Alero :: 1999 - Car Died Twice When Started To Accelerate From A Stop
Nov 2, 2008
I have a 1999 Alero with the 2.4L in it. It has about 170,000 miles on it. Has been driven very smooth and maintained well.
Last week when I was out my girlfriend was driving the car and it died on her twice when she started to accelerate from a stop. I usually drive the car (99% of the time) and I have never had this issue. Then during the last week that I have been back from vacation I started to notice the issue. Within the last week it has gotten noticeably worse. Now it seems like half the time (seems to be when the car has warmed up, not an issue with a cold car) it hesitates quite a bit when starting acceleration from a stop.
I have been thinking it could be the Catalytic Converter being plugged or perhaps it needs a new fuel filter. The service engine soon light is not coming on so I assume there are no codes being thrown.
View 8 Replies
Advertisement
I started up the truck. It cranked perfectly as always. Was half way out of the parking lot going give mph and a warning beeping started with a message "stop vehicle safely". I did and the engine died. When I try to crank it it will not turn over at all. No power to engine at all.
View 5 Replies
I have a 2005 ford f250 6.0 I was driving back home from a interview and my truck died at a stop light it would crank but no start I tried replacing the stc fitting didn't work so the I replaced the ipr still didn't work bought a new hpop still didn't work I'm lost at this point I have low pressure oil pump is working new icp, what is going on?
View 8 Replies
I have a broken gas gauge so i pretty much run it until its empty. Has been fine but just died about a week ago. Nothing else was wrong with it. Worked and ran great after for about a week then i went to start and it did the same thing. I have listened for the fuel pump and it sounds like its working. I have not checked the fuses...I am curious what else it could be if after one week with a fuel filter it would do it again
View 17 Replies
So a couple days ago I started my truck and it fired up like normal, but then sputtered out and died after a few seconds. I tried starting it up again and it did the same thing. I tried once more and it started up fine and I drove away.
It sounds like my truck is running out of breath or something and just sputtering out. Runs fine once it turns over though. My issue is that it is happening almost every time I start it now. I have to turn it a couple times before it catches. What this might be?
View 11 Replies
I have a 1999 Pontiac Montana that has recently started whining when I accelerate. It stops after I take my foot off the gas pedal. It usually takes about 15 minutes of driving before the whining starts. It started about 4 months ago and has recently become louder.
Van has 85K miles.
View 13 Replies
I have a 99 olds Alero. recently my engine started to knock. I had it brought to my mechanic who told me its a connecting rod or a Bearing in the engine in cylinder 3 or 6. He put in thicker oil for now and the knock isnt as bad.
I want to know if it would be worth putting a used engine in to replace the one now. Would it be worth swapping it?
View 7 Replies
My husband bought this car 12 days ago. Had NTB check it out and they said we were good to go.
This afternoon, out of nowhere the car started getting usually hot, even though is was almost freezing outside. (Pic of temp below)
I pulled over and let the car idle for about 10 minutes. It cooled down by an amount so small its not even worth noting. I decided to try to make it home. As I drove it started to drop in temp... The car started sputtering as I slowed down at a red light. It started to shake. Then it cut off. I think I made this worse because I keep stepping on the gas hoping to get it back on. It did but it shook worse and anything close to 20 mph made it shut off again. It did this a total of 4 times before I made it home. Each time I stepped on the gas repeatedly to get it going again.
Once home I popped the hood and the pictures below are what I saw. Its in what I believe to be the radiator overflow. I checked the oil, and I do not see it there. I got down on the ground and looked for other leaks but all I see is the gunky stuff. The consistency is light very watery caramel. There was like smoke coming from the engine and it looks wet (included below).
Called my local repair shop and they are quoting me 3 grand. They said I need to replace the engine. My husband can't get to the car for another week and it is our only vehicle.
View 19 Replies
so i was driving along & my 2000 f250 7.3 started to chug then died. I pulled over & it started right back up. I did some running around & was on my way home & it did it again only this time it would barely idle (same chugging). It died again & now it wont start. Turns over strong.....
View 14 Replies
My 1999 GLS Wagon died on me at a stop light. The motor turns but won't start. Replaced fuel pump, filter, fuse, and relay on advice from a few friends. Still no go. Another friend recommended I check the crank sensor.
View 1 Replies
1999 Ford F-150 V8 5.4L... The other day I was attempting to fix my 4wd. I discovered that the vacuum tube by the 4wd solenoid had become disconnected. I reconnected it and in an effort to see if my fix was successful, I drove my truck up one of the canyons nearby. I got to an area full of loose rock and popped my truck into 4wd. As soon as I began to drive, the truck started idling very rough and died. I attempted to restart it for the next few minutes unsuccessfully. I got it started once and it continued to idle rough for a few seconds and died. I have not been able to start it since. It turns over but will not crank. It is not throwing any error codes. What I have checked so far:
Spark plugs are working.
