Camry :: 2002 XLE - No Spark On Cylinder 2 And 4
Jul 5, 2012
I recently changed my timing chain on my 2002 Camry XLE and now it won't start. I have done this twice before on different camrys but it is the first time this happens. I don't have spark on cyl 2 and 4. I checked all connections from the ignition coils to the ECM, no opens or shorts. All ignition grounds are good also. I check the continuity from the Crank and Cam sensors to the ECM and they are good. The timing chain was put in like the repair manual says. There is fuel pressure and good battery voltage so I am now stuck.
View 11 Replies
Advertisement
I have a 02 F250 with 137 thousand miles. When it had 130 thousand on it I had the plugs changed unknowing that this year 5.4 was known for blowing the plugs.
View 14 Replies
2002 Toyota Solara SLE v6 w/ 209k miles
Drove the car home from church yesterday, this morning went to start and wouldn't start..
Tested the Fuel Pump and that looks good.. Pulled a spark plug and did a spark test and I get no spark.
After reading up I get the sense it is either the Crank Angle Sensor or the Timing Belt snapped .. I don't know the last time the timing belt was changed, we got the vehicle @ 190k miles..
Does a no spark symptom sound like a timing belt that could have snapped? I believe these are non-interference engines so it should be ok..
When turning the car over the RPM gauges doesn't look like it is moving but wanted to see for a complete spark failure.
View 2 Replies
I recently replaced the spark plugs on my 2002 Camry SE V6 (Gen 5). Let me just say that it was INCREDIBLY DIFFICULT to reach the rear 3 plugs as they sit underneath the intake manifold, way to the rear of the engine compartment. To reach those, I had to unplug some wires reaching on top of the engine, then loosen the intake manifold.
Along the way I broke a tiny air valve that sits underneath intake manifold, and replaced it right away, before starting the car.
When everything was put back together, the car started wonderfully, only to notice the engine light come on. I had the codes checked at the dealer and they indicated a malfunctioning Catalytic Converter and A/F Sensor and some other emissions stuff. Later that day, the VCS/TRAC OFF light came on as well. The service guy at the dealer said those typically come on together with the Check Engine light, which sounds like something he pulled out of somewhere!
The car drives well, no hesitation, no weird behavior, but has no traction control, naturally. While loosening the manifold I had to use a little force to flex it out of place. My guess is that it I may have yanked something out place: may be a wire issue, or a sensor.
View 13 Replies
Stuck at Starbucks at the moment waiting for my car to get towed. Thought I would post here to get some feedback.
I have a 2002 4 cylinder Camry that is refusing to start. The battery seems OK as all the lights are on. The car is not turning over either (cranking).
The car has had no issues (touch wood) since I got it at 50k miles. It is currently at 100k miles.
I believe the issue is with the starter. When I started the car earlier today, I noticed it started a little differently then before. It took a second or two longer to start.
Does the problem can be a starter? I am getting the car towed to my house in about an hour.
View 4 Replies
I have a 2002 Camry, 2.4 with 155k miles.
This morning I was going to work and was making a lane change and hit the accelerator quite aggressively. Suddenly my engine started to run really rough and shook the car and the check engine light started flashing.
I checked the engine code and its giving me a P0302 Cylinder 2 Misfire warning.
I have read that there can be various reasons but I figured since this problem is consistent its not a vacuum issue? Could it just be a bad plug? I don't have the tools to fix it, I am going to get them soon to pull the plugs and inspect then, and will replace them anyway since I don't think they have ever been replaced.
View 11 Replies
So i have a 2002 camry LE 4 cylinder, it has about 173000 miles on it. It belonged to my dad and I bought it off him in June. My dad has always been religious about getting it serviced so it's not like the car is on its last legs or anything. I've driven the car myself probably for 40-50k of those miles while I was living with him, and occasionally when he goes on vacation. The car would always run smooth and other than worn brakes was in tip top condition for a car with its age and mileage.
Anyway, I went to get my oil changed on the 5th. Got out and the car felt zippy and all that good stuff. One week later, I'm parking at home after running errands. As I pull into the spot I notice some faint white smoke coming from under the hood. I pop the hood and see the smoke coming from behind the radiator. No real one spot that the smoke is coming from, but emanating from the middle, behind the radiator up towards the top. I checked the coolant reservoir as my girlfriends old car used to go through periodic overheating due to her never taking care of it, and I'd usually fill it up and make sure the radiator was full and that would be that.
