Avalon 2005-12 :: 2006 - Transmission Speed Sensor / Engine Code P1705
Aug 14, 2014
Have the P1705 engine code (Direct Clutch Speed Circuit Fault) on 1996 Avalon.
I have removed it and trying to examine connectors and unit for problems.
Seems simpler to replace but cannot see spending the money on a crap shoot. Here is what I know:
Took voltage reading from each of the 2 connectors on the harness each with the key on but car not started. 1 probe to 1 connector and other probe to battery ground. Each connector displayed 0.76V.
Checked resistance across connectors on removed Sensor and it was 600+.
So...are these results determine whether the sensor is bad or the connector harness has an issue? Am I measuring incorrectly? Finally, is there only one of these sensors? I see on later models there are 2. Toyota P/N: 89413-08020
View 6 Replies
Advertisement
I have an 08 avalon w/ 281k miles. NEED to replace the transmission speed sensor (P0500 code thrown). Where is it located on the trans and what is the part #? I'm thinking about servicing the trans while I'm there but looks like a lot of "comments" regarding this transmission and the problems with servicing it!?
View 9 Replies
I received error code P0031 on my 06 Avalon the other day. It states that the HO2S (Heated Oxygen Sensor) is bad. Bank 1 Sensor 1. I located the sensor but have a few questions...
Just to give an over view for those that don't know where these are, there are 4 sensors the one in the front on the manifold (upper - B2, S1), (lower - B2, S2) and the rear manifold (upper - B1, S1), (lower - B1, S2).
All of the sensors look the same with 4 wires. what the part number is for the sensor? Also since this is the hardest one to get to, I would like to know where the wire routes to. I found the wire up to the connector on every other sensor except the one I need (B1S1). It looks like it runs towards the top of the engine but from the top I don't see it.
View 2 Replies
So, I have my check engine light and the code is p0327 (knock sensor). Clear cose but it returns. Going on for 3 days now. I was suspicious that something else is going on. I also remembered I've been using a little more antifreeze in the reservoir. So, today I needed to watch the coolant. I ran the car for an hr and I found a lot. Red coolant on my belt, the back passenger side of my engine and it was caked on with coolant. I think the water pump is going up.
I was concerned that coolant was also leaking from the intake manifold but it's only the right side, so I'm pretty sure the coolant is being slung around from the belt. I rinsed the engine down and the knock sensor code went away. Temporarily, until more coolant got back there. Do you think I will need to replace the knock sensor along with the water pump or should the sensor work ok after some intense cleaning after the water pump replacement?
View 5 Replies
I have a check engine light come on in my 07 Avalon and had the car scanned. It was throwing error code P0031. I'm gonna go ahead and replace this O2 sensor, however, I'm having a hard time finding the correct part# for this sensor.
View 1 Replies
So, my '06 XL just popped up a P0051 code, which is the bank 2, sensor 1 (the upstream A/F sensor that you can easily view upon opening the hood in the front exhaust manifold. Easy enough of a replacement on that one, but what about bank 1, sensor 1 (the upstream A/F ratio sensor on the firewall side of the engine)? I changed my oil today and I can access three of the four oxy/A/F sensors, but the upstream rear looks like a bitch! Out of curiosity, I called a local Toyota dealer and they said it would be 300.00 total to replace the hidden sensor on the firewall side. Does this amount seem realistic? I know that there is a TSB for this sensor that states to replace the exhaust manifold/cat assembly. I def. can't afford no 1700.00 crap right now!!
View 3 Replies
I had a rebuild done on my 2002 Accent. My question is now we get a code for the output shaft speed sensor. Would this have been replaced as part of the transmission rebuild?
View 2 Replies
2006 Avalon Limited: getting a P0015 code. My mechanic says it has to do with cam sensors(?) "cam pos actuator b bank 1: timing over retarded." Dealer told mechanic that they've never seen one of these sensors go and to check the wiring harness for damage; mechanic found none. 153,000 miles.
View 7 Replies
I experienced a misfire code for #4 cylinder on my 2006 Toyota Avalon approx 8,000 miles ago and replaced the three front bank coils with Beck/Arnley coils. I didn't realize they were made in china until they arrived. The car ran fine until today when I got another misfire code for the same cylinder. I still had the two old coils in the garage so I swapped out # 4 and I'm happy to report that solved the problem. My question is should I be concerned that the # 4 cylinder has gone thru two coils in 8,000 miles or chalk it up to cheap chinese crap replacement parts?
View 4 Replies
I bought late 98 F-250, 5.4 G, 4WD. OHad to replace the steering flange because they messed up the ignition cylinder and flange. Truck didn't run for 4 years. 249K miles, no history available. Got the engine running, no DTCs. D, 3, 2, 1 barely moved the truck forward but, R hauled butt in reverse. Checked transmission fluid it was good and clean.
