My 2002 camry 4cyl auto, jap built, with near 190k miles, check engine light just came on, P1135, has not replace any sensor since I own at 125k, 7 years ago, did noticed last 3 to 6 months, mileage drop to 25 or 26mpg average, used to be around 30+mpg, I thought it was change season for gasoline mix.
View 3 RepliesSo my 02 Camry V6 has the check engine light on. I had them scan at AutoZone. the codes that came up were P1130 and P1135. After reading some threads here, seems like it's the A/F sensor?
Just to confirm, there are two A/F sensors in the V6 model? I can see the front one easily but not the rear one. Need to identify which sensor needs replacement?
Just got a P1135 Code on the 1MZ-FE 2002 Camry.
My code reader pulls it up as (no typo below) : AirCFuel Sensor Heater Circuit Response Malfunction.
So I know it's a bad Air/Fuel sensor. Which one though? I replaced the rear sensor by the firewall about 6 months ago which fixed the check engine code (I don't remember the code). Would it make sense that the front one failed now or the back one failed again? Most of my research points me to a bad rear sensor however a lot of people also report that a code reader would report the sensor as "Bank 1 Sensor 1".
The rear sensor was replaced with a Denso 234-9042 Sensor.
I would play the replace and test game... however inspection is due within the month and after resetting the code, it usually takes about 50 miles to return. Being in college, 50 miles takes about 2 weeks.
I have a 2002 Toyota Camry LE V6 with codes p1135 and p1155. Both sensors that are supposedly faulty have been replaced.
The new sensors are denso 234-9043 and 234-9047. I am confident that the second one was the right one replaced as both the new and the old had a little green marker(the location is near the firewall.) not 100% sure about the other one.
The sensors were brand new so I don't know what the problem is.
I picked up a 2002 Prius with 164k, still on original battery. It giving code P3030 which evidently relates to a high voltage line snapped on the bus bar.
View 4 Repliesis my Toyota camry going to stall cause it has po401 code and I think it has an muffler or exaust leak can the cause po401 code.
View 3 RepliesI got home tonight and smelled coolant. Looked under the car, coolant everywhere. I see the issue: a big hose (maybe 2" in diameter) has a tear in it and is spraying out coolant. I'm going to replace it, but once I do, how should I add coolant back into the radiator? Do I just pour it into the overflow?
2002 toyota camry 4 cylinder
The check engine light for my V6 Toyota Solara is on for the codes P0125, P1133, and P1135. I changed the Bank 1 oxygen senor in addition to the temperature coolant sensor. During the drive back home from the mechanic the check engine light came back on, so I went back to the mechanic and was told that maybe the sensor was defective. The Denso sensor was exchanged, but again, the check engine light came back on. Have I been buying faulty parts or is there a different problem? The first time the oxygen sensor was changed smoke started coming out from the exhaust and from under the hood.
View 6 RepliesI recently purchased a used, high mileage 2004 Infiniti G35x (AWD) 145K miles from a reputable new car dealer here in my town. The car was impeccably maintained and clean inside and out. Just a week or two after the purchase my SES light came on revealing engine Code: P0430 (catalyst efficiency below threshold bank 2) pointing to a new catalytic converter in my future. Infiniti recommends premium unleaded for this vehicle. I found out my son filled her up with mid-grade unleaded. Is there any chance this could have triggered the SES light to come on? (Previous owner states he always used premium unleaded in the vehicle since ownership.) I also double checked the gas cap to make sure it was on tight. I find it extremely odd that the SES light would come on so shortly after the purchase. I mean what are the odds? Don't dealers run a diagnostic scan of their trade-ins to check history and for potential problems prior to selling their used cars? I test drove this car numerous times without any indication of a problem and right on the heels of the purchase it passed state emissions... now just a few days later, the SES light comes on. Why wouldn't emissions pick that up? I have reset the SES light (code) and filled her up with premium unleaded. Now it's a waiting game to see if the light comes on again. If the light reappears, I plan on taking it back to the dealer to work out some kind of "reasonable solution" to repair costs. I'll find out just how willing he is to stand behind his cars. I realize that this is a high mileage car, and I hardly expect perfection, but I didn't see this coming. What to do... what to do... By the way, I checked all the fluid levels ... no discoloration in the oil (fresh, golden brown)... no discoloration in the coolant... transmission fluid, good... all other levels are good. Car runs fine, no rough idle in cold...
View 11 Replies2006 Subaru Forester X 2.5L AT non-turbo
I changed the oil and oil filter; replaced the air filter (Fram), and replaced the alternator and a/c belts. I also got a full tank of gas at Sam's Club, I was nearly empty. I've gotten gas plenty of times there, before.
