Camry :: 2003 KE - Whistling Sound From Engine Compartment At Acceleration After 2500 Rpms
Sep 16, 2015
I have an 03 Camry LE with 80,000 miles I do all the maintenance myself it has had the alternator replaced once at around 40,000 miles. The problem that just started is a whistling sound that ONLY is audible after 2500 rpm at acceleration. When the car is in park no matter how much I revive the engine I can not get it to make the whistle sound it ONLY can be heard at acceleration after 2500 rpms.
Also once I cease to accelerate it goes away while I'm driving there is NO Whistling. I've read that it could be the alternator so I had it checked twice on the car and it checked out good it passed all tests. I've removed the belt and spun the pulley to listen for bad bearing but to me sounded fine. I've removed the throttle body boot and checked for cracks an found nothing also cleaned throttle body (not that it needed it) while I had it off.
Also checked air box and nothing. The only thing I've done recently was take out cabin air filter to clean and replaced it but there was no problem with that. What's puzzling is that it ONLY occurs at acceleration after 2500 rpms then stops after acceleration.
View 1 Replies
Advertisement
I have a 2003 excursion... it is a v 10and just yesterday there was a whistling noise. I parked the vehicle and idle it slowly but no noise. I drove it again n the noise was there again. So the noise is there at 2000-2500 rpm. I'm wondering if its my exhaust manifold?? Also I'm starting to loose power. When running and in parked it shut off.
View 10 Replies
I have a 2003 Camry 2.4 LE with 120k miles on it. It's been very well taken care of. As of now, here is the maintenance that has been completed at my dealership. By the way, I don't trust dealerships, but I do have one nearby that is actually beyond outstanding (and I know a little about cars):
- Regular oil changes, and always with 5W-30
- Radiator flush and thermostat replacement
- Tranny flush
- New front brakes, rear brakes cleaned, and lines flushed.
- Oil pan gasket replaced
- Valve cover gasket replaced
- Spark plugs replaced (at around 105k)
So, with this information being provided, here is my current problem. Lately, as I accelerate between 1500-2500 rpms, the engine has a louder than usual (but not too loud) groaning noise. Basically, the engine just sounds a tad louder than normal along with groaning noise. The engine also feels as though it is running kind of "dry" (if that makes any sense).
Now, above 2500 rpms, it's just fine. It's amazing on the highway, but I feel as though it has slightly lost acceleration in the city. The only issue with the car is the infamous greyish/blue smoke at startup, but that rarely happens and when it does, its a small amount of smoke, and it has never affected it's performance or gas mileage. Another thing is that I had to have that dreaded oil splash guard removed, because apparently the timing chain punctured it and it was about to fall off.
This problem has been recent within the last month. Just before this, the car has been on a roundtrip to Tucson from Tulsa, and Amarillo twice, complete with 32+mpg on the highway! So, what's wrong? Serptentine belt? PCV valve? Cam or something underneath the valve cover?
View 11 Replies
I've got an 02 Camry with the 2.4l 4, it's got a whistling sound from the engine that isn't ground-speed or engine-speed dependent, it's triggered by specific throttle positions...
Because of this, I'm 99.9% sure it's simply air whistling over the throttle plate at certain angles (my old 88 ford station wagon's throttle screamed like a banshee when the cruise was set to 78kph on level ground) but I thought I'd ask in here in case any variable cam timing system or something that can cause similar noises.
The noise has been there as long as I can remember, but it made me wonder the other day when I had my windows down (been trying to limit AC use to save fuel unless it's *really* hot) and heard it reflecting off passing traffic; Wouldn't Toyota have noticed something that loud and done something about it in an engine design?
View 3 Replies
I've had a used 2007 V6 Camry for about six months now.
I recently started noticing a quiet set of rapid clicks/clacks sound coming from engine compartment/firewall area more or less on driver side. I'm not sure if it was there all along or if I just began noticing it.
It occurs after starting the car, putting it in drive and as soon as I let off the brakes and begin rolling. It might only happen going forward. I will have to notice if it does it in reverse.
It happens rapidly and stops and I don't hear it again until I repeat the steps above after the car has sat a while. I don't believe it will do it again, if say, after doing it once I stop, put it into park and then back into drive and go.
