I have a 1994 Buick LeSabre Limited with a 3800 engine.When the engines cold,it starts fine and drives fine.When it reaches operating temp,if you shut it off. It will crank but not start back up until its cold again. I've replaced the crank and cam sensors but no change.
View 2 RepliesHaving issues with 00 lincoln ls not reaching normal operating temp.
View 1 Replies I own a 2012 GTI. For about the last week the cat needs to be driven for about 8 miles before reaching operating temperature (190). If I make a stop before the gauge has reached 190, the car will cool of very quickly. I realize it is very cold outside but this car and previous GTIs have not had this problem. The heater will not produce heat for the first 4 miles or so which is also not normal. The car has 17,000 miles and is parked in a heated garage every night, fwiw.
Maybe the water pump or something else in the HVAC system?
I have a 2002 jeep wrangler TJ, 4-cylinder and lately it has been stuttering/hesitating after the car reaches its' operating temp. To give more context, I've had a similar issue recently that a local mechanic said resulted from a bad o2 sensor and exhaust leaks. He fixed what he could and replaced the sensor. This fixed the issue, but he did mention there was another leak in the manifold that he couldn't get to? I asked him if it was okay to drive for the time being and he said yes. A couple months have passed and I'm now getting the same issue. I'm wondering if it is a result of the leak and if I've worsened the situation? Currently I'm noticing the same hesitation/stuttering accompanied now by a strong exhaust smell while driving. Also there seems to be a buildup on the engine itself as if there is an oil leak. I'm not 100% everything is related, but I'm willing to bet they have stemmed from the same unresolved issue.
I realize this jeep is 12 years old and that things are bound to happen. Unfortunately, I'm a broke college student and I've already spent quite a bit on other repairs recently. (new radiator, oil pressure sending switch, power steering sensor, leak repair, etc.) I'm at my wits end because this is my daily driver and I don't want to exacerbate the problem!
So beating the dead horse here. I have an 03 6.0 that the batt light comes on only after reaching operating temp. Using fords self test mode it shows 13.5V to 14.3V, pull the regulator plug light goes out, A circuit has batt V and I circuit has no V Key off and batt V with key on. I have wiggled wires in the dash and under the hood replaced the reg plug. I feel as though I have read every thread with not much success.
View 7 RepliesMy Buick has started acting weird and I've had a hard time figuring out what's going on. As I understand it 94' was the transition year for the OBD1 and OBD2 sensors, therefore auto zone and o'reilly haven't been able to pull codes on my car. It runs off of OBD1 codes but has 16 point OBD2 sensor pins.
Here's the problem: When the car is started it revs up to 2000rpm at idle, when shifted into neutral the rpm jumps up to 3500. In drive and reverse it goes back down to 2000rpm. While driving the car is hard to stop and surges when I take my foot off the break, it also gains speed on flat ground without touching the gas pedal. After driving the car when I put it back in park it revs back up to 3500rpm and is quite noisy.
I've replaced the mass airflow sensor, cleaned out the entire throttle body (there was a little carbon build up but not too bad), replaced all the vacuum hoses(that put a stop to it for about a week), and I'm still having the same problems. I recently replaced the a/c pump because the bearings went bad but I don't think that would cause any problems like this.
I have a very, very slight gasket leak on my valve covers but it's been like that for the last few months and the car was acting fine. The car has done this before but it usually stops after you drive it somewhere. The hotter it's gotten out the more often it started happening and now it's not stopping like it did before.
Since our weather has turned cold with lows just above 0ºF and highs around 10ºF, and we've had 9" of snow this week, I have been driving a seldom used 1994 LeSabre rather than my "nice" car, an '08 Grand Marquis. There's no point in exposing the newer car to salt and slick streets. At least the interstates are completely cleared off. The LeSabre runs great despite its 177K miles. The only issue I have with the Buick is that it has died repeatedly after a 20 mile run up or down the interstate. I lift my foot or tap the brake pedal to turn off the cruise control, and the engine dies. The first time it did it, I pulled over, stopped, put it in park and restarted it. Now that I know what it's doing, I keep rolling, put it in neutral, and restart it before getting to the bottom of the ramp. I does it ALMOST every time after a long 65 to 70 MPH run. It was not doing it the last time I drove it at more bearable temperatures, in the 40s or 50s so it may not be a problem next week. It does not seem to do it going from stop light to stop light, even at low temperatures. It has the 3.8 Liter V-6. Why it might be doing this?
