On cold mornings if I do a sharp right turn (Left turns just naturally are not sharp, so I don't know if it's both ways). I get a rumbling noise in the transaxle. It sounds like a rumble, if it's limit slip noise it's pretty bad. It does not seem to be a problem in the summer. Dealer found nothing but if they don't do it while it's cold they won't hear it.
View 2 RepliesRecently my 2006 Azera Limited with 3.8L V6 is making a valve tappet noise when cold - it goes away when the car is driven a few minutes. It now has 142K on it, is it just that the tappet has gotten 'dirty' and is sticking, or is this a sign of a much more serious problem? I am presuming the Azera has hydraulic tappets. There is no lack of engine performance or misfire at all. I have not yet changed its oil, the dealer I bought it from said they changed the oil when I bought it, just under 3000 miles ago. Could they have used the wrong oil? Too thick a grade? I have heard several other possibilities - the 'oil control valve' I think, or the valve lash being out of adjustment - but wouldn't either of these be constant issues? I'm hoping it's just oil related, which could be fixed easily..
View 39 RepliesI'm up to 102k on my 2007 Azera Ltd. In the last two weeks I started getting a grinding/rattle type noise when I turn my AC/Fan up to the higher levels. When it's on low/mid you can't hear anything. Does this mean the compressor is starting to go or is this something else going on?
View 5 RepliesI have a 2013 Avalon hybrid that is almost 1 yr old.
I have recently notice a single "pop" noise that seems to be coming from the rear when I turn right with a sharp turn.
I have looked in the trunk and under the vehicle but I cannot find where it is coming from.
Sometime when I make a sharp turn (such as turning out of a parking lot) I hear a "pop or click" noise coming from the front end. I cant tell whether this is normal or not and I wanted to know if this was a sign of anything serious. The car only has 70k miles and is in pretty good shape. Still stock suspension.
View 8 RepliesI have a 2006 rx330 with belt squeaking noises on after warming up for say 10 mins on cold mornings, while reaching home I could hear the noises on cold days, the outside temperatures usually 35 to 40 F happens. While driving no noises, only happen on cold days when temperature is above 50 no problem. Should I replace the belts, how many belts are involved ? Tensioner problems ?
View 1 RepliesI have 35k on my 2009 camry, (past warranty). All of a sudden in the last few days when I make a sharp left turn (like into a parking spot) I hear a grinding noise from my car. Not really a full on grinding, but like a quiet fart can muffler noise. No issues with alignment, driving straight, or sharp right turns.
View 5 RepliesThe other day i noticed that when i make a sharp turn left or right i hear a clicking noise. If the clutch is engaged it clicks and if its not then it does not click. It is also louder when i turn right... I am thinking CV axle!
View 4 RepliesI have a 2013 Santa Fe with a 2.0T. A couple of days ago, I heard a squealing noise when I make a sharp turn to the left, like maybe a power steering belt would do. This has continued and I have also noticed that the AC fan almost completely dies at the same time. Car has 6,000 miles.
View 3 RepliesI have been doing some research on why my 6sp MT makes a weird almost "Plastic Grinding" noise when shifting from 1st to second on cold days when it sits overnight. It has been getting under 40 degree that last couple days and it seems to go away after just a few minutes of driving. It only happens from 1st to 2nd. I have been told its normal and just because the trans fluid is thicker when cold.
View 3 RepliesAt 120k miles, my 2003 Camry LE 2.4L started to make some noise when making sharp right turn at low speed (below 5mph) going forward. It sounds like the tire rubbing the fender or somewhere, not metallic, and it's periodic, at 2-3Hz or so. It comes from somewhere on the driver side but I'm not sure. The car doesn't make noise when turning at stop or backing up or going straight, and the noise seems to disappear if turning at higher speed (maybe the turn is not sharp enough).
First I suspect the tire is rubbing the fender. But after inspection, no rubbing marks can be found, and there seems no rubbing when the car is parked and the wheel turn all the way to the right. Then I suspect a bad CV axle. But the boots seem in good shape with no leaking grease, and there's no noise when backing up.
