Camry :: 09 - Power Steering Fluid Low Pressure Hose?
Oct 13, 2014
The Power Steering Reservoir has a small leak that makes the area under it looks oily and messy, so i followed a member's DIY PS flush, I used Walmart Supertech ATF Dexll/lll fluid but now I am thinking about using Mobil1 Synthetic ATF once I get the reservoir out.
The new red color shoes the leak is coming from the edge of the connection between the top and bottom plastic parts of the reservoir.
so my questions are:
1- How do i remove/pry or pop the reservoir out of its bracket?
2- Can i use JB Weld epoxy to glue/reinforce them parts together or just pick a used one from junkyard?
and last question: What size ID/OD is the PS fluid low pressure hose?
View 7 Replies
Advertisement
Just checked out at 2003 V6 LE with 120k miles for $5500. Car seems to be in excellent mechanical condition but I did notice quite a significant power steering fluid leak, seems to be coming from the reservoir. I see that there are two hoses for about $80 each listed on Partsgeek.
Is this a common problem, can the clamps just be tightened, Could it be the reservoir it's self or even the pump too high a pressure?
Seems to be quite a lot of fluid running down the side of the car but after taking it for a test drive I didn't see any signs of it squirting out so perhaps it's a slow leak and been leaking for a while.
View 6 Replies
I have an 07 Camry with a hard to turn steering wheel. I had to replace the high pressure hose from the rack due to a leak. After that I basically bled the system as one would do under normal circumstances. With the cars front wheels off the ground I turned the wheel hard left and right. The wheel did give a bit but not to the point of perfection. After many turns I put the vehicle on the ground and repeated the process. The fluid no longer leaked but the stiffness was still there.
The hose was replaced at 110,000 miles. It's currently at 112,000 miles
View 14 Replies
Just replaced power steering pressure hose while engine out as PM. New hose wasn't correct shape so I bent the tubing to fit. I later realized that I bought a hose for power steering without variable assist and the hose for variable assist looks correct.
Is there any harm in leaving the "w/o variable assist" hose in now?
View 1 Replies
I have a 1989 Honda Accord DX with less than 120k miles. I have two problems.
1) the low pressure hose for the power steering has worn out and is leaking by the fittings (badly) and I can't find the parts to fix it. The high pressure hose was also leaking but we found and replaced that part, and
2) I accidentally topped off the power steering reservoir with brake fluid (this was after I already knew the leaks existed).
View 4 Replies
So, I have a 1995 Jeep Grand Cherokee (Orvis edition) with about 270,000 miles. It still runs great and has been really useful in the snow this winter. A couple days ago the power steering pressure hose blew. My mechanic wants to replace it, but I can get a replacement hose locally. Is there any reason I shouldn't just do this myself. Do I need to worry about the fluid sprayed around the engine? The serpentine belt is only a few months old and squeaked only a little on the three mile drive to get it home.
View 8 Replies
My high pressure power steering hose just blew at the "B" nut at the pump. Meaning, the fitting is still in the pump but the line is out. Do I need to replace the whole line or is there a retainer I can swap out?
View 14 Replies
How to remove the "high pressure" power steering hose. I have drained the fluid, disconnected from the pump, and also from the rack. Removed the center clamp, and got it all "loose". However, I cannot seem to figure out how to "fish" the hose out. There is a long piece of metal tubing that connects into the rack, and it seems to be resting above some cross member that is not removable. Went to the library, and searched the AllData Online manuals. On the "How to replace the High Pressure Hose" page, it only showed a diagram of the power steering system, with no written description on how to remove the hose. I am not on a lift, but jacked up and supported and on my back under the car with the right wheel removed. I am stumped, and the new hose is due to arrive soon.
View 2 Replies
Just had dealer repair shop complete power steering fluid flush in Jan 2013. Vehicle now has lost all power steering fluid (April 2013) and dealer repair shop has told me it is due to high pressure hose failure - need to replace & then verify pump condition (dealer repair shop not sure if pump bad until hose replaced to test) for repair bill.. I was told this was not related to repair shop power steering flush because this hose not removed for flush or part of that procedure (at which time a transmission flush & spark plugs replaced (minor tune-up) . Just wondering if any pro mechanic can respond with advice about the relative close time frame these two events & if there may be a probable related reason?