View 10 Replies1994 Buick LeSabre Custom 3.8 Litre V6 with 103277 miles.
It runs smooth when idling in Park, rough when I put it in gear when I am stopped (either drive or reverse) has hesitation when accelerating, it smooths out again when driving then it starts to drive rough at about 55 MPH.
Mechanic told me it was the plug wires. I replaced those and the plugs. This fixed the hesitation when accelerating issue, but the other issues remain (now even seem a little worse) I thought the plugs and/or wires were bad, so I rechecked the gauge on the plugs and traced to make sure I had the wires hooked up right. Everything seems in order.
I have added fuel injector cleaner, and changed the oil, oil filter, spark plugs, spark plug wires, air filter, flushed the radiator, and changed the thermostat. (For a tune up since it has admittedly been a while)....
I have a 94 buick lesabre custom that is stalling intermittently and runs rough intermittently. We have had it for diagnostics and it could not read the codes. We changed the computer and it still can't read the codes. The diagnostic tool says it cannot connect when it is plugged in or it displays white flecks like snow flakes on the tool screen. It is an OBDII. The pin structure of the data connector port is two pins top row and bottom row two pins some blanks and one pin. We don't know how to fix it with no diagnostic codes and we don't know what to do to get the codes because we have changed the computer.
View 8 Replies'92 Camry 5S-FE 4cyl 2.2L A/T; This one has me puzzled. Runs well, newer ignition parts, but does not start when warmed up to OpTemp. Starts fine cold, restarts when warm after 5-10 minute cool down (is not overheating). Will start hot if starting fluid is injected into throttle body, so problem is unlikely spark, it has to be fuel, right? Just ran SeaFoam thru top end as I was advised it could have been carbon build up, but that did not fix. Got some carbon burn off, but hot start issue remained.
Could it be fuel pressure regulator? Fuel pump and filter both replaced less than a year ago. I have basic tools, but not much more than a Multimeter for test equipment.
My car would not start yesterday, and I realized the fuel pump was not running. So I bought a new fuel pump today and put it on, the car still won't start, the fuel pump still does not run and I have been told to check the relay. I cannot find the relay for this car.
View 7 RepliesI have a 2002 Buick LeSabre. Back information is this. the car has had a coolant leak for years, very slow though. Last night while working (I drive for a living) the thermostat climbed up to hot and then immediately went back down to the middle range where it normally goes, so I thought I was fine. It then climbed back up and staled out. It started again nearly immediately and I made it back to my work. About 30 minutes later I began to drive home. The temperature gauge started to climb up again, and then immediately went back to normal running temperature. I kept an eye on it.
About 2 minutes later it shut off completely. I had dash lights, head lights, and emergency flashers. Trying to restart it killed my battery and I had it towed home. This morning I put water in it (it was a gallon low even though I had filled it three days prior). I got a jump start but the car wouldn't start. It cranked and cranked but would not start. I did notice a leak of water from near the bottom of the engine. I am curious as to what the problem may be and why it is not starting now.
The car (97 Buick Le Sabre with 3800) ran fine and started fine until one day last week it did not turn over. After about 10 minutes it was tried again and this time it did start. It was used regularly with no issues for the next few days. Then one morning it didn't start (or turn over) and hasn't really been successfully started since. The battery is good and cable connections too. So my mechanic figured it was probably the starter. Since I had this weekend free, me and my friend replaced the starter. But it still did not start. We then turned the ignition to run and crossed the solenoid terminals with a metal tool and then the engine turned over and ran for a brief period (around 5 to 10 seconds) but then killed.
This procedure was duplicated a few times. So we figure it wasn't the starter, the battery, or most of the larger cable connections. The tension wheel had failed on it in the recent past so we wonder if when the belt blew out if it had hit and weakened a wire somewhere that has now failed but difficult to locate. We also wonder if the car's security system maybe failed and it thinks the car has been stolen. This might explain why it won't start or stay running when ignition is circumvented. Note: the panic button on the key fob works properly. All of the fuses were checked and none were found to be blown out. What the root cause of this problem might be and how to repair it?
