Camry :: 1994 Toyota LE - All Electrical Remains On With Key Removed From Ignition
Aug 20, 2014
I have a 1994 4 cyl Toyota Camry LE. For the last couple of years, when I parked the car after driving it and removed the key from the ignition, the air conditioning would continue to operate normally and blow cold air through the vents, and all of the other electrics would all operate for about 5 seconds, then shut down normally. Again, this was after driving the car, engine off, with the key removed and the ignition switch in the proper "off" position. I didn't think much of it at the time.
Recently, the problem has advanced to something worse. Now, when I turn off and remove the key, all electrical components remain on indefinitely (ie radio, air conditioning, wipers work, etc... )
I can physically power down each of the individual components using it's respective switch, but there is still accessory power on the vehicle. Basically, with the key removed, the vehicle thinks it is in accessory mode. All the dash lights are illuminated, like right before you start the vehicle. The only way to completely remove all electrical from the vehicle is to physically disconnect the battery.
View 6 Replies
Advertisement
I have a 2005 Toyota Camry LE. After changing the battery I now get an 12 beep sequence a few seconds after removing the key. The car is a base model and I do not have keyless ignition. It has two tones, and the sequence is high-low-high-low high-low-high-low high-low-high-low. I thought this was something reset after the battery change, but I can't find anything about it in the owners manual. I want to turn this off.
View 2 Replies
My 1994 Toyota Corolla wagon has a problem. I drove to work, all seemed fine. I jumped in it in the afternoon, and my key won't go in the ignition - it gets half way in, and that's it. It feels like the key is bumping into something into the ignition lock cylinder. In the interest of full disclosure, I've sprayed some WD-40 into the lock cylinder, thinking maybe the pins were jammed. If that is the case, it hasn't worked. Zero improvement. This originally happened when it was really cold out, so I've waited and tried it again on a warm (40 degree) day - no change (though my door lock and ignition have been more stubborn in the cold in the past, but only marginally so). So, what are my options? I guess you can't (easily) replace the lock cylinder without the key in the "on" or "acc" position (which I obviously cannot do). I'm not opposed to using a screwdriver as the key, or hot-wiring the car, but don't want to take drastic (or stupid) steps before being sure I don't have other choices..
View 6 Replies
My ignition is stuck in the on position. with the key removed the ignition is still on. the door alarm continues to ding like the key is in, and all the accessories stay on.
2001 7.3 limited.
View 8 Replies
Sometimes when I take the key out of the ignition, the wipers move up slightly. I notice the passenger's blade most as it parks a bit higher than the driver's blade, so when they move up the right one is more obvious. They don't move a full cycle, just up about an inch and stop.
View 16 Replies
I am happy owner of a 740 1987 4 door sedan. How to solve the problem: the engine do not stop when ignition key is removed.
View 3 Replies
2000 PASSAT 1.8t. As u pull out the key out of the ignition key chamber, u should here a click sound. That I believe signals the car that the key has been pulled out of the ignition key chamber. Well I don't hear the click sound anymore when the key is pulled out of the ignition key chamber and as a result, the car thinks the key is still is the ignition chamber, alarm does not work, radio stays on after key is out, I have to manually lock and unlock car. I think the key chamber has a pin that did not set right when I pulled the key out. I think some thing is stuck . Tired spraying WD40 into the key chamber with no results.
View 2 Replies
I guess not ALL of the time, but pretty often when I turn off my truck and remove the key from the ignition, I get the "key is in the ignition" chime, and I'm not allowed to lock my truck.
View 2 Replies
I get a call from my mother saying their 1994 Toyota Camry 2.2L car won't start. I went over there today and the first thing I check was the spark. I hooked my spark tester and had my dad crank the engine over. No spark. So I removed the distributor cap and tested the resistance on the primary and secondary sides of the coil. The secondary side was low. So I went and got a new coil, installed it and it still wouldn't start. I checked the spark again and it had spark, but still wouldn't start. I then proceeded to check the fuel pressure. I hooked up my pressure tester to fuel filter, with the included adapter, and had my dad turn the ignition switch to ON position. No pressure. Then I had him try and start the engine, the pressure jumped up to 41 PSI. I then sprayed a little gas into the throttle and the engine would try to start. I'm stuck.
View 5 Replies
Car has been working fine but yesterday the transmission just wouldn't engage. The engine was running fine. I've just been using it as my around town car so probably put about 5K miles on it a year at this point. It has small dent in the bumper and the interior is fine but old.
I'm tempted to replace the transmission because it is an easy (albeit expensive) solution, and less work (and money) than looking for another used car with an unknown history. But does it make any sense? I've replaced the exhaust, tires and battery recently. When might the engine start giving me trouble?
1994 Camry Wagon, 215k miles,
View 10 Replies
This started today, when I turn off the ignition and remove the key the radio stays on and the steering column does not lock. The guy at the dealership suggested spraying wd 40 into the ignition. No go.
2008 sonata.
