Camry :: 2003 - Driver Side Window Stuck 1/4 On The Way Up Using Auto Button
Jul 26, 2014
Just purchased a used 2003 camry 2.0G A/T. The driver's side window slides down well when using the auto button, but gets stuck 1/4 way on the way up. Have to wait a while before holding the button to slide it up all the way. What might be wrong and how I can correct?
View 1 Replies
Advertisement
My rear windows, driver's side mostly was stuck...on and off, mostly off...since I bought Kitacamry 2 years ago, and discovered this...(for search engine users the title identifies potential sources for the problem)...
The windows were so snug that they stuck to the rubber if not used much, and here in south Florida they're hardly used, and often would not roll down...sometimes they would but not always...dealers thought it was the motor, or the regulator or the switch...and who could blame them?
I've discovered that it's not the regulator, and that the motor was just not strong enough to "break the seal" of the rubber.
I recently had a regulator repaired (a screw was loose) and noticed that the shop sprayed the rubber with silicone and that made the window glide much more smoothly...soooo....
I sprayed the other windows' rubber seals...and WOW....all open and glide down and up smooth as silk...If your windows are stuck....give silicone spray a shot...
View 2 Replies
My wife and I recently purchased an 02 Camry. Last night the drivers door stopped opening from the inside and outside. Then we noticed the window was getting stuck rolling down and when I pushed down a bit the door popped open! Happened a couple times before the window got stuck.
View 2 Replies
1998 f150 4x4 the drivers window is stuck up. It clicks by the up button but not the down button. The pass window works fine by both buttons, the door locks work fine. Took out the switch it tests with a ohm meter fine. The switch has power to it. I took out the window motor jumpered it to the battery and it works in both directions. Manually ran the window up and down and it moves freely. I swapped the relays under the dash and everything operates the same. I'm not sure where to go next for trouble shooting this problem.
View 6 Replies
I have a 2012 Lariat fairly well loaded out. However, the so called "auto" window button on the drivers door works auto in down only. Just curious if something is wrong with mine because it is will not do auto for raising the window. One would think that on a truck the auto would work both ways. I know on my Expedition it works both ways. Just wondering if mine was faulty before I go to the dealer.
View 8 Replies
Passenger side window not operable from drivers side anymore, with the respective button. However, the windows does work when I try from the passenger side.
View 10 Replies
So it started when the auto up DID work, and when it closed, it automatically came back down. In order to close the window, I had to use the switch in the non-auto mode. Now, the auto up and down don't work.
View 11 Replies
My GTI has 300 miles on it, just noticed that the auto up/down function on the driver's side window switch only works sometimes. You have to push or pull hard on the switch to get it to auto open or close. I'm assuming it could just be a faulty switch?
View 9 Replies
My drivers window goes up and down good but the auto down does not work. I checked the fuse/relay that is in the box under the hood, drivers side and it looked okay but to be sure I swapped it with the one for the electric seats, same amp and relay and it still does not work.
View 2 Replies
So after 6 1/2 years, my original Panasonic battery died today morning. I used jump start to get to work and used the same method to take the car to Sears to replace with Diehard Platinum.
While driving back, after the battery replacement, I noticed that I couldn't use auto power window roll up or down on driver side (manual roll up/down worked). Other three windows won't even work. I checked the windows lock button and it wasn't in lock position.
I turned the ignition power off and turned on to ACC. Then I could able to roll driver side windows up/down in auto. However, other three windows remain nonoperational. I also noticed a small green light on the window is illuminated only for driver side.
View 4 Replies
So once in a while, a full press (either up or down) on the drivers side window button does not cause the window to fully open or close fully as it should... I'm wondering if this is something (a "feature") I'm somehow activating and just don't know it, or what. If I roll the window all the way up (needing the hold the button up until the window is all the way up), it will then behave normally--a full press down, release, and the window will go all the way down. This just started in the last month or so...
View 10 Replies
I bought an '02 LE, 4 cyl w/123k miles and found electric issues. Are they somehow related and indicate a bigger issue? No lights by shifter (PRINDL). Auto shut-off for overhead light works intermittently. Driver door lock button works intermittently – at times when you pull to lock door it’s ok. At times it slides back and forth doing nothing, and can’t be locked manually w/ key or w/ remote. Driver and passenger windows kind of jump at start of open and end of close.
View 2 Replies
I have been having sporadic issues with the button/system of my drivers side window. It is an '06 XLT SCrew. The window always reponds when I am lowering, but there are times when I hit the button and it won't come up. I wiggle the armrest, or fiddle with the button and it will eventually work. I haven't been to a dealer yet, but I know this will totally fail at the most inconvenient moment. The other three windows work great.
View 2 Replies
When pulling down my drivers window and then pulling it up it gets stuck half way up. I have to push the window hard toward the outside while pressing the button to get it back up. If I am pulling down the window and stop before this point, I have no problem pulling it up again.
View 11 Replies
Just dropped the car off at the dealership with the driver's side rear window stuck down. My local dealer here was pretty good, had the car inside (is expected to rain today) and put me in a rental.
In addition, they are going to investigate my touchscreen, as I've been having some red/white flickering issues when it is?
View 3 Replies
Rolling up windows last night and all my windows go up except for drivers side. I can hear the motor so that's not the problem, I believe the window got taken out of its 'tracks' and is loose in the door. I can hear it moving around in there when I am driving and opening and closing the door. I am trying to be very fragile with it, how to take the door off so I can see the interior of that door.
View 8 Replies
2002 accent with the driver window stuck down. I have the door panel off and when i look up I see the pulley with the cable balled up and two cable ends hooked to nothing.
View 3 Replies
A few weeks ago, my left power window spit up a screw and now the window is stuck. The motor grinds away and the window won't budget. Would a regular auto mechanic be able to fix this or do I need to go to a body person?
View 1 Replies
I have a 2003 Montana (same as Venture). The driver side window will get stuck half way down and the motor will grind. You can then run it back up, but when closed it will grind again.
View 4 Replies
2011 Santa Fe limited fwd
Bought as 6 month old demo in 2011 and from day one rear driver side power window has gone up and down slower than other three windows. Going up decidedly worse. My fault for not having it looked at while still under warranty.
Behavior the same using either driver's switch or the rear switch.
Well, now it occasionally gets stuck in down position. Neither switch works. But, if I press switch and pull up on window I can eventually get it to close.
I looked at other posts and saw no clear solution for this intermittent problem.
View 2 Replies
Where I can find an electrical schematic for the driver's door window? It recently stopped going up and down, and I want to pull the switch panel out and test the switch before yanking the whole door panel to test the motor. I just need to figure out which connector pins should get tested for continuity.
View 3 Replies