When turning the ignition into the ON position, I am able to hear the fuel pump working.
I have not seen any cracks in the vacuum hose.
All the fuses are still okay.
What the culprit may be?
View 2 Replies
I have an 03 with a 6.0 diesel, going down the road and started losing power and then died. Won't start, and I don't have a scan gauge. Several sources said ipr valve, and from videos on youtube I thought may be a good place to start. I bought a socket and pulled the valve, to check the screen. There is no screen whatsoever on the ipr. The oils clean, as I had changed it about 200 miles ago, and I ran a magnet in the hole looking for a screen, couldn't find anything so I used my fluid pump in the hole. No trash, screen or anything. Do some ipr valves not have screens? What would be my next step??
View 2 Replies
After I turn left from a stop my 2002 Alero pulls hard to the left for a while. Then after a while the car tracks straight. The same happens when I turn right from a stop; the car pulls to the right for a short time - then tracks straight. I checked the tie rods - they are tight.
View 7 Replies
I was driving from home to work the other day and it was 6 degrees out. My heat was working good and everything was fine and then all of a sudden the passenger side started blowing cool air. Not cold not warm. Driver side was still hot. It is a lariat and has dual temp zones. Everything I read everyone says blender doors but what would make it stop working out of no where when everything was fine. Occasionally when I start my truck and turn the heat on it makes a popping noise under the dash when the blower kicks on. But it has done this since I owned it an never had an issue. It's 25 below today and I would really love to have completely functional heat. It's an 2008 f350.
View 14 Replies
I have hesitation as I accelerate especially starting from a stop. It will continue until cruising speed. Funny thing is when I put the cruse control on the hesitation stops and it runs fine. If I want to accelerate while on cruse the hesitation starts again until I let off the accelerator. Is it the TPS ? I changed it two months ago.
View 8 Replies
My Superduty recently started clunking when I accelerate from a dead stop. The harder I hit the gas,the harder it clunks. I unbolted the driveshaft from the rear end and the yoke slides easily. Tranny mount looks tight. Could it be the front driveshaft? Sometimes when I brake hard and the truck comes to a complete stop it will do it too.
View 14 Replies
Our 1999 automatic Rav 4 (157,000 mi) occasionally won't accelerate from a full stop or from a low, in-town speed. You step on the accelerator and the engine just flutters at low rpm, stuttering. If you drop it into neutral and start revving it will eventually "catch" and be fine. Very dangerous when entering roadways. We have a new timing belt, cleaned up throttle plate, new sparks, water pump, oxygen sensor.
View 1 Replies
My wife was driving home yesterday when our Kia would not accelerate when she pressed the accelerator. All the lights came on the dashboard and the engine shut off. So, she had to pull over.
After she pulled over and attempted to restart the engine, the engine would turn over (click like it wanted to start) but would not start. Though the fuel was low, the tank still had 1/8th of a tank, and the "low fuel" light was not on.
This morning, I put gas in the car and it started after two or three attempts. I was able to drive it to a gas station to fill it up. The car started without any issues.
It started, but I'm concerned that there is an underlying issue, like a fuel pump, filter, or something else.
View 6 Replies
Every time I come to a stop or accelerate from a stop theres this weird squeaking sound coming from I am guess in the suspension?? Whats causing this.
View 2 Replies
Cruising down the street in my 7.3, i come to a stop, and I go to accelerate, and there's no power. It says "service engine soon" so if I try to turn it over again it'll just crank. But if I turn the key off and back on, it'll start right up. It's done this 3 times.
View 5 Replies
Well shoot, not even 120k on the odo and I've had my first major problem with the truck, and the one thing I hoped wouldn't be an issue, especially since I don't work my truck hard and 95% is driving unloaded highway as a daily driver.
Last time I drove it coming home from grocery store there was a big racket from down under (transmission area). It instantly didnt feel right - there was a slight drag even when the clutch was in, but rolled fine when I pulled it out of gear entirely. Was VERY difficult to go into first gear. Other gears shifted ok but some of them felt hard too. Would not go into reverse at all!. Slight bit of clinking noises every time I started from a stop, but made it home ok and things seemed to ease up as I went. Today, seems to be shifting fine, reverse works and everything.
Now for several years I've had a noise that I couldn't figure out. I am guessing it's related because it sounded like was coming from tranny area. Often, when starting out from a stop, there was a bit of clinking noise like a couple tin pie pans rattling together just as the clutch started to go. I kept thinking it was loose heat shield or something clanking just under the initial vibration of getting going. Never did find anything loose. I'm guessing it's internal.
I've called a couple local shops and so far no one wants to mess with it. Dam this sucks i hoped the MT would be more reliable, not the first thing to go. I myself have never messed with any aspect of a transmission, though I not opposed to learn however I was hoping to take this on an out of state trip end of May, and I'm not going to have much any free time between now and then.
View 9 Replies
