I have a 2002 Camry 4cyl. with 235,000 miles and recently when I had pulled into someones driveway on a downhill slope and when I put the car in reverse and tried to back out, the car revved up like in neutral then slammed into reverse like it was slipping and then slamming into gear. Forward gears seem, what maybe causing it.
View 4 RepliesSomething is awry with my 2008 Prius. It started a couple of weeks ago when I was starting to back out of my parking place at the P.O. When I put the car into reverse it immediately went back into Neutral. I tried several times to put it in drive and reverse but it kept going back into neutral, I also tried turning the car off and on to no avail. Eventually it would not go into Park and had a warning that the batteries would not charge if the car was not in park. This happened about 4 times in a matter of weeks and then last Saturday (I went to get ice, I live in AZ) the car would not go into drive and did not appear that is was going to go into drive. It ended up that I was able to drive the car home (without the A/C running) by holding the shifter down in drive manually. Ice melts real quick in 100+ heat!
View 18 RepliesWhile driving with cruise control set at 80 mph in my 2002 Toyota Camry, the engine suddenly revved up to 4200 rpm while going up a hill on the freeway. I was wondering if this sudden high rpm could do damage to the engine? The car has 163,000 miles on it.
View 8 RepliesI have a 2003 T&C 3.6L with tow package, purchased used (privately) with 25K miles in 2006. Since I have owned it, it will occasionally not go into any gear when first started after sitting at least overnight- basically stays in neutral until engine is revved to about 2500 RPM. You can rev it in neutral or while it's in gear. This always works, and the transmission will then work fine until another overnight stay. I have had the transmission serviced 3-4 times (once when it first happened, and then at recommended intervals. The car now has 96K on it, and it has been happening less frequently (in fact, it hasn't occurred in about two weeks). I have discussed this with two Chrysler dealers, and have left it overnight twice, but of course it didn't repeat at the dealer. I haven't been able to correlate when it happens with anything except: it seems to occur more frequently when garaged in Pittsburgh than when sitting outside in Myrtle Beach (I spend time in both places).
View 3 RepliesI've noticed something weird with my 14.5. Over the last two days it's making a clunking noise and the car shudders going from neutral to reverse. I never noticed it before on this car and certainly not on my 2012. I'm not on a hill, revving it, or anything, foot is firmly on the brake. I first noticed it going from drive to park, felt it, and was able to repeat it sitting there by going from neutral to reverse.
The other oddity I noticed is the car sometimes rocks forward once I put it in park and took my foot off the brake, even with the parking brake on, but it doesn't do that all the time either, grade doesn't matter. The parking brake works fine, it holds the car in place in neutral on a slight incline, and I felt it when I backed the car up with the brake on a month ago.
Didn't think to mention this at my appointment the other day but now that it's acting odd going from N to R I'm wondering if I should have. This transmission seems to shift better though overall then my last one (little smoother, quicker) so I'm hesitant to have them start messing with fluid levels or anything.
So I've worked on this A/C for 3 years, I don't drive this truck very much or often, partly because the A/C doesn't blow cold. Its a 99 f250 7.3 ... Here's what I've done, first it was low on Freon so I added some and it got cold, take off driving and it gets hot. After some research I check the clutch air gap and pull a washer. This changes nothing, I put a valve on the heater core, so I could manually shut it off just in case.
This year I replace the compressor because the clutch isn't staying engaged when I revved it up in neutral. I went ahead and replaced the drier and Orifice Tube, the orifice tube was clogged up. So I start recharging the system, and I get 2 3/4 cans in and its blowing cold, low 50's high 40's its 75 degrees outside. The gauges read 35 low and 300 high, I'm a little confused cause it was suppose to hold 41oz from what I looked up but ok.
I rev the motor just to check everything out, the low side heads down for a second then starts going up, the high side starts going up and doesn't stop. The high side goes all the way till it hit the high pressure switch 450 wow. I'm thinking its over charged, I let it idle and the compressor kicks on and the low is around 50 and the high is at 350. So I rev it up again 1800 rpms or so, and the low side drops down and so does the high side. Except this time the low side drops down to 15 " I had the low pressure switch unhooked and looped" and the high side around 225.
Last week, I had my 2002 V6 on the highway for a few hours, and the transmission slipped from drive into neutral. I thought it was my wife who bumped the shifter while passing a snack to my kids in the back seat. So i put it back in gear, and kept driving.
Today, my wife was getting off the highway, and she said that as she was on the offramp, it slipped out of gear by itself again.
