Camry :: 2002 V6 - Check Engine Light Came On While Driving On Freeway / Code P0128
May 18, 2013
I have a 2002 v6 Camry with over 270k on it. Today the Check engine light came on while driving on the freeway. When I got home I used my scan tool and it gave me the following codes.
P0128, P0440, P0446 and P0440, P0441, P0446 pending.
I understand that the 128 has to do with coolant temp and that the other codes are evap system related.
What I'm trying to figure out is what might have caused them to all occur at the same time. I know once with my 98 Camry it threw a P0125 which had to do with coolant temp issues but it also threw several other codes for a bad 02 sensor and the 125 was just a false code (replaced the 02 sensors and they went away). If this 128 is possibly a false code or if I also have a bad thermostat/sensor on top of an evap system issue.
Also. coolant level is good and I checked the gas cap and insured it was on tight, reset the codes and am waiting to see what comes back.
View 1 Replies
Advertisement
I have 2002 camry 4 cylinders and has 175,000 miles. I was driving on the freeway and suddenly I felt a jerky motion and check engine light came on. When I stopped at light the car began to vibrate and when started driving at low speeds it got me home. Admittedly I had put lot of hard miles on the car in past 6 months and I was lazy in getting oil changed in time. It might have been 7000 miles since oil chg. I took the car to local oil change place they did not mention anything about engine but they said my transmission oil was dark and burnt. They said I should flush and replace. I agreed and tech said he had to do second flush as oil was still dark. After second flush, he said its little bit better.
I was hoping this would solve my problem but unfortunately no. Car was still vibrating and when i drove at slow speed it was driving but as soon as I tried to accelerate the car lost power. Check engine light has been on since the incident at freeway, but now check oil light and battery sign came on. The power steering lost power. I had to park the car and restarted, as long as I drove very slowly it would drive but if I tried to accelerate where the rpm went from 1 or to next level car would loose power with warning lights on. I had recently replaced fuel pump, filter and any repair which was suggested to me. Admittedly I have not done timing chain or belt.
View 9 Replies
I'm getting a P0128 code on my 2003 V4 Camry. Autozone diagnosis says it's either
a) coolant low level
b) sensor not working correctly
c) thermostat not working correctly.
As part of 90k mile check about 3500 miles ago, the mechanic replaced the coolant. I didn't check the coolant after he had replaced it but I just checked it today and it's about 1 inch below the full level. Is this normal coolant usage considering that it's been about 3500 miles and 3 months since it was last filled?If the coolant level is okay, then how do I figure out if it's the sensor/thermostat?
View 10 Replies
08 RX350 with ~100K miles. Two weeks ago the Check Engine/TRAC light were on, VSC light blinks, so I tightened the gas cap, and pull the negative and cleared the code. Hoping this is just a gas cap issue.
2 weeks later all those lights are back again, so my mechanic pulled the code and came up with P0128. He told me it should be the problem with the Coolant Temperature Sensor. The water pump, thermostat was replaced last year and coolant level is OK. No issue with coolant temperature and the car drives like normal. My mechanic cleared the code and told me to drive it again until the lights come back and he will pull the code again.
08 RX350 AWD
08 Avalon Touring
View 5 Replies
I recently had the engine light come up on my Hyundai Elantra 2003. I read the code with my cheap little code reader with the torque lite (free) app on android. It threw the P0128 code which means a faulty thermostat.
Here's the web link to all the details on the code: [URL] ....
I have checked the coolant level and its good. The strength of the coolant is good to -40 Celsius. The engine fan is not running at all. I recently changed the thermostat. I'm leaning towards faulty ECT. The car takes forever to blow hot air too. It has done weird readings in the past with the temperature gauge in the cab.
I just bought a infrared temperature reader of Amazon and want to check the temperature where the water comes out of the engine past the thermostat and compare it to the reading on the torque app readings. I'm thinking it won't match.
View 15 Replies
Got a 2002 GT with the NA 3.8 and 150,000 miles. The car has pretty much sat for the past 6 months, driven very sparingly. If it's been sitting for a while (like over night or longer) it will start no problem. If I turn the car off for a shorter period, it will crank but not fire. It will start only if I pump the gas as I'm turning the ignition.