I'm having 4WD problems with my Yukon, but the dealer keeps telling me there's nothing wrong with it (this has been going on for 2 winters now), which is either code for, "let's wait until it's extended warranty expires, so we don't have to pay for it," or "the computer says nothing is wrong, so that's all we're going to look at." When it's in 4WD, anytime I make a sharp turn or even turn a corner there's a grinding noise in the front, if I try to back up, it will only go as far as one revolution of the tires then stop (I have to take it out of 4WD to backup), eventually the "Service 4WD" light comes on, but apparently nothing gets recorded on the computer. It has 32,000 miles on it.
View 6 Replies2004 Jeep Wrangler Sport 5-speed Bought used 2yrs ago. 76,000 miles Only seems to happen after driving for more than an hour. When I either back into my driveway or turn sharp into a parking sport, mostly to right, I get a bumping sound, like something rubbing. My mechanic has replaced the sway bar links, front rotors, axle yoke, had a front differential leak so seal was replaced, and am still getting the sound. Tires Bf Goodrich All Terrain Do not do off road.
View 4 RepliesWhen ac is on only have cold air coming from passenger side vents?? Took to my mechanic and they check ac levels and said it was ok. They said they would have to take off the entire dashboard to check at a cost of $1,000 in just labor alone?
View 3 Replies2008 Azera Ltd. with 100,000 miles. Good cold air on passenger side but not drivers side. Where is drivers side acuator located so I can try to test and replace?
View 13 RepliesSo the Jetta developed a new noise lately that sounds just like what can be head on this video.
The spring-clicking kinda noise only happens when i make a sharp right turn at low speed and seems to be coming from the driver's side. So i though bad outer cv joint.
Well, I put on a brand new OEM unit last night and noise is still there.
For the last few weeks, when I make a turn (particularly a sharp turn in either direction) I get a "clunking" noise that sounds like it is coming from the front end somewhere. I can also feel it - almost like a gear slipping and engaging again. I am not in 4WD mode when this is happening. It NEVER happens unless I am turning a corner. If I drive straight, it's fine. 1999 Explorer XLT (4 door, 4wd model)....
View 2 RepliesI recently purchased a 2006 Hyundai Azera which has developed a rattling sound upon cold start up. Based on service bulletin 06-20-002 I believe the issue is with the timing chain tensioners. I am looking at getting a DNJ TK147 timing set kit to replace them with. Do this kit contains the updated tensioners? It is located on rockauto.
View 4 Replies2007 Azera 120k miles. Have noticed first thing in the morning when shifting from 4th to 5th gear, I hear a clunk.. Yesterday I heard two clunks when downshifting from 5th to 4th. Tried shifting the car manually today and was able to replicate the problem. After 15 minutes of driving, the problem is gone.Never seems to happen in the afternoon after car has been driven.Transmission fluid is full. Have always changed at the 60k intervals.Fluid is not burnt. Light pink color.
What could possibly be causing this? Is this likely to get worse? How long might I have before the car might become not drivable ? I ask this because I have been considering trading it in for a new car. Now seems to be a good time to buy a 2016 car, since the 2017"s are almost out.
I am trying to change my 2006 azera's transmisson fluid.
I tried to find the location of transmission fluid drain plug bolt, but i can't find either in the service manual nor owner's manual.
Looking for a photo to show the transmission fluid drain plug bolt?
I have a 2005 Honda Civic that was making noise on the front passenger side wheel and what sounded like the front driver side strut clanging (bottoming out) when I hit a bump, sharp right turn heading down hill, or hit a pot hole (small or large). I brought it in to a mechanic to diagnose the issue. They told me I had a bad wheel bearing and also needed new struts. They quoted me a price on parts and labor that I thought was too high, so I checked a few other mechanics to make sure that I needed the work and try to get a better quote. All said the same work needed to be done, so I eventually had them repaired.
My car seems to ride better and I don't hear the noise from the front passenger side wheel anymore or the noise from the front driver side strut, however, there is now a clunking like sound coming from the front suspension (left and right sides). It sounds kind of like something might be loose. I can hear it over slight bumps, and when turning whether I'm going slow or even coming out of a parked spot.
Is there something else that may need repair after having all this other work done? Have I caused a "needed repair chain reaction" or something?