Avalon 2005-12 :: 2008 - No Check Engine Light On Startup
Apr 26, 2015
Do the check engine lights when you put the switch in the start position or as I know if working properly. I have a 2008 toyota avalon XL,
View 14 RepliesDo the check engine lights when you put the switch in the start position or as I know if working properly. I have a 2008 toyota avalon XL,
View 14 RepliesI have a 2009 Avalon that is displaying a Check Engine Light and a VSC light. Is it possible it is doing so because I have two different brand tires on the front hankook and the back Michelin?
View 2 RepliesMY 06 Avalon has acquired a check engine light that goes on and off sporadically..mechanic states it was a misfire cleared the codes but now it has come back and then turned itself off only to come back again. Car 80k miles..needs tuneup ?
View 14 RepliesIt came on yesterday and went out on it's own today then came back on later. The code is PO354. the manual says the "D" ignition coil primary is open or has a problem. I don't believe it because the engine runs fine. Opinions?
View 14 RepliesTook my 07 Avalon Touring to the dealer because of a check engine light. They replaced coil and plugs, but also told me unbalanced wheels had caused the computer to throw a code. As Click and Clack would say, this sounds bogus. I'm feeling no vibration and the wheels were balanced about 3 months ago.
View 3 RepliesMy check engine light came on in my 06 toyota avalon. i had the code read at pepboys and they said it was something like 0300 misfire. i took it a few days later to my personal mechanic and he said nothing popped up when he tested the code. i notice the car (engine) is running a little rough though. What is the firing pattern as i want to try and fix by putting new plugs and coils.
View 1 RepliesMy Avalon has 55,000 miles on it. when it is idling the motor seems to be very noisy. to me this isn't normal my service rep says there should be no problems if there is no check engine light on.
Should not be as noisy with such low mileage. dealers says if there is no problem and that is the way it is they will charge me for the diagnostic fee. seems like it's not right the way it sounds so what is everybody's opinion on this issue. Oil level is up and very good so just wondering if it could be very variable valve timing solenoid making noise.
I try to do my own maintenance. I have a 2006 Avalon Limited. This has happened twice recently, using cruise it has kicked off and gives me the VSC light and the check engine light and cruise error, when running codes I get the following P0138 & P2195 both have to do with the O2 sensor on bank 1, and P1578 & P1201 which are brake malfunction. I have been searching the Internet for any information on what could be causing my issue with no luck. I have a 3000 mile trip and need to figure this out soon.
View 14 RepliesI have a CEL on my 2007 Avalon so I decided to take it to Autozone to get a scan. Error code P0015 was returned. This code has to do with B Camshaft Position, Timing Over Retarded (Bank 1). I've done a little research and I've read that this could possibly from a dirty screen on the Oil Control Valve, the OCV itself, or the Cam Position Sensor. Before replacing parts, what I would like to do first is to check/clean the screen on the OCV. Secondly, I would like to swap the Cam Position Sensor to a different bank and see if the other bank throws an error. If the other bank throws an error, then I know the sensor is bad and needs to be replaced. With this said, I am having trouble locating the OCV and CPS. Where the valve and sensor is located. A diagram would be useful.
View 14 RepliesI replaced the water pump. Huge problem. I will get rid of the car before I replace that again. But, it is replaced and the car is functioning.
Unfortunately, the check engine light remains on and I still get p0327(knock sensor) code and car has a slight ruff run.I have the Actron code reader(fairly cheap, but effective) and it will clear the vsc but not the check engine. Upon restart, the check engine light reappears in 7 seconds followed by the vsc symbol. This has been for a week now. So I have been dreading tackling this project next. But I figure if I'm doing this, I better change the rear plugs and maybe the rear coil packs as well.
Don't want to do this, but whether I do it or send it to the dealership, once is all I'm gonna do. I say all of this and yesterday, the check engine light goes away on its own and full power is back and ruff run gone.
I still plan to go into the engine this year because my car just hit 120,000 miles and i have to change my plugs. If it recurs, I will change it all. I will just wait. Only going in once.
I have an '05 I bought 3 years ago and any time it sits outside and gets rained on, the VSC/check engine light comes on when I start it and it doesn't go away for 2-3 days at a time. The frustrating part is that any time this happens, I get the E3 error with the cruise control even though there's not a drop of water to be found anywhere.
View 6 RepliesWeekend trip in the 09 Avalon and after stopping for fuel i end up with a check engine light and two codes P0014 and P0015, camshaft over advance bank 1. Cleared the codes but came back hours later. What am i looking at to correct this problem?
View 14 RepliesSo, I have my check engine light and the code is p0327 (knock sensor). Clear cose but it returns. Going on for 3 days now. I was suspicious that something else is going on. I also remembered I've been using a little more antifreeze in the reservoir. So, today I needed to watch the coolant. I ran the car for an hr and I found a lot. Red coolant on my belt, the back passenger side of my engine and it was caked on with coolant. I think the water pump is going up.
I was concerned that coolant was also leaking from the intake manifold but it's only the right side, so I'm pretty sure the coolant is being slung around from the belt. I rinsed the engine down and the knock sensor code went away. Temporarily, until more coolant got back there. Do you think I will need to replace the knock sensor along with the water pump or should the sensor work ok after some intense cleaning after the water pump replacement?
