My car has a little over 200k on it. It does have new brakes on the front. I can hear the wheels squeak when I drive. It only does it sometimes, but i can hear it the most going around 30 MPH but it will speed up as I speed up, etc. Like I said it only does it sometimes. What it is. I bought it after brakes were put on, btw.
View 13 RepliesSo recently after new tires installed and alignment done (1 month ago) I noticed a squeak/creaking sound while driving (0-40MPH) if i turn my wheel right a little it will squeak. It sound like its coming from the right side rear wheel. Prior to tire/alignment i had my brakes changed and resurfaced the rotors (2 months ago). My car is a 2013 chrysler 200. I noticed the noise a day after the alignment but not sure if it was happening after the brakes.
View 19 RepliesI just bought my first car, a 2000 saab 9-3 convertible (base model) a month or so ago. The car had been neglected for the last year or so and I have been spending the last few weeks fixing all its issues. This last weekend I replaced the rear shocks, font struts and the rotors and brake pads on all four wheels. After driving about 20 miles or so I started to notice a squeak coming from the front right wheel well and since has become more and more noticeable/pronounced.
Squeak description:-cyclically increases and decreases in volume with each rotation of the wheel
-the squeak is constant: squeak that gets louder at a certain point in each wheel rotation but is always a certain baseline volume as long as the wheel is turning
-the volume of the squeak is NOT AT ALL effected by braking (EXACT same noise driving as while braking) which leads me to think its has nothing to do with the pads or rotors
-HERE IS THE WEIRD ONE: the squeak disappears completely when driving in reverse!
-the squeak is about the pitch and sound of a cricket, only constant and Ii guess louder.
-the noise is unaffected by turning sharply to the right and left.
Additional details:- I had to use a gear puller to press the axle out of the wheel bearing (was stuck from rust). I hooked to the back of the wheel bearing ( what the lug nuts screw into ) and pressed on the center of the axle. Maybe this could have damaged it or the cv joint?-while I was switching that wheel's strut insert out, the carrier bearing leaked 1 (maybe 1 and a half) teaspoons of grey oil from the larger end of its boot and stretched out an inch or so from the weight of the hanging axle.
I have a 1994 Bonneville with charging problems. When started the gage on the dash might go up to 14 and stay there or not charge at all. The car at times while driving will charge then not charge and then charge again it is all over the place. I have put on a new battery, Alt. and starter still the same thing. I have had the car at Battery Specialist and they said it's in the wiring. I have put a new harness on and still the same thing.
View 2 RepliesYesterday this thing died on me twice. 30mph to 0 in nothing flat. No problems with stalling before yesterday. It's at the shop now, but they tell me they aren't finding anything and probably won't if they can't get it to die on them too. It had only been driven for about 5 minutes before each occurrence, and each time I had just topped a small hill(if that matters). The second time, it did slightly hesitate to restart and seems to me there was some light smoke from the tailend.
View 19 RepliesOn Sept 10, 2011 I was driving towards a major highway when my airbag light came on. I just figured it was a sensor malfunction and kept driving. I proceeded to the highway and when I was up to 57MPH I put my cruise control on. About 3 minutes later both of my airbags deployed while I was driving. Do you think I need a lawyer?
View 19 RepliesRecently, my 1995 Bonneville SSE randomly will stall. No hesitating, no surging, no rough running, just DIE. This happens while driving, stopped at traffic light, warm / cold, Whenever the mood stikes it!
It always (so far) starts right back up. So far it has not tripped a code or caused any service lights to stay on. I've cleaned the battery posts and don't know what else to do.
Except there is a small problem, a squeak has started that is definitely based on my speed. It seems to go away a little when I turn.
At EV speeds it sounds like the plane wheels from the beginning of "Back in the USSR".
Steering wheel that squeaks or creaks when you turn it? It's not very loud but getting annoying...
View 2 RepliesI have an 04 GLI with around 130,000 miles. I have developed a squeaking noise coming from the front end of the car. I cant really tell if its the right or left side. I can tell you i only hear it when driving under 30 mph and it seems to happen more often when i slightly turn the wheel to the right. Also when i accelerate from a stop or let off the clutch pedal into 2nd or 3rd. I wonder if it could be the wheel bearings going bad? I replaced both front and rear control arm bushings back in December just for some background. FYI, by squeaking i mean the sound of metal to metal. Its not a squeal or hiss, or anything to do with a boost leak. When you hear it, it sounds like a squeak, squeak, squeak kinda pattern but comes and goes depending on speed and the turning of the steering wheel.
View 2 RepliesNeed to identify what could this be? It used to come and go, now it's constantly here. I took it to the dealer but there was a 3 hour waiting time, so I might have to go another time. If you do know what is it, could I fix it myself? While driving there's no squeaking, but I can hear a metal on metal sound while on bad roads, the type of noise you would expect from a bad tie rod or something like that, on good roads it's fine. The noise you can hear on the video happens when I push the car side to side. [URL] .....
