Camry :: 1998 Toyota Stalling Frequently And RPM Gauge Shaking
Jan 18, 2013
I've been having frequent problems with my car.
Here's the information about it:
200,000 miliage
engine light is on when key is in ignition, but goes off when car starts up
Four cylinder engine
Here's the problem:
Car stalls intermittently
when it is about to stall, when i slow down, car putters a bit, and RPM gauge shakes wildly
when coming to a complete stop, car shuts off completely, and when trying to start back up, engine chokes.
Temporary solution:
I put the car in neutral and floor the gas pedal, then the car works again.
View 1 Replies
Advertisement
I have a 4 cylinder '98 Toyota Camry with 82k miles on it. I got the car second hand from a family friend 7 months ago. About 3 months ago, my engine would sputter and then shut off when I'd start slowing down below 30mph and stopping at lights after I'd been on the interstate. Issue occurs only when I've accelerated quickly during that drive (ie accelerating hard to go up a hill to merge or to pass a slow car).
When I need to stop, if I'm fast enough to get the gear in neutral, hold down the break and rev the engine at the same time, then it most likely won't shut off. It's like trying to do CPR on my car... The spark pugs have been replaced, oil changed, and fluid levels checked but the problem still happens. What could be the problem??
View 2 Replies
I have a 97 Camry that looked like it had a small oil leak coming from the head gasket. It needed oil added every few days or so, so I changed the head gasket and now it overheats!
I changed the T-Stat, no luck. I took the radiator out and flushed it. It seemed to flow great too. I had the garden hose on full blast going in the top and it was coming out of the bottom just as fast with no back pressure out the top. So I think the radiator is good.
I'm pretty sure the fan was kicking on at the correct time but just to be sure I hard wired it so it's always on if the key is no, still over heating. Compression test shows 200, 209, 209, 211. That's pretty good right?
Just to be sure that the exhaust was not leaking through the new head gasket and heating up the coolant I did a liquid block test. Where you suck air out of the radiator cap and then it goes through a chemical which will change color if it contains exhaust gases. Not only did the liquid not change color, it was very hard to get any air out of the radiator, indicating that the system is tightly sealed correct?
The car is not loosing any coolant. I changed the coolant gauge sensor as well, still shows overheating.
Before I changed the sensor out I bought a thermometer and put it in the radiator. I was able to leave the cap off even after it started to get hot. The coolant did start to rise a little but I just bled it off from the drain plug at the bottom as it got higher, making sure to leave it full and not get any air. And the temp stayed below 200. This made me think that it was not overheating and thus the new sensor. This was not the case though. I realized that the coolant coming from the engine was very hot and then going into the radiator where it could cool down via my always running fan and then go past my thermometer.
The heater works great and even cool the engine down. This means that the heater core is not blocked and that the water pump works correct?
So after all of this I decided that there must be something blocking a coolant port. SOOO I took it all apart again only to find no blockages. I can see very well down into the block and fairly well through the cooling ports on the head and everything looks fine.
I also checked out the water pump and that looks great. Still in great shape and the bearing is not worn at all.
There was only ONE thing that was wrong on the engine (that I found) and that was the throttle body gasket. It was put on the wrong way so as not to fully block that air passage that I believe is pulled from the block into the throttle body. this could cause overheating?
View 12 Replies
My old 1996 Camry with 2200 cc 4 cylinder engine, frequently keeps losing power to the spark plugs. I have changed the fuel filter and the ignition coil. That did not work. I also noticed that the car was starting when I unplug and replug the primary wire plug to the ignition coil. So I have replaced the primary power plug with a six inch pigtail and a used plug purchased from a salvage yard. This is not working either. The Toyota dealer near my house want to replace the igniter and the Engine Control Module just to be sure that these are not the sources of problem. The dealer did not test these parts. So I refused to replace the parts without a proper test. I would like to test these parts. Is there a test available for the igniter and ECM that could be performed. I have access to a lot of tools. I need a schematic and/or test to test these components.
View 18 Replies
I had a problem with my steering wheel shaking at various speeds. Eventually I found a bad inner tie rod and replaced it. The shaking is gone, but whenever I get over 70 mph there is still a very small vibration. I had all 4 wheels aligned after changing the tie rod. Tires are brand new, less than a week old. The mechanic checked my ball joints while doing the alignment and said they were good. Could my struts be causing the vibration? They need replaced, not sure if the previous owner ever replaced them and the car has 225,000 miles.
View 3 Replies
Two cars, a Toyota Camry and a Corolla, are shaking when driving them, esp. around 35-45 mph when accelerating. This started right after a historic snow storm in Virginia that brought 24" of snow and temperatures in the teens and a bit lower. Nothing appears to be wrong with any of the tires. The shaking feels like the car as a whole; it does not really come through the steering wheel. We`ve only driven each car once since the storm.
I`m thinking this may be from all the moisture and cold. Does this sound reasonable? Do you think it might work its way out, or do we have serious problems with two different cars on our hands?
View 13 Replies
1989 Camry, 2.0L A/T- 97K mi.- This car has developed a violent shaking condition when traveling at highway speed. It only occurs after the car has been driven for at least 1/2 hour. It does not appear to be related to an individual wheel or axle, and happens only when the accelerator pedal is depressed and the car is in gear and moving at 50+ MPH. Steering is not affected, nor does turning the steering wheel increase or decrease the shaking. The shaking stops when the accelerator is released. The engine runs smoothly, with no misfire or vibration.