I don't believe it's the CV joints. It does it once and stops and is not related to movement of the steering wheel. It almost reminds me of a relay switching something.
I'll also add that I had a 1995 Prizm and 2000 Corolla that did the same thing. Both were manual transmissions. The click they made was much louder though their cabins were not sealed as well as the Camry. The clicks would happen only after the car had sat a while as soon as the car first started rolling and then would stop. Could it be the same thing in all three cars?
View 4 Replies
2011 Sonata GDS. I previously purchased 19" Gen coupe wheels and never had a problem immediately. Approximately 2 months later of driving with the 19" wheels, when I got onto the highway one day, the car did a slight jerk with acceleration and the acceleration halted for a split second. Ever since that day, anytime I accelerate fast and/or reach highway speeds, the car has a delay when I hit the throttle. The car then has a "rattle" "groaning" sound that comes when the RPMs hit around 2000-2500 rpm. It will go away if I drive slow speeds/slow RPMs or shut the car off for a short amount of time. I have taken my car to the Hyundai dealer 3 times. I've had the adaptive values for the transmission and engine reset and that didn't do anything. I had a mechanic ride with me in the car to make sure they were hearing the sound and the delay in shifting and the mechanic was very shocked and had never even heard a sound like this before.
View 10 Replies
2003 Toyota Camry LE 4 cylinder
I am experiencing a loud noise which is getting worse from inside my engine compartment. I took off the heat shield assuming it was coming from the exhaust manifold but it is not. It sounds more like it is coming from the intake manifold. Now I would assume it was the intake manifold issue that has been described in many threads but it is not a vibration or clanging sound. It just sounds like air is escaping from my intake. What baffles me is that the sound is loudest in drive. Then neutral is the next loudest, then reverse there is very little unordinary sound.
I hear it a little bit when I am going like 15-20 MPH in reverse and let off the gas to decelerate. There is a noticeable noise increase just at idle too. I checked and all fluid levels are good. I changed the tranny fluid about a month ago and according to the dipstick it is right on where it should be. The sound is increasing and I am worried about what it may be. It sounds as if it has an exhaust leak but I do not see anything.
View 6 Replies
03 camry 205,000 miles. After first start when backing up, there is a thrumming vibration noise coming from the engine compartment. The noise is less when moving off in drive.
View 6 Replies
Truck sat for 1 1/2 years. Changed filter and put in 15 gallons of fuel. Had maybe 1/2 gallon old fuel in tank. MAYBE. Fixed fuel line because it wasnt getting fuel and it fired right up and idles great.
Truck has no acceleration over 2500 (or so) RPMs but idles fine. This is depending on how hard you push the pedal of course.
If you drive the truck normally like a grandmother it seems to be ok. As long as you dont need a passing gear or need to accelerate more than 1/4 pedal
If you try to push the pedal to get the next higher gear it will sometimes hit the gear fine. IF you floor the truck it will totally lose acceleration. Then the truck will run like crap even slow for a good while. But then it will clear up for the low end. Then you can drive it normally. Then when I think I can test the upper end I get the same thing again.
View 14 Replies
Ok, my question is, when gas pedal is pressed half or more down-ward, a squeal sounding is coming from engine compartment. 2003 ranger v-6 3.0 flex....
View 1 Replies
My 2008 Accent started to stutter between 1500 and 2500 rpms. Now the check engine light has come on, and the engine is idling rough.
View 3 Replies
I have a Chrysler Sebring 2005Engine cuts out at 2500 spurts stutters can't go above 35 mph...But still runs... No cruise available will not come on.. Engine light on... Which I guess from what I read is normal In "limp mode" Got it home.. Shut it off.. Starts back up.. I'm thinking cam/crank shaft sensor? Both of those are new.. And an ECM all from a prior problem.. Or fuel pump.?? Not enough pressure to keep up with demand..
View 4 Replies
When I accelerate (particularly during heavy throttle) I hear a sound that sounds like a diesel engine between 2000 and 2500 rpm's. It almost sounds raspy in nature.
View 24 Replies
I have a 97 f150 with 4.2 4x4 auto. I have a bad miss under acceleration. if i ease on the gas no problems. stomp it and it chugs and pops back thru airbox til it gets to 2500 rpm then clears up. If I shift it manually and keep rpms up its fine till it gets below 2500. I have replaced spark plugs, plug wires, fuel filter, upper and lower intake gaskets, cleaned injectors, new air filter and cleaned o2 and mas sensors. Had vacuum system checked and was told all good.
