C/K :: 1988 - Oil Pressure Gauge Pegged At Max When Running
Dec 12, 2015
So I have an 88 k1500 with the 350 that the previous owner removed and rebuilt... Didn't hook a lot of stuff back up etc... It's like a puzzle. It runs good for the most part but the oil pressure gauge in the cab pegs out when it's running. I've heard 1989 and older 350 engines have 2 oil pressure switches/sending units. I know about the one up by the distributor. But can't seem to locate the other one. Also what does the one by the distributor control? And what does the other one control?
View 1 Replies
Advertisement
95 jeep cherokee. My oil pressure gauge sometimes jumps up to 80lbs or bobs between 40 and 80lbs. Could this be anything other than sensor or gauge itself?
View 12 Replies
I have a 2000 Accent GL with the 1.3
I was driving home with a known overheating problem, when the temp gauge pegged and a heard a distinct rattling. I knew right away what happened. as I pulled over the engine stopped turning. I opened up the hood, and my suspicions were confirmed. I blew a headgasket. I went back into the car to call AAA, and I heard a loud POP!! the radiator blew from the heat and pressure.
after it got home and cooled down I tried cranking it over and it has NO comression. it just spins.
should I take the time and money to replace the headgasket, or should I just get a junkyard motor?
I know I need a new MAF. I had a "multiplicative fuel system running lean" code for a LONG time. I regrettably assume this is what caused the failure in the first place.
View 18 Replies
So a couple weeks back I'm on expressway home and I look down and and temp gauge is pegged out overheating I immediately pulled off and shut it down and towed to a buddy of mine's shop he flushed it filled it up w antifreeze and checked for leaks and couldn't find one. I drove it for about a week and got out to for a quick stop , Ex parked on a slight decline and came out to prolly half gallon of coolant on the ground..I limped it to my buddies shop as it was not running hot .. he has checked it out but can't find any leaks, even after having it run 30 or so minutes..
View 6 Replies
Yesterday my fuel gauge stopped working it is pegged all the way to the left. I filled up the truck no change. Got home and my garage door opener would not work and when sitting in car the map lights wont come on, the overhead lights work when you open the door. Cannot find any reference to what fuse any those items are connected to. is there a fuse for the fuel gauge?
View 9 Replies
The Oil Gauge on the Instrument panel of my '99 Jeep Cherokee Classic is pegged fully to the right (TWICE the normal reading) when the vehicle is Stopped at a Light or stop sign. As I accelerate the needle drops down to NEARLY normal but pegs again as I decelerate to a stop. The engine sounds normal, operates like normal, no smells, oil level on dipstick is OK. What's up with this?
View 3 Replies
Boost gauge is pegged and have no turbo don't know if the code has anything to do with the problem or not its a po6a7...
View 6 Replies
Twice in the last year my 1999 Ranger (@138,000 miles) has started running very loudly: I checked dash and see oil pressure gauge says no oil pressure. First time this happened, I pulled over, had it towed. At garage they start it up: gauge normal, they check oil says its OK. I take it to the dealership, they replace sending unit, but can't explain why it was running loudly. Today same thing happens: I checked oil pressure gauge, it's OK. After an hour, starts running loudly, gauge in red. Park car for 15 - 20 minutes, start it up: all is well: gauge OK, running quietly. This is amy 'spare' car, so it only gets driven 1 -2 times per month, short distances.
View 4 Replies
My truck threw a code p1299 last night on my way home from the lake. I was towing on a huge grade and all the sudden my engine temp gauge pegged out on me and check engine light came on. I pulled over and noticed a bunch of coolant had overflown the cap but the engine didn't seem to have over heated. When I restarted the truck the engine temp was immediately normal range. I drove for another 30 min or so and the engine temp started to climb and then come back to normal then climb and stay pegged. I pulled over again and noticed the coolant level was low and coolant had overflown the reservoir. I restarted the truck and once again it was normal. I just drove surface streets the rest of the way with no issue. I suspect blown head gasket. This is a 2003 F-250 6.8L with 100000 miles.
View 8 Replies
Driving my 2003 today seen the "check gages" light on and the trans temp gage pegged on hot. CRAP, tranny time! look at the edge evo and it reads trans temp as -60F ???. Plugged in the torque pro and it reads 8,240F. At that point I figure its PROBABLY not that hot. Let it sit for a while and back to normal. Watch trans temp on torque pro as I drive it and everything is fine till it gets to about 150, then it jumps to 60F, then 30F, the 8240F. The cooler lines and trans pan are both feel normal. Picked up a new temp sender on my way home.