Next day, the CEL comes on. It's a P0304 code. (Cruise control light is flashing, too.) Engine stumbles and runs rough when cold; idles fine when warm, runs OK, but not the same, when warm. CEL is steady, which is "not bad" but I can make it flash if I hit the accelerator while the engine is cold. Resetting the computer by disconnecting the hot battery terminal didn't work; CEL came on again two days later and symptoms remained.
I buy some MAF cleaner (CRC) and use it; MAF was pretty dirty on the upstream side, actually.
I'm going to change the plugs and wires (they need it, anyway) and I've ordered a new ignition coil, which I'll also switch out.
I've also ordered the gasket for the throttle body, which I'll take apart and clean once that comes in. Last step is to order replacement O2 sensors.
I'm 99% certain there's nothing wrong with the engine, in terms of rings, valves, pistons, etc. I think I'm covering all the bases in addressing this myself. I'm on a limited budget so I'm doing all the labor myself and ordering non-OEM parts on-line, after researching to make sure the parts have a good reputations, fit, etc. (Yes, that's all a big FU to Subaru service for being over-priced but besides being relatively poor I also enjoy doing this stuff.)
I have been getting a code 18 which is a loss of tach signal. I have checked the distributor and the module and they are both good. Where do I start next?
View 2 RepliesMy Touareg (2007) was running great until this morning when the MIL (malfunction indicator lamp) came on. Checked with a mechanic who got a reading of PO306 which he explained was the #6 cylinder problem. All VW dealers are closed for service by now but I must drive back to work in St Louis tomorrow? Is it OK for me to drive with that MIL on?
View 7 Replies I'm using an innova 3100/abs tester and that's the code it throws back. The company is zero support, claiming it is an internal Dodge code that they have no info for.
The code is : 50FE
Is that any use to me, or did I buy this tester for nothing..?
Check engine light just came on. I scanned the car and the code PO704 came up.
"Clutch switch input circuit malfunction."
If I replace my clutch switch, will this solve the problem? I got the part number #1jo 927 189f i just want to make sure its that switch that's bad.
I'm owner of a VW GTI 2011 Stage 2 APR
Chip Stage 2, APR Intake
Today I got a Check Engine light, I plugged my scanner and read: P2404/009220 EVAP Leak Detection Pump Sense Circuit: Implausible Signal. But I realize that I have 2 tube near the motor that doesn't have anything on it.
I own a 2003 Volkswagen Passat Wagon 2.8L SFI DOHC 6cyl. I have a code P3081 I have replaced the temp sensor and the reserve coolant tank I am going for the thermostat next. I cannot get rid of this code. Also since the code started when my wife drives short distances and turns off the car it won't start again for about 15 min unless it is jumped started. To top it all off she came home yesterday and said she turned on the a/c and it worked for about 10 min and then made a lot of noise and quit working.
View 2 RepliesThe issue with 99 Corolla CE with 147,000 miles....
I have a misfiring P0303 Code - Cylinder #3 Misfire. Here is what has been done in an effort to remedy the misfire. A major tune up, new spark plugs, new fuel injectors, new spark plug wiring, new coil packs, The car runs ok once warmed up but in the morning the engine vibrates until warm and also shivers a little while the car is stopped at a stop light. I have dropped it off at the mechanics a couple of times now to no avail. Once the code is reset it will not display the CEL for a couple of days but the symptoms still remains. The CEL comes back on within 2-3 days with the same code. Really frustrating! Well, at least this time CEL in not flashing like before it comes on and stays on.
As title states, I scanned my gti and got P0420 (nothing new here) and P1136. I did some searching and looks like vacuum leak can cause this, however I also read that it'll affect my idle. I replaced MAF 2 years ago with a brand new OEM one, my idle is NOT rough, at all.
View 1 RepliesHow can I fix these deep scratches on the back of a side mirror?
View 14 RepliesI have a 4 cyl 02 camry LE. Recently the CEL came on and a few minutes later the oil light. after a day or so they went away. When it happened, I immediately went to the auto parts store and they checked the engine codes and got only one the P1349 repeated several times.
About 6 months ago my water pump leaked and that was replaced along with the timing belt. Shortly after that I had the oil changed and they over filled it i found out. I changed the oil and that was fine. i did develop a slight oil leak from the top passenger side of the engine though. so far i don't notice my oil level dropping. I just see some oil spray in that area. I mention this as they seem related to the code.
The code relates to Possible causes
- Dirty or low engine oil
- Valve timing
- Oil control valve
- Variable Valve Timing controller assembly
- Engine Control Module (ECM)
I've got the intermittent misfire codes on my '02 Camry, and after changing the spark plugs and the ignition coils the problem still persists.
At first there was no noticeable misfire, I took it to two different mechanics and neither said they could find anything wrong. A few weeks later the misfire became noticeable when I'm sitting at a stop light. I can feel an occasional rumble in the engine.