To start off with I am not car smart! I have a 2008 Santa Fe 3.3L V6. Last year about this time (December) I had problems with the vehicle upon start up would be miss firing and the check engine light would come on. I would turn the vehicle off and restart and it would be fine and not happen again sometimes for a week and sometimes for months. I hooked it up to the computer and found that it was missing on the #6 cylinder. I had the coil pack replaced and that seemed to fix the problem (replaced spring 2011). About a week ago it started doing the same thing (December 1). Upon initial start up when the car is cold and the outside air is very cold it started missing again and having a rough idle. Would turn of the car and restart and would run fine but check engine light would come on.
Hooked it up to the computer once again and it read random misfire. This has happened twice now in two weeks with the same reading each time. Always when it is cold (engine and outside temp) and seems to reset itself when turned off.
I spoke with a mechanic who recently had this same issue with a different vehicle and after trying many things replaced the engine coolant temp sensor and that did the trick. He said it was a cheap start therefore i bought the part and now am looking to replace it. The only problem being i am car dumb and cant find it. I have done many searches and the diagrams i have found don't do me any justice. The past posts on here have given pictures of older models that dont match what i am looking at. It probably is right in front of my face. Any picture of a 2008 that will show the correct area I should be looking at? The vehicle only has about 57,000 miles on it.
My car just turned 85k miles. The day it turned 85k, I recieved a message from dealer saying their records indicate car is due for 85k service. Coincidence? Note: I do not have my service done at the local toyota shop. They have not seen car since last warranty work probably 2+ years ago.
Also at about this same time, the service engine light came on, (oil change needed). Since I only use mobil 1 in the car with genuine Toyota filters, I am not to concerned if the car gets another 500 miles on it while scheduling a service. However, this time, returning from a short trip on Sunday, the VSR (traction control) and the check engine light came on. Only Code is p0015 left bank. Monday, warning lights are gone, and oil change is scheduled for Wednesday.
Is the VSR and the P0015 related.
I have a 2005 Avalon with a 2GR-FEV6 engine with approx. 130,000 miles on it that ticks or chatters for about 2 seconds at startup. The sound is coming from the #2 bank directly below & forward of the oil filler cap (forward most bank, right side). The sound is only present after the car has been sitting for 2-3 hours or more and relatively cool right before startup. There is no other drivability issues such as reduced performance, power or gas mileage. It's not throwing a fault code and the symptoms began within 5000 miles of changing to Royal Purple synthetic oil at 110,000 miles. I don't know if that is a coincidence or the reason for the ticking.
My initial thought was a faulty VVT-i oil control solenoid/valve but I pulled it out, put 12 volts to it and it worked fine. My second thought was a possible clogged VVT oil screen or filter. give me the possible symptoms of what a clogged screen would do? Would it cause the VVT-i actuator to lag just long enough to cause this noise since the oil needs to get through the screen to flow through the oil control valve to affect the operation of the VVT-i actuator and if so what is actually making the noise? It sounds like rocker arms slapping but just in that one spot.
I am driving a 2007 Avalon XLS with about 71,000 miles. These lights came on together yesterday. After consulting this forum, I checked the gas cap and found it was indeed loose (or at least had not been engaged with any of the "required" three clicks.) I closed the gas cap tightly and restarted the car. The lights promptly came back on.
I drove to AutoZone where someone pulled the codes: P0306 and P0356. They gave me a printout suggesting the number 6 cylinder was misfiring (P0306) and an ignition coil circuit fault (P0356).
I have a 2005 f-150 with the 5.4 engine. Bought it new and now it has 107,000 miles on it. Recently,it would have a shudder at 65 or 75 mph then the passing gear would kick on and it worked perfectly. The warning check engine light came on,then,when it acted up it would flash intermittently. Took it in to the dealership and put it on the diagnosis machine. Said cylinders 2,3, and seven were not steady etc?? So,after he took it out and drove it he said those particular cylinder walls were scored. I put in a K-N air filter at about 50,000 miles,and he said that they do not seal properly and dust got by the filter into the intake and got into the engine and did this damage. One think he found was a bad coil on one cylinder and replaced it. And just as he said,when I got on the road home I romped on it and it cut out and the intermittent signal showed again! He said that that would happen and it did.
View 2 RepliesMust have pushed the wrong button in the dark. Anyway, the TRAC button and the check engine light both lit when I started the car. (push button start). How can I get it off??
View 9 RepliesI have a 2006 Avalon and for the last 2 weeks the VSC and Check engine lights have been coming on and stay on for 2 days and goes off.
View 4 RepliesI own a 06 limited and my Check engine along with VSC lights came on. Autozone read the code and it is a P2195 error. According to AZ the O2 sensor cost $500, according to websites the fix is O2 sensor and manifold ~$1800. I don't have that much money. The dealer told me that it was ok to drive with warning lights on. I checked the MAF sensor and it is clean. The O2 sensor or A/F sensor Stuck Lean - bank 1 sensor 1. If I want to do the work myself, any diagrams, picts, instructions etc......
View 8 Replies