So the reservoir is basically bone dry, I add coolant to the line and I check the radiator. The coolant in the radiator is filled to the top when I go to fill it. I take the car out later that night and it's still smoking slightly. The smoke doesn't start until the car's been running for about 10 minutes or so, which I'm guessing is how long it takes for the underhood components to warm up enough to vaporize the liquids in there. The temperature gauge is always smack dab in the middle while I'm driving and the car is smoking. The smoke is white and there's not a ton of it.
Monday I check the reservoir tank and it's empty again, I refill it and there's still smoke after 10 minutes. Luckily, I work 10 minutes away so I'm just getting to work/home when the smoke starts. I'm planning on taking it in to a radiator specialist on Saturday morning but curious what the community thinks it might be. I'm totally car ignorant so a self repair is kind of out of the question.
View 5 Replies
I have a 2002 Toyota Camry XLE 4 cylinder. I made a mess today, filled 13 galleons of Diesel in my gasoline Camry. It ran fine for 5 mins and then stopped.
I am planning to drain the fuel tank. I see one i hope fuel line in the hood which I plan to open using a wrench and drain the Fuel tank. Is that right?
Also do I need to do any other things immediately? I was thinking may be I will change fuel filter also.
View 14 Replies
Our 2002 LE Camry master-cylinder reservoir is loose, at least with the engine not running. Is this normal? It moves about 1/4", side-to-side. With the engine running, the pedal almost goes to the floor, but I've been told that's normal. I'm not sure that it is, but my wife seems to get by with it that way. Our engine is 4cyl.
View 4 Replies
I own a 2002 Camry XLE 4-cylinder with about 95,000 miles which is in excellent condition and well-maintained. Recently I began to hear a rattle, tapping or knocking sound apparently from the passenger side of the engine compartment (passengers agree with apparent location). It almost sounds like engine knocking, but the times it happens seem to rule that out. It could be some metal vibrating against something, but I can't hear it when I'm under the hood, and nothing appears loose. I've taken it to my trusted independent mechanic, but he couldn't duplicate the sound driving for 15-20 minutes on the freeway or see anything wrong when put on a lift. The sound doesn't occur all the time, of course; that'd be too easy.
The noise begins:
-after I've been driving 15 minutes or more
-after the car gets above 45-50 MPH, but when the noise finally begins, it will then occur down to as low as 30 MPH.
Last weekend I drove 1000 miles roundtrip on the freeway at 65-80 MPH; it didn't begin for 30 minutes, but continued most of the way to my destination (5.5 more hours), though it did seem to stop a few times. This week, my 20 minute drive to work, which has about 10 minutes on the freeway at 65, has not caused the noise to happen once.
Characteristics of the problem:
-the noise is not related to RPM; once it begins, it is about the same frequency and volume at 30 MPH as at 80 MPH
-it doesn't occur when in park or neutral and idling, even if the engine is revved, and even if the noise was just occurring on the freeway moments before
-it doesn't change when running over rough pavement or in turns
-it doesn't change when regular gas is replaced with premium (tried this last week to rule out engine knock, though the lack of RPM affecting it probably ruled that out already).
So it seems like it may be related to the speed of the car and perhaps the temperature of the engine or compartment. The hood latch appears to be holding tight with no play, the strut mounts were replaced 10K ago, and the wheel bearings check out fine.
View 7 Replies
This has the 2.2 engine with the ignition coil mounted on the firewall, not inside the distributor.
Original not start condition seemed to be fuel related because it tried to sputter on time after it died in the middle of the intersection.
Changed fuel filter, primed and no start.
Checked for spark at the plug wire using a solid wire and touching a ground - no spark on any cylinder.
Tested for voltage at the center distributor cap - have 12 volts - replaced distributor - no spark
Replace ignition coil and ignitor - no spark
The wires all test with the right ohms so I'm not sure what is left to replace.
View 6 Replies
Driving last night and my 08 died after searching I found the ICM fuse was blown. I replaced the fuse and now it has a misfire on cylinder 6. I have changed the coil with no luck. I replaced the plugs and wires about 2 weeks ago and I don't find any problem with the plug or wire. I checked at the coil and there is no spark at all on cylinder 6. I was thinking the ICM is bad but was wanting some opinions.
View 11 Replies
I have a 2001 Hyundai Sante Fe that died on me while driving down my street. The engine sounded like it was loading up for about 1-2 seconds, then it died. It turns over but does not fire.