View 5 Replies
OK so 2006 f550 6.0
If I want to monitor fuel pressure with a gauge in cab while running all the time... (not just testing) can I purchase one of the secondary fuel filter caps that have a port in the top and connect the sensor to this to run or is there a better way? (Or is that not going to work)
Cap I am talking about is something like this
[URL]
(I know this is a combo kit but they do sell the fuel only) But since it has a threaded port in the top I could connect the fuel pressure sensor to that and go from there correct? Would that give accurate readings?
View 4 Replies
'98 Regal LS. The car was parked with the engine running, and the doors locked spontaneously. Starting then, noticed that the fuel gauge and coolant temp gauge were pegged out.
Short somewhere? Could a bad BCM cause this?
View 3 Replies
I got an 88 celica convertible from my neighbor. This is a fixer upper. It needs a battery and an alternator. But i jumped it and after idling for 10 minutes, the temperature Gauge was almost in the red. Yes the radiator has water in it. Is it the thermostat? Or the head gasket?
View 2 Replies
'97 F150 4.6L 4wd automatic... My gauge jumps around, sometimes it works and other times it shows no pressure. Could that be the oil pump? Or is the gauge most likely bad? Whats the actual purpose of an oil sending unit?
View 6 Replies
Last week I was driving on the highway and noticed the oil pressure gauge showed no pressure. Limped a half mile to the mother-in-laws and called for a tow. As my truck was pulled onto the flatbed I could see oil all over the bottom of the engine, tranny, rear end, etc. Turned out to be a bad oil pressure sender, which was leaking enough oil to blow the plug off the top of it.
I replaced the sensor, cleaned the engine and under-carriage, checked oil level (which showed no loss of oil) and drove around for a week without an oil pressure gauge while I waited for a new pigtail. Put the pigtail in yesterday and drove it today for the first time since. Gauge was working, got to the bank and it was reading zero pressure again. Limped home and watched the gauge go back up quickly and then back down. This happened twice and was showing pressure when I shut it off. Checked under hood, no oil leaks and plug is still secure.
View 9 Replies
The tire pressure warning light has been on in my car for about a week. The dashboard computer says that the tire pressure in the front right tire is 17 psi, but when I use the pressure gauge, the reading is almost 40 psi. Is this something I should be concerned about? What could be causing this problem?
View 16 Replies
I was recently given my first Volvo. Its an 88 240dl. While driving my temp gauge climbs up to the red and sometimes hovers inside of it. It normally climbs up at stop signs and comes down on straight always then climbs right back up close to red. When the gauge was in the red i stopped the car and popped the hood open to see that the engine was not actually overly hot.
first i replaced coolant. nothing
then i replaced the thermostat. nothing
flushed radiator. nothing
Today i finally had enough and decided to switch out the water pump with a new one hoping that it would solve the problem seeing as it still had the factory one on. It did nothing. the gauge continues to climb up. I did replace one of the two senders in hope that it would fix the gauge reading but nothing.
View 4 Replies
My 1988 240DL wagon....the engine temp gauge is not working? is see the wire that goes to the sensor in the engine block, it is there and connected to the sensor. is there a way to test the wire? I have purchased a new sensor, but I have not replaced it yet.
View 1 Replies
How would I test (if Possible) the A/C Clutch Cycling Pressure Switch on my 88 E-150 4.9L? I had to replace the evaporator, it was leaking along a seam. I have a feeling the Cycling Switch is bad too.
I was hoping for a simple test w/o Gauges. The Switch is in a real tough spot to remove it. I also heard they could be adjusted. There are no leaks in the system and no blockages, that we detected when we evacuated and recharged the system.
View 6 Replies
My 1988 jaguar it don't matter whether the weather is hot or cold it will run great for about six or seven miles then it will just shut off like you turned the key off. well then you can wait about 15 or 20 minutes and ti will start and run fine for another few miles off again.
View 11 Replies
'88 K1500 350 with the Holley 670cfm TBI. Last year this truck started intermittently running rich to the point of stalling while at idle. I replaced the coolant temperature sensor and it ran fine, for a while. After a few months the same issue returned during cold weather but seemed to resolve this spring when things turned warm. Now the engine is really running rich all the time. I checked the CTS and got 2400 Ohms cold and 270 Ohms hot which isn't far form what I found as to be in spec. If I disconnect the CTS the truck runs better (idles up some) and does not appear to be running as rich but still not right. There are no codes in the computer and the O2 sensor was also replaced not that long ago.
View 5 Replies
