Check engine and VSC lights came on wife's car, took to dealer, they hooked up computer and now stating that the Evap system has a leak. They want to replace the Charcoal Canister and they are quoting $900.00.
View 5 RepliesI am driving a 2007 Avalon XLS with about 71,000 miles. These lights came on together yesterday. After consulting this forum, I checked the gas cap and found it was indeed loose (or at least had not been engaged with any of the "required" three clicks.) I closed the gas cap tightly and restarted the car. The lights promptly came back on.
I drove to AutoZone where someone pulled the codes: P0306 and P0356. They gave me a printout suggesting the number 6 cylinder was misfiring (P0306) and an ignition coil circuit fault (P0356).
At roughly 140,000 miles, my wife's '07 Santa Fe GLS has thrown a P0456 code. Does this code on a Santa Fe common?
It is "evaporative emission system leak detected (very small leak)." The good news, I guess, is that it is 'very small.' However, being small may make it more difficult to detect.
It came on yesterday and went out on it's own today then came back on later. The code is PO354. the manual says the "D" ignition coil primary is open or has a problem. I don't believe it because the engine runs fine. Opinions?
View 14 RepliesMust have pushed the wrong button in the dark. Anyway, the TRAC button and the check engine light both lit when I started the car. (push button start). How can I get it off??
View 9 RepliesI have a 2006 Avalon and for the last 2 weeks the VSC and Check engine lights have been coming on and stay on for 2 days and goes off.
View 4 RepliesI own a 06 limited and my Check engine along with VSC lights came on. Autozone read the code and it is a P2195 error. According to AZ the O2 sensor cost $500, according to websites the fix is O2 sensor and manifold ~$1800. I don't have that much money. The dealer told me that it was ok to drive with warning lights on. I checked the MAF sensor and it is clean. The O2 sensor or A/F sensor Stuck Lean - bank 1 sensor 1. If I want to do the work myself, any diagrams, picts, instructions etc......
View 8 RepliesI have a CEL on my 2007 Avalon so I decided to take it to Autozone to get a scan. Error code P0015 was returned. This code has to do with B Camshaft Position, Timing Over Retarded (Bank 1). I've done a little research and I've read that this could possibly from a dirty screen on the Oil Control Valve, the OCV itself, or the Cam Position Sensor. Before replacing parts, what I would like to do first is to check/clean the screen on the OCV. Secondly, I would like to swap the Cam Position Sensor to a different bank and see if the other bank throws an error. If the other bank throws an error, then I know the sensor is bad and needs to be replaced. With this said, I am having trouble locating the OCV and CPS. Where the valve and sensor is located. A diagram would be useful.
View 14 RepliesI replaced the water pump. Huge problem. I will get rid of the car before I replace that again. But, it is replaced and the car is functioning.
Unfortunately, the check engine light remains on and I still get p0327(knock sensor) code and car has a slight ruff run.I have the Actron code reader(fairly cheap, but effective) and it will clear the vsc but not the check engine. Upon restart, the check engine light reappears in 7 seconds followed by the vsc symbol. This has been for a week now. So I have been dreading tackling this project next. But I figure if I'm doing this, I better change the rear plugs and maybe the rear coil packs as well.
Don't want to do this, but whether I do it or send it to the dealership, once is all I'm gonna do. I say all of this and yesterday, the check engine light goes away on its own and full power is back and ruff run gone.
I still plan to go into the engine this year because my car just hit 120,000 miles and i have to change my plugs. If it recurs, I will change it all. I will just wait. Only going in once.
I have 06 XLS with 56,000 miles and about 3 weeks ago the check engine and VSC lights came on. It was fixed, a ignition coil on the 4 cylinder.
Now driving home today the check engine and VSC lights are on again! I was wondering should try to get the dealer to replace all the remaining ignition coils ?
Plus I read their was some type of manufacturer defect on the original ignition coils from the factory. Why Toyota won't recognize this issue ?
Two ignition coils in a little over a month . My first Toyota and I'm rolling with the punches .
