Camry :: 2004 LE Won't Start After Head Bolt Repair

I just inherited a 2004 Camry LE I4 like the one I already own. This car has 257785 on the ODO. I got the engine already taken apart from the Head Bolt Issue known for the 2AZ-FE Engines. I finally got everything back together, the timing is all set and I am at TDC. I also added all the fluids and got a new battery. The old one way pushing out 10.4 VDC from sitting so long. This is how everything turned out:

- During the Initial turn over the engine tried to crank and just ended up sputtering and cranking again.

After the first crank, I got my OBD scanner and plugged it in. These are the Codes that showed up:

- P2716 - Pressure Control Solenoid 'D' Electrical

- P0010 - A Camshaft Position Actuator Circuit/Open Bank 1 a

- P0778 - Pressure Control Solenoid 'B' Electrical

- P2102 - Throttle Actuator 'A' Control Motor Circuit Low 9

- P0748 - Pressure Control Solenoid 'A' Electrical

So I found another thread on here about a Highlander with the same engine and Codes. The grounds ended up being the cause. I searched TIS for the Electrical Diagrams and found all the Engine Compartment Grounds. I cleaned the grounds and tested them all came back showing correct Voltage.

After that, I tried to crank it again and still didn't start, so i hooked up the OBD Scanner again. These are the codes:

- P0983 - Shift Solenoid 'D' Control Circuit High

- B1660 - Passenger Airbag Indicator Malfunction (Clock and Airbag Status Light on Dash were not Plugged in)

Now I have noticed these problems without even starting it:

- Turn the Key to 'ON' without cranking; everything is fine (all dash lights show up)

- Turn the Key to 'OFF' after the 'ON' Position; the Oil Pressure Light, AirBag Light, Battery/Alternator Light and CEL All stay lit. If you activate the Cruise Control or E-Brake the Cruise and BRAKE Light come on respectively. If you take the Key out everything is still the same.

- While the Lights are stuck on the Dash; if you flip the Wiper Switch Down the Left Side Radiator Fan turns on.

- If you turn the Blower Motor Fan on while the Key is in the 'ON' Position then to the 'OFF' Position; the blower motor stays on.

I looked at all the Fuses and none are blown. What else could it be? I have spent a while looking at everything and can't figure it out.