Accord :: 93 EX Sedan - Temperature Gauge Reading Cold
Nov 17, 2011
I have a 93 accord ex sedan, 4 cylinder, automatic that I bought in August. I live in South Dakota & it's starting to get cold here. When I first bought the car the temp gauge was working fine in that it would move to the middle of hot/cold range. Recently, I've noticed the interior doesn't get warm for awhile, even after driving 20 miles. It blows warm air but it seems like it should be warmer. I've also noticed the temperature gauge barely moves, if it does at all. Most of the time it doesn't move or just stays on cold. I did some research on here & thought I would try to change the thermostat, upper & lower hose and the antifreeze. I'm hoping this will heat up the interior better because it's starting to get cold here & fix the temp gauge.
Previously, I had a 91 accord & that would warm up great, even when it was bitterly cold here. What would cause the temp gauge to do this? I'm even thinking about changing the transmission control module because I read on here that could cause the gauges to have wrong readings. The speedo & rpm gauges also seem to have wrong readings, especially in the mornings or when I first drive it. I used my gps & found the speedo to be off by as much as 10 mph. The other item I've noticed is that I only get around 23-25 mpg highway & on my other accord I was averaging 28-30 mpg highway. Not sure if this is related or not but thought the more info the better.
I have done all the basic maintenance-oil & filter, plugs & wires, valve cover gasket, air filter, tranny fluid but have never done anything with the heating/cooling system.
View 3 Replies
Advertisement
Tempature gauge on my 2001 sierra (4.8) has been running low for awhile. The highest it will reach is round 160. It's currently running rough/rich and bad mpg. I replaced the ECT sensor but didn't work. I'm not sure if there are two ECT sensors on this model. I don't think it's the cluster. Is there a second sensor I'm overlooking?
View 13 Replies
I have a 2003 Passat and the engine temperature gauge will read 190 normally and then suddenly drop to almost zero, stay there for a while then head back up.
I purchased a temp sensor to replace the old but for the life of me I can seem to locate it. I know it's in the back or rear of the engine somewhere.
BTW, the car has the 1.8 engine.
View 2 Replies
I have 2002 Camry 2.4L (2AZ-FE Engine) Japan built. Lately, I noted the temperature gauge stay at the 4th mark when engine fully warm up (first mark is at bottom and slightly longer than the next few marks), is this normal? Which mark it is at when fully warm up.
View 1 Replies
1991 Ranger STX, 4.0. Had a leak from the rubber seal on the thermostat. Changed the thermostat (stat 195) and seal. Now my temperature gauge is not showing a constant reading, goes to half way and when the thermo opens the gauge falls down to a quarter. The gauge is cycling this way every time the thermo opens.
View 2 Replies
My girlfriend has a 2004 Toyota Camry SE, 2.4, 4 cly, with 198k miles. All maintenance has been done per book guidance since she has owned the car. The other day the car began running really rough on her way home. as soon as she put it into park and lowered rpm the car stalled out. temperature gauge did not read hot, but noticed white steam comes from hood when i seen she pulled up, Opened hood let cool down and coolant looked nasty as heck. So I did coolant flush and replaced the thermostat as per advised from parts store. Did not make a difference because during test drive, half mile down the road, car temperature gauge was reading hot. Shut the car down waited 10 to 15 minutes and drove back home.
Altogether drove roughly 10 miles max in hot condition is stop and cool down and go again mode. Also note, this is the first time using a forum of this sort. Along with, I'm not a mechanic as some are, but I know my way around a tool box no problems. I'm on the verge of just ordering new water pump, belts, fans, fan relays switches, radiator and all since I'm going to be in there to fix it anyways.
View 8 Replies
I have an 02 f350 7.3 power stroke...Yesterday I noticed the outside temp was reading wrong,it was jumping from 67 to 86 to 92 back to 67..Temp was prob around 90 with high humidity and my a/c was on..So I got to where I was going and when I restarted my truck to go home the fuel gauge dropped to empty(I just fueled the day before) and fuel light came on and outside temp still wrong on the overhead digital display...Are these two things related???
Stopped the truck restarted it and fuel reads correctly again....Went out today and fuel light back on and on empty...Outside temp wrong again,a/c is on .....I disconnected the batteries when I got home to "reset the system"if there is such thing, fuel gauge working but outside temp wrong..?? Where is the outside temp sensor ?could condensation be running onto the sensor and throwing off my temp gauge? Just strange that both these things happened at the same time......I don't think its a fuse or they wouldn't work at all. I should mention all the other gauges work correctly...
View 7 Replies
I have a 2000 Honda Accord - VTec - 4Cyl - 2.3L - Engine Type: F23A1.
The temperature gauge in the dash board does not function. I was told the temperature sending unit must be changed.
Where exactly on the engine is this unit located?
View 1 Replies
I have a 2001 Excursion Limited V10. 146000 miles 2 wheel drive. I have had it about a year and this is my first winter to really have experience with her.
When the outside temperature is very cold and the engine is cold from sitting all night, at start up, the oil pressure gauge reads nothing and the oil pressure/temp idiot light is on. Only does this during the first very cold start up or after sitting and engine getting very cold again.