So, I have my check engine light and the code is p0327 (knock sensor). Clear cose but it returns. Going on for 3 days now. I was suspicious that something else is going on. I also remembered I've been using a little more antifreeze in the reservoir. So, today I needed to watch the coolant. I ran the car for an hr and I found a lot. Red coolant on my belt, the back passenger side of my engine and it was caked on with coolant. I think the water pump is going up.
I was concerned that coolant was also leaking from the intake manifold but it's only the right side, so I'm pretty sure the coolant is being slung around from the belt. I rinsed the engine down and the knock sensor code went away. Temporarily, until more coolant got back there. Do you think I will need to replace the knock sensor along with the water pump or should the sensor work ok after some intense cleaning after the water pump replacement?
Took my 07 Avalon Touring to the dealer because of a check engine light. They replaced coil and plugs, but also told me unbalanced wheels had caused the computer to throw a code. As Click and Clack would say, this sounds bogus. I'm feeling no vibration and the wheels were balanced about 3 months ago.
View 3 RepliesMy car just turned 85k miles. The day it turned 85k, I recieved a message from dealer saying their records indicate car is due for 85k service. Coincidence? Note: I do not have my service done at the local toyota shop. They have not seen car since last warranty work probably 2+ years ago.
Also at about this same time, the service engine light came on, (oil change needed). Since I only use mobil 1 in the car with genuine Toyota filters, I am not to concerned if the car gets another 500 miles on it while scheduling a service. However, this time, returning from a short trip on Sunday, the VSR (traction control) and the check engine light came on. Only Code is p0015 left bank. Monday, warning lights are gone, and oil change is scheduled for Wednesday.
Is the VSR and the P0015 related.
I have a 2005 1.8 TJetta GLI owned for about 2 months now. Gas cap warning pops up then goes away when I turn off the car then check engine light comes on. I've change the gas cap to new oem one changed the purge valve [URL] .... After a couple of weeks same issues again brought it to my mechanic he ran a leak detector and told me that there are Evap leaks. I read somewhere that I might need a need charcoal canister and a fuel tank.
View 12 RepliesRecently my 2005 scion tc CEL light came on and I diagnosed p0456. At the same time when I turn the car on in the morning it idles at 2k RPM for about 3 minutes and then the idle goes down to around 900. If I park and return to the car within 2 hours the idle stays down but if I wait it goes back to 2k and I have to wait a few minutes for it to come down. My question is whether this is related to p0456. What could be wrong and how do I fix it?
View 2 RepliesMy 2005 Mustang w/ 4.6L is giving a P0456 code and also won't let me fill it with gas completely. I think I've narrowed it down to the canister vent or purge valve. Looking for narrowing down which would cause the gas fill issue.
View 7 RepliesI had a burned out left low beam headlight on my 2007 Toyota Avalon XLS yesterday. I have the halogen (2006) type bulbs. Today I purchased two new low beam bulbs and installed both sides new while I was at it. I had disconnected the battery and replaced both bulbs. Now the headlights (both hi and low beam) work perfectly in the auto as well as on manual mode, however my fogs lights now don't work. The fog lights worked last night prior to replacement of the low beam bulbs. So I checked for continuity of the fuse and both fog light bulbs and all were OK.
View 1 RepliesI have a 2009 Avalon that is displaying a Check Engine Light and a VSC light. Is it possible it is doing so because I have two different brand tires on the front hankook and the back Michelin?
View 2 RepliesI got gas last week and then my SES light came on. I took it to my local auto parts store and used the code reader. The code that it produced was P0456. The guys at the store wasn't useful because he said it could be as simple as my gas cap needs replacing or a much bigger problem. Should I take it to the dealer or is it something I can fix myself?
View 1 RepliesI (or rather my dad) have a 2007 avalon limited. I'm trying to install a backup camera for him. I don't know if it's something I did now but I see the outer reverse lights (on the car body, rather than trunk lid) don't come on as they should. Also any tips to install the video interface and/or camera are extremely welcome - it can never be too basic!
View 11 RepliesMY 06 Avalon has acquired a check engine light that goes on and off sporadically..mechanic states it was a misfire cleared the codes but now it has come back and then turned itself off only to come back again. Car 80k miles..needs tuneup ?
View 14 Replies