal. I have new NGK wires, denso iridium spark plugs.
View 2 Replies
I purchased an '08 F150 about 6 months ago, and have a problem that two mechanics haven't been able to solve. The truck has a 5.4L engine. Unfortunately, I bought from an auction and the 30 day warranty expired before I realized the problem.
After a longer drive (30 minutes to work) the engine is warm, and I always back into my parking spot or driveway. In low gear, it begins to idle very rough and the engine shakes. If I leave it long enough, it will stall. Usually I pop it into neutral, give it some gas, and its fine. I just bought a camper trailer, so I'll need to use the lower gear when backing up.
So far, the engine has been flushed twice, the solenoid replaced and phaser replaced. The second mechanic has recommended I contact a dealer, but haven't had luck with them with my previous Explorer. What it could be? I will be getting the diagnostic paperwork this week.
View 14 Replies
Still showing the same codes (per repairman) and still having the intermittent rough idle at low speeds when the engine is warm. It has been so intermittent that I could almost live with it.
So repair guys first replaces the VCT's and runs fine until warmed up and the problem reoccurs with the same codes. He replaces both cam phasers and tensioners today and still same problem and same codes which point to the VCT and cam phasers.
Truck has 80k, city driven, oil changed every 3k or so. Burns ethanol and still runs great at speeds over 10 mph even when this problem appears.
View 9 Replies
Friend of mine drives a 2008 Camry with 2GR FE engine, with 65 000 miles. When the engine is cold it runs fine but when is fully warm it idles low, in D or R at around 560-600 rpm. When he shift from P to R or from N to D, the idle goes down, not up like it should. The spark plugs are new, air filter is new. No CEL.
View 10 Replies
I just purchased my first F150, 4.6L V8, 55,600 Miles. It intermittently has a rough idle and only seems to be when the engine is hot. I've had engine and tranny mechanics look it. The spark plugs have been inspected and are within an acceptable range. The throttle body has been cleaned. There are no trouble codes of any kind. What I can check next?
View 13 Replies
The engine on my camry 2007 was overheated and I had the headgasket replaced but now it has misfire codes and rough idle this is a 2.4 engine I replaced 2 of the coils but still it has a rough idle... when the car is running it runs pretty good.
View 5 Replies
I have a 2002 Camry SE (V6) with approx. 180K miles. The Engine mounts were shot so I decided to change them. I am a reasonably qualified mechanic (FAA Aircraft Mechanic) and perform most my work on my cars so didn't think this would be a big deal.
My procedure was to jack up front & put frame on jack stands then removed both wheels. Then with hydraulic jack and blocks under oil pan I started by removing all or the three lower engine mount hold down nuts (3 on bottom, 1 on top of each. NOTE: I changed the dogbone first which took 5 minutes.
I then jacked up engine about two inches or so and pulled out each old mount, then lowered engine back down making sure everything lined up as best I could. Then finished by tightening all of the nuts. Done. ....or so I thought.
When I went to start, the engine cranked but with a an unusual vibration and generally rough idle, more noisey than usual. When I drive it shift fine and everything works, just unusual vibration and noisey inside car.
I also used my BOSCH code checker and got ZERO CODES.
What is even more unusual is the engine when you are outside the car listening sounds fine. Just sitting inside do I sense the unusual vibration and noisy idle.
I checked for loose vacuum hoses, anything obviously pulled loose, etc and found nothing.
Again the car started and idled fine before the engine mount change now starts kind of rough and is noisy [inside car] but quiet outside.
nothing really changed except the moving of the engine block up and down to get the old mounts out.
View 7 Replies
After a long trip from Houston to Dallas, my vehicle started to ride rough and eventually die on idle. It seems to idle fine, but then die after the first minute. I am getting code P306 and others all dealing with random misfires and misfires on ALL cylinders. The troubleshooting steps I have taken so far to no avail are:
(1) Replaced spark plugs with pre-gapped iridium
(2) Checked ignition coils
(2) Checked all vacuum hoses and air intake leaks
(3) Changed air filter(not a big deal)
(4) Removed and cleaned the throttle body with carb cleaner thoroughly
(5) Checked the intake manifold for leaks and did not find any.
(6) Computer PCM checked for updates and issues at dealer
The dealer said it needed new fuel injectors, which seemed kind of fishy due to the following symptom:
The car runs GREAT at highway speeds, but it is unable to maintain an idle for an extended period of time and dies due to misfires. I hear a chugging in the engine sometimes.
Due to these symptoms, I self diagnosed this as a fuel regulator?
View 14 Replies
We have owned a 95 Camry V6 for 20 years and it has always been reliable. However, several days ago, the car started to have its first engine performance issue. When we start the engine cold, there was rough idle/engine lope. If it was warmed up for about 5-10 minutes, the car was fine for the entire day. but during this rough idle, the car jerked slightly as well if i press on the gas.
Since the symptom began, I took it to local shop A and they replaced all the spark plugs, pcv valve and air filter which did not solve the rough idle/looping problem. The rough idle continued, and few days later, I was unable to start the engine though it cranks. (at least that's what I think it does). Had it towed to shop B and they've replaced oil pump, which they thought to be the problem. I took it home, and the next morning I found myself unable to start the car.
View 6 Replies
2001 windstar rough idle at warm up, start drive the van with cold engine for about 3-4 ml s, come to a light, stop, van starts rough idling, if I don't put it in neutral and hit the gas it will die ... after that , no problem .
