Camry :: 2002 LE 4cyl CEL Gets On?
May 11, 2015
Just picked up my 02 Camry, I drove it up from Fla, after driving it about 250 miles or so the CEL comes on, car drives fine, getting 34mpg at 78mph Stopped for gas unhook battery cable (reset the computer) light is now off Drive the car about 250 miles or so no light, stop shut car off, once we restart the car & get going about 5 miles it pops on again? Drives fine, runs fine, drove until next fuel stop and same procedure all over again light stays off for 250 miles or so then as soon as I shut off and restart it pops on about 5 miles after I get going? The car has 62k miles on it, good clean oil & temp never get hot at all.
View 14 Replies
Advertisement
My mother's 2002 Camry with about 60K on it has been starting hard lately. No check engine light has come on. I did a full tune up hoping the problem would be solved but no luck. The car cranks a lot before it fires. First thing in the morning it cranks more than it should, starts, and then she gets a little smoke out of it. The rest of the day it cranks a lot before firing. I'm assuming that it is a fuel system issue because if she turns the key to the run position and waits a few seconds, the car starts up normally. Sounds to me like the fuel is draining back. What controls the fuel from draining back to the tank in a 2002 model with a 4cyl, the fuel pressure regulator, fuel pump, or something else?
View 5 Replies
Just purchased a 2002 Camry for my son to drive to school. The car has 275,000 highway miles on it The car was well maintained by the previous owner. I have heard that the timing chain should last about 300,000 miles. However, the owner's manual does not mention any replacement interval. Since the cars mileage is approaching 300k, I'm wondering if the chain needs to be replaced. The engine runs great. However, I do hear a bit of a rattle from the timing chain pully area. I replaced the valve cover gasket and inspected the chain but didn't notice anything unusual. I have mainly driven import cars with timing belts and not sure if this rattling noise is normal for a Toyota with a chain or an early sign of needing replacement.
View 5 Replies
After a long trip from Houston to Dallas, my vehicle started to ride rough and eventually die on idle. It seems to idle fine, but then die after the first minute. I am getting code P306 and others all dealing with random misfires and misfires on ALL cylinders. The troubleshooting steps I have taken so far to no avail are:
(1) Replaced spark plugs with pre-gapped iridium
(2) Checked ignition coils
(2) Checked all vacuum hoses and air intake leaks
(3) Changed air filter(not a big deal)
(4) Removed and cleaned the throttle body with carb cleaner thoroughly
(5) Checked the intake manifold for leaks and did not find any.
(6) Computer PCM checked for updates and issues at dealer
The dealer said it needed new fuel injectors, which seemed kind of fishy due to the following symptom:
The car runs GREAT at highway speeds, but it is unable to maintain an idle for an extended period of time and dies due to misfires. I hear a chugging in the engine sometimes.
Due to these symptoms, I self diagnosed this as a fuel regulator?
View 14 Replies
I have a 2005 4Cyl Camry - transmission replaced under warranty at 89K. The car now has 150K and I have been having a couple tranny issues recently.
Most alarming - When the car is warm and you shift from Park to Drive the car hesitates for 3-5 seconds before it slams into Drive.
Now the car threw a CEL about a month ago. Took into the Toyota and they took a look at it. Said the code was related to 3 Shift Sensor Solenoids, so they cleared the codes and took the car for a test drive and said "all clear" car is fine and there's nothing wrong.
I'm wondering if one of the sensors is going bad and it just isn't throwing a code yet.
View 13 Replies
07 camry 4cyl high oil consumption doing oil changes every 5k. Car has 61000 miles on it. I had to put 2 quarts of oil just before oil changes, oil level was still below low, so car burns 3 qrt of oil every 5k. What should i do?
View 2 Replies
So I recently went out to start my car one morning and it decided to just crank and not start. A few days prior to that I was on my way into work and it shut off on me 4 times but started back up every time, it was only 5 degrees Fahrenheit that morning and I was under 1/4 tank, so just thinking I got some bad fuel or moisture in there I ignored it and went on about my business until it didn't start that morning. Since then I've searched on here and found a couple people that had similar issues and I tried what they had done to fix theirs, this is everything from trying the second key and on.
There is no power at the fuel pump except for the sending unit portion, and I did check with someone cranking the engine, it just has no power... So I thought, relay...well apparently they don't have a fuel pump relay on this car? It's all controlled by the ECU? I decided to hook up my scanner to see if there were any codes getting thrown, this would show if it was CPS or the like, nope, no codes at all showed up. I'm completely lost at this point, and have resorted to buying a subscription to all data as I used them in the past and had luck, well this time they've got nothing for me that I've found useful. I'm about to send the car off to the first person that's willing to pay a fair price. Glad it's warm enough to get the summer car out!
View 5 Replies
My car has 219k miles and has been very loud and when i turn it on the rpm meter goes to 3 and gradually car quiets down and needle comes down to 1. While i drive the steering wheel vibrates too. I took it to the mechanic i was told that timing chain needs replacement as its about time. I was under the impression that timing chains do not need replacement.
The steering wheel vibrates (shakes) it makes light clicking sounds too. I have not been able to diagnose the problem by myself. I think these two things may not be related but engine is really loud. Does timing chain needs replacement? and if it does what else along with it should be replaced?
View 4 Replies
My camry won't start I got a new battery and a new starter (they are both good) and it sill wont start.
View 4 Replies
I have a 2010 Camry Le with the 2.5 4cyl. What I'm trying to diagnose started in the last 2 weeks, the engine just seems like it's lost some power overall but there is no unusual sounds coming from the engine and it has not triggered and codes. I have checked the simple stuff like the air filter and plugs but am not sure where to turn next.