View 4 Replies
I have a really small leak coming from the lower end of my power steering hose, it's super small, I was wondering if I could fix this by wiping it down really well and dry, and then layering it with plasti-dip. I think the leak is small/slow enough for me to get in a few good layers. Would this be an okay fix, or would the plasti-dip separate fast?
View 2 Replies
2001 F150 Supercrew 5.4L ... Dealership unable to locate replacement pressure hose for power steering . I've returned 3 wrong parts. The hose in pic goes all the way up to the reservoir.
View 13 Replies
I just recently had a new pressure hose (had a leak) replaced on the power steering pump but there is a slight squeaking noise when I turn the wheel. the mechanic says it'll go away after a week or so because of the new fluid that was put in? Is this correct?
View 4 Replies
I have a 2004 with the 4.6l. The high pressure hose is leaking from rust. From other posts I have read, it looks like I should rent a puller and remove the pulley first, and then I'll have access to where the hose connects to the pump.
Question: The leak occurred while driving home from vacation today. Went we stopped for gas, we noticed a shutter in the steering. I added about a 1/2 quart to the reservoir - there was still some fluid but foamy. I made it home, and I when I checked again the reservoir was empty.
Should I go ahead and replace the pump while I am at it? I wondering it if could have gotten damaged from low fluid. The truck has 190k so it's not like the pump owes me anything. Will it make any of the repair easier to toss out the pump too?
View 9 Replies
OK, I have developed a leak in the power steering hose that connects to the fluid reservoir (the smaller diameter hose). The dealer only sells this as an assembly (all the way to the pump, and very expensive). The hose is molded. Need to replace just this first hose section? AutoZone and several others I checked don't seem to have this (at least on line).
View 11 Replies
So the big rubber hose attached to my power steering reservoir is leaking and my mechanic told me to replace it. I went to a couple of different Autozone stores and they both couldn't identify the correct dimensions of it. They told me to take it out and then bring it to them. This is very hard for me since this is my only car and how to pull the bottom bit of the hose out from whatever it's attached to.
I've measured the length to be about 2.4 feet but I'm not sure on how thick it is. I've taken a pic of the hose here:
View 2 Replies
2010 camry LE
A family member did a tune up on the car and did not realize that the power steering reservoir had a HOT and COLD min/max lines. He filled up to the max line for HOT while the car was completely cold. He also filled up with Prestone Power Steering fluid with Stop Leak instead of ATF/DEXIII.
The car was driven a few times for maybe 50 miles in total before I found out about all this and I drained the fluid out to the appropriate levels. However the steering at low/parking speeds is still very tight (tighter than what I used to remember, at least).
Did he royally screw up the power steering system here? What can I do?
View 2 Replies
I have a 2006 Camry 4 cylinder. The bigger rubber hose coming out from the power steering fluid reservoir has been leaking for quite some time now. I've tried putting a second clamp on it which has worked but hasn't stopped the leak completely. As far as I understand, the big hose has a certain bend to it so I can't just get any rubber hose from an auto parts store and chug it in.
It is leaking all over the nearby surface:
I need to identify the part number for that power steering rubber hose so that I can replace it once and for all. Once the power steering fluid leaks out, my steering starts groaning whenever I turn it.
View 3 Replies
I need to replace the power steering hose because my power steering fluid is leaking. Is this the right part? [URL] .....
View 14 Replies
So I've been noticing my power steering in the reservoir has been going down for quite some time. Now its more noticeable than ever. Just about a month ago I topped off the tank to the "max" line and now its at the "min" line. I also notice the fluid on the garage floor. I've always had a lot of grease (I assume the fluid) all around the body and under the reservoir under the hood. It seems to be leaking from the hose where it connects to the actual reservoir. Maybe the clamp is bad or something.
View 14 Replies
My power steering fluid reservoir is a little low. Which type or brand of power steering fluid should I fill it up with?
I know that I should use Dextron III, but does the brand matter? Or can I mix the OEM fluid with an aftermarket fluid.
View 3 Replies
My wife was driving yesterday from work and suddenly felt the steering becoming hard to steer so she was able to drive home but barely made it to our driveway (very hard to steer). I saw fluid dripping down the right side of the car. I opened the hood and saw lots of brown fluid spilled all over. Power steering fluid reservoir was empty. So my question is, is this primarily caused by power steering pump failure causing spillage of fluid contaminating the drive belt causing it to slip (car overheated a little bit) or Serpentine belt failure (120,000 miles with original belt) causing power steering pump to fail and eventually leak fluid.
Photos: [URL] .....
View 6 Replies