1996 F250. I think its a Ford works great until yesterday. Put it in reverse had to rev it up to get it to move and when it did kind shook and sliped an does back up but doesn't like it....
View 5 RepliesI have a 3.6 4motion and recently after i started it up just now too, it made a diesel like weird sound, and the RPM revved up to like 3500 then went back to idling.
View 4 RepliesI have a 2002 Hyundai Elantra GLS with over 215,000 miles. About a month ago, I started my car and it revved up & down from 2 to 4 rpm. I took it to my mechanic and replaced the TPS, thinking it would fix it. What to do next. My mechanic fixes cars, but doesn't do it professionally. I don't have the money to take it to a dealership.
Now, after doing a tune-up and changing out other sensors the RPMs came down to 3 and will stay at 3 rpm when I start the car. When I drive it, it pulls on it's own without touching the gas pedal and is hard to brake. What else I need to fix or replace?
I have a 4 cyl 2002 Camry with around 80,000 miles. Last night I put the car in reverse (flat parking lot) and the car started to buck/jerk when moving backwards. Going forward the car is fine. No check engine light.
After driving for two miles I tried putting the car in reverse a few times and it was fine. This morning I tried putting the car in reverse 8-10 times. One time I got the bucking again, went forward and then reverse again and no problem. Trans fluid was changes 5 months ago.
How difficult it is to remove the rear seat on a 5th gen 2002 Camry XLE? There's a set of leather seats at a local yard and I'm thinking of buying it.
My follow up question is what the h ell do I do with my old seats? Is there even demand on Craigslist for that stuff? They're power and in good condition.
Not sure why but randomly one time putting my car into reverse, both back up lights seemed to not turn on and I don't believe they are broken or blown.
View 4 RepliesI replaced the front hubs and bearings on my brothers 2002 Camry today. He drove less than a block and developed awful grinding noise and it won't move in reverse or drive. It rolls when I put it in park. I had to pull it back into my shop. Is it possible the inner CV came loose and i didn't realize it? It all seemed to go back together fine. The new CV axle nuts were quite tight and slow to put on with my impact gun.
What else could possible go kaput when I re & re hub/bearings? And what a long ugly job to replace those bearings. Don't even think about doing this without a good hydraulic press. Up to the point of getting knuckle off, it was easy job.
2002 Camry, Automatic Transmission
Have an occasional problem. When shifting from park to drive/reverse, I occasionally get a loud, brief (1 -2 seconds) rattling noise from the engine compartment. It's my daughter's car so not sure yet if this is a cold start only issue or if present after car has been driven, then stopped and re-started. The problem does only occur occasionally. Where to start troubleshooting? I've looked for loose external pasts with nothing found.
Is there a programming sequence that will keep my 2002 Camry from locking all doors when the vehicle is put in drive/reverse. I realize this is considered a safety feature but I prefer to lock them myself.
View 10 RepliesIs there any harm being done by putting the car in neutral to force a coast then putting it back in "D" to charge up the battery just before coming to a stop? I've changed my driving patterns and started heavy usage of the CC and putting the car in neutral for a forced coast, but putting the car back in D just before coming to a stop or even after the down-slope coast ends. Just before going back up hill.
View 9 RepliesVehicle was repaired after front end collision and I get no codes found on scanner, had some bad connectors which I replaced and codes went away. I don't get ready light and the dash lights do not cycle off (ABS, SRS, Check engine, Etc. Etc.) The car will shift into neutral but not drive or reverse. Has new Aux battery and Hybrid battery is showing two bars. What to check ?
View 6 RepliesI am experiencing a slight vibration with in drive or reverse but not when it is in neutral. I change the spark plugs and checked the PCV. I have the latest model already and I replace the gasket in the PVC. There is no errors in VAGCOM.. What could be causing that? Mounts???
View 4 Repliesi have a 1994 nissan quest 3.0 v6 and when i put it in reverse or drive it will slip into neutral if i am stopped. Also the front motor mount needs to be replaced, which I will do soon. Are these problems related, if not how do i fix the shifter/linkage problem? When driving the vehicle upshifts and downshifts perfectly.
View 1 Replies1986 S10 blazer automatic transmission won't go into reverse OR neutral! It goes fwd in both reverse and neutral. It goes into park just fine. The fluid is full and not burnt. It will drive forward when in reverse and in neutral. I turned the engine off and checked neutral, it was not in gear but tried to go forward as soon as I started the engine.
View 16 Replies