View 13 Replies
2005 camry 3.0, engine would not go above idle, check engine light on, vsc light and trac off light. codes, 2122 pedal position sensor circuit, 121 throttle position sensor, 505 idle air control, 2111 throttle actuator control valve stuck open, 2121 pedal position sensor. After checking online found many people who have had the throttle bodies fail, removed intake hoses and with the key on engine off actuator throttle. throttle valve did not open but could hear the amperage increase to the motor as the pedal was pushed further.
Replaced throttle body with a used one and checked operation. valve open fully and smoothly. cleared faults, vehicle was fine for approx. two weeks, then the same thing happened. replaced throttle body again with a used one and vehicle was fine for a day. Now the same occurrence. Checked fuses, wiring and connectors and all seem okay. Pedal position sensor fail? What is the likelihood of this happening? Is the throttle body once again suspect?
View 3 Replies
Back after months...van has been checked by 2 ford dealer mechanics here in VA , nothing.
Now it's the opposite ...temp outside 90 or higher, drive it for 8 -10 ml, park and come back after 15 min. From shopping, try to start, won't idle, stalls every time I try , after 6-8 attempts, back to normal, all together 3 times, last time was so bad, had a real problem to make it back home, at every stop, it stalled.
Back to the shop ....they drove several times, no show ...it's fine, don't know what to do ????
View 5 Replies
I drive a hot mess of a vehicle. It is a 1997 for taurus that's got more than its fair share of miles on it.My big brother drove this car when he was 16 and I am 22. I am a college kid and I don't do much to my car knowing it will die soon but at the same time I don't have much money to do much. We have a good relationship most of the time and I gladly provide gas and regular oil changes in exchange for transportation.
My car when its warm outside especially idles very rough. So rough that at times it stalls out. It seems to happen most often and to the worst degree when the outside temp is very high and it has been running recently and I'm trying to start it up again. At other times and temperatures it has idled rough but not bad enough to stall. Once I start driving, or moving, its fine. The rough idle makes my car sound like a boat, that's the best way I can explain it.
Why my car does this? How to fix it?
View 2 Replies
I bought a 2005 Camry LE 2.4 4 cylinder. It was rather loud while driving, but especially while accelerating. It had error code P0420 from the beginning. It had a completely broken torque strut which I eventually replaced. Afterward since it toned down the kicking from the engine, I was able to notice that I could feel and hear the engine kicking like a cylinder misfiring. The computer gave me error code P0353 (Ignition Coil C Primary/Secondary Circuit Malfunction) consistently, and only a couple of times gave me error code P0500 (Vehicle Speed Sensor Malfunction) which went away.
I swapped the ignition coil and spark plugs around but the error code would persist on the same cylinder. The spark plugs didn't look particularly worn but I'm not experienced on what bad plugs look like. The codes persisted still, but later on P0353 went away, and the obvious kicking stopped but it still ran with a lack of power and hesitating on acceleration along with a strong smell of fuel in the exhaust. I measured the resistance of each fuel injector and all measured the same. I removed and flushed each of them with cleaner, but same situation.
What do you think? I don't get the bad cylinder code anymore but something is clearly wrong. Bad fuel injector? Bad wiring harness? Bad compression or head gasket (maybe from the movement of the engine while the torque strut was bad)? Hopefully not the computer... And could the loud noise be related to this problem or is that probably just a cracked exhaust from when the torque strut was allowing engine movement?
View 5 Replies
This is what my car is doing after it warms up. It will do it then stop, then do it again and so on. I am pretty sure when the motor is under load it runs a little rough but is hard to tell. The car has 178,000 miles on it. timing belt was done at 113,000. I just replace the plugs and wires changed the oil and the air filter 1,000 miles ago. and it will still do it. I am at a loss as to why it keeps doing this. I have tried injector cleaner, sea foam and engine restore. What would cause this? The check engine light is not on. i replaced the crankshaft positioning sensor about 40,000 miles ago.
Its a 2003 hatch with the 1.6 5 speed .....
View 8 Replies
We are at 120K miles. The vehicle runs fine most of the time, but every once in 10-15 starts, it will rough idle or stall after a short warm up time when my wife stops at an intersection. Once she restarts it, it runs fine.
I have changed the spark plugs and wires, the fuel pump, the crankshaft position sensor (was fried) and after consulting this forum, I checked the fuel pressure regulator and the diaphragm is not leaking.
I was able to recreate the rough idle and the CEL on the dash, but my two OBDII readers said there were no codes And the bluetooth reader I am using is indicating that the following tests are not completing: Fuel System, Catalyst, Evaporative System and Oxygen Senors.
The dash CEL resets itself upon restart and does not light until the symptoms return.
After reading the Haynes Repair Manual, I am wondering about the Evaporative Emissions Control (EVAP) system? But I don't want to lead the troubleshooting.
We bought the vehicle at 60K miles and it has been mostly reliable.
View 26 Replies
I have 2004 f150 small v8 (4.7?) Has about 92000 miles.
When warm truck runs excellently. At first start up the idle is very rough and raw gas smell for about 4 minutes then truck runs like new. Will start and restart great until it cools down overnite.
My actron says missfire cyl 3. Did not fix it. Dealer says that on start up compression is zero in cylinder three but is 100% when it warms up. Suggested I run seafoam through it. He thinks it has a vacuum leak or carbon at start.
In my limited knowledge I am thinking:
sticky lifter
bent push rods
warp valve
View 4 Replies
'91 buick, 3 spd. 0 acceleration in 3rd, trouble code says TCC curcuit. Lopes @ idle when warm, runs rough @ times. many new sensors, timing chain & sprockets, still, the loping.
View 1 Replies
I have a 05 dodge magnum v6 2.7. Only when its warm it stalls at idle. Scanned it code p0137 came back low voltage o2 sensor 1 of 2. I replaced all 4 o2 sensors and still stalling...
View 18 Replies