I can drive just a short distance (2 blocks) and both gauge and light go to normal and stay there for the rest of my drive. I am using a quality 5/20 oil and filter and the level is good. Warmer days it has never happened. Truck runs fine, smooth idle, no "limp mode". She has not had any recent work done. All the other dash gauges read fine.
There is something about really cold temperatures that have to be causing the issue , I think. ??
View 5 Replies
I have a VOLVO S40 with mileage of about 122,000 km, engine and transmission models were B4204S, MPS6. The car water temperature suddenly down during driving. Connect the VIDA DICE to read the relevant fault codes, just only one: "ECM-0118 engine coolant temperature sensor, signal is too high, B420S3 0" according to the fault code, the least can exclude network CAN line, because in the communication control unit.
View 1 Replies
I've owned this Toyota Camry 2004 LE for two years now and this issue started couple of weeks ago , I the tempreture gague is always at cold , mean less than 25% . where it used to be always in the middle and at the 50% right in the middle . heat still works , have not tried AC yet , it is still in the 20-30s here in Minnesota . I am suspecting maybe a thermostat or some other heating cooling sensor somewhere .
View 5 Replies
I just bought a 1997 Toyota Tercel 5-speed stick, with 175,000 miles, and the temperature gauge moves from its lowest possible position to its highest possible position when the key is turned on, although the engine does not overheat, and no coolant is leaking or being burned. I replaced the coolant temperature sensor, but the actions of the gauge were not affected. I don't know if it is somehow related, but the heater blows cold, regardless the setting of the temperature dial on the dash. What I might try next?
View 3 Replies
I have a 2007 f150 with the 5.4 in it and today I was driving it and my tempreture gauge randomly shot to cold and check engine light came on. Also can't even find the dam radiator cap due to too much plastic!!!
View 2 Replies
I have a 2001 ford ranger xlt 2.3L and the temperature gauge has been staying a cold. And my heat doesnt heat well. I'm guessing I need to replace the thermostat. Before I do that could it be anything else?
View 9 Replies
The other day in our 2001 Honda Accord sedan, 4cyl, 140k miles, we were driving and the wheel became, how do you say, less attached to the car than it used to be? The wheel and the car had a nasty break-up and we were caught right in the middle of it. (see pictures) We were driving down a straight road, going straight, and boom, the wheel fell off and the car landed on one of the suspension bits . We were doing 30 and did fine. But we had literally just exited the freeway, where we were doing 70, a minute or two before this happened. Further, there was no noise, no vibration before this happened. The car was acting quite normally.
We had it fixed at a Honda dealership. We were on the road and it set us back $1070 and a full day. But there you are. So the problem is fixed, and I asked the dealership people to please inspect the other ball joints.
But...now I'm paranoid every time I drive the car. And I want to check them for myself. I read about the jack the car up and try and shake the tire trick. Is that foolproof? Is there more I can do to make certain that all the remaining bits that are supposed to be holding the wheel on are not, in fact, about to break?
View 16 Replies
Have 1996 850 Turbo sedan. When tank is full the gas gauge needle will only go up 2/3 of the way, when nearing empty, needle is below red line. Gas light does work. Can I just remove instrum. Cluster and manually turn needle to top (after a fill up)? If not can I just replace the gauge/motor behind panel or do I have to replace instrument cluster?
View 2 Replies
My honda accord 2003, 4 cylinder (101000 miles) has constantly check engine light on, also transmission has been rough (it started right after a trip to mountains). The transmission sometimes becomes smooth as normal but still check engine light on and most of times transmission is jerky. I took it to mechanic, he did testing and there was no code.
View 7 Replies
So, this may sound strange but from the get-go of owning my Prius I have always sort of doubted the accuracy of the outside temperature reading. I am not totally worried about that part, as I don't really care about the reading, but I would love to understand something. When the thermometer reads the temperature as "37 degrees" it displays this bar that states it as such. The same bar where it notifies you if you change the temperature or volume via the steering wheel. So, I guess my question is , is there something specific about that number or is it just a quirk of my individual Prius? Also, it is worth noting that no other temperature causes it to display this message, only 37 degrees.
View 6 Replies
The outside temperature is reported inaccurately by your C? I now automatically deduct 5 degrees from whatever my C tries to tell me is the temp. I may mention this at my 5,000 visit to the dealer because I'm wondering if the sensor is placed too closely to something creating warmth. But....it's definitely reading too high.
View 19 Replies
My 2013 is always off by a few degrees (too warm) on the outside temperature display. This is not the sun or other outside influence. I wouldn't mind if it was just a couple degrees but it is always 5-10 degrees off. Can this be adjusted?
View 12 Replies
Just about every trip i take my temp gauge pegs and dinger goes off and check gauges lights up in the message center. It eventually will go back to normal or if i shut key off and restart truck it goes to normal. im guessing it is the temperature sensor for the gauge but not sure?? If it is, where is the gauge sensor located?
View 14 Replies
