Alero :: 2002 - Emission Evap Not Ready?
Mar 2, 2012
2002 olds alero 3400 engine.....I had a code of a p1401 insufficient flow to egr ..Which is most of the time the clogged passage. I took the throttle off an accessed the egr passage. Boy was it clogged with carbon so I cleaned it out thoroughly, which fixed the problem.
I reset the computer I drove it a few days and now all the monitors are ready, except the evap monitor. I have drove a few days highway, street, stop and go etc my tank being half filled etc. And its still not ready. Car has to take emission soon. Its a coincidence because the Alero ac isn't working so it can't be turned on right now.I ran into a similar problem with a 2000 Monte Carlo the evap wouldn't go to the ready status he had a short somewhere and the ac compressor would work intermittently. The compressor finally worked one day with defrost on and the evap went to ready.
View 3 Replies
Advertisement
New owner of a 2003 1.8TPassat (29,000mi) as of the last 2 weeks and have just had my MIL come on. Scanned it at home with my Actron CP9125 scanner and got this code (P0455) which reads in the scanners manual as "EVAP Emission Control System Leak (Large)". Didn't know if this was a generic description of the code or VW has a more specific definition. What precisely this is in reference to, gas cap, vacuum hose????? Or what VW's actual description of this code is?
View 3 Replies
Threw this code p0442 evap emission control small leak. I see its a popular code to have....
View 14 Replies
My 2003 F150 4.6 wouldn't pass emissions testing last week due to the OBDII not being ready to test. I knew that would happen as I had just reset the code (I get a CEL anytime after a heavy rain - I think it is a bad coil coming). After I reset and drive for a while, I don't get any codes and everything is ready but the EVAP.
I reset the computer on Friday. Let it sit overnight. Filled the gas tank Saturday. Sunday I drove a 200 mile round trip. Ran the cruise control at 60 for a good 50 miles. I did some local running around. All things that should have/could have triggered the EVAP system to run.
Where is the best place to start looking for problems? I changed the gas tank a couple years ago and I think everything is tight on it. Should I just change the gas cap in case it is the culprit?
View 14 Replies
I have a 1998 Oldsmobile Aurora with 103,000 miles. I'm receiving the codes P0300B Misfire and P0440B Evap Emission.
I use Premium Unleaded gas (not at a cheap station) so I don't think it's the gas causing the misfire code P0300B. Also I've put on a new gas cap but I still get the Evap Emission code P0440B.
Working on a 1998 Oldsmobile Aurora with these 2 codes?
View 17 Replies
So mad today. Check engine light came on, plugged in my scanner, got P0441 EVAP Emission Control system Purge Flow Fault and P0455 EVAP Emission Control System Leak (Large).
8-month old '13 TCH XLE is getting a check engine light already.
View 7 Replies
Just received a P0441 CEL (Evap Emission System Incorrect Purge Flow). I have a 2.7l engine, 2WD. I've read other forums and it seems it's most likely the purge valve or charcoal canister.
View 7 Replies
I've had the check engine light come on and was told it was probably from topping up too much and that it would go off on it's own... I should say I have no issues with idle or rough starts.
I had it scanned at Auto Zone. The print out shows: "EVAP emission system incorrect purge flow probable cause
1) Faulty purge control solenoid
2) Faulty vent solenoid
3) Blocked vapor canister
Previous posts suggest if it were a blocked vapor canister I'd have trouble completely filling the tank so I am hoping it's one of the others. Almost everything I see suggests the purge control and that looks like an easy fix. My concerns are a) if it is the vent solenoid - how hard is that to get at and b) what is the part number as I can't find it listed anywhere? I want to have both on hand before I start trying to fix this. Lastly if it is the vent solenoid should I just give up and see a dealer??
View 3 Replies
I have a 130K+ 2002 SC430 in which I recently started to smell gas in the cabin when air vents were set to pull air from outside. Within two weeks, I got the check engine light with two codes, P0440 and P0446, which mean "Evap Emission Control System Malfunction".
In doing some research the check light light could be everything from a gas cap which is not tighened properly, to a bad "charcoal canister " (whatever exactly that is), to a cracked or disconnected "Evap Hose". The only other SC430 related thread I could find on this topic is [URL] ....
