My auto tranny goes into "safe" mode every so often. It thinks there is something wrong and stays in third gear. The d4 indicator stays on even if another gear is selected (it's indicator light is on too). I changed the fluid (clear, red - in fine condition).
View 14 Replies2001 Accent, 1.5L Automatic with OD, 263,000 km
Transmission goes into Fail Safe Mode but the CEL does not light up and code reader shows no codes. Shifts fine in town,1-2-3-4...4-3-2-1, but on highway when going up inclines (steep), transmission downshifts from Overdrive into 3rd,as i press the accelerator it will downshift into 2nd (as normal), until i reach the top of the incline (3500-4000 rpm) but then as the car levels out on the highway, it will shift back and forth between overdrive and 3rd, (jerky shifting) then finally goes into Fail safe mode, 3000 rpm at 80-90 km/h. Once I shut the car off for a few minutes, the transmission is fine and shifts normally. Fluid levels are good. Why the CEL is not giving code?
I was driving at 40 -30 mph on a dark street and rammed through a bit of water ( maybe 4" high and 6 feet across). So right after i got these tranny codes and my tranny went to safe mode kicking hard when shifting:
P0705
Transmission Range Sensor Out Of Self Test Range Or Shorted To Ground
P1783
Transmission Over Temperature Condition
P0712
Transmission Fluid Temperature Sensor Circuit Input Low
P1702
Transmission Concern
Luckily I was a block away from home. So i assumed all those sensors shorted with water ( I thought they were all water proof...hmm) so i let them dry.
So the codes went away and the truck seamed fine for 2 weeks until i felt the tranny kicking again into gears yesterday. So today i went on a test drive and it was fine at first until it went into safe mode again with only 2 codes:
P0705
Transmission Range Sensor Out Of Self Test Range Or Shorted To Ground
P1702
Transmission Concern
So, that means the other sensors dried out and i destroyed the TRS? and if so would it malfunctioning cause the tranny to go into safe mode or could there be some other issue?
My auto transmission in my 2007 Elantra with 125,000 miles went into default mode, stuck in 3rd gear. No codes went off. I drove it home this way, but after sitting for 90 minutes, now it works fine. I've heard about the input and output sensors. What should I replace? I went to HMA service to get info on both sensors, but it wasn't detailed enough.
View 3 RepliesWhere I live people on the highway accelerate quickly. I try to stay in the EV range up to 15 mph but, when I do someone is up my rear end.
However, when I accelerate manually in EV mode I can accelerate up to 25 mph with the flow of traffic.
My concern with repeatedly accelerating up 25 mph in EV mode will be harder ( lessen the life ) on the battery or the transmission or the electric motors.
I'm guessing it's safe for the electric motors and the transmission because the plug in prius can accelerate up to 62 mph and it's fine.
However th
So is it 100% safe for the car to repeatedly accelerate out of EV mode?
I got a 99 B.5 Passat..
a couple days ago.. I put water into the car cause the light came on. The next day the check engine light appeared. I drove the car and parked it for a few hours..
When I went back into the car the check engine light still appeared.. And not only that it went into SAFE MODE with all lights highlighted... PRND432..
I have a 2009 SX4 Crossover, which came with a Garmin nuvi 760 ... but which has been customized for Suzuki. I actually already own a "real" Garmin nuvi that we've been using in our other vehicles, so the Suzuki customizations are fairly obvious to me.
For the most part, they are welcome value-adds over a standard Garmin nuvi 760, with one very annoying exception ... and that is the mandatory "Safe Mode".
Suzuki has apparently decided for me that I must always have Safe Mode enabled, by removing the enable/disable option for this in the Suzuki version. A "real" nuvi 760 (and for that matter all other real Garmin nuvis with Safe Mode) has a Safe Mode enable/disable toggle button on the Security settings panel; and that has been removed from this panel in the Suzuki version.
While I understand the safety issues involved with a driver trying to use certain features while the car is moving, did Suzuki forget that they also install a passenger seat up front as well; and that maybe me or my wife, while in the passenger seat, might be trying to look up some location information for us while we are driving through an unfamiliar place looking for things? The only way to get out of Safe Mode is to pull the car over somewhere and stop ... very inconvenient, especially in congested city traffic. This has happened to us a number of times now, and is really getting old.
So I'm just wondering if any way to disable Safe Mode on the Suzuki version of the nuvi 760? Or, what I am actually hoping is that the option to turn toggle it on/off really is still there but just hidden, and that maybe there is a way to un-hide it ...