View 3 Replies
Took this car for scheduled maintenance, tuneup on 12/19. AFTER the tuneup, it started shaking when in idle or going slowly. Took it back 1/5, they confirmed it was misfiring, checked a computer code, replaced one of the coils. The misfiring went away but returned, worse than ever, last week (early Feb).
I read somewhere that replacing coils for misfiring can be just treating the symptom, not the cause. What should I do now?
View 13 Replies
I have a 1998 Honda Civic with 166Kmiles that is new to me. For about 1.5 months I had no issues but about a month ago I was driving and noticed something odd. If I tapped the brake, the lights would dim and the radio would cut out. Not every time but frequently. As I was coasting into my parking spot, I pushed the power window button to close the window and the car stalled. After that I started having hit and miss troubles getting the engine to crank. Either it would crank or there was NO power (i.e. no dashboard lights, radio, etc.) at all. Jump starting would work but I had to get the cables just so. Last week it gave up occasionally starting. I can still jump start but again the cables have to attached just so. Once started the car will run but I have to keep it above idle or it might stall. I replaced the battery to no avail. What is my next step in solving this electrical system problem?
View 4 Replies
I have a '92 toyota camry that we just purchased and put a new engine in... now it's stalling when you come to a stop and are taking your foot off the accelerator. we've tried a fuel injector, a fuel clean, fixed vacuum leaks, and replaced the fuel filter, and fuel preside regulator... it's still doing it and is getting worse.
View 1 Replies
My toyota camry 2003 shakes,vibrating while driving in the front, right side especially, It shakes most at a certain low speeds. The cars is always shaking when it reaches 60mile range upward. what could be the problem??
View 7 Replies
When starting the car (2002 Toyota Camry XLE) with 114k miles, I noticed that I can gasoline. I also have a rare intermittent stalling when brake & come to a stop. Earlier post: [URL] ....
What could cause the smell of gasoline when I start my car? Is this something that needs to be fixed or can it be ignored? Would this be something that could cause intermittent stalling when braking? After the stall happens, I'm unable to immediately start the car but it starts normally after 15 minutes. Is this the result of some flooding by the gasoline?
View 19 Replies
This is Toyota Camry 98 with V6 3.0 engine.After smelling burnt oil while driving (mostly during stops, to be more precise), I took the car to Toyota service mechanics. They found leaks in both valve cover gaskets, and a leak from behind the timing belt cover. The leaks from valve covers were dripping onto exhaust, causing the burning smell.
The total repair cost is quoted at around $2k ($700 for valve covers and $1300 for what is behind the timing belt assembly).
Is it worth doing ? My worry is that, since 3 separate seals are failing, it is likely that other seals will start failing soon.Should the whole engine be rebuilt instead ?
View 14 Replies
A couple days ago I saw that my Toyota Camry was overheating, the gauge was going about 3/4s of the way and then returning to normal. I had then replaced the T-stat but noticed the fans were not running, so I replaced the relay as it tested bad. The fans then started to work when the A/C was turned on, but I noticed the car was still going 3/4s of the way then returning to normal.
So, I took it to a mechanic and looked for his opinion on it, he tested it and said that everything is working fine and when the engine gets hot enough the fans kick on, bit the gauge still hits 3/4s hot and then returns to normal. My mechanic said that he has seen this before in other car models and that everything is working as intended. I was just wondering if this is a common occurrence with some cars? Or should I look for other possible problems? I've never personally owned a car that looked like it was overheating then quickly corrected itself.
View 9 Replies
My 1998 Toyota Camry with about 157k creaks esp around turns and even more with adult rear seat passengers (not my in-laws my husband's). When my dealership did a really expensive routine service on my car said the front links and bushings needed to be replaced, but after the amount they charged me I had no money left. Would fixing these fix my creaking? If not should I do replace them anyways?
View 1 Replies
My son's 1998 shook and cut off at a red light today. I am taking it to be fixed and do not want to be taken for a ride financially. What it could be, so I can show up at the repair shop professing some knowledge?
View 4 Replies
Filled the gas tank as full as I could get it. Done this many times. Now the fuel gauge is stuck on (F) full.
View 1 Replies
I've owned this Toyota Camry 2004 LE for two years now and this issue started couple of weeks ago , I the tempreture gague is always at cold , mean less than 25% . where it used to be always in the middle and at the 50% right in the middle . heat still works , have not tried AC yet , it is still in the 20-30s here in Minnesota . I am suspecting maybe a thermostat or some other heating cooling sensor somewhere .
View 5 Replies
My 94 Camry 4 cyl fuel gauge seems to be broke. It always shows empty. The "fuel warning" light doesn't come on however. The last time it worked, I had about 1/2 tank and filled it up. It took several minutes for the gauge to creep up to full. It worked for a few days and then when i started the car this evening, the gauge showed empty and tays on empty.
What is the most likely issue here? I've read that it could be the sending unit, bad wiring or the gauge itself. All other dashboard gauges are working fine.
View 12 Replies
My 2000 Toyota RAV 4 has had an oil leak problem for some time. So far, we have just been checking the oil frequently and adding oil as needed. The problem seems to be getting worse. I have taken it to more than one person and have received more than one recommendation. The car does have 244,000 miles on it so I realize that it would use more oil than a newer car. The last time the oil was checked it was after the car had been driven 136 miles. We added a little over a half quart of oil. Is that extreme? Should I be thinking of getting rid of the car?
View 16 Replies
My 22 year old daughter drives my 98 Toyota Camry. The lights in the dash have burned out. I need to find out how to replace those bulbs or should I just tell her to be home before dark or maybe tape a flashlight to the steering wheel?
View 6 Replies
