Camry :: 08 - Car Vibrates When Braking At High Speed
Oct 6, 2013
My car is an 08' camry LE v6. I bought it with 45,000 miles on it and I've had this issue since I got it, put 10k miles on it with no change. When I am going 55mph+ or going downhill the car vibrates when I brake, the steering wheel shakes pretty violently. It doesn't seem to affect the stopping power and it's perfectly smooth at low speeds. I don't think it's a wheel balance/alignment issue because it's only when braking, even at 80mph this car is the smoothest ride I've ever had.
View 7 Replies
Advertisement
I just bought a 2009 Toyota Camry with 78K miles on it. Everything is great except at highway speeds it shakes and vibrates when braking. The higher the speed the worse it is. Steering wheel shakes as well. I pulled both front tires off and the rotors appear to be smoothe on both sides with no grooves, etc. However, I'm due for new front brake pads. There's some pad left but could that be why it shakes and vibrates when braking? How do you tell if rotors are warped? Rotors are smooth but could they still be warped?
View 16 Replies
I have an 05 Camry LE & when ever I'm on the highway going around 50-80mph & need to break my steering wheel starts to shake until I either stop or put my foot back on the gas. Last year my power steering rack & one of my motor mounts got replaced, & for awhile it stopped & figured because that was going out that's what was causing it.
Well about a month later it started back up & still does it, I've taken it to the dealership & have told them & they test drove it, felt the same thing I felt but didn't find anything. Is there anything else that could be causing it ? Earlier last year my bearings were lose in the front, and I managed to get my brakes stuck & had that all fixed & since then that's when it started shaking . I took it back to that shop & mention every time I go in for oil changes at my dealership, is there something else I'm not aware about that I should ask them to look at ?
View 6 Replies
If the front rotors are warped would I not feel it when braking anytime and not just braking hard at high speed?
View 2 Replies
I've been noticing my steering wheel shakes if i normally brake going on the highway at high speed. My friend said that it's probably your brakes and rotors. Get them replaced and resurface and that should fix the problem. Can i get some confirmation before i do this?
1. I just had my tires replace at 55k and bought this car new back in feb 09. it has 62k.
2. also i've been reading up on camries fail water pump. i'm thinking of doing this over the weekend or should i just wait until i notice some leaks?
3. lastly, any major thing i need to be aware of. i've done the normal engine oil and filter change, cabin and engine air filter change, that's about it. i hope these camries are bullet proof like the old school (92-95).
View 14 Replies
Just 2 months old car with 1100 miles on it suddenly chokes, vibrates profoundly when it slows down from high speed and turns the check engine malfunction light on ...
Dealer checks and finds following codes P0171(too lean), P0441 Purge & P0455 Gross leak ...
View 19 Replies
2010 RX 350 NAP ... Brand New and OEM where it would apply : Tires (Conti's LX20s)
Brakes / Rotors (had same shake before replacing and did not improve after replacement but maybe I am dealing with a bad caliper here)
Tie Rod Ends
Stab Links
Lower Control Arm Ball Joint
None of which have solved a vibration issue thus far. Strut feels solid and the corner push test had the car settle out in less than 2 bounces.
If car has sat a while the driver front (where the issue lies) feels like a imbalanced tire/bent rim (rotated the wheels just to be sure it didn't follow the wheel/tire) or like a broken belt. The tires are almost brand new and only put them on because I was trying to eliminate the point of issue.
When braking, a light touch to the brake pedal makes a almost light clank sound (like weight shift is causing the clank or perhaps a sign of a bad caliper (although pad wear looks even but didn't have rotors rechecked but even with brand new rotors it was there so I don't feel it's a warped rotor plus the vibration is there even when not applying the brakes.
There is only one control arm and the bushing didn't look cracked beyond the normal surface cracking I have seen on most rubber bushing. The upper support is from the strut so perhaps a bad strut or maybe strut support/cap/bearing?
At a total loss as the local garages cannot find anything wrong. My thought was a bad wheel bearing, although there is not any grinding sound that you typically hear when a hub is going bad.
Could also be the CV Joint but not sure how to tell if that really issue the issue unless I replace all the other parts first (hub, caliper, strut/support/bearing).
View 9 Replies
My Prius c has always made a high speed whirling noise when braking but now at speeds of 42 to 46 MPH this high speed whirling noise is there and when you are just coasting have a noisy transmission or is this something I should be getting to the dealer with.
EVCT transmission noise ....
View 7 Replies
Lately my 2007 GX470's steering wheel has a shaking/vibrating problem whenever I apply the brake at speed above 50 mph or so. Without braking or with braking at slower speed, there is no problem at all -- everything is glass smooth.
1. I assume the front brake rotor is warped?
2. Will I need to change the rotor or is there a way to fix the warp (it that's the problem) without changing the rotor?
3. Approximate part & labor cost?
I plan to bring to dealer for a check up but would like to know ahead of time what to expect.
View 14 Replies
I got an 04 GLI ... When I'm driving at about 60 mph, and I apply the brakes lightly, i get a vibration in the steering wheel. it doesn't happen under heavy breaking, just when i press the pedal down lightly to slow down, and there is NO pulsation in the pedal at all during any time.
Some history of the car:
Just did pads and rotors 2 weeks ago,
car has spacers, hub centring.. the problem occurs with out the spacers also.
had an alignment a month ago.
had tires balanced 2 months ago
tires are 2 months old.