In addition, on occasions it has died while at idle or coasting to a stoplight. After it dies it will fire back up no problem.
Fuel problem perhaps?
The "Service Engine Soon" light has been on for about a month before it started acting up. I had the codes checked at AutoZone and it came up with P0442 and P0128.
View 12 Replies
It just so happens that I got my letter from the DMV telling me I needed to get my new tags, and this is an emissions test year for my car. I was buys the last few weeks so I figured this would be a good week to do it. Yesterday.......check engine light comes on. How does that happen???
So now I'm on a time crunch. I went to Advanced Auto this morning and they checked the code. It's P0440, an Evaporative Emissions code. Any thought on what that me be, or any checklist as to what to check first? I'm fairly handy, but know nothing about cars. I'm sure I can figure it out with some instructions.
Summary: Got a check engine code of P0440, Evaporative Emissions. On a time crunch because I need to get an emissions test done. I can probably fix it myself with some direction.
View 2 Replies
I keep getting the same code for the check engine light of P0128. I have replaced the thermostat twice and the ECT sensor already. I do know know what else I can do for getting this fixed. I have checked the fans and they are working correctly. I have also checked to make sure there is nothing wrong with the head gasket. My car does not over heat, but it does take forever for the temperature gauge to rise. This is for a 2006 Hyundai Elantra. What else I can do?
View 2 Replies
I have a 2002 Toyota Camry V6. The warranty expired in Feb 2007. The car has only 67,000km.
The check engine light came on and the code is P0770, Solenoid E malfunction. The problem was first reported at 43,000km, when the car was still under warranty but only a transmission flush was performed and the code was reset.
I wrote Toyota and after almost two months they told me they do not cover it because is out of warranty and I do not qualify for the Goodwill program. I tried again to tell them that instead of fixing the root of the problem they temporarily covered it, but again I got a NO. No comments about the mileage, time, etc. Just the car is out of warranty and I'm out of luck.
View 8 Replies
I have an engine code of P0128 (low coolant temp etc.) I now think it's because I no longer have an Engine Splash Shield under my engine and the extra air is cooling the engine. I took it off after backing into a snow bank like an idiot. At first I thought it might be that I poured green coolant into the pink coolant because I lost coolant cleaning the throttle body (120,000miles). This mixture supposedly causes clumping and clogs in the system etc. Since then I flushed the coolant system and replaced it with yellow coolant which popular mechanics said was OK. So I'm left with the question of do i change it again to the pink coolant (~$50 compared to ~$15 for yellow coolant, thats why i got the yellow) or do i get an engine splash guard? Or Both?
View 11 Replies
Yesterday while driving on the freeway in EV mode, my PIP (one of the first delivered to the states) flashed the "Check Hybrid System - Stop the vehicle in a safe place" message. I was near my house so I just went home. My SG2 showed code P0C3E, which is apparently an inverter over temperature code.
Took it to the dealer this morning and they just informed me that the car needs a new inverter, but no other details… "internal fault" is what he said.
While googling, i found this recall notice:
Green Car Congress: Toyota recalling about 701,000 Gen 3 Prius vehicles in US over software issue in inverter assembly
that doesn't talk specifically about the PIP and implies that it is a software problem, but goes on to say if the car is in a fault condition the inverter will be replaced. of course, it's possible that a software problem leads to hardware damage.
View 16 Replies
I have unfortunately inherited a 2007 Toyota Camry LE at the passing of an uncle. I recently purchased an Innova 3140 b diagnostic scanner which pulled up several codes. One of which keeps popping back.
P0128 refers to (according to innova).
Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature).
I have replaced the coolant temperature sensor but the codes came back after a few days. I cleared it once again and the code reappeared that same day. I have a thermostat on standby ready to install if the fix requires such.
View 8 Replies
Check engine light on and code is P1451. I have been told its one or all four things:
1. Gas cap,
2. Evap Canister vent solenoid,
3. Evap purge solenoid,
4. Evap canister.
I am trying to fix this problem on the Taurus. I have changed the Gas cap and this did not solve the problem. The other three things on the list: Are these three separate things? Or are they part of the same thing?