After a little troubleshooting, I have no spark in cylinders 1 and 4. I swapped the two coils thinking that I had a bad coil, but then the suspected bad coil created spark on the 2-3 cylinder side. So both coils work.
I towed the car to the shop and the mechanic after about 2 hours of billed labor, he is leaning toward a bad ecu. He said there also is no fuel metering from two of the fuel injectors. He checked the resistance on the injectors and said they are fine. He is thinking it is a control/command issue. The car has many other unrelated problems and I am not sure I want to spend too much more money on it.
I am skeptical about a bad ecu. Or sensors that may be causing my two cylinder no spark and alleged fuel problem?
View 14 Replies
A friend of mine has a 93 Corsica with the 2.2 liter engine. His #4 cylinder has no spark. #1 and #4 share a coil and #1 has spark. Also #2 and #3 are ok. He has replaced the coil for 1&4 and also the ignition control module but still only has spark on #1. The wires are new and test ok. How you can have spark on one side of a waste spark system?
View 1 Replies
I have a 99 Saturn SL2/auto. Cylinder 1 will not fire. It has spark to the end of the plug. But the cylinder will not fire. No oil is getting on the plug it isn't fouling out. A brand new plug doesn't work at all. The cylinder is DEAD!
View 8 Replies
I have a 2001 Dodge Ram 1500 that I bought used a couple of years ago. About every 20k miles (120k miles on it now) I get a check engine light and upon diagnosis it's the 4th cylinder spark plug fouled out, every time. I change the spark plug, but the old ones are always identical in damage. The porcelain has cracked on the spark plug.
View 17 Replies
I purchased a 2000 Ford Ranger last year. Within the first two months of ownership, the vehicle was having a cylinder 4 misfire. To fix it, I replaced the fuel filter, plugs, wires and cap - replacing the wires, plugs and cap fixed the issue. The issue went away for four months when cylinder 4 misfired again. I brought it to a repair shop and they again replaced the wires and plugs. The vehicle now has a cylinder 6 misfire.
There has to be something causing these plugs to continually go bad. Rather than just replacing the plugs again, I'd like to attempt to be proactive and fix the root of the issue. I've googled the issue and some of the forums seem to indicate a bad EGR valve.
View 10 Replies
I recently took a 4.6 from a 98 e-150 van and put in a 1997 f 150. put new oil pump, bearings, and rings. Got everything hooked up and ready to roll. turn over but no spark to any cyl. What it might be?
View 14 Replies
I have been burning up spark plugs in the left hand cylinder (when facing the engine from the front). I have burnt up two plugs in a month in that cylinder. I have low compression in that cylinder and my oil consumption is high as well (1QT every 300 miles). My question is, is the oil fouling plugs and the oil consumption connected or is there other things I should look into?
View 2 Replies
Ok , i have a 2004 Pontiac Grand Prix GT V6 GM 3.8, my car didnt have any misfires until after i changed my Lower Intake Manifold Gaskets. After changing the gaskets and putting everything back together. The car ran fine. The next day i took it an hour and 30 min away, while driving there it started misfiring and shaking,rough idle at an hour into the trip. The check engine light went to blinking. The Next day i drove it all the way back home in the condition. Put code scanner to it, and received P0303 "Cylinder 3 Misfire":
So i automatically assumed it was the coil pack because i just installed new wires and plugs a week before changing Lower Intake manifold Gasket. Bought new coil pack. Still getting rough idle and P0303 code. So i decided to take a look at Cylinder 3 Spark plug and it was dry black, carbon fouled:
So went and bought new spark plug, installed it, started car and still rough idle and misfiring. Took the new spark plug out and it had been FOULED also ( DRY BLACK AGAIN). So i was told to switch a coil pack around. I did it and the started car, took away some of the rough idle, car actually wasn't misfring or shaking, would run smooth for about 5-8 seconds then start misfiring (Didn't that until i switch coil packs around).
Next Decided to pull out the rest of the plugs from the back and all of them were WET with GAS!! and 2 Spark plugs are just dry fouled!! (Cylinder 3, Cylinder 1). If I can figure this out i will fully have my car back to running correctly.
View 12 Replies
1998 Ford Explorer. Coil pack isn't putting out spark to that cylinder. Would the next step be to replace the pack, or might I check something else 1st?
View 5 Replies