View 3 Replies
In Jan my 94 Toyota Camry started having issues with starting- for instance, I would run an errand for 10 minutes get back in the car and it wouldn't start. However, this tended to be random. When this problem happened more often I took it in and they said I needed a new starter so I got one (Feb) and didn't have any issues for a month, but then began to have the same issue on and off again. I took my car back in for the second time and they said it must have been a bad starter. They gave me ANOTHER new starter (Apr) and my issues continued soon after. I took it back in and they didn't have an answer for me other than the starter was good. Took it to another mechanic and he had the car for two days and could not find ANY ISSUE with the car. I let it brush over during the summer months because I never had this issue (June-Aug) and now that it's gotten cold again I'm having this problem.
Few things to note: -Anytime I have this issue I'll hit the starter with a hammer and it will ALWAYS start. This has been the case since January.-It ALWAYS starts in the morning and when I get back in my car after working all day. However, if I were to run errands in the morning or at night it would not start with the stop and go. -This only happens in the cold months -They tested the newest starter and they say there's nothing wrong with it.-Within the past two years I've had MANY things replaced on this car and any shops I've taken it to say it's a great car with no issues they can find.
View 10 Replies
I have a 94 Camry 2.2. When I am driving 45 MPH the transmissions acts like it is shifting into N or OD and then the RPMS fluctuate between idle and 1500 or so. Then when I it will shift hard because the car has decelerated. If I stay in the throttle during this it just jerks or lunges.
View 3 Replies
My 94 Camry 4 cyl fuel gauge seems to be broke. It always shows empty. The "fuel warning" light doesn't come on however. The last time it worked, I had about 1/2 tank and filled it up. It took several minutes for the gauge to creep up to full. It worked for a few days and then when i started the car this evening, the gauge showed empty and tays on empty.
What is the most likely issue here? I've read that it could be the sending unit, bad wiring or the gauge itself. All other dashboard gauges are working fine.
View 12 Replies
I've got a 1994 Camry V6 that I am swapping transmissions from automatic to manual. Before the swap, the engine ran fine and started first time every time. Now that I have everything back together, the car will take many times of 10 seconds or longer cranking to be able to start. Once it does start, it idles very high and within 15 seconds will die. If, during the time it is running, you touch the gas at all, the car instantly dies. I've got CEL's for CPS and TPS. I have replaced both sensors numerous times, checking with a voltmeter they are within spec as are the wires, I have replaced the ECU and wiring harness.
View 5 Replies
1995 toyota camry 4 cylinder engine - My car was working fine yesterday, but today when I inserted my key; the key won't turn at all. I have try changing the shift control to neutral and jerk the steeling wheel. I have also went and copy my key. When I inserted the new key, it finally turn all the way, but then it got stuck in the ignition. After a few hour I got the new out of the ignition and try again. This time the new key can't turn all the way. My uncle believe that the key ignition sensory is the problem.
View 1 Replies
I own a toyota camry le automatic that has the engine light on and dies while driving. I've taken it to a mechanic and he diagnosed the error codes p0500 and 720. we fixed the 720 by replacing the trans. speed shaft sensor and replaced the vehicle speed sensor with one we bought from ebay. The rpm will shoot up randomly whilst the check engine light is on. the speedometer works just fine now. car dies when it slows down or at a stop. the rpm goes far below 1000 and i smell gas then i hear it beginning to struggle just to stay on.
The dash lights dim and return to normal then dim again and repeat then it shuts off and the battery light along with oil light come on. turns on fine but when put in reverse or drive it shuts off. it cant go more than 3 minutes without it messing up. when the engine light isn't on it runs just fine but once it turns on i've got about three minutes to get back somewhere safe. also when it does want to die i have to give it gas for it to stay on. i feel a major lag also and the o/d light flashes along with the pwr light.
View 1 Replies
When going short distances, half mile to two miles, and I turn off the car it will not REstart. Dash lights come on but engine does not make a sound. No clicking, no engine trying to turn over, nothing. After the car sits for awhile and cools off it starts up with no hesitation at all. If on the road for several minutes the car does not have this problem no matter how far or how many times I turn it off and on. The battery checks out ok. Someone said it could be a ground wire loose. What do you think. Is this something I could do myself?
View 5 Replies
I have a 1992 Toyota Camry. About once every 15 to 20 times I turn the ignition, the car won't start. Sometimes there's just a click and then nothing, and sometimes all the lights on the dashboard will flash for a second and then nothing, in each case the starter does not turn over. However, I discovered that instead of needing a jump from another car, if I just connect the jumper cables to the battery and leave the other end of the cable on the ground, the car will start right up after this happens. One other note, the clock is always reset after this. What is the problem and how can this be fixed?
View 6 Replies
I have a 1994 Toyota Camry. Took it to a shop to repair an oil leak. They had to dismount the transmission to get to the gasket. I got the car back and the transmission was messed up. Took it to a transmission shop and they told me that the transmission "cable" wasn't positioned correctly by whoever had done the work and they could fix it. They told me it was safe to drive it until my appointment. The engine was revving too high before changing gears and while driving home, I heard a loud rattling noise in the engine and my car stopped in the middle of the road. I'm told that a rod has broken inside the engine. My question is: can this in any way be related to the transmission cable not having been set/positioned correctly?
View 5 Replies
Just bought for around town. Problem with starting. Turn ignition and sometimes hear grind. Second try in neutral and she starts right up. I don't know if it's problem with key ignition/coil, or the starter.
Also need to convert a/c, fan ok but no cooling. Is this major cost to convert?
View 4 Replies