View 9 Replies
It's a 2003 Ford F-150. When I'm driving slow I hear what sounds like a tin can clanking up against another piece of metal, coming from the rear end. Right, Left, or center I'm not sure. U-joint maybe?
There is also a bit of wobbling when I'm braking at a high rate of speed.
View 5 Replies
I own an 08 Rx350 at 70k miles now. This is my first car ever; my parents bought it brand new and gave to me as gift after I graduated from college. I try to take good care of it; whatever the dealership tells me to replace, I replace it. I follow the maintenance schedule and owners guide to a T. I never really paid attention when my parents drove this car...but I don't know why my car vibrates when I get maybe above 60 mph and try to apply the brake. I do not brake hard and now I pretty much avoid applying brake and just let it glide. Is this normal? Whenever I visit the dealership they do a complete check up. All the check up results are normal;nothing wrong with tire trims, brake pads, suspension etc.
View 9 Replies
My 2002 v6 camry is shaking while braking on a downhill at highway speed 60mph. This started yesterday. Afterwards on level surface and lower speed no shaking. Late yesterday, again on highway downhill, more shaking.
I live on a mountain and do not notice the shaking coming down at 30mph, including yesterday.
A couple of months ago the pads were 75% and the rotors were resurfaced approx 4000 miles ago. And the rotors are the third pair if i remember correctly.
I bought the car new and it has 121000 miles on it.
View 8 Replies
On my 2006 Camry, my ABS comes on intermittently when braking (~5% of the time) and the speed is very slow (5 mph or less). Exact speed is hard to say. I think one of the ABS sensors is misreading. No ABS fault light on dash.I have an explanation of how to check the sensors for AC voltage when spinning the wheel using a DVM.
1. Without a lift can I check this under the hood instead of at the wheel? Possibly at the plug into the ABS module.
2. Someone else on another thread mentioned that their dealership hooked in a monitor and drove around.
When I asked my dealership how they would diagnose this, they said they would do the same check as I mentioned above (#1). This would be expensive and since it is intermittent, they might not see anything. Do this monitor exists and what it is called?
View 13 Replies
I have an 03 Camry LE I4 with about just under 100k miles. Recently, under semi hard braking at highway speeds, the steering wheel will shake quite a bit to the point that I don't feel safe braking hard. I initially thought the brake rotors were warped, but those were replaced less than 2 years ago somewhere around 80k miles. I've taken it to many shops and here are the verdicts they've given me:
1. Rear drums are warped which is the problem (I don't think so...)
2. Control arm bushings need replacement (coming from shop who did brake work before)
3. Ball joints need to be replaced
4. All rotors should be resurfaced
What should I do?
View 9 Replies
I switched my front rotors 4 times in the last 4 years.
I know you probably thinking its the driver. I've owned the car since 2012 and have only put on 46000 kms.
The rotors vibrate and have that weird stop and go hesitation when braking.
Is it simply OEM or nothing?
View 15 Replies
This is a 1996 Toyota Tacoma, 2WD, 2.4L. When I apply the brakes I get a very heavy vibration in the front end, almost like a wobble. The vehicle otherwise stops fine. No noises. The vibration occurs at pretty much any speed over 20 mph. The frequency does not seem tied to the actual speed but it's hard to tell for sure. It does not do it when I apply the emergency brake only.
I replaced the front disk brake pads, with new clips and shims. There were worn down pretty far and needed replacing. Unfortunately that did not make any difference in the vibration. Rotor runout and minumum thickness were checked while changing the disk brake pads and both were within specs. I did a quick inspection of the ball joints and tie rod ends by trying to move the tire and everything seems tight enough.
I'm not very proficient on suspension issues. What else can I look for.
View 19 Replies
We have the 6.8 4x4 2001. Mostly use it for towing 6K #. Bought 2 years ago. Front and rear brakes were new and all 4 rotors were machined at Ford dealership prior to purchase. Have put on 13,000 miles since then, majority towing.
View 14 Replies
I have a 2012 camry se v6, with about 56k miles. It has been lowered on H&R springs since 20k miles. I recently got new rims, but used my old tires. I developed a high speed vibration. I got it aligned twice, and balance twice. But i still can not get rid of this vibration?
View 2 Replies
Ever since day 1 when I make a hard stop i had a vibration when braking - heard i need to put bigger rotors on also change calipers - asked FORD about this and they said it would have to be aftermarket rotors and calipers ???
View 9 Replies
Camry 2000 CE 102,xxx miles. My car died in Jan 14, after have P0770 for while, only Reverse gear work. The mechanics said the tranny need to re-build. I had him bring the tranny to tranny shop to re-build ($1650), then the code still pop up. Brought it back, they said the ECU needs to be reset. I had the car next day then that code pop up again!
They replaced the Solenoid E. The code is still there. Brought the car back, they took the tranny to rebuild it again. Drive the car for a day, the darn code pop up again, now they blamed on the ECU. Ok my mechanic guy replaced it at my own cost for part ($150) but the code is still there. This time they blamed on the high idle rpm approx. 1600-1800. My mechanic tried to fix the high idle speed so the tranny stop blaming other causes. He cleaned IAC valve, replace O-rings (I don't remember the location of them) then he said whenever he inserted the new ones, they start to crack!
View 1 Replies