View 12 Replies
Had a first-time issue with my car today. Background, 2010 II bought in June, just short of 15K miles, never had any kind of mechanical issue.
While en route to work this morning, I was about halfway into my 15 minute drive to work, when I noticed my engine was idling very high, I would guess 2500 rpms. It started doing it while I was driving around 35 MPH, then continued doing it while I stopped at a traffic light, and continued when I continued driving to a speed around 50 MPH. The high idle while stopped was not transferred to the wheels, so it was not a safety issue as it would be in other cars.
When I got back up to 50, curious to try something, I hit the ECO mode button and the car returned to normal. I took ECO back off and the car was still fine. I had no further problems.
I would point out that this morning was about the coldest temp that the car has experienced. Outside temp ranged from 7 to 10 degrees.
View 14 Replies
-My pickup was parked and hit in the rear axle in January. I had to have the whole axle replaced as well as the leaf spring to frame mounts.
-I finally received the pickup back and now when the trans is in Drive it will not up-shift until the rpms reach 2500 and it is a hard shift.
-Also the speedo does not work now.
-Check engine light also came on with code P0500- vehicle speed sensor.
-I replaced the VSS at the transfercase and the ABS sensor in the rear differential with no change.
View 8 Replies
97 f150 4.6 4x4, no check engine light, no missing or sputtering, however when I try to get going I can't get passed 2500 rpm and when it finally does its still kind of sluggish and can't pass as easy. Changed fuel filter. It idles fine and when I put it in neutral it will go up to 5000 rpm if I want.
View 6 Replies
I've been getting a blinking engine check light.. I pulled all the codes:
P0050: H02S Bank 2 Sen 1 Heater Circuit
P0155: O2 Sensor Heater Circuit Malfunction Bank 2 Sen 1
P0304: cylinder 4 Misfire detected
P0688: ECM/PCM Power relay sensor circuit
I've had the car sitting for awhile because I lost my job and didn't have any money to roll it around much.
I just changed out the spark plugs and two of these had a white coating on them.. I was hoping this would take care of the misfire after I replaced them. I also bought a new battery because mine had lost charge a few times.
The Car will run with an engine check light, but if I go past 2500-3000 rpms then it will start blinking (which means don't drive it )
The oil has been sitting in it for about 2 months, so I'm about to go change that and I'm hoping this will allow me to drive it without issues.
Any of these codes thrown and know what they could be? Which O2 sensor (like a link to a website that sells them). Trying to get this thing running again.
View 7 Replies
I recently purchased a 2013 elantra.
I have noticed that there is engine vibration and noise felt in car and pedal when accelerating at around 2500-3000 rpm's before it shifts. Is this normal behavior? It just does not seem as smooth as it should be. I have only put about 600 miles on the car.
It has been very cold, but it does not go away after warming up.
View 10 Replies
Yesterday as I crawled my way through heavy traffic on my drive home from work, my car started lurching unexpectedly. When I let up on the gas, the lurching subsided. I was able to recreate the behavior multiple times on my drive home, as well as while parked in my driveway. As the RPM exceeded 2500 the engine would lose oomph/power and the RPM would start stuttering/oscillating between ~2500 and ~2800 RPM. The behavior was identical regardless of which gear I was in (D1, D2, D3, D, or N), regardless of my speed, and regardless of how aggressively I was pressing the accelerator pedal. Every time the RPM hit 2500, the engine freaked out.
This morning, it did NOT happen when I tested it briefly. I was able to rev up to 3500-4000 RPM without any issues. I did read a case online in which someone experienced a similar issue that only manifested after the engine had been running a while. My car has ~173k miles on it, and this is its first engine issue. What might be causing this?
Video attached; also located here: [URL] ....
View 7 Replies
1984 prelude...1.8l .... I have posted previously on this vehicle and I have had some "success". The car will run with the support of starting fluid but will only stay running if the engine is kept at 2500 rpms or higher. If you let off the gas, it will bog out and die. Starting it requires another shot of starting fluid and a foot on the gas.
View 14 Replies