I had to do some work on the car which required disconnecting the battery, Usually the radio goes into safe mode which I unlock using the 4 digit code. However this time i entered the wrong code and the radio went into 02 safe mode?? Now the radio is not responding at all to any inputs from the buttons, its literally locked. I have disconnected the battery again and left it for a bit hoping it would clear it but no luck it still says 02 safe and I can't enter the code to unlock it.
View 5 RepliesIs it safe to rev the engine while in inspection mode (forced idle). Someone has a question about checking for valve noise in the top thread about common 2G problems in the maintenance discussion, and I unsure about giving advice concerning revving the engine via the throttle motor. I will mention, I suppose, the check engine light will turn on.
View 3 RepliesI unhooked the battery for about an hour. I hooked it back up. I started the car put the selector into drive. CLUNK. Disengaged the parking brake. Drove. It turns out when I shifted to D it went straight to third and stayed there. I turned off the car, restarted it. Still stuck in third. Drove a few miles. Restarted it. No more issues. My guess the tranny went into safe mode, but why?
View 3 RepliesI have replaced my trans and now I have a problem with it going into fall safe mode. I was told it was to do with a sensor on the transfer case. Could this be my problem? I can turn the truck off and turn it back on and it will shift out, but when I stop and start to take off it goes back into the fall safe mode, staying in high gear.
View 4 RepliesHow to bypass the safe mode feature of the navigation unit? I've found bypass modules on the internet that go for around 200 but was wondering if there's an alternative method that would possibly be DIY and very low cost?
View 2 RepliesThere had been a lot of discussion about the engine light coming on and the Engine fail safe mode. A lot of folks said the dealer could not fix it. It happened to me and my dealer fixed it. This is what the dealer did to correct the problem
EEC Tested
Code P2106
Disconnected all wheel speed sensors and reprogramed PCM per SSM 17272 and Ford Hotline
No more problems.....
I was driving down a road tonight and my entire truck shut down, and it said engine safe mode. I lost all power steering and gas, all I had were breaks and electronics. What does that mean?
View 1 RepliesMy AC always defaults to Recirculation mode the first time I use it after starting the car even though Auto mode is off.
Can I change this to default to fresh air mode?
So i noticed, when in auto mode, whether sport mode is on or off, it does the same thing. If i floor it from a stand still, the transmission takes noticeably longer to go from 1st into 2nd then from 2nd to 3rd, 3rd to 4th, etc. 1st to 2nd takes like a good second, kinda like this:
1st VROOOOM.....................2nd VROOOM..3rd VROOOM..4th.....etc..
If I drive it in manual mode, then it shifts just as fast. So this only happens in auto.
I have a 2008 F350 with a 6.4 Powerstroke diesel engine that just experienced total engine failure. It has around 65K miles.
There is a heavy burn star pattern on all 8 pistons, a few pistons are cracked, a few cylinder walls are scored, glow plugs are melted, both heads are cracked with multiple stress fractures in each head.
About 1 month previously, the transmission would not work in tow mode and caused the engine to go into limp home mode. The dealership just replaced the entire tranny as a warranty item. About 1 week before the engine failure, I put in a 5.25 oz bottle of Lucas injector cleaner with a full tank of gas.
The Ford dealership is saying that the star pattern on all 8 pistons is due to high pressure fuel overspray and is evidence that I had a tuner on this engine and that the warranty is invalid. I did not have a tuner. What might have caused this engine failure?
Also, they only ripped down the top half of the motor, not the bottom half. I heard this might have been caused by a cracked crank shaft, but Ford refuses to investigate this possibility.
It hasn't been cool enough to use the heat yet, but I've noticed that whenever I hit "AUTO" on the climate control of my V3, the A/C automatically starts. I noticed in the manual that I can have the dealer make it so that the A/C doesn't automatically come on with AUTO, and that, to me, makes sense for winter.
View 19 RepliesI have one minor complaint with my A/C system. I always run it in recirc mode, but the Touareg A/C system always places it in auto-recirc, so I always have to press the recirc button everytime I start the car. Is there a way to keep the car in recirc mode between starts?
View 24 RepliesEvery time I put it on auto the lights are always on. I heard some cars had the light sensor not activated at the factory. My question is can i just do it myself or have someone do it over a vag-com? I don't want to take it to the dealer if its an easy fix [IMG] [URL] ....
View 19 RepliesI have a Viper SmartStart and sometimes forget to turn the AC down to LO and leave it in Auto. Is there any way to set the car to always start up with those AC settings?
View 8 Replies