View 7 Replies
Our Camry has about 105,000 miles on it. Car is well maintained, I change the oil every 3 k or so and the air filter is clean (although it is not a factory air cleaner- it is a K&N filter). Other maint is done as specified by the warranty/maintenance book although the car is long out of factory warranty.
We occasionally pull a 800 lb pop-up tent trailer and just got back from the Sierras after driving up some pretty tall passes with it. Car ran great, got great mileage, temp gauge rock steady. I say this because it is probably the most stressful driving we do with this car. While we live in the city we are retired and the car is not exposed to constant heavy traffic, dust or snow. Mileage seems to have remained pretty steady, even with the hesitation.
Got home from the mountains and a couple days later the car began to hesitate when under load. The hesitation shows up as a slightly uneven surge when the car is going up a hill or when it is cold. About 20 mph the car seems to momentarily stop accelerating, then evens out and upwards of 40 mph I don't feel it at all. The hesitation is getting a bit worse over the last couple days in frequency, but still isn't felt on the freeway. I don't know if the hesitation is related to the recent trip to the Sierras.
I hooked up my OBD II computer to see if there are any DTCs, none shown, even left the computer on the car for a day to see if anything might pop up when the car surged, but the computer isn't seeing trouble codes.
My other thought was "got some bad gas", ran the tank out and put in new gas, fuel injector cleaner and dryer. With one new tank it hasn't worked. I haven't replaced the fuel filter yet.
Tried driving the car in 1st and 2nd gear only and found that the hesitation isn't dependent on what gear I'm in, but seems to be more about the speed and load. In neutral, slowly revving the engine, I don't detect anything that sounds or looks like a hesitation (just watching the tach).
Been reading about problems some Toyotas have had with unintended acceleration but I'm not sure that is my problem. I have to admit I didn't know that my Camry was "drive by wire" and maybe I don't understand it enough. Maybe a "reflash" might be needed?
My sense is that I should go ahead and do the next major maintenance items including plugs, but if I had a bad plug or plug coil wouldn't that show up as a Diagnostic Trouble Code item?
Could this be a bad injector or fuel filter? Wouldn't they produce a DTC? How do I break down the next steps?
View 12 Replies
I have a 2004 Toyota Camry 4cyl. Vehicle had ran hot. Performed the procedure and sent the head to the machine shop for the works. Replaced the timing chain and the oil pump chain along with the tensioner, rails and sprockets. Performed the timing chain procedure and even questioned the information about the counterclockwise rotation against the figures of clockwise,, but aligned all of the links to the dots on cams, crank, oil pump and crank. Vehicle spins tries to crank but, floods all of the plugs, no codes, good compression , fire and even hand rotated the crank to check all of the timing marks and all looks fine.
View 6 Replies
Every 3 or 4 days my 2000 Camry 4Cyl Std Tranny keeps blowing out the 30A Buss Fuse in the under hood fuse box. What this fuse runs and what could be the problem. I don't think my Fan Motors are running could this cause the Fuse to pop.
View 11 Replies
I have recently purchased a 1998 Toyota Camry 4 cyl. I had to replace the water pump as it was leaking coolant, I also changed the front and rear brakes and also the front rotors. As I was driving it after the brake change I noticed that I would seem to lose power, kind of like it wasn't getting any fuel or something. My rpms would go down, but most of the time would quickly rise again when I pushed on the gas.
View 3 Replies
Why my 2010 auto trans 4cyl Camry often feels like someone is applying the foot brake when I take my foot off the accelerator? Is it the auto trans downshifting? When I feel it occur and slip it into neutral, it releases and I coast freely again. It's really annoying sometimes especially as I've been driving a 1995 Camry auto for the past 15 years which does not do this.
View 14 Replies
I have a 2003 Solara 4cyl, some months ago it started to blow light blue smoke on start, but would go away after a few minutes. My mech, could be the valve guides. Then about a month ago it blew a head gasket, didn't overheat though, as I stopped, added water and went to the mech. So new gasket and a valve job, but it still blows smoke on start. THe mech said going to 20w50 might work, it didn't. I check the oil last week, thought it should a couple of qts low, so I added oil, but the blue smoke is still there, and I started to smell oil burning. I thought maybe I added too much, so I add another oil change w/20w50....still have the oil burning, blue smoke on start... The mech thinks might be leaking in the rings...ugh....probably could/ve bought a new engine by now...... The check engine light had been intermittent, the mech said it the catalytic converter....it finally went off by itself four days ago....maybe it burned out..........
View 5 Replies
My 03 Camry is blowing cold air on the passenger side while the heat is on. The drivers side blows hot air as it should. The coolant is full. Its a 4cyl LE and does not have dual climate control.
View 14 Replies
I have 2007 Camry CE, 4 cyl, 102,500 miles. The rubber boots on both front and rear struts can be easily lifted with a screw driver to reveal the shiny shaft. Strut seems be pass the 'fast brake' test (no bounciness). There is oily residue on the strut body. Is that normal? If replacement is needed, should I go with Monroe or other brand. I want the original Camry ride.
Brake pads seem to have 3/16"-1/4" thickness left. All equipment is original.
View 1 Replies
2003 Camry 2.4L 4cyl
I noticed my engine light turned on. I went to Autozone to hook the car up to the computer. The computer printed out the code P0420. My coolant temp is normal. What can this code mean. The car has over 126,000 miles.
View 14 Replies
2010 camry 4 cylinder, Heater/ac air flow control not working. Only blows air to defroster which it has no temp control.
View 1 Replies
Looking for procedure how to check the level, condition and how to replace transmission fluid on 2012 Camry SE 4cyl? Is there a service manual available for download?
View 10 Replies