1996 Buick Le Sabre. About 1 time in 10, the car will not start. The starter is fine; seems to get no gas. Took it to garage for diagnosis. They could find NO problem: but replaced plugs and wires anyhow. Car still refuses to start -- just about 1 time in 10. It seems to have a bigger problem if the car was parked going UPHILL. This is not always the case. Is it likely to be the fuel pump? Is there no way to check this without simply replacing the fuel pump?
View 4 RepliesI have a 2001 Buick LeSabre (Limited), with 101,000 miles. It runs great and a very reliable car except:
After going for some driving in town during a warm day (60 F or above) doing business, the engine gets warm but within normal temperature range, and after making a stop to get groceries for eample, I have to be very careful when starting the car again. If I let the starter go for more than a quarter tourn (crank), the engine gets week and acts like it is flooded with gas, just like when we had carburators in old car and it dies after a few shakings.
So I have to wait for 15 minutes at least before I restart the engine but doing so I have to be really careful again not to let the starter crank for more than a quarter turn. However, this problem does not happen during cold weather days (say below 40 degrees F). What is going on with my car?
My buick has a weird problem, basically it wont start the security light comes on, nothing and i mean absolutely nothing works inside of the car and the power window circuit breaker under the back seat is burning hot, obviously its an electrical problem but I am thinking its the body control module but I want to be sure .... what it could be?
View 5 RepliesMy dad has a 98 Buick La Sabre that will shut off at times. It once shut off as he was turning on the air cond. last summer. Right after it stalled and would not start he attempted to open the windows but they would not work. After a few hours and cooling off it started and the windows worked again. He took it to a shop who said it was the map sensor. They changed it but the problem happened again a few weeks after. The fuel pump has recently been changed along with the fuel filter.
One mechanic suggested it could be the ignition control modular or knock sensor. He recently got a different car so I an going to test drive it for a while. If it shuts down I will test for spark to confirm it is not a fuel problem. I will also try swooping relays to see if that is not the problem. I will be cleaning all the connections I can find with contact cleaner as it can't hurt.
What could be the problem. Could it be a short, a bad wire that once it gets to much of a load on it cuts the engine off?
95 ford f250 with 5.8l. I have currently replaced the battery, alternator, distributor, cap, rotor, icm, coil, plugs, wires, act sensor, ect sensor, fuel pump, fuel press regulator. I got it to start today by messing with timing at distributor it ran to operating temp and died. Would crank but not start.. So I replaced the act tensor today.. Now it still won't start... koeo test gives code 327... I am stumped and about to tow it away...
View 11 RepliesI have a 99 Buick LeSabre and it died while I was pulling into a parking lot. It wouldn't start back up. I tried listening for the fuel pump and nothing. It's not priming or making any noise. Once I got it home I replaced the fuel pump relay. Still nothing so then I changed the fuel pump. Still nothing. I'm stumped. I'm going to check all the wires tonight to make sure I got them on right. Is there any other relay or fuse on these cars that I can check?
View 3 RepliesI was wondering my buick a 1995 lasbre it cranks up fine and the engine light comes on and off when i start driving it cuts off and cranks right back up people say its the crank sensor...
View 1 Replies Having a problem with my 1997 Buick Lesabre. It's a v6, automatic 4 door, and I live in good ole HOT Florida.
Anyway for about two weeks ago I went to start up the vehicle and it would turn over, run for about 2 seconds, and then turn off and did that about 5 or 6 times. Knowing very little about cars I had a friend try to jump me, and nothing, still wouldn't turn on. So I left the car there, came back five days later. It started and ran, and I drove straight to the mechanic. I had noticed my belt whistling a little so he put on a new built, fix a power steering pump fluid leak, and put on a new belt tensioner.
Anyway, I pick it up a week ago and it starts up no problem. Today the problem has started again. Some times now though it will start up, run for a little while and then just shut off. Doesn't seem to make a difference whether I am idling or not. Sometimes now though it will turn over, but not actually fire up and start.