View 1 Replies
I was on my way to work this morning when the car just stopped accelerating (or so it felt), all the dash lights came on, I pulled over to the side of the freeway (I was very lucky). Radio and a/c were still working. Powered off, powered on too soon a couple of times - the red triangle and check engine both came on again. Cooled my jets and gave it a few minutes, powered on and the red triangle was gone, but the check engine was still on. Drives perfectly, no problems w/either gas or hybrid engine.
View 19 Replies
I own an 04 Hyundai Elantra with around 196,000 miles on it, and have run across a problem I haven't had to deal with before. A few days ago, my check engine light came on while driving. I didn't really notice much, but when I started it again it began idling roughly. I got it home and pulled the code, which was P0341 (camshaft position sensor). This isn't the first sensor I've had go on the car (I replaced an oxygen sensor and throttle position sensor a couple years ago), however I ran into two problems:
1. How likely is it that it's the sensor that's bad as opposed to something like the timing belt or VVT adjustment?
2. Since the sensor isn't horribly expensive, I decided to try replacing it, but I can't get any socket to fit on the bolt that secures it. I've heard it's a 10mm, but nothing seems to fit snugly. Maybe there's just so much crud and corrosion that it's ruined the head. I tried using an extraction socket, but no luck.
View 5 Replies
I have a 2006 Sonata, 6 cylendar. Today, the Check Engine light came on while driving home from work (note: there was no difference in performance of the car).
I went to the nearest Auto Zone to pull the code. The code reader came back with P0110. The guy at Auto Zone ran it through their computer and Hyundai didn't even come up in the list of code definitions for P0110. However, for all the other makes and models, this code is for the IAT.
The guy at Auto Zone, just for fun, tried to look up an air intake sensor for a Hyundai Sonata, 2006, and was told that this car does not come equipped with an IAT sensor. What caused the Check Engine light to come on and what do I need to have repaired?
View 2 Replies
I have a 2002 4 cylinder Camry, and I've been having trouble with the EVAP test completing. I've been running the EVAP test to the letter, with no success, so I figure the problem might be dependent on something else not completing.
I used to get the occasional check engine light for loose gas cap. So a few days ago I intentionally left the gas cap VERY loose (it's essentially just sitting in the filler nozzle). But I'm not getting the check engine light. I think that the gas tank pressure test may not be running, and that may be why I can't get the EVAP test to complete successfully.
Conditions: The gas level is about 1/2 full, and the ambient temperature has been around 20-35 degrees F.
I'm having a hard time searching. Most search results deal with how to resolve the loose gas cap problem. The check engine light is not burned out... it comes on briefly when I start the car!
View 5 Replies
2002 Camry 4 cyclinder. P0128 code - replaced the thermostat and coolant. P0128 code is now locked in. Lifetd the battery cable, but it is still there when I start the engine - or - it comes comes back immediately when I start the engine. Coolant temperature looks normal on the dashboard gage when I drive the car. What should I do now?
View 3 Replies
My wife's car has 83000 miles on it. We bought it as a factory certified pre-owned vehicle with about 1800 miles on it and it came with the warranty. For the last two years the check engine light comes on with code 441 I don't worry about it till time to get inspection sticker here in Texas. I have been about to reset the computer and drive it till the computer is ready to be inspected and it has passed for two years. Now it won't reset and I have tried to test the vacuum switch and it seems to click when I apply voltage but light won't go off. This code can cost up to about 2000.00 to try and detect. I am not interested in having the dealership keep guessing on my dime.
View 2 Replies
I own a 2003 Camry LE. I went to Autozone to find out what the check enginge light was for and was given P0031. When the service person checked it out on the computer he said the probable causes were:
1) open or short circuit conditions
2) poor electrical connections
3) failed oxygen sensor
4) EFI relay fault.
I asked how it could be narrowed down and he said it I would have to get the car checked out.
View 14 Replies
2001 Camry 4 cylinder. Check engine light came on yesterday. Advance Auto pulled out the code P0446 for the evap. emissions system vent circuit.
The car has no symptoms other than this and is current on all maintenance, but obviously it is a 10-year old car and so it goes.
View 9 Replies