Came back to it a few days later it threw a P0720 (output speed sensor circuit) and I have no reverse, park feels like it wants to move, R is neutral, N is forward, D is forward, 3 is forward, 2 is forward, 1 is forward. The N is full drive. I cleared the P0720 code after it came up and it has not returned. The instrument gauges work but the odometer display is intermittent. Linkage? Fluid? Sensor? Wires?
View 4 Replies
It came on yesterday and went out on it's own today then came back on later. The code is PO354. the manual says the "D" ignition coil primary is open or has a problem. I don't believe it because the engine runs fine. Opinions?
View 14 Replies
Changed all the spark plugs and also new coils on the rear bank, drove car and the code 302 returned. Did not have the code while idling, code came up when started driving. Added lucas fuel injector cleaner to the gas tank. Curious about Seafoam and if I should try it and which method to use it by. I know it can be added to oil, fuel, or injected right into the vacuum hose from the brake booster. My wife's car and she is getting crabby.
View 9 Replies
I drive an 05 Gli n my car has been shutting off on me took it for a diagnostic n the code po322 came up engine speed sensor. So my question is. Is their a DIY on replacing the sensor I'm picking it up tomorrow. To be honest I don't even know where the sensor is located...
View 8 Replies
I have a CEL on my 2007 Avalon so I decided to take it to Autozone to get a scan. Error code P0015 was returned. This code has to do with B Camshaft Position, Timing Over Retarded (Bank 1). I've done a little research and I've read that this could possibly from a dirty screen on the Oil Control Valve, the OCV itself, or the Cam Position Sensor. Before replacing parts, what I would like to do first is to check/clean the screen on the OCV. Secondly, I would like to swap the Cam Position Sensor to a different bank and see if the other bank throws an error. If the other bank throws an error, then I know the sensor is bad and needs to be replaced. With this said, I am having trouble locating the OCV and CPS. Where the valve and sensor is located. A diagram would be useful.
View 14 Replies
What to do Misfire Error all cylinders also coil code P0356 . It is 2006 Avalon Ltd with 37,000 miles always maintained and all recalls completed. Is there something I missed or is this for real or could there be a common problem that is causing all the errors. Car idles ok and no problem driving below 60 mph anything over and you can fell a shutter like it will lose power.
View 14 Replies
I replaced the water pump. Huge problem. I will get rid of the car before I replace that again. But, it is replaced and the car is functioning.
Unfortunately, the check engine light remains on and I still get p0327(knock sensor) code and car has a slight ruff run.I have the Actron code reader(fairly cheap, but effective) and it will clear the vsc but not the check engine. Upon restart, the check engine light reappears in 7 seconds followed by the vsc symbol. This has been for a week now. So I have been dreading tackling this project next. But I figure if I'm doing this, I better change the rear plugs and maybe the rear coil packs as well.
Don't want to do this, but whether I do it or send it to the dealership, once is all I'm gonna do. I say all of this and yesterday, the check engine light goes away on its own and full power is back and ruff run gone.
I still plan to go into the engine this year because my car just hit 120,000 miles and i have to change my plugs. If it recurs, I will change it all. I will just wait. Only going in once.
View 3 Replies
Check engine and VSC lights came on wife's car, took to dealer, they hooked up computer and now stating that the Evap system has a leak. They want to replace the Charcoal Canister and they are quoting $900.00.
View 5 Replies
The MIL light came on and I noticed the shifting P-D or P-R was hard. Checked the Transmission Fluid and noticed it was low. Topped it up, but still MIL is on and shifting hard still. I bought a OBD2 Scanner and it returns P0707 "Transmission Range Sensor Circuit Low Input". Should I try clearing the DTC? It's a drag because it's my wife's car and she's driving mine.
View 1 Replies
MY 06 Avalon has acquired a check engine light that goes on and off sporadically..mechanic states it was a misfire cleared the codes but now it has come back and then turned itself off only to come back again. Car 80k miles..needs tuneup ?
View 14 Replies
My car just turned 85k miles. The day it turned 85k, I recieved a message from dealer saying their records indicate car is due for 85k service. Coincidence? Note: I do not have my service done at the local toyota shop. They have not seen car since last warranty work probably 2+ years ago.
Also at about this same time, the service engine light came on, (oil change needed). Since I only use mobil 1 in the car with genuine Toyota filters, I am not to concerned if the car gets another 500 miles on it while scheduling a service. However, this time, returning from a short trip on Sunday, the VSR (traction control) and the check engine light came on. Only Code is p0015 left bank. Monday, warning lights are gone, and oil change is scheduled for Wednesday.
Is the VSR and the P0015 related.
View 4 Replies
I try to do my own maintenance. I have a 2006 Avalon Limited. This has happened twice recently, using cruise it has kicked off and gives me the VSC light and the check engine light and cruise error, when running codes I get the following P0138 & P2195 both have to do with the O2 sensor on bank 1, and P1578 & P1201 which are brake malfunction. I have been searching the Internet for any information on what could be causing my issue with no luck. I have a 3000 mile trip and need to figure this out soon.
View 14 Replies