If it factors in, I only use 93 octane gas. Interestingly enough, the check engine light came on within 30 seconds of me using the window washer to clean the windshield (at highway speeds), likely a coincidence.
View 14 Replies
CEL came on after a couple of driving cycles showing code P0456 (evap emission control system very small leak detected)............. car drives fine has good gas mileage.....
View 13 Replies
Engine runs perfectly but "check engine" light" stays on due to faulty Emission Evap control pressure sensor (P/N; 89460-0w020). Problem is Toyota no longer makes this part and there is no after market for it. It appears I may have to "junk" a perfectly good truck.
View 9 Replies
I have a 2002 Alero 2.2 4 cyl and the gauges, head lamps in auto position, windows, fan, and radio will not come on. When car is off and key turned to acc. radio will work. It still drives ok, doesnt seem to be draining the batt but the check engine light came on. I took it to autozone and they COULD NOT read the codes and didn't know why.
The speedometer, temp and fuel gauges haven't worked for months now and the rest of the accessories not turning on is a recent issue.
The only thing that comes on regularly is the backlight for the dashboard and now the check engine light. I had the ignition switch replaced right before the speedometer, fuel and temp gauges stopped working. I noticed tapping the key sometimes gets the radio, windows, and fan working but not the dashboard gauges. Don't want to replace the ignition switch again since it doesn't seem to do anything for the dashboard gauges.
View 3 Replies
The car cranks but doesn't start. I checked the fuel pump fuse & its OK. I sprayed carb cleaner in the intake & it started for about 2 seconds. What some of the possible causes?
View 5 Replies
My driver side window problem escalates as it gets warmer within the cabin. I have replaced, and have been told that my window regulator and motor and clips are fine but NOW it is the main control switch/box that is connected to all window buttons within the driverside door itself. I was shown, that it is a black box that has the widow switched connected to it and my best chance is to replace it so the driver side window, the only window that does not go down, will work again.
View 1 Replies
My 02 Alero will start, but when I went to put it into reverse it looked into neutral and wont come out. I can move the gear shift but it won't come out of gear.
View 3 Replies
I have a 2002 and i just recently started having a problem with my turn signal. It seems that when its hot outside, my turn signals wont work, left or right signal. could it be the fuse, or would it be within the steering wheel.
View 3 Replies
I have a 2002 Alero with 124,000 miles and it's been giving me problems lately. Sometimes while I'm driving my car just shuts off. Radio still on and lights work, but the car just stops running. There are days where I can start my car with no problems and there are days where my vehicle doesn't start at all for days/weeks. I've taken my car to two different shops and they didn't find anything wrong with it but as soon as I got it back it started doing the same thing again. What is wrong with this car or what I need to do?
View 11 Replies
My 02 Ford Focus makes a racket in 5th gear. The engine sounds like it's ready for takeoff. The other gears are quiet but when I pick up speed, the noise is a steady & relentless hum.
View 7 Replies
I have a failure on the evap system of my 2002 Escape, and need the proper testing procedure for this particular purge valve. I was able to fix the purge valve on my 2013 Explorer, with no issue, but the Escape has a different type and I'm not sure I'm testing it properly. I want to verify the purge valve is working properly instead of just throwing parts into it. I know it is likely either the valve or the gas cap, but it could be something other than those two items, so I want to get the simple stuff checked out first.
View 3 Replies
The sound is coming from the front passenger side. The noise gets louder the faster I go, put in neutal and noise still there press brake noise there turn wheel no change in pitch. Jacked it up and there's no play in wheel. Just changed both front wheel bearings 6 months ago.
Just changes all brakes today and got all new tires today. I'm thinking maybe the differential bearing but not sure and if so how to change it. I travel from Mississippi to Baton Rouge, LA everyday for work, about 240 miles round trip. What would happen if a bearing went out while driving 70 mph on interstate.
View 3 Replies
Lately I have been having some trouble with 2002 Oldsmobile Alero v6. When the car is sitting in park I have noticed that the engine idles roughly, And when I try to drive it, the car hesitates on the acceleration every now and then. Also the emissions light (the orange one) will come on for awhile and then dissapear. At first I though it was dirty fuel injectors so I added some Fuel injector cleaner, but that has not fixed the problem. I was thinking the park plugs may need replacing?
View 1 Replies