View 1 RepliesI have recently bought a B5.5 2003 Passat 1.9TDI SE. It is a really nice car but recently it has developed a fault. When I turn the steering wheel it squeaks. It sounds like the steering wheel is rubbing against something. What could be causing this ? Does it need some lubricant applying ?
View 1 RepliesI have a 2006 LX with 25k miles.. within the past 1,500 miles or so, I notice there is a squeaking/creaking/rubbing sound coming from the steering wheel column when I turn (and cut, specifically) the wheel at stopped and low speeds (such as pulling out of the driveway or maneuvering into a parking spot). At faster speeds this doesn't happen.
I intend on bringing this to the dealer. What should I expect, and should I bring this in ASAP?
My sister has a Camry that has a squeak in the steering wheel occasionally when you turn the wheel. She lives in another state, and so I'm only going by her description, but I'll be visiting soon.
She describes it as an intermittent squeak/groan when the wheel is turned. I think it may be plastic on plastic, but it is definitely coming from the area around the column (up by the combo switch and ignition switch area), not down by your feet, she says.
I'm not sure of the year, but it is in the 2001-2003 range, I believe. I think this is just an annoyance thing, not a mechanical problem.
I have an '03 Subaru Forester and my mechanic recently replace the rear wheel bearings and seals. Afterward, I noticed a high pitch squeak from the rear right wheel at slow speeds. I brought it back for my next oil change and had them look at it. I watched them take off the wheel and brake drum. He hand-turned the wheel mount and it made the squeak sound from the bearing. Then he said that it's no big deal and put it all back together.
So, is it really not an issue? I'd rather not have noises coming from something brand new, but I also like my mechanic and don't want to make him do a lot of extra work if this thing is just going to go away on it's own.
This is a known issue with Lexus. Bring your Lovely RX to the dealer so they can replace the Steering wheel column, so it will stop the "Squeak" noise.
View 2 Replies2002 Solara, 69K miles, occasional squeak from steering wheel when turning, sounds as if it is coming from where the wheel connects/rotates at the column - sounds like a weak rubber horn (like clowns use) or a rubbery, balloons-rubbing-together sort of sound. Not loud - only noticed when I was w/out the radio on (had an exhaust repair last week and was enjoying the quiet). It's not an external steering pump whine - it really seems as if it is coming right the steering column. Short of leaving cheese to there to coax out a mouse . . .
View 6 RepliesI had the clock spring recall done last week and now when I turn my wheel almost to full lock for a tight turn, it has a little "chirp" when going past a certain point. I'll definitely bring it back to them to correct it, but I'm guessing no quick fix but I can easily remove my airbag and check from there.
View 4 RepliesHad the car at the dealer over the weekend for oil change. Told them I was hearing a squeak when turning the wheel, not just when it is cold. Anyway they told me that my rack is leaking and they ordered a rack and P/S Pump for some reason? Does that seem normal at 38,000 miles. Also I asked if when they replace the rack do the align it, answer was no, even though parts are under warranty. I drive mostly highway but maybe 2 miles in the city where the roads have been pretty bad while construction is going on, Not sure if that hurt the rack or something else. The dealer hit me I think at 15,000 mi to change the P/S Oil for some reason, so it is all covered but I just think it is odd to go that suddenly. What next? I don't abuse the car at all.
2009 Sonata SE V6
My parents own a 2013 Elantra 4-door (sedan) and for the last few months it's been making a metal grind/squeak. Here are the following characteristics:
-It occurs only during acceleration from a full stop or low speed. It would then disappear if we drive it longer or get to 60km/h.
-We've diagnosed it to the front right wheel.
-It sounds like the squeak at you get when your break pads are almost used up - metal on metal grinding squeak
-It seems to be temperature related as the squeaking occurs less during cooler temperatures - it comes back once (I assume) the wheel / brake / rotors are sufficiently warm.
We have brought it to a mechanic and he did hear the squeak. He took of the pads and re-lubed (not on the braking side obviously). No change. BTW the pads are still very beefy and is the original pads that came with the car.
Searching online it seems this issue is fairly common and it seems to be the brake pads. Is this what's happening to my parents' car? If so is it as simple as replacing the brake pads with a different brand?
I'm getting a pulsing. High-pitch squeak from what sounds like the left/front wheel when making left turns and occasionally driving straight at low speeds after a left turn, usually while NOT applying the brakes. In fact, applying the brakes firmly stops the sound until I release the pedal. After that, sometimes it comes back immediately and sometimes not.
Two weeks ago I replaced the R/F cv axle and the sway bar link. Harder job than it should have been because I had a heck of a time getting the lower ball joint bolt free.
This past weekend, I replaced both front rotors because I was certain that one was warped since I was getting a very loud pulsing squeal only when braking. I also have had a tendency to over torque the lug nuts which I had read can cause warped rotors. I now use a torque wrench for that.
I've made sure that the rotor shield isn't touching anything and checked the pads for damage and unusual wear. Pads are at about 75%.